剩余污泥减量化工艺条件优化研究

运用超声处理连续流活性污泥系统中不同种类的污泥,并将其回流至原系统中,研究其剩余污泥减量化效果。按正交实验设计并进行试验,确定最优工艺条件。结果表明:当声能密度为0.6 W/mL,作用时间为5 min,超声污泥为混合污泥,回流比为7∶120时,减量效果最佳。且在该条件下经一周期的运行,污泥减量效果达到96.24%,COD由进水的830 mg/L降至44 mg/L,NH4+-N和TN分别由进水的62.43 mg/L和103.19 mg/L,降解到2.31 mg/L和6.52 mg/L,达到《城镇污水处理厂污染物排放标准》(GB18918-2002)一级排放标准。     

A competitive indirect enzyme-linked immunoassay for lead ion measurement using mAbs against the lead-DTPA complex

Immunoassays for quantitative measurement of environmental heavy metals offer several advantages over other traditional methods. To develop an immunoassay for lead, Balb/c mice were immunized with a lead-chelate-protein conjugate to allow maximum exposure of the metal to the immune system. Three stable hybridoma cell lines were obtained through spleen cells fusion with Sp2/0 cells. One cell line, 2A11D11, produced mAbs with preferential selectivity and sensitivity for Pb-DTPA than DTPA, exhibiting an affinity constant of 3.34 ± 0.24 × 10⁹ M⁻¹. Cross reactivity (CR) with other metals were below 1%, except for Fe(III) with a CR less than 5%. This quantitative indirect ELISA for the lead ion was used to detect environmental lead content in local water sources; importantly, the results from the immunoassay were in excellent agreement with those from ICP-MS. Development of immunoassays for metal ions may thus facilitate the detection and regulation of environmental pollution.     

Impact of anthropogenic emissions and open biomass burning on regional carbonaceous aerosols in South China

Carbonaceous aerosols were studied at three background sites in south and southwest China. Hok Tsui in Hong Kong had the highest concentrations of carbonaceous aerosols (OC = 8.7 ± 4.5 μg/m³, EC = 2.5 ± 1.9 μg/m³) among the three sites, and Jianfeng Mountains in Hainan Island (OC = 5.8 ± 2.6 μg/m³, EC = 0.8 ± 0.4 μg/m³) and Tengchong mountain over the east edge of the Tibetan Plateau (OC = 4.8 ± 4.0 μg/m³, EC = 0.5 ± 0.4 μg/m³) showed similar concentration levels. Distinct seasonal patterns with higher concentrations during the winter, and lower concentrations during the summertime were observed, which may be caused by the changes of the regional emissions, and monsoon effects. The industrial and vehicular emissions in East, Southeast and South China, and the regional open biomass burning in the Indo-Myanmar region of Asia were probably the two major potential sources for carbonaceous matters in this region.     

CCS scenarios optimization by spatial multi-criteria analysis: Application to multiple source sink matching in Hebei province

A method, based on spatial analysis of the different criteria to be taken into consideration for building scenarios of CO₂ capture and storage (CCS), has been developed and applied to real case studies in the Hebei province. Totally 88 point sources (42 from power sector, 9 from iron and steel, 18 from cement, 16 from ammonia, and 3 from oil refinery) are estimated and their total emission amounts to 231.7 MtCO₂/year with power, iron and steel, cement, ammonia and oil refinery sharing 59.13%, 25.03%, 11.44%, 3.5%, and 0.91%, respectively. Storage opportunities can be found in Hebei province, characterised by a strong tectonic subsidence during the Tertiary, with several kilometres of accumulated clastic sediments. Carbon storage potential for 25 hydrocarbon fields selected from the Huabei complex is estimated as 215 MtCO₂ with optimistic assumption that all recovered hydrocarbon could be replaced by an equivalent volume of CO₂ at reservoir conditions. Storage potential for aquifers in the Miocene Guantao formation is estimated as 747 MtCO₂ if closed aquifer assumed or 371 MtCO₂ if open aquifer and single highly permeable horizon assumed. Due to poor knowledge on deep hydrogeology and to pressure increase in aquifer, injecting very high rates requested by the major CO₂ sources (>10 MtCO₂/year) is the main challenge, therefore piezometry and discharge must be carefully controlled. A source sink matching model using ArcGIS software is designed to find the least-cost pathway and to estimate transport route and cost accounting for the additional costs of pipeline construction due to landform and land use. Source sink matching results show that only 15–25% of the emissions estimated for the 88 sources can be sequestrated into the hydrocarbon fields and the aquifers if assuming sinks should be able to accommodate at least 15 years of the emissions of a given source.     

饮用水消毒副产物控制工艺研究进展

通过对氯、二氧化氯、紫外线等常见消毒工艺以及去除已生成消毒副产物的深度处理工艺进行了分析,探讨了各种消毒工艺的消毒性能和对消毒副产物的控制效果以及各种深度处理工艺对消毒副产物的去除性能,为实际水处理中消毒以及深度处理工艺的选择提供了参考。     

碳纳米管电极原位产生过氧化氢及其对亚甲基蓝脱色效果简

将碳纳米管固定化制成多孔疏水性导电薄膜构建电化学阴极还原体系,实现过氧化氢在阴极的原位产生。电极特性研究表明,电极在较宽的电压范围内均具有较好的活性。考察了阴极电位、电极成分、氧气流量和电解质浓度对过氧化氢原位产生的影响,在优化条件下经过120 min后过氧化氢达到66.17 mg/L,并探讨过氧化氢原位产生的机理。在此基础上考察原位过氧化氢氧化工艺下对亚甲基蓝的脱色效果,并分析其脱色机理。     

响应面法优化甘蔗渣-污泥复合活性炭的制备工艺

为了提高污泥活性炭的吸附性能以提升其实际应用价值,提出在污泥中掺杂甘蔗渣制备复合活性炭,并采用Plackett-Burman联用响应面法对影响复合活性炭碘值的条件进行筛选优化。通过Plackett-Burman实验筛选出热解温度、热解时间和甘蔗渣与污泥干重比为主要影响因素,对这3个因素进行Box-Behnken实验,经响应面优化得到影响碘值的二次响应曲面模型,模型显示热解温度与热解时间、热解温度与干重比的交互作用显著,并确定了最佳制备条件:热解温度550℃、热解时间30 min和干重比50%,此时复合活性炭碘值为814 mg/g,优于未优化条件下制备的复合活性炭。通过比表面积、孔结构和碘值的测定以及元素和扫描电镜分析得出,甘蔗渣的掺杂提高了复合活性炭的比表面积、微孔体积、碘值及含碳量。研究结果表明,甘蔗渣掺杂和制备条件优化是提高污泥活性炭吸附性能的有效手段。     

Mn/γ-Al2O3催化剂的制备及头孢合成废水的催化臭氧氧化法深度处理

对Mn/γ-Al₂O₃催化剂的制备条件及头孢合成废水的催化臭氧氧化法深度处理工艺条件进行了优化。实验结果表明：以Mn（NO₃）₂溶液为浸渍液,Mn/γ-Al₂O₃催化剂的最优制备条件为浸渍液浓度0.10 mol/L、浸渍时间9 h、焙烧温度400 ℃、焙烧时间2 h;在反应时间为30 min、废水pH为9.0、臭氧通量为4.6 mg/min、催化剂加入量为5 g/L的条件下,当进水COD、BOD₅、ρ（氨氮）和色度分别为220~250 mg/L,8~10 mg/L,10~12 mg/L和60~70倍时,出水COD、BOD₅、ρ（氨氮）和色度的平均去除率分别为53%,30%,33%和93%,出水水质满足GB 21904—2008《化学合成类制药工业水污染物排放标准》的要求。     

活性污泥缺氧转化1-2-7-三氨基-8-羟基-3-6-萘二磺酸

1—2-7-三氨基-8-羟基-3—6-萘二磺酸（TAHNDS）作为偶氮染料的脱色产物很难被常规的厌氧-好氧染料废水处理工艺所去除。研究了未经驯化的活性污泥对TAHNDS的缺氧转化效果。结果表明,只有在特定的缺氧条件下（ORP在-50～-150mV之间）,TAHNDS才能被活性污泥所降解转化。当浓度在10—80mg／L范围内,TAHNDS可在72h内转化93％以上。加入100mg／L的硝酸盐和0．64mmol／L的氧化还原介体蒽醌-2-磺酸钠（AQS）可将40mg／L的TAHNDS的转化时间从84h缩短到36h。光谱及HPLC—MS分析表明,TAHNDS在缺氧条件下主要是通过脱氨基和脱磺酸作用生成已知可好氧生物降解的3,5-二氨基4-羟基萘-2-磺酸。因此,缺氧处理有望作为预处理工艺促进废水中TAHNDS的完全降解。     

中国南方塑料大棚气象灾害风险区划

利用中国南方地区15个省市自治区160个气象观测站台1990-2009年的气象资料,综合考虑气温、光照、风速、降水等主要致灾因子,并根据这些数据建立了基于实数编码的加速遗传算法的南方塑料大棚气象灾害的投影寻踪等级评价模型,计算出南方塑料大棚的气象灾害月份和季节的风险等级,并按季节进行了风险区划。结果表明:春季四川盆地地区气温回升较快,有利于设施作物生长,风险最低,重庆、贵州等地由于由于太阳总辐射低,设施作物易受到寡照灾害,风险等级最高;夏季沿海地区暴雨、台风等自然灾害频发,对设施结构有较大影响,有较高的风险;秋季高灾害风险等级分布较少,以低风险为主;冬季以北纬25°为分界线,北部地区气温低、热量条件缺乏,不适宜塑料大棚发展,南部地区则相反,风险低。我国南方秋季西部地区、冬季南部地区及春夏两季的四川盆地地区的气象灾害风险最小,适合塑料大棚的发展,研究结果为我国南方塑料大棚发展的合理布局和气象灾害防御提供参考。