酱糟与醋糟混合发酵产沼气研究

酱糟、醋糟是我国食品酿造行业产生的废弃物,通过厌氧发酵不仅可以解决废糟处理问题又可获取能源.因此本研究在中温(35±1)℃的条件下,根据C/N比的不同,进行了酱糟/醋糟干物质(TS)比分别为1∶0(N1)、1∶1.5(N2)、1∶3(N3)、1∶7(N4)、1∶18(N5)和0∶1(N6)的混合发酵实验.结果表明,单一酱渣的延滞期为17.46 d,混合发酵明显缩短了延滞期,为3.00-3.83 d;混合发酵组(N2～N5)累计产甲烷量的实验结果比计算结果分别提高了1％、16％、14％和10％,其中,N3组C/N比为25.7∶1,提高最为明显;各组发酵产生的沼气的甲烷体积分数在65％～ 70％之间;Gompertz模型拟合可以用于酱糟和醋糟混合发酵产甲烷的过程;酱、醋糟发酵的产酸类型以乙酸型发酵为主.     

汽油在西北黄土上吸附特性的研究

通过动力学和热力学吸附实验,研究了汽油在西北地区黄土上的吸附行为,同时研究了提取的天然腐植酸对汽油在黄土上吸附行为的影响.结果表明,汽油在黄土上的吸附在6h内达到平衡.无论是否加入腐植酸,汽油在黄土上的吸附动力学过程均符合Elovich方程,其热力学吸附符合Freundlich方程.腐植酸的存在使汽油在黄土上的吸附能力减小.反应温度从25℃升高到45 C,汽油在土壤上的饱和吸附量从6.300mg·g-1减小到1.365 mg·g-1,表明汽油在黄土上的吸附属于放热反应.溶液pH和土壤粒径的增大,均不利于汽油在黄土上的吸附,溶液pH和土壤粒径越大,其在黄土上的吸附量越小.另外,在室温下对吸附了汽油的土壤样品和纯汽油挥发行为的研究表明,吸附了汽油的土壤样品的汽油挥发比纯汽油慢,其挥发率与时间成对数关系.     

工业园区低碳发展模式评估与规划分析

通过对工业园区低碳发展模式的评估,分析其低碳发展的能源特征、经济特征与人力特征,并确定工业园区二氧化碳减排的潜力能源。基于能源-碳减排(EC)、经济-能源-碳减排(EEC)和人力-经济-能源-碳减排(HEEC)三种不同情景,在未来发展的一定规划期内,对工业园区具有二氧化碳减排潜力的能源进行规划分析,确定其年递减率,从而实现工业园区不同情景下的二氧化碳减排。通过实际案例研究,证明了评估与规划分析模型的可行性。     

UNITANK工艺在城镇污水处理厂的应用

广东省某城镇污水处理厂采用UNITANK新工艺,在项目的运行中,根据具体情况采取了较为有效的应对措施,克服了该工艺应用于大型污水处理厂的不足,运行效果良好,出水水质稳定,达到国家一级B排放标准。     

微量元素对双孢蘑菇菌丝生长的影响

聋用固体平板和液体摇瓶培养试验方法,研究了Zn2+、Cu2+、Co2+、Mo(VI)、Mn2+等5种微量元素对双孢蘑菇2796菌丝生长的影响。通过测定各处理组的菌丝干重、胞内多糖、过氧化物酶活和菌丝生长势等生长参数表明,双孢蘑菇在添加上述5种浓度为20—40mg/L的微量元素时,对菌丝生长势、胞内多糖量和胞外蛋白量等都有促进作用,加入的浓度不同其促进程度也不同。加入Mn2+促进菌丝生长的效果最明显,使菌丝干重达最高值(200mg/100ml),胞内多糖量高达23mg/100ml,分别比对照组增加200%和400%,但添加高浓度的微量元素则会抑制菌丝的生长。     

全球环境变化对土壤有机碳库影响的研究进展

全球环境变化对土壤生态系统有机碳库的影响是当前研究的热点。本文综述了大气CO2浓度升高、温度上升、氮沉降等环境因素变化对土壤有机碳输入与土壤呼吸可能的影响,介绍了关于全球环境变化对土壤有机碳库影响的研究手段及其存在的问题,并就今后研究土壤有机碳对全球变化的响应提出了几点建议。     

Characteristics of the stabilized/solidified municipal solid wastes incineration fly ash and the leaching behavior of Cr and Pb

Fly ash is a hazardous byproduct of municipal solid wastes incineration (MSWI). An alkali activated blast furnace slag-based cementitious material was used to stabilize/solidify the fly ash at experimental level. The characteristics of the stabilized/solidified fly ash, including metal leachability, mineralogical characteristics and the distributions of metals in matrices, were tested by toxic characteristic leaching procedure (TCLP), X-ray diffraction (XRD) and scanning electron microscopy-energy dispersive spectrometer (SEM-EDS) respectively. Continuous acid extraction was utilized to extract metal ions and characterize their leaching behavior. The stabilization/solidification procedure for MSWI fly ash demonstrates a strong fixing capacity for the metals by the formation of C-S-H phase, hydrated calcium aluminosilicate and ettringite. The stabilized/solidified fly ash shows a dense and homogeneous microstructure. Cr is mainly solidified in hydrated calcium aluminosilicate, C-S-H and ettringite phase through physical encapsulation, precipitation, adsorption or substitution mechanisms, and Pb is mainly solidified in C-S-H phase and absorbed in the Si-O structure.     

Wastewater-nitrogen removal using polylactic acid/starch as carbon source: Optimization of operating parameters using response surface methodology

The use of PLA/starch blends for nitrogen removal was achieved. The influence of different operating parameters on responses was verified using RSM. The conditions for desired responses were successfully optimized simultaneously. Blends material may have a promising application prospect in the future. Nitrogen removal from ammonium-containing wastewater was conducted using polylactic acid (PLA)/starch blends as carbon source and carrier for functional bacteria. The exclusive and interactive influences of operating parameters (i.e., temperature, pH, stirring rate, and PLA-to-starch ratio (PLA proportion)) on nitrification (Y₁), denitrification (Y₂), and COD release rates (Y₃) were investigated through response surface methodology. Experimental results indicated that nitrogen removal could be successfully achieved in the PLA/starch blends through simultaneous nitrification and denitrification. The carbon release rate of the blends was controllable. The sensitivity of Y₁, Y₂, and Y₃ to different operating parameters also differed. The sequence for each response was as follows: for Y₁, pH>stirring rate>PLA proportion>temperature; for Y₂, pH>PLA proportion>temperature>stirring rate; and for Y₃, stirring rate>pH>PLA proportion>temperature. In this study, the following optimum conditions were observed: temperature, 32.0°C; pH 7.7; stirring rate, 200.0 r·min^-1; and PLA proportion, 0.4. Under these conditions, Y₁, Y₂, and Y₃ were 134.0 μg-N·g-blend^-1·h^-1, 160.9 μg-N·g-blend^-1·h^-1, and 7.6 × 10³ μg-O·g-blend^-1·h^-1, respectively. These results suggested that the PLA/starch blends may be an ideal packing material for nitrogen removal.     

加速溶剂同时萃取和净化-气相色谱-三重四极杆串联质谱测定土壤和沉积物中8种多溴联苯醚

建立了土壤和沉积物中8种多溴联苯醚(PBDEs,BDE-28、BDE-47、BDE-99、BDE-100、BDE-153、BDE-154、BDE-183和BDE-209)加速溶剂同时萃取和净化-气相色谱-三重四极杆串联质谱(ASE-GC-MS-MS)的分析方法。通过优化加速溶剂萃取与弗罗里硅土在线净化和串联质谱多反应监测模式的条件,较好地去除基质干扰,并提高了三重四极杆串联质谱定性的准确性及定量的灵敏性。该方法采用改进的色谱柱能同时分析包括高溴代联苯醚BDE-209在内的8种PBDEs,其浓度范围为1～100 ng/mL(BDE-209为10～1 000 ng/mL),线性良好,线性回归系数均大于0.997。方法检出限为0.004～0.1 ng/g,方法回收率为75%～110%,方法精密度为2.4%～15.6%。适于批量处理土壤和沉积物中含有多组分痕量PBDEs的样品。