Source apportionment of indoor, outdoor, and personal PM2.5 in Seattle, Washington, using positive matrix factorization

As part of a large exposure assessment and health-effects panel study, 33 trace elements and light-absorbing carbon were measured on 24-hr fixed-site filter samples for particulate matter with an aerodynamic diameter <2.5 microm (PM2.5) collected between September 26, 2000, and May 25, 2001, at a central outdoor site, immediately outside each subject's residence, inside each residence, and on each subject (personal sample). Both two-way (PMF2) and three-way (PMF3) positive matrix factorization were used to deduce the sources contributing to PM2.5. Five sources contributing to the indoor and outdoor samples were identified: vegetative burning, mobile emissions, secondary sulfate, a source rich in chlorine, and a source of crustal-derived material. Vegetative burning contributed more PM2.5 mass on average than any other source in all microenvironments, with average values estimated by PMF2 and PMF3, respectively, of 7.6 and 8.7 microg/m3 for the outdoor samples, 4 and 5.3 microg/m3 for the indoor samples, and 3.8 and 3.4 microg/m3 for the personal samples. Personal exposure to the combustion-related particles was correlated with outdoor sources, whereas exposure to the crustal and chlorine-rich particles was not. Personal exposures to crustal sources were strongly associated with personal activities, especially time spent at school among the child subjects.     

Characterisation of the dilute HCl extraction method for the identification of metal contamination in Antarctic marine sediments

A regional survey of potential contaminants in marine or estuarine sediments is often one of the first steps in a post-disturbance environmental impact assessment. Of the many different chemical extraction or digestion procedures that have been proposed to quantify metal contamination, partial acid extractions are probably the best overall compromise between selectivity, sensitivity, precision, cost and expediency. The extent to which measured metal concentrations relate to the anthropogenic fraction that is bioavailable is contentious, but is one of the desired outcomes of an assessment or prediction of biological impact. As part of a regional survey of metal contamination associated with Australia's past waste management activities in Antarctica, we wanted to identify an acid type and extraction protocol that would allow a reasonable definition of the anthropogenic bioavailable fraction for a large number of samples. From a kinetic study of the 1 M HCl extraction of two Certified Reference Materials (MESS-2 and PACS-2) and two Antarctic marine sediments, we concluded that a 4 h extraction time allows the equilibrium dissolution of relatively labile metal contaminants, but does not favour the extraction of natural geogenic metals. In a regional survey of 88 marine samples from the Casey Station area of East Antarctica, the 4 h extraction procedure correlated best with biological data, and most clearly identified those sediments thought to be contaminated by runoff from abandoned waste disposal sites. Most importantly the 4 h extraction provided better definition of the low to moderately contaminated locations by picking up small differences in anthropogenic metal concentrations. For the purposes of inter-regional comparison, we recommend a 4 h 1 M HCl acid extraction as a standard method for assessing metal contamination in Antarctica.     

Electrochemical monitoring of methylparathion degradation in an acid aqueous medium in presence of Cu(II)

A study was undertaken to determine the effect of Cu(II) in degradation of methylparathion (o,o-dimethyl o,4-nitrophenyl phosphoriotioate) in acid medium. Initial electrochemical characterization of Cu(II) and methylparathion was done in an aqueous medium at a pH range of 2-7. Cu(II) was studied in the presence of different anions and it was observed that its electroactivity depends on pH and is independent of the anion used. Methylparathion had two reduction signals at pH < or = 6 and only one at pH > 6. The pesticide's transformation kinetic was then studied in the presence of Cu(II) in acid buffered aqueous medium at pH values of 2, 4, and 7. Paranitrophenol appeared as the only electroactive product at all three pH values. The reaction was first order and had k values of 5.2 x 10(-3) s(-1) at pH 2, 5.5 x 10(-3) s(-1) at pH 4 and 9.0 x 10(-3) s(-1) at pH 7. It is concluded that the principal degradation pathway of methylparathion in acid medium is a Cu(II) catalyzed hydrolysis reaction.     

Analysis of extinction in ultraviolet and visible spectra of water bodies of the Paraguay and Brazil wetlands

The extinction spectra in ultraviolet and visible radiation were analyzed using filtered and unfiltered water samples obtained in 11 open water bodies in the Neembucù (Paraguay) and Pantanal (Brazil) wetlands. The role of dissolved and suspended matter in the total extinction was analyzed between 260 nm and 700 nm. The chromophoric dissolved organic matter (CDOM) was the major component in extinction of considered ultraviolet radiation (260-400 nm). The differences in CDOM concentrations explained the main pattern of extinction of the ultraviolet radiation in the samples. Nevertheless, differences between the studied water bodies were found also to depend on the rate of photodegradation and photobleaching. The methodology developed in the present study was to distinguish "humic optic waters" according to quantity and quality of dissolved and suspended matter present. In the "humic optic water", the penetration of 10% of incident UV radiation and the photoactive layer are estimated. The influence of particulate matter increases in the total extinction of the wavelengths higher than 400 nm. The integral of the extinction curve of suspended matter in the visible wavelengths (400-700 nm) was found to relate with the total suspended solids and chlorophyll concentrations.     

Effects of the mosquito larvicide GB-1111 on bird eggs

Golden Bear Oil (GB-1111; legal trade name for GB-1313) is a petroleum distillate used in the United States and other countries as a mosquito larvicide. As part of an evaluation of the potential effects of GB-1111 on birds, fertile eggs of mallards (Anas platyrhynchos) and bobwhite (Colinus virginianus) were incubated in the laboratory, and treated on day 4 of incubation with external applications equivalent to either 0, 1/3, 1, 3 or 10 times the maximum rate (X) of 47 l/ha (5 gal/A) of field application of GB-1111. Hatching success was significantly reduced in mallards treated at 3 and 10 times the maximum field application, with a calculated approximate LD50 of 1.9 times the maximum field application. Most mortality occurred within a week of treatment. Hepatic P450-associated monooxygenase activity (ethoxyresorufin-O-dealkylase; EROD) was negatively related to dose. In the 3X group there was a significant increase in the concentration of hepatic reduced glutathione (GSH) but a decrease in protein-bound thiols (PBSH). Hatching success of bobwhite was marginally reduced at the highest level of treatment (10X). Other effects at this level in bobwhite included a significant increase in incidence of abnormal embryos or hatchlings, lower body and liver weights, and a two-fold increase in hepatic microsomal EROD activity in hatchlings. The recommended maximum rate of field application of GB-1111 is unlikely to impair the survival or development of bobwhite embryos but is potentially toxic to mallard embryos under conditions of larvicide drift or spray overlap.     

Characterization of metal adsorption kinetic properties in batch and fixed-bed reactors

Copper adsorption kinetic properties in batch and fixed-bed reactors were studied in this paper. The isothermal adsorption experiments showed that the copper adsorption capacity of a granular activated carbon (Filtrasorb 200) increased when ionic strength was higher. The presence of EDTA diminished the adsorption. An intraparticle diffusion model and a fixed-bed model were successfully used to describe the batch kinetic and fixed-bed operation behaviors. The kinetics became faster when the solution pH was not controlled, implying that the surface precipitation caused some metal uptake. The external mass transfer coefficient, the diffusivity and the dispersion coefficient were obtained from the modeling. It was found that both external mass transfer and dispersion coefficients increased when the flow rate was higher. Finally effects of kinetic parameters on simulation of fixed-bed operation were conducted.     

BETR-World: a geographically explicit model of chemical fate: application to transport of alpha-HCH to the Arctic

The Berkeley-Trent (BETR)-World model, a 25 compartment, geographically explicit fugacity-based model is described and applied to evaluate the transport of chemicals from temperate source regions to receptor regions (such as the Arctic). The model was parameterized using GIS and an array of digital data on weather, oceans, freshwater, vegetation and geo-political boundaries. This version of the BETR model framework includes modification of atmospheric degradation rates by seasonally variable hydroxyl radical concentrations and temperature. Degradation rates in all other compartments vary with seasonally changing temperature. Deposition to the deep ocean has been included as a loss mechanism. A case study was undertaken for alpha-HCH. Dynamic emission scenarios were estimated for each of the 25 regions. Predicted environmental concentrations showed good agreement with measured values for the northern regions in air, and fresh and oceanic water and with the results from a previous model of global chemical fate. Potential for long-range transport and deposition to the Arctic region was assessed using a Transfer Efficiency combined with estimated emissions. European regions and the Orient including China have a high potential to contribute alpha-HCH contamination in the Arctic due to high rates of emission in these regions despite low Transfer Efficiencies. Sensitivity analyses reveal that the performance and reliability of the model is strongly influenced by parameters controlling degradation rates.     

Calculating pesticide sorption coefficients (Kd) using selected soil properties

Pesticide soil/solution distribution coefficients ( Kd values), commonly referred to as pesticide soil sorption values, are utilized in computer and decision aid models to predict soil mobility of the compounds. The values are specific for a given chemical in a given soil sample, normally taken from surface soil, a selected soil horizon, or at a specific soil depth, and are normally related to selected soil properties. Pesticide databases provide Kd values for each chemical, but the values vary widely depending on the soil sample on which the chemicals were tested. We have correlated Kd values reported in the literature with the reported soil properties for an assortment of pesticides in an attempt to improve the accuracy of a Kd value for a specific chemical in a soil with known soil properties. Mathematical equations were developed from regression equations for the related properties. Soil properties that were correlated included organic matter content, clay mineral content, and/or soil pH, depending on the chemical properties of the pesticide. Pesticide families for which Kd equations were developed for 57 pesticides include the following: Carboxy acid, amino sulfonyl acid, hydroxy acid, weakly basic compounds and nonionizable amide/anilide, carbamate, dinitroaniline, organochlorine, organophosphate, and phenylurea compounds. Mean Kd values for 32 additional pesticides, many of which had Kd values that were correlated with specific soil properties but for which no significant Kd equations could be developed are also included.     

Non-aqueous phase liquid spreading during soil vapor extraction

Many non-aqueous phase liquids (NAPLs) are expected to spread at the air-water interface, particularly under non-equilibrium conditions. In the vadose zone, this spreading should increase the surface area for mass transfer and the efficiency of volatile NAPL recovery by soil vapor extraction (SVE). Observations of spreading on water wet surfaces led to a conceptual model of oil spreading vertically above a NAPL pool in the vadose zone. Analysis of this model predicts that spreading can enhance the SVE contaminant recovery compared to conditions where the liquid does not spread. Experiments were conducted with spreading volatile oils hexane and heptane in wet porous media and capillary tubes, where spreading was observed at the scale of centimeters. Within porous medium columns up to a meter in height containing stagnant gas, spreading was less than ten centimeters and did not contribute significantly to hexane volatilization. Water film thinning and oil film pinning may have prevented significant oil film spreading, and thus did not enhance SVE at the scale of a meter. The experiments performed indicate that volatile oil spreading at the field scale is unlikely to contribute significantly to the efficiency of SVE.     

Gas-phase mercury reduction to measure total mercury in the flue gas of a coal-fired boiler

Gaseous elemental and total (elemental + oxidized) mercury (Hg) in the flue gas from a coal-fired boiler was measured by a modified ultraviolet (UV) spectrometer. Challenges to Hg measurement were the spectral interferences from other flue gas components and that UV measures only elemental Hg. To eliminate interference from flue gas components, a cartridge filled with gold-coated sand removed elemental Hg from a flue gas sample. The Hg-free flue gas was the reference gas, eliminating the spectral interferences. To measure total Hg by UV, oxidized Hg underwent a gas-phase, thermal-reduction in a quartz cell heated to 750 degrees C. Simultaneously, hydrogen was added to flash react with the oxygen present forming water vapor and preventing Hg re-oxidation as it exits the cell. Hg concentration results are in parts per billion by volume Hg at the flue gas oxygen concentration. The modified Hg analyzer and the Ontario Hydro method concurrently measured Hg at a field test site. Measurements were made at a 700-MW steam turbine plant with scrubber units and selective catalytic reduction. The flue gas sampled downstream of the selective catalytic reduction contained 2100 ppm SO2 and 75 ppm NOx. Total Hg measured by the Hg analyzer was within 20% of the Ontario Hydro results.