Ultrafine particle emission characteristics of diesel engine by on-board and test bench measurement

This study investigated the emission characteristics of ultrafine particles based on test bench and on-board measurements. The bench test results showed the ultrafine particle number concentration of the diesel engine to be in the range of (0.56-8.35) × 10⁸ cm^-3. The on-board measurement results illustrated that the ultrafine particles were strongly correlated with changes in real-world driving cycles. The particle number concentration was down to 2.0 × 10⁶ cm^-3 and 2.7 × 10⁷ cm^-3 under decelerating and idling operations and as high as 5.0 × 10⁸ cm^-3 under accelerating operation. It was also indicated that the particle number measured by the two methods increased with the growth of engine load at each engine speed in both cases. The particle number presented a "U" shaped distribution with changing speed at high engine load conditions, which implies that the particle number will reach its lowest level at medium engine speeds. The particle sizes of both measurements showed single mode distributions. The peak of particle size was located at about 50-80 nm in the accumulation mode particle range. Nucleation mode particles will significantly increase at low engine load operations like idling and decelerating caused by the high concentration of unburned organic compounds.     

山西夏季气溶胶空间分布飞机观测研究

以搭载了多种气溶胶观测仪器的飞机为观测平台,在2013年夏季首次对山西中部地区霾日及晴空大气气溶胶空间分布特性进行了观测,得到气溶胶粒子数浓度和尺度的垂直分布廓线以及不同高度气溶胶粒子谱分布特征.研究发现,山西夏季非降水天气条件下气溶胶粒子以核模态和积聚模态的细粒子为主,粗粒子很少.霾日气溶胶数浓度是晴空的2~3倍,主要是核模态的小粒子;气溶胶粒子数浓度随着高度逐渐减小,低空存在气溶胶累积区,逆温层的存在是导致气溶胶累积区形成的主要原因;气溶胶粒子尺度随高度增加,大粒子主要分布在2500m以上的高空;不同高度上的气溶胶粒子谱均呈双峰或三峰分布,谱型基本一致,从近地面到5000m高空,气溶胶粒子谱随高度的增加略有展宽.观测区域气团后向轨迹模拟结果显示,4000m以上高空气溶胶粒子主要是从中国西北地区远距离输送而来,3000m以下气溶胶粒子则主要来源于近地面排放.     

汞分析仪直接测定土壤中总汞的方法研究

建立了利用RP91C-RA915M汞分析仪直接测定土壤中总汞的方法。该方法直接固体进样,省去了常规方法加酸消解、赶酸、定容等繁琐的前处理步骤;利用标准土壤绘制工作曲线,无需反复稀释标准储备液配制标准溶液,测定了方法检出限、精密度及准确度。结果表明此方法准确、可靠,是一个比较理想的分析方法。本方法的检出限为0.25μg/kg,相对标准偏差为1.98%~4.92%,标准样品测定准确,加标回收率为92.8%~106%。     

Ultrasonic preparation of nano-nickel/activated carbon composite using spent electroless nickel plating bath and application in degradation of 2,6-dichlorophenol

Ni was effectively recovered from spent electroless nickel （EN） plating baths by forming a nano-nickel coated activated carbon composite. With the aid of ultrasonication, melamine- formaldehyde-tetraoxalyl-ethylenediamine chelating resins were grafted on activated carbon （MFT/AG）. PdC12 sol was adsorbed on MFT/AC, which was then immersed in spent electroless nickel plating bath; then nano-nickel could be reduced by ascorbic acid to form a nano-nickel coating on the activated carbon composite （Ni/AC） in situ. The materials present were carefully examined by Fourier transform infrared spectroscopy, X-ray diffraction, field emission scanning electron microscopy, X-ray photoelectron spectroscopy and electro- chemistry techniques. The resins were well distributed on the inside and outside surfaces of activated carbon with a size of 120 ± 30 nm in MFT/AC, and a great deal of nano-nickel particles were evenly deposited with a size of 3.8 ± 1.1 nm in Ni/MFT. Moreover, Ni/AC was successfully used as a catalyst for ultrasonic degradation of 2.6-dichloronhenol.     

废弃产品回收处理企业环境绩效评价初探

近年来,废弃产品回收处理行业日益受到政府和社会各界的关注,而回收处理企业是实施回收处理活动的主体,相关法律、法规的出台对回收处理企业提出了更高的要求。本文在概括梳理相关法律、法规的基础上,初步建立了废弃产品回收处理企业环境绩效评价指标体系,为回收处理企业采用先进的技术工艺、降低环境负荷、加强职业健康监护和企业环境管理提供参考,以适应国家政策要求和行业发展的需要。     

城市排水涵道油气混合气体爆炸研究现状及展望

城市发展带来的油气运输管道与市政管网的交叉、近距离并排布置等问题十分突出,一旦油气管道发生泄漏流入市政管网并引发爆炸,将会造成极大的破坏,类似事故在国内外屡见不鲜。通过对大量国内外关于油气混合气体爆炸的相关文献进行分析,归纳了城市排水涵道油气混合气体爆炸研究存在的主要问题,即针对排水涵道内气体聚集和运移规律的研究较少、缺乏对混合气体在潮湿环境中的爆炸机理以及沼气对油气混合气体爆炸点火能量及爆炸威力影响的研究、缺乏对油气混合气体爆炸在不同断面尺寸和不同排放工况时排水涵道内的传播规律及爆炸效应的研究,并针对这些问题,提出了城市排水涵道内油气混合气体爆炸今后的研究方向。     

新型TCAS吸附树脂对水中Cd2+的吸附去除研究

通过静态吸附试验,研究一种由超分子受体化合物磺化硫杂杯芳烃（TCAS）与树脂结合的产物——新型TCAS吸附树脂对重金属Cd²⁺的吸附去除性能,并初步探讨了吸附机理。试验研究结果表明,TCAS吸附树脂对Cd²⁺的饱和吸附量为14.45 mg/g。当温度为20℃,0.5 g TCAS吸附树脂对10 mL浓度为5 mg/L的Cd²⁺溶液吸附60 min时, Cd²⁺的去除率可达到99%以上。pH值是影响TCAS吸附树脂吸附效果的重要因素,在pH=5～9时,Cd²⁺的去除率随着pH值的升高而增大。在试验范围内,TCAS吸附树脂对Cd²⁺吸附符合Freundlich方程。吸附在TCAS吸附树脂上的Cd²⁺可洗脱回收,TCAS吸附树脂也可再生利用。 TCAS吸附树脂对重金属Cd²⁺的吸附机理主要归因于TCAS对Cd²⁺的络合作用。     

Exposure to heavy metals in blood and risk perception of the population living in the vicinity of municipal waste incinerators in Korea

Background, aim, and scope

The purpose of this study was to monitor and present the heavy metal concentrations in the blood of residents of areas near municipal waste incinerators (MWIs), who are more prone to environmental pollution. We also sought to compare and analyze the residents?? perception of environmental pollution as one of the factors affecting heavy metal concentrations in the blood using a survey about the perceived damage caused by the facilities. Since heavy metal levels in the blood can be affected not only by local environmental pollution but also by personal and occupational factors, heavy metal levels in the blood need to be verified and consistently monitored.

Methods

Residents who live within 300?m of MWIs in Seoul are acknowledged to be under indirect influence according to the Waste Disposal Act. A survey was given to 841 residents living within 300?m of a MWI from 2006 to 2009. The concentrations of heavy metals (lead, cadmium, and mercury) in the blood were measured in the 841 surveyed residents and in 105 residents in reference areas. Additionally, the perception of the damage caused by municipal waste incinerators was investigated using scores from 1 to 5 on a Likert scale.

Results

The measurements of the heavy metal concentrations in the blood showed that the mean concentrations of lead, cadmium, and mercury were 43.1, 1.7, and 1.3?ug/L, respectively. The blood levels of lead and cadmium were slightly higher in the group of the subjects who had resided the longest near the municipal waste incinerators. When compared with the domestic investigation by the Ministry of Environment, the concentrations of lead and cadmium were a little higher, while that of mercury was a little lower. Overall, there was no significant difference in the distribution of heavy metal levels in the blood among age groups. Additionally, the investigation of the perceived damage from municipal waste incinerators showed that the subjects     

Kinetics and pathways for the debromination of polybrominated diphenyl ethers by bimetallic and nanoscale zerovalent iron: effects of particle properties and catalyst

Polybrominated diphenyl ethers (PBDEs) are recognized as a new class of widely-distributed and persistent contaminants for which effective treatment and remediation technologies are needed. In this study, two kinds of commercially available nanoscale Fe⁰ slurries (Nanofer N25 and N25S), a freeze-dried laboratory-synthesized Fe⁰ nanoparticle (nZVI), and their palladized forms were used to investigate the effect of particle properties and catalyst on PBDE debromination kinetics and pathways. Nanofers and their palladized forms were found to debrominate PBDEs effectively. The laboratory-synthesized Fe⁰ nanoparticles also debrominated PBDEs, but were slower due to deactivation by the freeze-drying and stabilization processes in the laboratory synthesis. An organic modifier, polyacrylic acid (PAA), bound on N25S slowed PBDE debromination by a factor of three to four compared to N25. The activity of palladized nZVI (nZVI/Pd) was optimized at 0.3 Pd/Fe wt% in our system. N25 could debrominate selected environmentally-abundant PBDEs, including BDE 209, 183, 153, 99, and 47, to end products di-BDEs, mono-BDEs and diphenyl ether (DE) in one week, while nZVI/Pd (0.3 Pd/Fe wt%) mainly resulted in DE as a final product. Step-wise major PBDE debromination pathways by unamended and palladized Fe⁰ are described and compared. Surface precursor complex formation is an important limiting factor for palladized Fe⁰ reduction as demonstrated by PBDE pathways where steric hindrance and rapid sequential debromination of adjacent bromines play an important role.