Effect of inoculation methods on the composting efficiency of municipal solid wastes

Four types of inoculation methods were studied during the composting of municipal solid wastes and dry grass (MSWG). The methods included a control group as well as initial-stage, two-stage, and multi-stage inoculations. Fulvic acids were extracted from the composting materials and characterized by spectroscopic techniques. The results showed that inoculation of microbes in MSWG enhanced the biodegradation of aliphatics, proteins, and polysaccharides. The inoculation also increased the molecular weight, humic- and fulvic-like compound content, as well as humification degree of the composting products. The inoculation of microbes in MSWG significantly improved composting process and efficiency. The improvement efficiency was in the order of initial-stage < two-stage < multi-stage inoculations. Inoculation of microbes based on composting organic matter composition and temperature enhanced composting efficiency.     

Spatial distribution and loading amounts of particle sorbed and dissolved perfluorinated compounds in the basin of Tokyo Bay

In this study, we analyzed over 30 types of PFCs, including precursors in both the dissolved phase and particle solid phase, in 50 samples of river water collected from throughout the Tokyo Bay basin. PFCs were detected in suspended solids (SSs) at levels ranging from <0.003-4.4 ng L(-1) (0.11-2470 ng g(-1) dry weight). The concentrations of PFCs in the SS were one to two order(s) of magnitude lower than those of PFCs in the dissolved phase. Relatively high levels of PFCs (total of 35 PFCs) in SS were observed in urbanized areas. The concentration of PFCAs, including PFOA and PFNA, were significantly correlated with the geographic index as artificial area (R(2) of the linear regression curve in a double logarithmic plot: 0.09-0.55). Conversely, PFOS and FOSA were significantly correlated with the arterial traffic area (R(2) in a double logarithmic plot: 0.29-0.55). Those spatial trends were similar to the trends in dissolved PFCs. We estimated the loading amount of PFCs into Tokyo Bay from six main rivers and found that more than 90% of the total PFCs reached Tokyo Bay in the dissolved phase. However, 40.0-83.5% of the long chain PFCAs (C12-C15), were transported as particle sorbed PFCs. Rain runoff events might increase the loading amount of PFCs in SS. Overall, the results presented herein indicate that greater attention should be given to PFCs, especially for longer chain PFCs in SS in addition to dissolved PFCs.     

垃圾焚烧炉炉膛温度的影响因素

垃圾焚烧过程的不稳定会导致大量有害物质的生成,为确保垃圾的清洁燃烧需要将炉膛温度控制在850℃以上,为此测试了焚烧炉运行的主要可控参数对炉膛温度的影响。结果表明,垃圾堆放位置在垃圾池深3～8 m处,并经过6 d以上发酵脱水后适合焚烧;炉膛温度随给料量、一次风率和一次风温增加而增大,随过量空气系数增加而降低,其中给料量宜控制在95%～110%之间;当过量空气系数为1.6、一次风率为90%、一次风温为260℃、给料量为100%时炉膛温度达901℃。     

高铁酸钾预处理对活性污泥脱水性能的影响

通过投入不同剂量的高铁酸钾于剩余活性污泥中,研究其对污泥絮体性质和脱水性能的影响作用。污泥絮体性质的研究包括絮体粒径的变化以及污泥EPS含量的变化。脱水性能的研究包括过滤脱水性能(以CST表征)以及脱水程度(离心泥饼含固率)。实验结果表明,高铁酸钾的强氧化性可以破坏污泥絮体结构,提高污泥的机械脱水程度;但同时污泥EPS含量增加,对污泥过滤脱水性能有负面影响。高铁酸钾氧化分解生成的Fe(OH)3具有絮凝能力,可以使污泥颗粒重新絮凝;而其混凝作用可以破坏污泥细胞的稳定性,提高污泥的沉降性能。     

树脂法去除并回收富营养化河涌水中的磷

磷作为一种重要的元素而被广泛应用于农业与工业中,然而磷的过量排放已成为许多封闭半封闭水体富营养化和沿海赤潮频繁发生的原因之一.去除水体中的营养盐特别是磷酸盐,是有效控制水体富营养化的关键.广州市某河涌水含总磷2.6 mg/L,采用并选择DS离子交换树脂对水中磷进行动态吸附和去除,可使水中的磷降至排放标准以内,解决河涌水含磷高的富营养化问题.由DS树脂所吸附的磷,通过淋洗可得到含磷富集液,使磷从水体中完全分离出来并获得回收.DS树脂的再生能力强,经6次吸附-解吸-再生后,树脂对河涌水中磷的去除率仍可达到90％以上.     

物化-生物组合工艺处理TNT红水

采用酸析+微电解+混凝沉淀+减压蒸馏+固定化微生物滤池+活性焦吸附组合工艺处理兵器八○五厂(襄樊分部)的TNT红水,出水中的硝基化合物浓度多小于0.8 mg/L,且多次未检出;COD最高值为76 mg/L,平均值为51.6 mg/L;色度为20°;苯胺浓度全部小于1 mg/L,达到了中试方案提出的要求,出水水质指标符合《兵器工业水污染物排放标准火炸药》(GB14470.1-2002)的要求.中试期间设备没有发生堵塞、燃烧等事故,减压蒸馏装置正常稳定运行,证实了减压蒸馏法处理TNT红水的安全可靠性.     

漆酶对活性黑KN-B和直接大红染料的脱色性能

利用白腐真菌漆酶对活性黑KN-B和直接大红2种偶氮染料进行脱色实验。考察反应时间、加酶量、pH值、染料浓度、温度对脱色率的影响,研究了ABTS介体以及金属离子存在下的脱色效果,并分析了漆酶脱色的动力学性能以及其对偶氮染料的降解规律。结果表明,活性黑KN-B和直接大红脱色适宜条件为：反应时间为30 min,加酶量8 U/mL,pH=7,染料浓度分别为50 mg/L和80 mg/L,温度40~45℃。ABTS介体对酶促偶氮染料脱色没有明显促进作用。Fe²⁺对漆酶脱色有较强的抑制作用;Cu²⁺对漆酶催化活性黑KN-B促进作用较大,对直接大红影响较小。漆酶对2种染料的脱色反应符合米氏方程,其催化活性黑KN-B和直接大红染料的K_m值分别为114.81 mg/L,317.5 mg/L,v_max值分别为6.57 mg/（L·min）和26.0 mg/（L·min）。     

Photo-dissociation of dimethylamine by KrBr excilamp

A study of dimethylamine photo-dissociation in the gas phase has been conducted using UV radiation delivered from a KrBr^* excilamp, driven by a sinusoidal electronic control gear with maximum emission at wavelength of 207 nm. The electrical input power and radiant power of the lamp were measured to determine their effects on the degradation. The influence of flow velocity and initial concentration of dimethylamine were also examined. In order to evaluate the photo-dissociation process comprehensively, several parameters were investigated, including removal efficiency, energy yield, carbon balance and CO₂ selectivity. It is shown that the removal efficiency increases with enhanced input power and decreased gas flow rate. A high removal efficiency of 68% is achieved for lamp power 102 W and flow velocity 15 m³ h⁻¹. The optimum dimethylamine initial concentration is around 3520 mg m⁻³, for which the energy yield reaches up to 442 g kW h⁻¹ when the input power is 65 W. In addition, two chain compounds (1,3-bis-dimethylamino-2-propanol; 3-penten-2-one, 4-amino) and three ring organic matters (1-azetidinecarboxaldehyde, 2,2,4,4-tetramethyl; N-m-tolyl-succinamic acid; p-acetoacetanisidide), were identified by GC–MS as secondary products, in order to demonstrate the pathways of the dimethylamine degradation.     

曝气沉砂池除砂机理分析

针对曝气沉砂池小试装置模型,通过配砂实验对沉砂池除砂率进行统计分析,研究曝气强度与HRT对沉砂池除砂率的影响。实验结果表明,不同曝气强度下,随着HRT变化,除砂率逐渐上升,并最终趋于平衡状态;不同HRT下,曝气强度与除砂率近似呈现一定的线性关系,且随着曝气强度的增大,除砂率降低;在HRT小于1min时,砂粒的运行路径和沉降时间缩短,不利于砂粒的去除;在HRT大于1min时,其中1、3和4min,随着气水比的增加除砂率降低幅度相对较小,曝气所引起的横向环流在一定程度上有利于砂粒的沉降,而HRT为2min时,除砂率降幅却很大,这与砂粒在曝气沉砂池池体断面分布有关,即断面处旋转流速和水平流速的大小变化将影响砂粒的运动;相比曝气强度,HRT对除砂率的影响较大。     

Different reaction mechanisms of diphenylether and 4-bromodiphenylether with nitrous acid in the 355 nm laser flash photolysis of mixed aqueous solution

The microscopic reaction mechanisms of diphenylether (DPE) and 4-bromodiphenylether (4-BrDPE) with nitrous acid (HNO(2)) in the absence of O(2) have been explored by the 355nm laser flash photolysis. It was proposed that OH radical, from the photolysis of HNO(2), added to DPE forms the C(12)H(10)O-OH adduct while added to 4-BrDPE forms the 4-BrDPE-OH and 4-BrOH-DPE adducts. The first-order decay rate constants of the C(12)H(10)O-OH adduct, 4-BrDPE-OH adduct and 4-BrOH-DPE adduct were measured to be (1.86+/-0.14)x10(5)s(-1), (2.19+/-0.04)x10(5)s(-1) and (1.56+/-0.03)x10(5)s(-1), respectively. The final photolysis products of DPE and HNO(2) identified by GC/MS analysis were phenol, o-hydroxydiphenylether, p-hydroxydiphenylether and p-nitrodiphenylether, while the final photolysis product of 4-BrDPE and HNO(2) identified by LC/MS analysis was mainly the dimer.