Higher pH and faster decomposition in biowaste composting by increased aeration

Composting of source separated municipal biowaste has at several plants in Scandinavia been hampered by low pH. In this study the hypothesis that increased aeration would improve the process was tested in full-scale experiments at two large composting plants. The O2 concentrations were high (>15%) even at the low aeration rates, so the prevailing low pH was not due to an anaerobic process environment. In spite of this, increased aeration rates at the start of the process resulted in higher microbial activity, increased pH and a more stable compost product. At one plant the decomposition rate varied in proportion to the aeration rate, to the extent that the temperatures and O2 concentrations were similar during the early processes even though aeration rates varied between 10 and 50 m3/(h, m3 compost). However, increased aeration caused severe drying of the compost, but at one plant the addition of water was adequate to prevent drying. In conclusion, by increasing the aeration rates and adding water to compensate for drying, it was possible to shorten the time needed to produce a stable compost product and thus to increase the efficiency of the composting plants.     

Solid waste management in Abuja, Nigeria

The new city of Abuja provided an opportunity to avoid some of the environmental problems associated with other major cities in Africa. The current status of solid waste management in Abuja has been reviewed and recommendations for improvements are made. The existing solid waste management system is affected by unfavourable economic, institutional, legislative, technical and operational constraints. A reliable waste collection service is needed and waste collection vehicles need to be appropriate to local conditions. More vehicles are required to cope with increasing waste generation. Wastes need to be sorted at source as much as possible, to reduce the amount requiring disposal. Co-operation among communities, the informal sector, the formal waste collectors and the authorities is necessary if recycling rates are to increase. Markets for recycled materials need to be encouraged. Despite recent improvements in the operation of the existing dumpsite, a properly sited engineered landfill should be constructed with operation contracted to the private sector. Wastes dumped along roads, underneath bridges, in culverts and in drainage channels need to be cleared. Small-scale waste composting plants could promote employment, income generation and poverty alleviation. Enforcement of waste management legislation and a proper policy and planning framework for waste management are required. Unauthorized use of land must be controlled by enforcing relevant clauses in development guidelines. Accurate population data is necessary so that waste management systems and infrastructure can be properly planned. Funding and affordability remain major constraints and challenges.     

Municipal solid waste management in Indian cities - A review

Municipal solid waste management (MSWM) is one of the major environmental problems of Indian cities. Improper management of municipal solid waste (MSW) causes hazards to inhabitants. Various studies reveal that about 90% of MSW is disposed of unscientifically in open dumps and landfills, creating problems to public health and the environment. In the present study, an attempt has been made to provide a comprehensive review of the characteristics, generation, collection and transportation, disposal and treatment technologies of MSW practiced in India. The study pertaining to MSWM for Indian cities has been carried out to evaluate the current status and identify the major problems. Various adopted treatment technologies for MSW are critically reviewed, along with their advantages and limitations. The study is concluded with a few fruitful suggestions, which may be beneficial to encourage the competent authorities/researchers to work towards further improvement of the present system.     

Improvements of nano-SiO2 on sludge/fly ash mortar

Sewage sludge ash has been widely applied to cementitious materials. In this study, in order to determine effects of nano-SiO(2) additives on properties of sludge/fly ash mortar, different amounts of nano-SiO(2) were added to sludge/fly ash mortar specimens to investigate their physical properties and micro-structures. A water-binding ratio of 0.7 was assigned to the mix. Substitution amounts of 0%, 10%, 20%, and 30% of sludge/fly ash (1:1 ratio) were proposed. Moreover, 0%, 1%, 2%, and 3% of nano-SiO(2) was added to the mix. Tests, including SEM and compressive strength, were carried out on mortar specimens cured at 3, 7, and 28 days. Results showed that sludge/fly ash can make the crystals of cement hydration product finer. Moreover, crystals increased after nano-SiO(2) was added. Hence, nano-SiO(2) can improve the effects of sludge/fly ash on the hydration of mortar. Further, due to the low pozzolanic reaction active index of sludge ash, early compressive strengths of sludge/fly ash mortar were decreased. Yet, nano-SiO(2) could help produce hydration crystals, which implies that the addition of nano-SiO(2) to mortar can improve the influence of sludge/fly ash on the development of the early strength of the mortar.     

Influence of aeration rate on nitrogen dynamics during composting

The paper aimed to study the influence of aeration rate on nitrogen dynamics during composting of wastewater sludge with wood chips. Wastewater sludge was sampled at a pig slaughterhouse 24h before each composting experiment, and mixtures were made at the same mass ratio. Six composting experiments were performed in a lab reactor (300 L) under forced aeration. Aeration flow was constant throughout the experiment and aeration rates applied ranged between 1.69 and 16.63 L/h/kg DM of mixture. Material temperature and oxygen consumption were monitored continuously. Nitrogen losses in leachates as organic and total ammoniacal nitrogen, nitrite and nitrate, and losses in exhaust gases as ammonia were measured daily. Concentrations of total carbon and nitrogen i.e., organic nitrogen, total ammoniacal nitrogen, and nitrite and nitrate were measured in the initial substrates and in the composted materials. The results showed that organic nitrogen, which was released as NH4+/NH3 by ammonification, was closely correlated to the ratio of carbon removed from the material to TC/N(org) of the initial substrates. The increase of aeration was responsible for the increase in ammonia emissions and for the decrease in nitrogen losses through leaching. At high aeration rates, losses of nitrogen in leachates and as ammonia in exhaust gases accounted for 90-99% of the nitrogen removed from the material. At low aeration rates, those accounted for 47-85% of the nitrogen removed from the material. The highest concentrations of total ammoniacal nitrogen in composts occurred at the lowest aeration rate. Due to the correlation of ammonification with biodegradation and to the measurements of losses in leachates and in exhaust gases, the pool NH4+/NH3 in the composting material was calculated as a function of time. The nitrification rate was found to be proportional to the mean content of NH4+/NH3 in the material, i.e., initial NH4+/NH3 plus NH4+/NH3 released by ammonification minus losses in leachates and in exhaust gases. The aeration rate was shown to be a main parameter affecting nitrogen dynamics during composting since it controlled the ammonification, the ammonia emission and the nitrification processes.     

Atrazine and alachlor transport in claypan soils as influenced by differential antecedent soil water content

Increased attention to ground water contamination has encouraged an interest in mechanisms of solute transport through soils. Few studies have investigated the effect of the initial soil water content on the transport and degradation of herbicides for claypan soils. We investigated the effect of claypan soils at initial field capacity vs. permanent wilting level on atrazine and alachlor transport. The soil studied was Mexico silt loam (fine, smectitic, mesic Aeric Vertic Epiaqualf) with a subsoil clay content, primarily montmorillonite, of >40%. Strontium bromide, atrazine, and alachlor were applied to plots; half were at field capacity (Wet treatment), and half were near the permanent wilting point (Dry treatment). Soil cores were removed at selected depths and times, and cores were analyzed for bromide and herbicide concentrations. Bromide, atrazine, and alachlor were detected at the 0.90-m depth in dry plots within 15 d after experiment initiation. Bromide was detected 0.15 m deeper (P < 0.05) in the Dry compared with the Wet treatment at 1, 7, and 60 d after application and >0.30 m deeper (P < 0.01) in the Dry treatment at 15 and 30 d after application; similar treatment results were found for atrazine and alachlor, although on fewer dates with significant differences. The mobility order of the applied chemicals was bromide > atrazine > alachlor. The atrazine apparent half-life was significantly longer in the Dry plots compared with the Wet plots. The retardation factor determined from the relative velocity of each herbicide to that of bromide was higher for alachlor than for atrazine. This study identifies the impact that shrinkage cracks have for different moisture conditions on preferential transport of herbicides in claypan soils.     

New measurements of cyanobacterial toxins in natural waters using high performance liquid chromatography coupled to tandem mass spectrometry

The presence and levels of the cyanobacterial toxins microcystin-LR, anatoxin-a, and cylindrospermopsin were measured in various Wisconsin waters where algal nuisance or bloom conditions were noted. Out of 74 samples analyzed, 36 had detectable levels of microcystin-LR (49%), and four had detectable levels of anatoxin-a (5%). Cylindrospermopsin, the toxin produced by Cylindrospermopsis (a warm water species that has been moving its range northward, including to Wisconsin), was not detected in the field samples tested. Concentrations of microcystin-LR ranged from 1.2 to 7600 microg L(-1). Anatoxin-a ranged from 0.68 to 1750 microg L(-1), which is the highest concentration reported from around the world. Cyanobacterial toxins, because of their high potency, deserve continued scrutiny by resource managers and public health officials responsible for recreational waters.     

Extractability of elements in sugar maple xylem along a gradient of soil acidity

Dendrochemistry has been used for the historical dating of pollution. Its reliability is questionable due primarily to the radial mobility of elements in sapwood. In the present study, the extractability of seven elements was characterized to assess their suitability for the monitoring of environmental conditions. Nine mature sugar maple trees (Acer saccharum Marsh.), a wide-ranging species in eastern North America that has suffered decline in past decades, were sampled in three Quebec watersheds along a soil acidity gradient. Five-year groups of annual tree rings were treated by sequential chemical extractions using extractants of varying strength (deionized H2O, 0.05 M HCl, and concentrated HNO(3)) to selectively solubilize the elements into three fractions (water-soluble, acid-soluble, and residual). Monovalent K; divalent Ba, Ca, Cd, Mg, Mn; and trivalent Al cations were found mostly in the water-soluble, acid-soluble, and residual fractions, respectively. Forms more likely to be mobile within the tree (water-soluble and acid-soluble) do not seem to be suitable for temporal monitoring because of potential lateral redistribution in sapwood rings. However, certain elements (Cd, Mn) were responsive to current soil acidity and could be used in spatial variation monitoring. Extractability of Al varied according to soil acidity; at less acidic sites, up to 90% of Al was contained in the residual form, whereas on very acidic soils, as much as 45% was found in the water-soluble and acid-soluble fractions. Sequential extractions can be useful for determining specific forms of metals as key indicators of soil acidification.     

Monitoring Contrasting Land Management in the Savanna Landscapes of Northern Australia

We compared measures of ecosystem state across six adjacent land-tenure groups in the intact tropical savanna landscapes of northern Australia. Tenure groups include two managed by Aboriginal owners, two national parks, a cluster of pastoral leases, and a military training area. This information is of relevance to the debate about the role of indigenous lands in the Australian conservation estate. The timing and frequency of fire was determined by satellite imagery; the biomass and composition of the herb-layer and the abundance of large feral herbivores by field surveys; and weediness by analysis of a Herbarium database. European tenures varied greatly in fire frequencies but were consistently burnt earlier in the dry season than the two Aboriginal tenures, the latter having intermediate fire frequencies. Weeds were more frequent in the European tenures, whilst feral animals were most abundant in the Aboriginal tenures. This variation strongly implies a signature of current management and/or recent environmental history. We identify indices suitable for monitoring of management outcomes in an extensive and sparsely populated landscape. Aboriginal land offers a unique opportunity for the conservation of biodiversity through the maintenance of traditional fire regimes. However, without financial support, traditional practices may prove unsustainable both economically and because exotic weeds and feral animals will alter fire regimes. An additional return on investment in Aboriginal land management is likely to be improved livelihoods and health outcomes for these disadvantaged communities.     

Volunteer Macroinvertebrate Monitoring: Tensions Among Group Goals,Data Quality,and Outcomes

Volunteer monitoring of natural resources is promoted for its ability to increase public awareness, to provide valuable knowledge, and to encourage policy change that promotes ecosystem health. We used the case of volunteer macroinvertebrate monitoring (VMM) in streams to investigate whether the quality of data collected is correlated with data use and organizers' perception of whether they have achieved these outcomes. We examined the relation between site and group characteristics, data quality, data use, and perceived outcomes (education, social capital, and policy change). We found that group size and the degree to which citizen groups perform tasks on their own (rather than aided by professionals) positively correlated with the quality of data collected. Group size and number of years monitoring positively influenced whether a group used their data. While one might expect that groups committed to collecting good-quality data would be more likely to use it, there was no relation between data quality and data use, and no relation between data quality and perceived outcomes. More data use was, however, correlated with a group's feeling of connection to a network of engaged citizens and professionals. While VMM may hold promise for bringing citizens and scientists together to work on joint conservation agendas, our data illustrate that data quality does not correlate with a volunteer group's desire to use their data to promote regulatory change. Therefore, we encourage scientists and citizens alike to recognize this potential disconnect and strive to be explicit about the role of data in conservation efforts.