用于城市生活垃圾好氧堆肥的滚筒式生物反应器研制

针对城市生活垃圾研制了一种用于好氧发酵的滚筒式生物反应器。滚筒式生物反应器的设计主要包括主体结构设计,支承装置的设计计算,传动装置的功率选用,进、出料装置的功能研究等。为保证滚筒式反应器发挥最大功用,在滚筒内壁增设抄板并设计了抄板的结构形式、布置情况及安装位置,用以延长生活垃圾在滚筒内的停留时间,使好氧发酵更为充分。     

变风量除尘系统在线节能控制技术研究

阐述了变风量除尘系统在线节能研究电气控制部分的设备、软件、控制等内容。根据实验的需求,通过采用变频控制、压力闭环控制、风量闭环控制等技术,实现在线节能技术的自动控制,并对实验数据进行采集,这对于该控制技术扩大到工程应用具有指导意义。     

水泥窑替代燃料中的重金属特性分析

以水泥窑常用的替代燃料——生活垃圾和污泥为研究对象,分别测定了重金属As、Cd、Hg、Cu、Pb、Cr、Zn、Ni总量,Cd、Cu、Pb、Zn的形态分布及As、Cr的价态,结果表明:脱水污泥中,8种重金属含量由高到低的顺序为:Zn>Cu>Cr>Pb>Ni>Hg>As>Cd。三种垃圾筛上物中,8种重金属含量由高到低的依次顺序为:Zn>Cr>Cu>Ni>Pb>As>Hg>Cd。市政污泥中,Cd以酸提取态为主,占总量的45%以上;Pb 94%以残渣态存在;Cu以有机结合态为主,占63.16%;Zn以铁锰氧化态为主,占43.5%。三种垃圾筛上物中,Pb几乎没有酸可提取态和铁锰氧化态的存在,重金属Cd没有残渣态存在。原生垃圾中,重金属Zn酸可提取态占18.52%,而堆肥垃圾筛上物和矿化垃圾筛上物中,重金属Zn酸可提取态为1%以下,铁锰氧化态含量为75%左右。垃圾和污泥中,重金属Cr(Ⅲ)、Cr(Ⅵ)均未检出。     

不同石化污泥配比的堆肥处理对青梗菜生长的影响

试验针对石化污泥生物堆肥,开展了五种不同物料配比和是否添加微生物菌剂的对比试验。试验结果表明:随着堆肥物料中石化污泥配比的提高,堆肥的含水率增大,种植青梗菜的平均单株株高、株重减小,单位面积产量也降低。堆肥物料配比相同的处理Ⅱ与处理Ⅴ对比发现,堆肥处理过程中未添加微生物菌剂的处理Ⅴ的青梗菜的平均单株株高、株重、单位面积产量显著低于添加微生物菌剂的处理Ⅱ,甚至低于石化污泥配比为100%并添加微生物菌剂的处理Ⅳ,试验表明,堆肥过程中添加微生物菌剂,其作用不仅可以提高石化污泥生物堆肥的堆体温度,缩短堆肥周期,而且可提高堆肥在农业种植应用中的效果。     

硫酸钙垢层清洗方法研究

从化学热力学角度和沉淀转化角度,理论上分析了碳酸钠、氢氧化钠分别与硫酸钙发生化学反应的可能性和反应进行的限度。并结合动力学规律,提出影响化学反应的条件,通过实验进行检验。最后提出,在实际工作中,达到良好清洗目的可采取的措施。     

明胶厂剩余高钙污泥作为燃煤固硫剂的应用研究

明胶生产产业在废水处理工艺中产生大量剩余高钙污泥,采用该剩余污泥作为燃煤固硫剂,在高温管式电阻炉内进行燃烧实验,通过测定燃烧前和燃烧后样品中的硫含量确定该剩余污泥的固硫效果。通过单因素研究煤粉粒径、剩余污泥粒径和剩余污泥/煤样%等影响因素对固硫率的影响。在单因素试验的基础上通过正交设计法优选达到较高固硫率的实验条件。实验结果表明:影响固硫率的因素从大到小依次为燃烧温度>剩余污泥/煤样%>煤粉粒径>剩余污泥粒径。以剩余污泥作为固硫剂,固硫率最高的实验条件为:燃烧温度800℃,剩余污泥/煤样为3%,煤粉粒径60⁹0目,剩余污泥粒径9090目,剩余污泥粒径90¹20目。并且,当温度达到1150℃,煤粉粒径90120目。并且,当温度达到1150℃,煤粉粒径90¹20目,剩余污泥粒径为60120目,剩余污泥粒径为60⁹0目,污泥/煤样(质量比)为3%时,固硫率可达62.78%,说明在高温下该剩余污泥保持较高的固硫率。将明胶厂剩余污泥作为固硫剂是较为合适的再利用方法,可有效缓解当前该污泥大量堆积污染环境的状况。     

Competitive sorption between 17α-ethinyl estradiol and bisphenol A/4-n-nonylphenol by soils

The sorption of 17α-ethinyl estradiol(EE2),bisphenol A(BPA),and 4-n-nonylphenol(NP) in single systems and the sorption of EE2 with different initial aqueous concentrations of BPA or NP were examined using three soils.Results showed that all sorption isotherms were nonlinear and fit the Freundlich model.The degree of nonlinearity was in the order BPA(0.537-0.686) > EE2(0.705-0.858) > NP(0.875-0.0.951) in single systems.The isotherm linearity index of EE2 sorption calculated by the Freundlich model for Loam,Silt Loam and Silt increased from 0.758,0.705 and 0.858,to 0.889,0.910 and 0.969,respectively,when BPA concentration increased from 0 to 1000 μg/L,but the effect of NP was comparably minimal.Additionally,EE2 significantly suppressed the sorption of BPA,but insignificantly suppressed that of NP.These findings can be attributed to the difference of sorption affinity of EE2,NP and BPA on the hard carbon(e.g.,black carbon) of soil organic matter that dominated the sorption in the low equilibrium aqueous concentration range of endocrine-disrupting chemicals(EDCs).Competitive sorption among EDCs presents new challenges for predicting the transport and fate of EDCs under the influence of co-solutes.     

Differences in rheological and fractal properties of conditioned and raw sewage sludge

Rheological tests for raw and conditioned activated sludge(AS) or anaerobic digested sludge(ADS) show that power-law relationships can be used to describe the evolution of several rheological parameters,i.e.,limiting viscosity(η∞),yield stress(τy),cohesion energy of the sludge network(Ec),and storage modulus(G’),with total suspended solid(TSS) content in raw and conditioned sludge.A gel-like structure that behaves similar to weak-link flocs/aggregates was observed in AS and ADS.As derived from the double-logarithmic plots of G’-TSS content,the mass fractal dimensions of the raw and conditioned AS or ADS flocs/aggregates were 2.70 and 2.53 or 2.85 and 2.79,respectively.The rheological tests also indicate that both polymer conditioning and increased TSS content led to improved elastic behavior,cohesion energy,and yield stress of the sludge network,as well as expanded the corresponding linear viscoelastic range.The porosity of AS or ADS flocs/aggregates will be improved by polymer conditioning.     

Removal of Cd2+ from water by Friedel’s salt (FS: 3CaO.Al2O3·CaCl2·10H2O): Sorption characteristics and mechanisms

The development of low-cost and efficient new mineral adsorbents has been a hot topic in recent years. In this study, Friedel’s salt (FS:3CaO·A12O3 ·CaCl2 ·10H2O), a hexagonal layered inorganic absorbent, was synthesized to remove Cd2+ from water. The adsorption process was simulated by Langmuir and Freundlich models. The adsorption mechanism was further analyzed with TEM, XRD, FT-IR analysis and monitoring of metal cations released and solution pH variation. The results indicated the adsorbent FS had an outstanding ability for Cd(Ⅱ) adsorption. The maximum adsorption capacity of the FS for Cd(Ⅱ) removal can reach up to 671.14 mg/g. The nearly equal numbers of Cd2+ adsorbed and Ca2+ released demonstrated that ion-exchange (both surface and inner) of the FS for Cd(Ⅱ) played an important role during the adsorption process. Furthermore, the surface of the FS after adsorption was microscopically disintegrated while the inner lamellar structure was almost unchanged. The behavior of Cd(Ⅱ) adsorption by FS was significantly affected by surface reactions. The mechanisms of Cd2+ adsorption by the FS mainly included surface complexation and surface precipitation. In the present study, the adsorption process was fitted better by the Langmuir isotherm model (R2 = 0.9999) than the Freundlich isotherm model (R2 = 0.8122). Finally, due to the high capacity for ion-exchange on the FS surface, FS is a promising layered inorganic adsorbent for the removal of Cd(Ⅱ) from water.     

Numerical simulation of alga growth and control in Dalian Bay

WAHMO model was used to simulate the distribution of pollutants in Dalian Bay, China as to predict well as the growth and control of alga. The observed and predicted values of main pollutants showed a good trend at all study locations and the different between them can be ignored. Simulation results illustrated that phosphate was one of limited factors to control algal growth at the location near the sewage outfall, meanwhile, away from the sewage outfall, the synergy of ammonium nitrogen and phosphate was the limited factor.