Ce-Sn-W-O_x催化剂的配伍优化及脱硝影响因素

采用共混热解法制备系列Ce-Sn-W-Ox复合氧化物,用于NH3选择性催化还原NO。通过正交实验优化CeSn-W-Ox配方,采用环境扫描电镜(ESEM)、X-射线衍射仪(XRD)等表征分析催化剂的微观形貌和固相结构,确立Ce-Sn-WOx最佳配比及结构形貌。结果表明,以粒度为5~8 mm的堇青石瓷片担载分散Ce-Sn-W-Ox,进行NH3-SCR脱除NO,当Ce/Sn/W元素摩尔比为1∶0.8∶0.6时,Ce Sn0.8W0.6Ox/堇青石NH3-SCR脱除NO效果最好。当空速为7 200 h-1,催化剂在252~426℃内脱除NO效率均大于94%。重点考察了反应空速(GHSV)、水蒸气(H2O)、SO2等对Ce Sn0.8W0.6Ox/堇青石NH3-SCR脱除NO活性的影响。研究表明,空速低于10 000 h-1时,催化剂脱硝活性受空速影响小;单独通入5%H2O对催化剂脱硝活性基本没有影响;单独通入429 mg/m3SO2导致催化剂活性略有降低;同时通入429 mg/m3SO2和5%H2O,催化剂脱硝活性下降至85.33%,除去SO2和H2O后,催化剂活性又能明显回升。     

RuO_2-IrO_2/Ti阳极电催化降解偶氮染料甲基橙模拟废水

以自制Ti基Ru O2-Ir O2镀层形稳电极为阳极,采用电催化氧化处理偶氮染料甲基橙模拟废水。以硫酸钠为支持电解质,在自然p H条件下分别考察了电解时间、电极间距、电流密度和电解质浓度等因素对甲基橙去除率的影响,并分析其原因。实验结果表明,在自然p H、电极间距为1.0 cm、电流密度为30.0 m A/cm2、电解质硫酸钠浓度为20.0 g/L、电解1.0h,甲基橙去除率高达90.0%以上。因此,电催化氧化法作为一种高效、简便的染料废水处理技术,具有一定的应用潜力。     

驯化菌种降解油制气废水的影响因素研究

利用筛选的3种微生物,在初步研究其对某些化合物降解能力的基础上,考察其降解油制气废水过程中一般因素如温度、pH值、供氧条件、废水浓度以及营养因素如磷源、碳源对微生物降解能力的影响。研究表明,各菌种可在自然环境条件范围内,保持对废水CODCr降解效果的稳定性。葡萄糖、乙醇的加入,可将各菌种对CODCr的去除率分别提高16.9%~26.5%、17.6%~25.6%。     

非点源污染河流的水环境容量估算和分配

通过河流相应集水区内氮磷的各污染源分析(包括农地、畜禽养殖和生活排污等),利用输出系数模型估算各非点源的氮磷投(排)放量和入河量;采用河段氮磷输入-输出平衡关系分析方法,估算河流对氮磷的每月自净量.以此为基础,参照水功能区划所要求的水质目标,提出了水质未超标河段相应集水区的氮磷剩余水环境容量按月估算模型,和水质超标河段相应集水区内氮磷投放削减量的按月估算模型,及其在各污染源之间的分配方案.结果表明,长乐江的总氮和总磷自净量分别达到775.9 t·a^-1和30.9 t·a^-1,自净率分别为28.8%和51.2%.河流对氮磷的自净量不仅受水文生态条件的影响而表现出较大的季节性变化,而且随着污染负荷量本身的增加而提高.按照水功能区划中Ⅲ类水的水质要求,长乐江总氮含量全年超标;各非点源的总氮投(排)放量均须不同程度的削减,削减总量应达到1 581.0　t;氮源削减量分配结果表明,化肥是应削减的最大氮源,要求在河流相应集水区内的化肥氮投放削减量为1 047.4 t·a^-1;而与各种氮源的投排放现状相比,要求削减比例最高的是畜禽养殖的氮排放量,达32.4%.长乐江流域尚有一定的总磷剩余水环境容量(2 335.7 t·a^-1).根据目标水质要求,平水期是各污染源总氮投放需要削减的量最大的时期,丰水期则是总磷剩余水环境容量最小的时期.     

医疗废物焚烧中二恶英的产生及控制

医疗废物的安全处置一直被世界各国所重视,我国自SARS灾难后,强化了医疗废物的治理力度。本文针对目前主要采用焚烧法处置医疗废物过程中二恶英的生成途径进行了论述,并结合二恶英的分子结构、毒性及危害提出了控制对策与建议。     

土地利用/覆盖变化对长江上游非点源污染影响研究

在国内外相关研究的基础上,利用输出系数模型,结合RS和GIS技术,对长江上游的非点源污染负荷进行了空间模拟和负荷估算.模拟结果表明,在不考虑流域损失的前提下,由于土地利用造成的非点源污染负荷TN总量从20世纪70年代的123万t下降至2000年的116万t,基本呈逐年减少的趋势,由土地利用造成的TP的变化趋势与TN基本相同,从70年代的3.7万t下降到2000年的3.5万t左右.就省份、土地利用类型和水系而言,四川省、种植用地和草地以及金沙江水系和嘉陵江水系对长江上游的非点源污染贡献较大.在非点源污染负荷强度上,重庆市和嘉陵江水系单位面积负荷最高,是今后应重点治理的地区.结果表明,该模型可以对长江上游这样的超大尺度空间的非点源污染进行较好的空间模拟.     

含有机物铁泥的超临界水氧化法资源化

氨基染料生产过程中产生大量含有机物的铁泥,对环境造成严重污染并造成资源的极大浪费.利用超临界水氧化法对含有机物铁泥进行资源化处理研究,并对产物进行了X射线衍射分析(XRD)、色差实验与电子探针分析.研究结果显示,用超临界水氧化法处理铁泥可以将铁泥中所含的有机物完全氧化,真正实现环境友好;超临界水首先将铁泥氧化成α-Fe2O3与γ-Fe2O3,再经过800℃煅烧后可以作为氧化铁红颜料使用;超临界反应压力对样品的晶型与颜色影响不大.     

Assessing groundwater quality and its sustainability in Joypurhat district of Bangladesh using GIS and multivariate statistical approaches

Sustainable groundwater quality is a key global concern and has become a major issue of disquiets in most parts of the world including Bangladesh. Hence, the assessment of groundwater quality is an important study to ensure its sustainability for various uses. In this study, a combination of multivariate statistics, geographical information system (GIS) and geochemical approaches was employed to evaluate the groundwater quality and its sustainability in Joypurhat district of Bangladesh. The results showed that the groundwater samples are mainly Ca–Mg–HCO₃ type. Principal component analysis (PCA) results revealed that geogenic sources (rock weathering and cation exchange) followed by anthropogenic activities (domestic sewage and agro-chemicals) were the major factors governing the groundwater quality of the study area. Furthermore, the results of PCA are validated using the cluster analysis and correlation matrix analysis. Based on the groundwater quality index (GWQI), it is found that all the groundwater samples belong to excellent to good water quality domains for human consumption, although iron, fluoride and iodide contaminated to the groundwater, which do not pose any significant health hazard according to World Health Organization’s and Bangladesh’s guideline values. The results of irrigation water quality index including sodium adsorption ratio (SAR), permeability index and sodium percentage (Na %) suggested that most of the groundwater samples are good quality water for agricultural uses. The spatial distribution of the measured values of GWQI, SAR, Fe (iron), EC (electrical conductivity) and TH (total hardness) were spatially mapped using the GIS tool in the study area.     

Spatial distribution characteristics of soil organic carbon in subtropical forests of mountain Lushan,China

The study on the spatial distribution of forest soil organic carbon (SOC) is of great significance for accurate assessment of carbon storage in forest ecosystems. In the present study, by taking eight kinds of forest soils of Mountain Lushan in the subtropical area as the research object, we studied the spatial distribution characteristics of SOC in this mountainous area. The results showed that the SOC content and SOC density (SOCD) of main forest types in the Mountain Lushan were lower than the national and the world average. The soil layer of Lushan forest was thinner, and the SOC and active SOC (ASOC) contents of different forest types and SOCDs are the highest in the surface soil. SOCD of the topsoil accounts for 32.64–54.03% of the total SOCD in the whole soil profile. Surface litter is an important source of SOC, and the different vegetation types are the important reason for the different spatial distribution of SOC in this area. Soil SOC contents in the high-altitude forest (bamboo forest, deciduous broadleaf forest, Pinus taiwanensis forest, evergreen-deciduous forest, and coniferous-broadleaved mixed forest) were higher than those in the low-altitude forest (evergreen broadleaf forest, shrub, and Pinus massoniana forest). However, the difference in SOC content exhibited at the altitude gradient is significantly lower than that in SOC in the soil profile. This indicates that both soil depth and elevation are the important factors that affected SOC distribution. However, the influence of soil depth on spatial distribution of SOC may be more complex than that of altitude. Vegetation types and soil properties are the main reasons for the large differences of reduction rate in the contents of SOC and ASOC.     

Silver near municipal wastewater discharges into western Lake Ontario,Canada

Because of the widespread use of silver nanoparticles in commercial products, discharges of municipal wastewater may be a point source of silver in the aquatic environment. We monitored two sites in western Lake Ontario impacted by discharges from wastewater treatment plants serving the City of Toronto. Concentrations of silver were elevated in bottom sediments and suspended sediments collected at the two sites. We also deployed two types of passive samplers in the water column at the two sites, the newly developed Carbon Nanotube Integrative Samplers for monitoring “CNIS-labile” silver and Diffusive Gradient in Thin Film samplers for monitoring “DGT-labile” silver. Results from these passive samplers indicated that the concentrations of silver at the two sites were either below detection limits or were in the ng/L range. In laboratory experiments where the sediments were re-suspended in Milli-Q water, a small proportion of the silver (i.e., <?25%) was labile and partitioned as colloidal or dissolved silver into the liquid phase after agitation. Nanoparticles tentatively identified as silver nanoparticles were detected by single-particle ICP-MS in suspension after agitation of both suspended and bottom sediments. Therefore, there is a need to assess whether silver species, including silver nanoparticles are transported from wastewater treatment plants into sediments in the aquatic environment. This study is unique in focusing on the in situ distribution of silver in natural waters and in sediments that are potentially impacted by urban sources of nanoparticles.