木材工业粉尘污染控制存在的问题与发展趋势

从中国木材工业粉尘污染控制现状存在的问题入手,分析了木材工业企业粉尘污染的原因,提出了控制粉尘污染的措施及发展趋势.保护环境是实现木材工业可持续发展的必然趋势,必须从工艺、技术和装备方面控制生产过程中的粉尘,使作业环境和大气污染排放达到国家环境保护标准和法规的要求.     

On-line optical determination of floc size of Fe(Ⅲ) coagulants

This study investigated the floc aggregation, average floc size, floc size variance and floc growth velocity when ferric chloride （FeCl3） and polyferric chloride （PFC） were used to treat the simulated water samples. The factors including coagulant dose, ionic strength and solution pH, which affect the floc aggregation, were studied. Experiments were carried out in a bench-scale reactor using photometric dispersion analyzer （ PDA）. Results showed that there were great differences between the floc aggregation of PFC and FeCl3. The average floc size and fioc growth velocity of PFC were much larger than those of FeCl3. Compared with FeCl3, PFC gave a better coagulation performance in wider range of pH, dosage and ionic strength. It was also found that the coagulation efficiency of PFC did not depend on average floc size but on floc growth velocity.     

Sorption of pyrene on two paddy soils and their particle-size fractions

In the present study, the sorption of pyrene on two kinds of bulk paddy soils, Gleyic Stagnic Anthrosols, and Ferric accumulic Stagnic Anthrosols as well as their particle-size fractions was investigated. The sorption isotherms fitted well with Freundlich equation. For both soils, the clay fraction（ 〈 2μm） and coarse sand fraction（2000-250μm） had higher sorption capacity than fine sand fraction（250-20 μm） and silt fraction（20-2 μm）. The IogKoc values obtained of each soil and its particle-size fractions were similar, proving that SOM content was a key factor affecting pyrene sorption. The Kd values showed a significant correlation with contents of dithionite-extractable Fe in both paddy soils and a good relationship with CEC in Gleyic Stagnic Anthrosols, indicating possible effects of surface properties of particle-size fractions on the sorption of pyrene.     

区域环境风险研究进展探讨

主要围绕国内外在区域环境风险领域的研究进展、趋势与不足进行分析评述,在此基础上提出了进行区域环境风险水平及阈值研究,并进行动态调控的研究新思路。     

采用钙钛矿型催化剂(La0.8K0.2Cu0.05Mn0.95O3)同时催化去除NOx和碳烟的研究

将钙钛矿型催化剂与碳烟均匀混合后置于固定床连续流动反应体系中,利用程序升温反应技术,在模拟柴油机尾气的情况下对同时催化去除氮氧化物(NOx)和碳烟的反应进行了实验研究.通过改变含Cu原料的用量,得到不同Cu取代量的催化剂La0.8K0.2CuxMn1-xO3,性能评价结果表明,La0.8K0.2Cu0.05Mn0.95O3催化剂的综合性能较好,碳烟的起燃温度及NO向N2的最大转化率分别为280℃和58.0%.采用该催化剂,进一步考察了进气中NO浓度、O2浓度、进气总流量及催化剂与碳烟的接触状况对反应的影响.研究结果表明,进气中NO浓度、O2浓度、气体总流量和催化剂与碳烟之间的接触状况对NO的去除率的影响比较明显,而对碳烟起燃温度的影响较小.O2浓度从5%变为7.5%时,碳烟的起燃温度及最大NO转化率分别从280℃和53.8%变为270℃和96.7%.碳烟与催化剂松散接触时,碳烟的起燃温度及最大NO转化率分别为290℃和48.4%,紧密接触时分别为275℃和70.4%.而进气中NO浓度、气体总流量的变化对碳烟的燃烧基本上没有影响,虽然NO的转化率有明显变化,但生成的N2总量基本不变.     

外控电势对Ch-1菌株生长及Cr(Ⅵ)还原的影响

为进一步优化Ch-1菌株对碱性含铬废水的处理及铬渣的解毒效果,以细菌总数和6价铬的还原率为指标,详细考察了外控电位对Ch-1菌株生长及Cr(Ⅵ)还原的影响.结果表明,电极材料对细菌生长及其活性有一定的影响,不锈钢电极和铂电极体系对细菌生长及活性的影响基本相同,而采用石墨电极细菌的培养效果欠佳.静态培养和动态培养Ch-1菌株时,Cr(Ⅵ)的最终还原率与初始Cr(Ⅵ)浓度无关,24h时Cr(Ⅵ)的还原率均达到了100%;但就还原过程而言,动态培养对Cr(Ⅵ)的还原速率明显优于静态培养,外控电势能够增强或抑制Ch-1菌株的生长及活性,0～-900 mV的负电位可以促进细菌的生长,而400 mV以上的正电势对Ch-1菌株的生长有抑制作用.在-800～ 200 mV的电势范围内,Ch-1菌株还原6价铬的能力得到增强,在此范围外其还原能力受到抑制.     

模拟消落带水华暴发行为的数值沙堆模型

以长江最大支流汉江近年来水华污染的现场资料为例,通过氮磷浓度、水温、流速和光照等实测数据构建了消落带开放水域环境体系的数值沙堆模型,描述了藻类生长及水华暴发的动力学机制;利用数值沙堆系统崩塌行为反映出的频率-尺度幂律关系作为判断消落带水域是否暴发水华以及规模大小的依据,采用有限尺度标度分析从不同侧面验证了水华暴发系统的自组织临界性,并揭示出各种拟合参数与水华暴发规模之间的定量关系.研究表明,沙堆模型如果存在良好的幂律关系,相应的消落带水域将暴发水华,且幂律指数越大,水华污染程度越严重.     

Ni2+对2-氯酚厌氧降解系统的影响

针对重金属对难降解有毒有机物厌氧降解的影响问题,采用间歇试验法研究Ni2 对2-氯酚(2-CP)厌氧降解系统的影响规律.结果表明,当ρ(Ni2 )＜5 mg/L时,Ni2 对2-CP厌氧降解表现出轻度促进,当ρ(Ni2 )为5～500 mg/L,Ni2 以抑制作用为主,抑制作用随ρ(Ni2 )的增加而增强.Ni2 对原基质及关键中间产物苯酚和苯甲酸的抑制程度表现为:苯酚＞苯甲酸＞2-CP;ρ(Ni2 )低时的驯化能有效提高厌氧污泥对Ni2 毒性的耐受性能,300 mg/L Ni2 对2-CP降解的抑制从驯化前的65%降至驯化后的21%.Ni2 对2-CP厌氧降解的抑制作用与污泥中Ni的截留量之间存在正相关关系.抑制浓度CIP值和方程αC=[1-(I/I*)m]/[1 (I/I*)n)]能较好地表征厌氧生物处理过程受抑制程度.     

热解析气相色谱法测定土壤中苯系物

建立了用热解析气相色谱法测定土壤中苯系物的方法.采用保留时间定性,外标法定量.方法检出限分别为:苯1.8 μg·L-1、甲苯3.5 μg·L-1、乙苯7.0 μg·L-1、间二甲苯8.6 μg·L-1、对二甲苯8.6 μg·L-1、邻二甲苯9.8 μg·L-1、苯乙烯10.0 μg·L-1;加标回收率在79%～100%之间,相对标准偏差为1.5%～3.9%.方法操作简便,快速,灵敏度高,能适应现代化的应急监测.     

Membrane fouling control by ultrasound in an anaerobic membrane bioreactor

In this study, ultrasound was used to control the membrane fouling online in an anaerobic membrane bioreactor (AMBR). Short-term running experiments were carried out under different operating conditions to explore feasible ultrasonic parameters. The experimental results indicated that when the crossflow velocity was more than 1.0 m/s, membrane fouling could be controlled effectively only by hydrodynamic methods without ultrasound. When ultrasound was applied, an ultrasonic power range of 60–150 W was suitable for the membrane fouling control in the experimental system. The experimental results showed that the membrane fouling was controlled so well that membrane filtration resistance (ΣR) could stay at 5 × 10¹¹ m⁻¹ for more than a week with the crossflow velocity of 0.75 m/s, which equaled the effect of crossflow velocity of more than 1.0 m/s without ultrasound. Translated from Techniques and Equipment for Environmental Pollution Control, 2006, 7(4): 25–29 [译自: 环境污染治理技术与设备]