Potential of secondary aerosol formation from Chinese gasoline engine exhaust

Light-duty gasoline vehicles have drawn public attention in China due to their significant primary emissions of particulate matter and volatile organic compounds(VOCs). However,little information on secondary aerosol formation from exhaust for Chinese vehicles and fuel conditions is available. In this study, chamber experiments were conducted to quantify the potential of secondary aerosol formation from the exhaust of a port fuel injection gasoline engine. The engine and fuel used are common in the Chinese market, and the fuel satisfies the China V gasoline fuel standard. Substantial secondary aerosol formation was observed during a 4–5 hr simulation, which was estimated to represent more than 10 days of equivalent atmospheric photo-oxidation in Beijing. As a consequence, the extreme case secondary organic aerosol(SOA) production was 426 ± 85 mg/kg-fuel, with high levels of precursors and OH exposure. The low hygroscopicity of the aerosols formed inside the chamber suggests that SOA was the dominant chemical composition. Fourteen percent of SOA measured in the chamber experiments could be explained through the oxidation of speciated single-ring aromatics. Unspeciated precursors, such as intermediate-volatility organic compounds and semi-volatile organic compounds, might be significant for SOA formation from gasoline VOCs. We concluded that reductions of emissions of aerosol precursor gases from vehicles are essential to mediate pollution in China.     

Mercury flows in large-scale gold production and implications for Hg pollution control

Large-scale gold production(LSGP) is one of the five convention-related atmospheric mercury(Hg) emission sources in the Minamata Convention on Mercury. However, field experiments on Hg flows of the whole process of LSGP are limited. To identify the atmospheric Hg emission points and understand Hg emission characteristics of LSGP, Hg flows in two gold smelters were studied. Overall atmospheric Hg emissions accounted for 10%–17% of total Hg outputs and the Hg emission factors for all processes were 7.6–9.6 kg/ton. There were three dominant atmospheric Hg emission points in the studied gold smelters, including the exhaust gas of the roasting process, exhaust gas from the environmental fog collection stack and exhaust gas from the converter of the refining process. Atmospheric Hg emissions from the roasting process only accounted for 16%–29% of total emissions and the rest were emitted from the refining process. The overall Hg speciation profile(gaseous elemental Hg/gaseous oxidized Hg/particulate-bound Hg) for LSGP was 34.1/57.1/8.8. The dominant Hg output byproducts included waste acid, sulfuric acid and cyanide leaching residue. Total Hg outputs from these three byproducts were 80% in smelter A and 84% in smelter B. Our study indicated that previous atmospheric Hg emissions from large-scale gold production might have been overestimated.Hg emission control in LSGP is not especially urgent in China compared to other significant emission sources(e.g., cement plants). Instead, LSGP is a potential Hg release source due to the high Hg output proportions to acid and sludge.     

Effects of Na+ on Cu/SAPO-34 for ammonia selective catalytic reduction

Copper-exchanged chabazite (Cu/CHA) catalysts have been found to be affected by alkali metal and alkaline earth ions. However, the effects of Na⁺ ions on Cu/SAPO-34 for ammonia selective catalytic reduction (NH₃-SCR) are still unclear. In order to investigate the mechanism, five samples with various Na contents were synthesized and characterized. It was observed that the introduced Na⁺ ion-exchanges with H⁺ and Cu^2 + of Cu/SAPO-34. The exchange of H⁺ is easier than that of isolated Cu^2 +. The exchanged Cu^2 + ions aggregate and form “CuAl₂O₄-like” species. The NH₃-SCR activity of Cu/SAPO-34 decreases with increasing Na content, and the loss of isolated Cu^2 + and acid sites is responsible for the activity loss.     

Seasonal variation and size distribution of biogenic secondary organic aerosols at urban and continental background sites of China

Size-resolved biogenic secondary organic aerosols(BSOA) derived from isoprene and monoterpene photooxidation in Qinghai Lake, Tibetan Plateau(a continental background site) and five cities of China were measured using gas chromatography/mass spectrometry(GC/MS). Concentrations of the determined BSOA are higher in the cities than in the background and are also higher in summer than in winter. Moreover, strong positive correlations(R2= 0.44–0.90) between BSOA and sulfate were found at the six sites,suggesting that anthropogenic pollution(i.e., sulfate) could enhance SOA formation,because sulfate provides a surface favorable for acid-catalyzed formation of BSOA. Size distribution measurements showed that most of the determined SOA tracers are enriched in the fine mode( 3.3 μm) except for cis-pinic and cis-pinonic acids, both presented a comparable mass in the fine and coarse( 3.3 μm) modes, respectively. Mass ratio of oxidation products derived from isoprene to those from monoterpene in the five urban regions during summer are much less than those in Qinghai Lake region. In addition, in the five urban regions relative abundances of monoterpene oxidation products to SOA are much higher than those of isoprene. Such phenomena suggest that BSOA derived from monoterpenes are more abundant than those from isoprene in Chinese urban areas.     

Regionalization based on spatial and seasonal variation in ground-level ozone concentrations across China

Owing to the vast territory of China and strong regional characteristic of ozone pollution,it's desirable for policy makers to have a targeted and prioritized regulation and ozone pollution control strategy in China based on scientific evidences. It's important to assess its current pollution status as well as spatial and temporal variation patterns across China.Recent advances of national monitoring networks provide an opportunity to insight the actions of ozone pollution. Here, we present rotated empirical orthogonal function(REOF)analysis that was used on studying the spatiotemporal characteristics of daily ozone concentrations. Based on results of REOF analysis in pollution seasons for 3 years' observations, twelve regions with clear patterns were identified in China. The patterns of temporal variation of ozone in each region were separated well and different from each other, reflecting local meteorological, photochemical or pollution features. A rising trend in annual averaged Eight-hour Average Ozone Concentrations(O_3-8 hr) from 2014 to 2016 was observed for all regions, except for the Tibetan Plateau. The mean values of annual and 90 percentile concentrations for all 338 cities were 82.6 ± 14.6 and 133.9 ± 25.8 μg/m~3,respectively, in 2015. The regionalization results of ozone were found to be influenced greatly by terrain features, indicating significant terrain and landform effects on ozone spatial correlations. Among 12 regions, North China Plain, Huanghuai Plain, Central Yangtze River Plain, Pearl River Delta and Sichuan Basin were realized as priority regions for mitigation strategies, due to their higher ozone concentrations and dense population.     

电絮凝净化含聚污水影响因素研究

目的为保障油田正常安全生产,促进油田含聚污水的循环利用。方法采用电絮凝技术单因素研究方法开展净化含聚污水的静态实验研究,探讨外加电流密度、极板间距、初始pH及聚合物浓度等因素对净化效果的影响规律。结果当初始pH为7.0,电流密度为4.0 m A/m2,极板间距为1.0 cm,电解16 min时,综合处理效果最佳。此时,含油量与浊度去除率分别为98.85%,99.93%,处理每克油平均消耗为0.0494 g的Al,处理每立方米含聚污水的能耗为0.2895 k Wh。污水中的聚合物浓度越小,净化效果越好。结论中性处理,极板间距为1.0 cm,外加电流密度为4.0 m A/m2,通电16 min是最佳处理条件。     

某型飞机外翼5—8肋损伤原因分析及修复探讨

目的 分析某型飞机外翼5—8肋油箱区结构不同程度损伤的原因,制定修复方案。方法采用受载分析、有限元仿真计算、静力试验数据分析等强度计算方法分析损伤产生的原因,采用扫描电子显微镜和光学显微镜对磨痕形貌进行观测等失效分析,对损伤结构件开展失效模式分析,根据损伤原因及失效模式制定科学简便的修复方案,同时对损伤长桁采取的修补措施进行强度校核。结果 通过对外翼油箱充压破坏理论分析、有限元仿真计算、静力试验数据反推,并结合飞机实际损伤情况,得出油箱破坏理论分析危险薄弱部位与真实破坏情况一致的结论。有限元仿真计算最危险结构部位与实际结构首先发生破坏部位吻合,可作为深入制定修复方案及推测实际加载压力的依据。通过静力试验数据反推、结构实际损伤及有限元仿真计算结论得出,外翼5—8肋结构出现损伤时油箱施加压力约0.5 MPa,针对损伤制定了更换外翼油箱内部第5—8肋损伤结构和贴补加强损伤长桁的修理方案,经结构强度校核,满足设计要求。结论 分析认为外翼5—8肋油箱区结构损伤原因为油箱压力超过设计值导致结构过载断裂,采用贴补加强修理损伤长桁和更换第5—8肋损伤结构的修复方案能够满足强度设计要求,可指导同类飞机类似结构损伤故障的原因分析和修理,提醒同类飞机维修人员在飞机维护时应关注外翼油箱压力超压问题。     

铍青铜弹簧片应力腐蚀断裂研究

目的研究传感器微动开关弹簧片应力腐蚀的机理,找到断裂原因。方法对弹簧片进行断口形貌观察、能谱成分分析,并进行产品模拟腐蚀实验。结果传感器内部意外进入雨水,在工作温度下形成湿热环境,开关盒中的游离氨在此环境下释放出来,在开关盒内部形成潮湿氨气氛,铍青铜弹簧片工作时凹面一侧承受静拉应力作用,从而在潮湿氨和拉应力共同作用下发生应力腐蚀开裂。结论通过采用无氨酚醛塑料制备开关盒,弹簧片的应力腐蚀得到了有效预防。     

聚丙烯酰胺降解菌株的分离及其油田含聚污水生物强化处理研究

应用厌氧Hungate技术,从大庆油田分离到一株聚丙烯酰胺降解菌株,菌株与Clostridium bifermentans(AY781385)相似性为99%,命名为Clostridium bifermentans H5。菌株能以聚丙烯酰胺为唯一碳源,静态试验表明,在附加乳酸钠和硫酸钠的条件下,聚合物去除率为52.5%;首次采用纯菌培养的厌氧污泥作为底物,水解酸化试验表明,乳酸钠作为碳源要好于砂糖,聚合物去除率为50.89%左右,砂糖为碳源聚合物去除率为43.55%左右;初步试验表明,应用高效降解菌株和水解酸化工艺处理含聚污水具有可行性。     

同槽双极锰电积生产工艺的现状及进展研究

为解决传统锰和二氧化锰制备过程中单独电解的高能耗、高污染问题,目前国内外在同槽电解制备金属锰和微粒二氧化锰方面已有一定的探索和研究。总结介绍了锰和二氧化锰的研究进展,电解液的制备方法、电极的制备研究以及最新同槽电解工艺的研究动态和发展,并在此基础上展望了电解制备锰和二氧化锰工业的发展趋势,致力于开发一种同槽双极锰电积清洁节能工艺,在同槽电解降低能耗的基础上发展清洁工艺,回收生产过程中产生的废酸,对环境保护、水体治理以及可持续发展具有重大意义。