Leaching of three imidazolinone herbicides during sprinkler irrigation

Some imidazolinone herbicides have been shown to be mobile in soil, raising concern about their possible movement to ground water. Three imidazolinone herbicides (imazamethabenz-methyl, 497 g ha(-1); imazethapyr, 14.7 g ha(-1); and imazamox, 14.7 g ha(-1)) commonly used in crop production on the Canadian prairies were applied to a tile-drained field to assess their susceptibility to leach when subjected to sprinkler irrigation using a center pivot. Tile-drain flow began when the water table rose above tile-drain depth, and peak flow rates corresponded to the greatest depths of ground water above the tile drains. Interception of irrigation water by the tile drains in each quadrant of the field varied from ～11 to 20% of the water applied. Under a worst-case scenario in which irrigation began the day after herbicide application and irrigation water was applied at 25 mm d(-1) for 12 d, there was evidence of preferential flow of all three herbicides and hydrolysis of imazamethabenz-methyl to imazamethabenz in the initial samples of tile-drain effluent. In subsequent samples, concentrations (analysis by LC-MS-MS) of the summation of imazamethabenz-methyl (25-24,000 ng L(-1)) plus its hydrolysis product imazamethabenz (63-26,500 ng L(-1)) greatly exceeded those of imazethapyr (<13-1260 ng L) and imazamox (19-599 ng L(-1)), thus reflecting relative application rates. In contrast, estimates of total transport of each herbicide from the root zone, which varied in each quadrant and ranged from 0.06 to 2.3% for imazamethabenz-methyl plus imazamethabenz, 0.71 to 3.1% for imazethapyr, and 0.61 to 2.8% for imazamox, did not reflect application rates. In shallow ground water (piezometer samples), there was inconsistent and infrequent detection all four compounds. With the frequency and amount of rainfall typically encountered in the prairie region of Canada, contamination of shallow ground water with detectable concentrations of the three imidazolinone herbicides would be unlikely.     

Methodology for the Study of Public Attitudes Concerning Air Pollution

A significant element of a community's total air pollution picture is the “state of mind” of the people living in the area with respect to air pollution. The reasons why a study of public attitudes can be an important factor in planning an air pollution control program are briefly summarized. The methodology applied in one such study in the St. Louis Metropolitan area is described, and possible variations related to different scope, objectives and survey area characteristics are suggested.     

Windblown Dust Contributes to High PM25 Concentrations

ABSTRACT

The revised National Ambient Air Quality Standards for PM include fine particulate standards based upon mass measurements of PM₂₅. It is possible in arid and semi-arid regions to observe significant coarse mode intrusion in the PM_2.5 measurement. In this work, continuous PM₁₀, PM_2.5, and PM_1.0 were measured during several windblown dust events in Spokane, WA. PM_{2 5} constituted ~30% of the PM₁₀ during the dust event days, compared with ~48% on the non-dusty days preceding the dust events. Both PM₁₀ and PM_2.5 were enhanced during the dust events. However, PM_1.0 was not enhanced during dust storms that originated within the state of Washington. During a dust storm that originated in Asia and impacted Spokane, PM_1.0 was also enhanced, although the Asian dust reached Washington during a period of stagnation and poor dispersion, so that local sources were also contributing to high particulate levels. The “intermodal” region of PM, defined as particles ranging in aerodynamic size from 1.0 to 2.5 um, was found to represent a significant fraction of PM₂₅ (~51%) during windblown dust events, compared with 28% during the non-dusty days before the dust events.     

1-Butanol Removal from a Contaminated Airstream under Continuous and Diurnal Loading Conditions

Abstract

A polysulfone microporous membrane module was investigated for control of 1-butanol-contaminated gas streams. A diurnal loading condition, using two different butanol concentrations, was used to simulate startup and stop conditions associated with shift work. The membrane module was also used to remove 1-butanol from air under continuous loading conditions in a bioreactor. The reactors were seeded with a mixed bacterial consortium capable of butanol biodegradation. Biokinetic parameters for butanol utilization were determined for the culture to be a maximum specific utilization rate (k) equal to 4.3 d^?1 and a half saturation constant (K_s) equal to 8.9 mg L^?1. A biofilter running only with diurnal loading conditions giving a “40-hr workweek” had an average 1-butanol removal rate of 29% (111 ppm, 74 gm^?3 hr^?1) from a 350-ppm influent at the end of an 8-hr operational day. End-of-day removal varied between 4 and 67% during the operational period. With continuous steady-state operation followed by placement on a diurnal loading schedule and influent butanol concentrations increased to 700 ppm, butanol removal averaged 38% (269 ppm, 145 gm^?3 hr^?1). Under continuous loading, steady-state conditions, 1-butanol removal from the airstream was greater than 99% (200 ppm, 73 gm^?3 hr^?1). These results suggest that the bioreactor can be operated on a diurnal schedule or 40-hr week operational schedule without any decline in performance.     

Management of Large Wood in Streams: An Overview and Proposed Framework for Hazard Evaluation

Instream and floodplain wood can provide many benefits to river ecosystems, but can also create hazards for inhabitants, infrastructure, property, and recreational users in the river corridor. We propose a decision process for managing large wood, and particularly for assessing the relative benefits and hazards associated with individual wood pieces and with accumulations of wood. This process can be applied at varying levels of effort, from a relatively cursory visual assessment to more detailed numerical modeling. Decisions to retain, remove, or modify wood in a channel or on a floodplain are highly dependent on the specific context: the same piece of wood that might require removal in a highly urbanized setting may provide sufficient benefits to justify retention in a natural area or lower‐risk urban setting. The proposed decision process outlined here can be used by individuals with diverse technical backgrounds and in a range of urban to natural river reaches so that opportunities for wood retention or enhancement are increased.     

Effects of doping amounts of potassium ferricyanide with titanium dioxide and calcination durations on visible-light degradation of pharmaceuticals

Acetaminophen (ACT) is one of the most frequently detected pharmaceuticals in aqueous environments, and treatment of ACT were generally carried out by photocatalytic degradations under high energy UV irradiation. In this study, potassium ferricyanide was utilized as a quadruple-elemental dopant in a TiO₂ photocatalyst in order to enhance its visible-light activity. Two critical parameters (amounts of dopants and durations of calcination) of the synthesis of the photocatalyst by a sol–gel method were systematically evaluated. Crystal structure of the doping TiO₂ was examined by X-ray diffraction while the effects of the two parameters on the photocatalytic activity were elucidated by various characterizations. Increasing the amount of dopant or the duration of calcination red-shifted the UV–vis DRS of the doped TiO₂. The estimated band gap energy of the doped TiO₂ decreased slightly as the amount of dopant increased, but it increased as the duration of calcination increased. The FT-IR yielded characteristic peaks that revealed the effects of the two parameters, whereas the SEM images revealed the morphological evolutions of each effect. The photocatalyst, synthesized at optimum conditions was able to remove 99.1 % acetaminophen with rate constant of 7.9 × 10⁻³ min⁻¹, which was 4.88 times greater than virgin TiO₂. In general, this study not only optimized synthetic conditions of the new visible-light active photocatalyst for ACT degradation but also presented characterizations conducted by SEM, XRD, UV–vis DRS, and FTIR to elucidate the relationship between modified structure and the photocatalytic activity.

Effects of doping amounts of K₃[Fe(CN)₆] and calcunation duration on visible light absorbance of TiO₂ photocatalysts

     

Secondhand smoke exposure is associated with smoke-free laws but not urban/rural status

The objective was to determine secondhand smoke (SHS) exposure with and without smoke-free laws in urban and rural communities. The research hypothesis was that SHS exposure in public places could be improved by smoke-free law regardless of urban and rural status. Indoor air quality in hospitality venues was assessed in 53 communities (16 urban and 37 rural) before smoke-free laws; 12 communities passed smoke-free laws during the study period. Real-time measurements of particulate matter with 2.5 µm aerodynamic diameter or smaller (PM_2.5) were taken 657 times from 586 distinct venues; about 71 venues had both pre- and post-law measurements. Predictors of log-transformed PM_2.5 level were determined using multilevel modeling. With covariates of county-level percent minority population, percent with at least high school education, adult smoking rate, and venue-level smoker density, indoor air quality was associated with smoke-free policy status and venue type and their interaction. The geometric means for restaurants, bars, and other public places in communities without smoke-free policies were 22, 63, and 25 times higher than in those with smoke-free laws, respectively. Indoor air quality was not associated with urban status of venue, and none of the interactions involving urban status were significant. SHS exposure in public places did not differ by urban/rural status. Indoor air quality was associated with smoke-free law status and venue type.

Implications:?This study analyzed 657 measurements of indoor PM_2.5 level in 53 communities in Kentucky, USA. Although indoor air quality in public places was associated with smoke-free policy status and venue type, it did not differ by urban and rural status. The finding supports the idea that population in rural communities can be protected with smoke-free policy. Therefore, it is critical to implement smoke-free policy in rural communities as well as urban areas.     

Multiresidue analysis of organophosphate and pyrethroid pesticides in duplicate-diet solid food by pressurized liquid extraction

An analytical method was developed for determining organophosphate pesticides (OPP) and pyrethroid pesticides (PYR) in duplicate-diet solid food. The method consisted of pressurized liquid extraction (PLE) with dichloromethane followed by cleanup with gel permeation and solid phase extraction columns and gas chromatography/mass spectrometry (GC/MS) analysis. Quantitative recoveries (73–117 %) of the target pesticides were obtained for spiked duplicate-diet food samples. The percent standard deviation (% RSD) of replicate food samples was within ± 20 %. Another method was developed for determining a common OPP metabolite, 3, 5, 6-trichloro-2-pyridinol (TCP) in duplicate-diet food. The method consisted of a PLE with methanol followed by liquid-liquid partitioning, derivatization, and GC/MS analysis. Recoveries of TCP ranged from 83 to 101 % for spiked duplicate-diet food samples. The % RSD of replicate food samples was within ± 15 %. The results confirmed that these methods are reliable and robust, and that they can be used in routine analysis. In addition, a storage stability study for a common OPP, chlorpyrifos (CPF), in solid food samples was performed. The fortified ¹⁵N-¹³C-labeled CPF was stable over 16 mo storage at ?20° C in the dark. The developed analytical methods were successfully applied to 278 duplicate-diet food samples from preschool children, demonstrating that these methods are robust and suitable for routine analysis in future exposure monitoring studies.     

Evaluation of the MIDTAL microarray chip for monitoring toxic microalgae in the Orkney Islands, U.K.

Harmful or nuisance algal blooms can cause economic damage to fisheries and tourism. Additionally, toxins produced by harmful algae and ingested via contaminated shellfish can be potentially fatal to humans. The seas around the Orkney Islands, UK currently hold a number of toxic algal species which cause shellfishery closures in most years. Extensive and costly monitoring programs are carried out to detect harmful microalgae before they reach action levels. However, the ability to distinguish between toxic and non-toxic strains of some algae is not possible using these methods. The microarrays for the detection of toxic algae (MIDTAL) microarray contains rRNA probes for toxic algal species/strains which have been adapted and optimized for microarray use. In order to investigate the use of the chip for monitoring in the Orkney Islands, samples were collected between 2009 and 2011 from Brings Deep, Scapa Flow, Orkney Islands, UK; RNA was extracted and hybridized with generation 2 and 3.1 of the chip. The data were then compared to cell counts performed under light microscopy and in the case of Alexandrium tamarense to qPCR data targeting the saxitoxin gene and the LSU-rRNA gene. A good agreement between cell numbers and microarray signal was found for A. tamarense, Pseudo-nitzschia sp., Dinophysis sp. (r?<?0.5, for all) in addition to this there the chip successfully detected a large bloom of Karenia mikimotoi (r?<?0.70) in August and September 2011. Overall, there was good improvement in probe signal between generation 2 and generation 3.1 of the chip with much less variability and more consistent results and better correlation between the probes. The chip performed well for A. tamarense group I signal to cell numbers in calibrations (r?>?0.9). However, in field samples, this correlation was slightly lower suggesting interactions between all species in the sample may affect signal. Overall, the chip showed it could identify the presence of target species in field samples although some work is needed to improve the quantitative nature of the chip before it would be suitable for monitoring in the Orkney Islands.