外加镍在土壤中的形态与再分配

镍处理土壤经室内培养12周后,采用连续提取技术对试验土壤中镍的形态与再分配方式进行了研究。研究结果表明,外加的水溶性镍进入土壤后的主要存在形态与添加的剂量有关:低剂量时,以铁锰氧化态为主,这一形态在100mg·kg-1处理土壤中占比例最大,达到31.6%;高剂量时,以交换态为主,这一形态在1600mg·kg-1处理土壤中占比例最大,达到48.4%。随着镍添加剂量由0(对照)增加到1600mg·kg-1,再分配系数逐渐由1.00增大到30.65;金属结合强度系数则由0.90减小至0.25,也反映出进入土壤中镍的剂量较大时,镍是以不稳定的形态占优。试验结果也证实了土壤具有减小镍的环境危害的作用,但这种缓冲能力是有限的。随着时间的推移,镍的形态会继续发生变化,但这一转化过程是缓慢的。因此,一旦土壤发生重金属污染,其对土壤环境的影响将是长期的。     

ECONOMIC EVALUATION OF RIPARIAN BUFFERS IN AN AGRICULTURAL WATERSHED1

ABSTRACT: This study determines the most cost effective spatial pattern of farming systems for improving water quality and evaluates the economic value of riparian buffers in reducing agricultural nonpoint source pollution in a Midwestern agricultural watershed. Economic and water quality impacts of alternative farming systems are evaluated using the CARE and SWAT models, respectively. The water quality benefits of riparian buffers are estimated by combining experimental data and simulated water quality impacts of fanning systems obtained using SWAT. The net economic value of riparian buffers in improving water quality is estimated by total watershed net return with riparian buffers minus total watershed net return without riparian buffers minus the opportunity cost of riparian buffers. Exclusive of maintenance cost, the net economic value of riparian buffers in reducing atrazine concentration from 45 to 24 ppb is $612,117 and the savings in government cost is $631,710. Results strongly support efforts that encourage farmers to develop or maintain riparian buffers adjacent to streams.     

拟除虫菊酯类农药中间体在鱼体肌肉中的积累和释放行为的研究

本文研究了8种与拟除虫菊酯合成有关的化合物在金鱼和鲤鱼肌肉中的积累和释放行为.实验结果表明,不同鱼种积累同一化合物的程度不同,其差别随着分配系数的增加而显著增加.平衡时的生物富集因子的对数log(BCF)值与分配系数的对数log P值之间有较好的线性关系,其相关方程式为log(BCF)=1.062 logP-1.558(n=8,r=0.975).化合物从鱼体释放到水中的速度符合一级反应动力学公式.释放半衰期的对数log t_(1/2)值亦与log P值相关.其相关方程式为log t_(1/2)=0.784 log P-1.571(n=8,r=0.945).本文结果有助于预测该类有机污染物对环境的影响.     

前屯煤矿矿井水处理作饮用水的技术实践

本文根据前屯煤矿矿井水排放规律和原水水质特征，采用ＫＪＳ型一体化净水器，锰砂除铁滤器及消毒等处理工艺，处理后水质完全达到国家饮用水标准，工程投资和运行费用均较合理。     

有机磷农药在土壤环境中的降解转化

有机磷农药是世界上应用最广泛的农药种类之一 ,它属于比较容易降解的、对环境污染较小的农药。从有机磷农药的性质出发 ,着重讨论了有机磷农药的水解、光解和微生物降解 ,这也是有机磷农药在土壤中的主要降解转化过程     

生物化学协同除磷研究

采用聚合硅酸铝和聚合硅酸铁两种混凝剂,比较了将混凝剂直接投加到反应器中和对生物反应器出水再进行混凝沉淀2种工艺的除磷效果,并对2种混凝剂的除磷效果进行了比较.结果表明:对于聚合硅酸铝,没有生物协同作用;对于聚合硅酸铁,投加量在40 mg/L以下时具有生物协同作用,30 mg/L时协同作用最明显;而且聚合硅酸铁的除磷效果好于聚合硅酸铝.     

PCR-DGGE技术在水解酸化-缺氧法处理采油废水的微生物研究中的应用

采用PCR-DGGE技术直接从水解酸化和缺氧反应器中的污泥样品提取DNA,测定部分菌种的16S rDNA V3区片段序列,通过NCBI基因库比对,初步确定不同生物反应器内优势菌种,并进行了多样性指数分析.结果表明,水解酸化反应器中的生物膜与缺氧反应器中悬浮污泥微生物种群结构存在较大的差异,显示了在不同环境条件下,微生物群落结构的连续动态变化过程.     

各种影响因子对电解法预处理医药废水的影响研究

探讨了电解法预处理医药废水时停留时间、电解电压、废水初始浓度、温度和废水pH值等影响因子对去除色度、COD和提高废水可生化性等处理效果的影响，并考察了其应用于工业实际废水处理的可行性。实验结果表明：电解法更适合高浓度医药废水的处理，色度的去除率可达到90％以上；电解时间宜控制在40-60min；电解电压越高，废水COD和色度去除效果越好；在实验温度范围内，温度对色度和COD去除率的影响不大；废水pH值为7．5时电解效果最佳，工程运用宜控制在6—9之间。     

铁炭法处理高浓度难降解表面活性剂废水的研究

就铁炭法对高浓度难降解拉开粉（阴离子表面活性剂）废水的处理效果进行了接近工业化的动态模型实验研究，结果表明酸化铁炭工艺对橡胶工业拉开粉废水具有显著的去除效果。在Fe：C=2：1，pH=4，停留时间60min，曝气量0．1m^3／h时，拉开粉（BX）和COD的总去除率分别约为80％和45％。     

Variations in exposure to in-vehicle particle mass and number concentrations in different road environments

Road environments significantly affect in cabin concentration of particulate matter (PM). This study conducted measurements of in-vehicle and on-road concentrations of PM10, PM2.5, PM1, and particle number (PN) in size of 0.02–1 µm, under six ventilation settings in different urban road environments (tunnels, surface roads and elevated roads). Linear regression was then used to analyze the contributions of multiple predictor variables (including on-road concentrations, temperature, relative humidity, time of day, and ventilation settings) to measured variations. On-road measurements of PM2.5, PM1, and PN concentrations from the open surface roads were 5.5%, 3.7%, and 16% lower, respectively, than those measured in tunnels, but 7.6%, 7.1% and 24% higher, respectively, than those on elevated roads. The highest on-road PM10 concentration was observed on surface roads. The time series pattern of in-vehicle particle concentrations closely tracked the on-road concentrations outside of the car and exhibited a smoother profile. Irrespective of road environment, the average I/O ratio of particles was found to be the lowest when air conditioning was on with internal recirculation, the highest purification efficiency via ventilation was obtained by switching on external air recirculation and air conditioning. Statistical models showed that on-road concentration, temperature, and ventilation setting are common factors of significance that explained 58%-80%, 64%-97%, and 87%-98% of the variations in in-vehicle PM concentrations on surface roads, on elevated roads, and in tunnels, respectively.

Implications: Inside vehicles, both driver and passengers will be exposed to elevated particle concentrations. However, for in-vehicle particles, there has been no comprehensive comparative study of the three-dimensional traffic environment including tunnels surface roads and elevated roads. This study focuses on the analysis of the trends and main influencing factors of particle concentrations in different road environments. The results can provide suggestions for the driver's behavior, and provide data support for the environmental protection department to develop pollutant concentration limits within the vehicle.