Experimental thermal storage research of organic binary phase change materials in building environment

This paper aims to reveal the heat transfer mechanism of low-temperature phase change material (PCM) and design PCM heat storage device in building heating environment. Firstly, low-temperature binary PCMs of lauric acid and stearic acid are prepared, and their thermal properties are investigated by DSC. Then, shell and tube latent heat thermal energy storage units are conducted, and heat transfer experiments are carried out to analyze the heat transfer mechanism of PCM. The results demonstrate that natural convection plays an important role in heat transfer process, and the heat storage efficiency of PCMs can be significantly enhanced by increasing the fin width and improving the inlet heat transfer fluid (HTF) temperature. Furthermore, some proposals are put forward to guide the design of PCM storage device in building heating environment.     

GC/MS法测定润滑油基础油中多环芳烃

对润滑油基础油中多环芳烃的气相色谱/质谱(GC/MS)测定方法进行了研究,探讨了样品的提取,固相萃取柱净化等前处理方法,同时也对仪器测定条件进行了优化.结果表明,在检测润滑油基础油中多环芳烃时,经优化的GC/MS法的加标回收率和精密度均达到较满意的水平.     

无银催化-分光光度法测定COD的研究

以XS-LP为催化剂,探讨了改进的无银催化HACH法测定污水中COD的系列条件实验。结果表明:在药剂A,B的投配比为1∶2,投加总量为12 g/L的条件下,其准确度、精密度与国标法有较好的可比性,分别小于10%和3%;对实际废水的测量结果与国标回流法的相关系数分别高达0.9951和0.9874,可满足一般环境检测技术规范要求。     

个体防护装备在应急救援处置中的作用

个体防护装备是保护人体不受外来有害因素伤害,保证人体安全与健康的重要装备.在工农业生产中,各国政府针对生产过程中可能出现的各种危害采取一系列工程技术措施保护劳动者的安全与健康,个体防护装备作为保护劳动者安全与健康的重要手段或最后一道防线,要求生产经营单位必须为劳动者配备.     

Effect of electrokinetic property of charged polyether sulfone membrane on bovine serum albumin fouling behavior

Negatively charged carboxymethylated polyethersulfone (CMPES) and positively charged quaternized polyethersulfone (QAPES) ultrafiltration (UF) membranes were prepared by bulk chemical modification and non-solvent induced phase separation method. The effects of PES membrane interfacial electrokinetic property on the bovine serum albumin (BSA) membrane fouling behavior were studied with the aid of the membrane-modified colloidal atomic force microscopy (AFM) probe. Electrokinetic test results indicated that the streaming potential (ΔE) of QAPES membrane was not consistent with its expected IEC value, however, within the pH range of 3–10, the ζ potentials of two charged-modified PES membranes were more stable than the unmodified membrane. When pH value was 3, 4.7 or 9, the interaction behavior between charged PES membrane and BSA showed that there was significant linear correlation between the jump distance r ₀ of membrane-BSA adhesion force (F/R) and the ζ potential absolute value. Charged modification significantly reduced the adhesion of PES membrane-BSA, and the adhesion data was good linear correlated with the flux decline rate in BSA filtration process, especially reflected in the CMPES membrane. The above experimental facts proved that the charged membrane interfacial electric double layer structure and its electrokinetic property had strong ties with the protein membrane fouling behavior.

Open image in new window

     

辉县市城区环境空气质量现状及污染防治对策

对辉县市城区2006—2011年间环境空气质量监测数据进行了评价,并对城区污染物浓度时空变化进行了分析。结果表明,辉县市城区大气污染主要表现为可吸入颗粒物污染严重,主要是能源结构不合理、锅炉废气污染严重、城区道路保洁方式落后等原因造成的,由此提出了合理规划城市布局、减少结构性污染等对策。     

A process integration approach to industrial water conservation: a case study for a Chinese steel plant

A systematic approach to optimizing water network has traditionally been utilized to exam and plan water conservation in industrial processes. In the present case study, water-pinch technology was used to analyze and optimize the water network of a steel plant near China's Zhangjiakou city. A system design was developed and a limiting constraint (Cl(-) concentration) was identified based on investigations of water quality then the minimum freshwater and wastewater targets were determined without considering water losses. The analysis was then extended by calculating the additional input of freshwater required to balance the actual water losses. A nearest-neighbor algorithm (NNA) was used to distribute the freshwater and recycled water among each of the plant's operations. The results showed that with some reconstruction of the water network, the flow rates of freshwater and wastewater could be decreased by 57.5% and 81.9%, respectively.     

Evaluation of municipal sewage treatment systems for pollutant removal efficiency by measuring levels of micropollutants

In order to evaluate the municipal sewage treatment systems used at Harbin municipal sewage treatment plant for their pollutant removal efficiency, raw sewage and effluent samples at different treatment stages from the sewage treatment systems were taken, priority pollutants (PPs) were identified and quantified using gas chromatography-mass spectrometry (GC-MS) and inductively coupled plasma-atomic emission spectrograph (ICP-AES). The test results indicated that there were one hundred and fifty species of organic pollutants identified in the raw sewage sample, and only ten species of PPs in all the sewage samples. The levels of dimethyl phthalate (DMP), diethyl phthalate (DEP), dibutyl phthalate (DBP), di-n-octyl phthalate (DnOP) in the sewage samples were 0.779-0.111 microg l(-1), 1.977-0.022 microg l(-1), 6.411-2.194 microg l(-1) and 7.152-2.953microg l(-1), respectively, and most of these phthalate esters (PAEs) were removed through anaerobic/aerobic (A/O) process; The levels of alachlor, acetochlor, atrazine were 0.074-0.021 microg l(-1), 0.160-0.096 microg l(-1) and 0.238-0.184 microg l(-1), respectively, and the total removal efficiency of atrazine was poorest through the sewage treatment systems. The levels of Cu, Cr, Se, Hg, Ni and Zn were 0.0030-0.2327 mg l(-1). It is therefore concluded from these results that the sewage treatment systems were efficient in removing most of the organic and inorganic compounds in this study, and so, the discharged effluent could cause little of the secondary pollution of the aquatic environment.     

Comparison of different liquid anaerobic digestion effluents as inocula and nitrogen sources for solid-state batch anaerobic digestion of corn stover

Effluents from three liquid anaerobic digesters, fed with municipal sewage sludge, food waste, or dairy waste, were evaluated as inocula and nitrogen sources for solid-state batch anaerobic digestion of corn stover in mesophilic reactors. Three feedstock-to-effluent (F/E) ratios (i.e., 2, 4, and 6) were tested for each effluent. At an F/E ratio of 2, the reactor inoculated by dairy waste effluent achieved the highest methane yield of 238.5 L/kgVS_feed, while at an F/E ratio of 4, the reactor inoculated by food waste effluent achieved the highest methane yield of 199.6 L/kgVS_feed. The microbial population and chemical composition of the three effluents were substantially different. Food waste effluent had the largest population of acetoclastic methanogens, while dairy waste effluent had the largest populations of cellulolytic and xylanolytic bacteria. Dairy waste also had the highest C/N ratio of 8.5 and the highest alkalinity of 19.3 g CaCO₃/kg. The performance of solid-state batch anaerobic digestion reactors was closely related to the microbial status in the liquid anaerobic digestion effluents.     

浅谈钢制氮封储罐泄漏防治措施

从消除储罐泄漏点、加强日常管理方面阐述了如何做好氮封储罐泄漏治理与预防,并对加强储罐泄漏防治提出建议。