Rapid measurement of emissions from military aircraft turbine engines by downstream extractive sampling of aircraft on the ground: Results for C-130 and F-15 aircraft

Aircraft emissions affect air quality on scales from local to global. More than 20% of the jet fuel used in the U.S. is consumed by military aircraft, and emissions from this source are facing increasingly stringent environmental regulations, so improved methods for quickly and accurately determining emissions from existing and new engines are needed. This paper reports results of a study to advance the methods used for detailed characterization of military aircraft emissions, and provides emission factors for two aircraft: the F-15 fighter and the C-130 cargo plane. The measurements involved outdoor ground-level sampling downstream behind operational military aircraft. This permits rapid change-out of the aircraft so that engines can be tested quickly on operational aircraft. Measurements were made at throttle settings from idle to afterburner using a simple extractive probe in the dilute exhaust. Emission factors determined using this approach agree very well with those from the traditional method of extractive sampling at the exhaust exit. Emission factors are reported for CO₂, CO, NO, NO_x, and more than 60 hazardous and/or reactive organic gases. Particle size, mass and composition also were measured and are being reported separately. Comparison of the emissions of nine hazardous air pollutants from these two engines with emissions from nine other aircraft engines is discussed.     

Towards safety,hygiene and environmental (SHE) management in African small and medium companies

Although Safety, Health and Environment (SHE) principles are adhered to in companies of developed countries, the application in developing countries is at its infant stage, as shown by the present article where the authors surveyed SHE Practice in 242 companies of 8 West-African countries.     

Formation of chlorinated disinfection by-products in viticulture

Background, aim and scope  The use of sodium hypochlorite (HYP) in viticulture results in effluents which are contaminated with halogenated substances. These disinfection by-products (DBPs) can be quantified as group parameter ‘adsorbable organic halogens’ (AOX) and have not been determined in effluents of viticulture yet. The substances that are detected as AOX are unknown. The AOX can be composed of harmless substances, but even toxic contaminants. Thus, it is impossible to assess ecological impacts. The aim of this study is to determine the quantification of AOX and DBPs after the use of HYP. This will be helpful to reduce environmental pollution by AOX. Materials and methods  The potential of HYP to generate AOX was determined in laboratory-scale experiments. Different model solutions were treated with HYP according to disinfection processes in viticulture and conditions of AOX formation in effluents were simulated. AOX were quantified using the flask-shaking method and identified DBPs were investigated by gas chromatography–mass spectrometry. Results  Treatment with HYP resulted in the formation of AOX. The percentage conversion of HYP to AOX was up to 11%. Most important identified DBPs in viticulture are chloroform, dichloroacetic acid and trichloroacetaldehyde. In addition, the formation of carbon tetrachloride (CT), 1,1,1-trichloropropanone, 2,4-dichlorobenzoic acid and 2-chloro-/2,4-dichlorophenylacetic acid was investigated. It was demonstrated that reaction temperature, concentration of HYP and type of organic matter have important influence on the formation of chlorinated DBPs. Discussion  The percentage conversion of HYP to AOX was similar to other published studies. Although a correlation of single compounds and AOX is difficult, chloroform was the predominant AOX. Generation of the volatile chloroform should be avoided due to possible adverse effects. The generation of dichloroacetic acid is of minor importance on account of biodegradation. Trichloroacetaldehyde and 1,1,1-trichloropropanone are weak mutagens and their formation should be avoided. Conclusions  The generation of AOX and chlorinated DBPs can be minimised by reducing the concentrations of the organic materials in the effluents. The removal of organic matter before disinfection results in a decreased formation of AOX. HYP is an effective disinfectant; therefore, it should be used at low temperatures and concentrations to reduce the amount of AOX. If possible, disinfection should be accomplished by the use of no chlorine-containing agents. By this means, negative influences of HYP on the quality of wine can also be avoided. Recommendations and perspectives  Our results indicate that HYP has a high potential to form AOX in effluents of viticulture. The predominant by-products are chloroform, dichloroacetic acid and trichloroacetaldehyde. In further research, wastewaters from a winery and the in- and outflows of two sewage treatment plants were sampled during vintage and analysed. These results will be discussed in a following paper.     

Vegetarianism, Sentimental or Ethical?

In this paper, I provide some evidence for the view that a common charge against those who adopt vegetarianism is that they would be sentimental. I argue that this charge is pressed frequently by those who adopt moral absolutism, a position that I reject, before exploring the question if vegetarianism might make sense. I discuss three concerns that might motivate those who adopt vegetarian diets, including a concern with the human health and environmental costs of some alternative diets, a concern about inflicting pain on animals, and a concern with the killing of animals. While I argue that vegetarianism does not make sense in some situations, I hope that this paper shows that there are many good reasons why the adoption of vegetarian, and—even more so—vegan diets might be appropriate in some situations. In carving out this position, I focus primarily on the question whether a morally relevant distinction between the killing of plants and the killing of animals should be made. I engage primarily with the views of two of the most prominent authors on this issue, arguing that neither Peter Singer nor Tom Regan provide a satisfactory account on the ethics of killing nonhuman organisms. Two views are challenged in particular, the view that relatively simple animals such as molluscs, as well as plants, lack awareness, and the view that animals without a preference to continue living stand to lose little or nothing by being killed. I provide some evidence to support the claim that many share my view that it is more problematic to kill animals than to kill plants, before analyzing why some suppress the negative feelings they associate with killing animals. By exploring these issues I hope to shed some light on the issue of whether the feelings of those who adopt vegetarianism are sentimental or make sense, and to stimulate reflection amongst those with an interest in food ethics.     

The modelling of a hybrid combined cycle with pressurised fluidised bed combustion and CO2 capture

This study investigates the possibility of capturing CO₂ from flue gas under pressurised conditions, which could prove to be beneficial in comparison to working under atmospheric conditions. Simulations of two hybrid combined cycles with pressurised fluidised bed combustion and CO₂ capture are presented. CO₂ is captured from pressurised flue gas by means of chemical absorption after the boiler but before expansion. The results show a CO₂ capture penalty of approximately 8 percentage points (including 90% CO₂ capture rate and compression to 110 bar), which makes the efficiency for the best performing cycle 43.9%. It is 5.2 percentage points higher than the most probable alternative, i.e. using a natural gas fired combined cycle and a pulverised coal fired condensing plant separately with the same fuel split ratio. The largest part of the penalty is associated with the lower mass flow of flue gas after CO₂ capture, which leads to a decrease in work output in the expander and potential for feed water heating. The penalty caused by the regeneration of absorbent is quite low, since the high pressure permits the use of potassium carbonate, which requires less regeneration heat than for example the more commonly proposed monoethanolamine. Although the efficiencies of the cycles look promising it will be important to perform a cost estimate to be able to make a fair comparison with other systems. Such a cost estimate has not been done in this study. A significant drawback of these hybrid cycles in that respect is the complex nature of the systems that will have a negative effect on the economy.     

Models at the interface between science and society: impacts and options

Within the CLEAR project a new approach to integrated assessment modelling has been developed for the participatory integrated assessment of regional climate change involving citizens' focus groups. The climate change decision problem was structured by focusing separately on climate impacts and mitigation options. The attempt was made to link the different scales of the problem from the individual to the global level. The abstract topic of climate change was related to options on the level of a citizen's individual lifestyle. The option of a low energy society was emphasised in order to embed the climate change decision problem in a wider range of societal concerns. Special emphasis was given to the characterisation and communication of uncertainties. The chosen approach allows different kinds of uncertainties in one framework to be addressed. The paper concludes with a summary of the experience made, and recommendations for the use of models in participatory integrated assessments. This revised version was published online in July 2006 with corrections to the Cover Date.     

Flow injection spectrophotometric determination of methamidophos using online hydrolysis

A new protocol for the online spectrophotometric determination of methamidophos has been developed. The method is based on online hydrolysis of methamidophos, and the resulting hydrolyzed product is reacted with sodium nitroproside to form a colored complex. The calibration curve is linear over the concentration range of 0.5–20 μgml^?–?1, with a molar absorptivity of 2.5×10⁴ L mol^?1 cm^?1. The method is fast and reproducible with a sample throughput of 90 samples/h. The method is successfully applied to formulations and real samples.     

Microbial degradation and impact of Bracken toxin ptaquiloside on microbial communities in soil

The carcinogenic and toxic ptaquiloside (PTA) is a major secondary metabolite in Bracken fern (Pteridium aquilinum (L.) Kuhn) and was hypothesized to influence microbial communities in soil below Bracken stands. Soil and Bracken tissue were sampled at field sites in Denmark (DK) and New Zealand (NZ). PTA contents of 2.1 +/- 0.5 mg g(-1) and 37.0 +/- 8.7 mg g(-1) tissue were measured in Bracken fronds from DK and NZ, respectively. In the two soils the PTA levels were similar (0-5 microg g(-1) soil); a decrease with depth could be discerned in the deeper B and C horizons of the DK soil (weak acid sandy Spodosol), but not in the NZ soil (weak acid loamy Entisol). In the DK soil PTA turnover was predominantly due to microbial degradation (biodegradation); chemical hydrolysis was occurring mainly in the uppermost A horizon where pH was very low (3.4). Microbial activity (basal respiration) and growth ([3H]leucine incorporation assay) increased after PTA exposure, indicating that the Bracken toxin served as a C substrate for the organotrophic microorganisms. On the other hand, there was no apparent impact of PTA on community size as measured by substrate-induced respiration or composition as indicated by community-level physiological profiles. Our results demonstrate that PTA stimulates microbial activity and that microorganisms play a predominant role for rapid PTA degradation in Bracken-impacted soils.     

Comparison of organochlorine compound concentrations in colostrum and mature milk

Human breast milk represents the best choice for the nutrition of infants. It is often used for monitoring human exposures to environmental chemicals. Uniquely suited to meet human biological needs, breast milk composition, especially fat content, changes significantly with time from delivery. With the aim to compare the concentration of organochlorine compounds (OCs) in colostrum versus mature milk, we obtained samples of fourth-fifth day postpartum milk (colostrum) and day-14 postpartum milk (mature milk) from 12 women enrolled in the project "Early Childhood Development and PCB Exposure in Slovakia". The concentrations of selected organochlorine pesticides and congeners of polychlorinated biphenyls (PCBs) were measured using gas chromatography with electron capture detection and reported on lipid adjusted basis. No significant differences were found between organochlorine levels in colostrum and those in mature milk samples. A very close correlation was found between the concentrations of organochlorine compounds in colostrum and mature milk (Spearman correlation coefficient r=0.94-0.98 for PCBs, and r=0.85-0.99 for organochlorine pesticides, p<0.001 for all compounds). The present study concludes that the use of colostrum samples provides a close estimate of the child's exposure to OCs in the early neonatal period and demonstrates that, despite the lower fat content, colostrum specimens are adequate to conduct OC analyses.     

Investigations of chemical fraction of Co and Ni in industrial fly ash and mobility of metals in environmental conditions

The quantitative evaluation of chemical fraction of Co and Ni in the industrial fly ash by methods of five step sequential extraction was carried out in order to characterize metal mobility in environmental conditions. The research involved (i) water-soluble (pH=7), (ii) acid-soluble (pH=5), (iii) oxide, (iv) sulfide and (v) residue metal fractions. It was discovered, that the total extraction of the studied metals from fly ash to solutions take place in the following quantities Co - 35.5 and Ni - 153.0mgkg(-1). The investigations of chemical fractions proved that the subject metals occur mainly in fly ash as: oxide (Co - 7.0, Ni - 28.5mgkg(-1)) and residue (Co - 11.5, Ni - 42.5mgkg(-1)) as well as sulfide (Co - 8.5, Ni - 46.5mgkg(-1)). Low concentrations of metals for water-soluble fraction (Co - 0.7, Ni - 1.2mgkg(-1)) and acid-soluble fraction (Co - 4.5, Ni - 23.5mgkg(-1)) were observed. The fractions of Co and Ni leachable from the ash in environmental conditions contain: 24.0% (Co) and 23.3% (Ni) of metal total amount in the industrial fly ash. The obtained mobility parameter of Co and Ni can be applied to estimate the concentration increase of mobile and hardly mobile forms of these metals in soil polluted with the ash.