Multiple copper adsorption and regeneration by zeolite 4A synthesized from bauxite tailings

Copper ions were first adsorbed by zeolite 4A synthesized from bauxite tailings, the desorption of Cu(II) using Na₂EDTA solutions was performed, and the recycling of zeolite 4A in adsorption and desorption was systematically investigated. It was observed that the Cu(II) removal efficiency was directly dependent on the initial pH value. The maximum removal efficiency of Cu(II) was 96.2% with zeolite 4A when the initial pH value was 5.0. Cu(II) was completely absorbed in the first 30 min. It was also observed that the desorption efficiency and zeolite recovery were highly dependent on the initial pH and concentration of Na₂EDTA in the solution. The desorption efficiency and percent of zeolite recovered were 73.6 and 85.9%, respectively, when the Na₂EDTA solution concentration was 0.05 mol L^?1 and the pH value was 8. The recovered zeolites were pure single phase and highly crystalline. After 3 cycles, the removal efficiency of Cu(II) was as high as 78.9%, and the zeolite recovery was 46.9%, indicating that the recovered zeolites have good adsorption capacity and can repeatedly absorb Cu(II).

     

Characteristics and management of domestic waste in a rural area of the Tibetan Plateau

In the rural area of the Tibetan Plateau (RATP), the characteristics of domestic waste, people’s environmental awareness, people’s willingness to pay and their influence factors were firstly studied by questionnaires, field samplings and laboratory tests. The results showed that, in the RATP, the generation of domestic waste was 85 g?d-1 per capita and it was mainly composed of plastics, inert waste, kitchen waste, glass and paper. The waste bulk density, moisture content, ash, combustible and low calorific value were 65 kg?m-3, 19.25%, 44.90%, 35.85% and 10,520 kJ?kg-1 respectively. These characteristics are influenced by income sources and geographical position to some extent. Classified collection should be promoted widely on the household and the village basis. Compost, fermentation, landfill, bioreactor landfill and semi-aerobic landfill have been approved as effective techniques to treat domestic waste, except incineration. The distance of 50–800 m between each collection facility and the disposal fee of around $0.8 per month per household are suggested. For suburbs or large population villages, it’s better to treat domestic waste by the centralized way. But for the remote rural areas, a decentralized way is proposed. Significantly, the educational and economic influence should be considered into an effective domestic waste management program.

Implications:?The current situatio n of the environment in the rural areas of the Tibetan Plateau (RATP) was surveyed. There, the generation of organics and moisture of domestic waste were low but ash, recyclables, and combustibles were high. People’s knowledge of domestic waste was absent but their participation in management was strong. Based on the current situation, compost, fermentation, and landfill were effective but incineration was inappropriate. Also, a localized mini landfill for a cluster of villages and or settlements was the best method there.     

生物基质活性炭对挥发性有机物的吸附

以咖啡渣和柚子皮生物基质为原料用磷酸活化法制成活性炭,探讨了制备条件对活性炭制备的影响,并研究了其对正丁烷的吸附行为。磷酸活化过程中磷酸的用量为生物基质质量的1.5倍为宜,咖啡渣采用超声干燥法,柚子皮采用水热法制备。制备的活性炭对正丁烷均有较好的吸附能力,以柚子皮为原料、磷酸用量为原料质量两倍活化制成的活性炭吸附性能最佳,最大吸附量约为商用活性炭的2倍。吸附剂均能较好地与兰格缪尔曲线相拟合,计算了不同正丁烷覆盖度下的等量吸附热,其变化规律与吸附曲线变化规律相一致。     

UV-Fenton体系预处理四氢呋喃废水实验研究

采用UV-Fenton体系预处理四氢呋喃废水,实验结果表明,pH值、反应时间、Fe2+和H2O2投加量等因素对处理效果有较大的影响。实验确定的最佳反应条件为:原水pH=5,Fe2+投加量2.5 mmol/L,H2O2投加量12 mmol/L,反应时间90 min,连续曝气,在此条件下,COD去除率可达85%左右。经UV-Fenton体系处理后,废水的B/C值由0.16增至0.47,可生化性提高,可满足后续生化处理的要求。     

某生活垃圾卫生填埋场渗滤液的梯度分离与表征

目前,渗滤液中污染物的粒度分布及其在渗滤液污染控制中的作用日益受到关注。通过系列微滤膜(1.2μm及0.45μm)对某生活垃圾卫生填埋场渗滤液各处理单元的渗滤液进行梯度分离,发现悬浮物对COD、浊度的影响较大;COD主要在胶体态和可溶解态间分配,不同渗滤液中的分配情况不同;磷主要与胶体、悬浮物以各种形式结合而存在;细胶粒和溶解态等小分子对TN的贡献大;不同粒度物质对pH的影响不明显;总残渣在可溶态组分中所占比例较大。膜微滤处理渗滤液可以有效的去除一部分物质,使COD、TP、TN、浊度、电导率都有不同程度的降低,pH逐渐升高,但对总N、残渣的去除效果不好。     

无硫膨胀石墨的制备及吸油性能

通过单因子实验考察了无硫膨胀石墨制备过程中氧化剂及插层剂用量、氧化反应及插层反应时间、氧化反应及插层反应温度对无硫膨胀石墨膨胀体积的影响。通过正交实验确定了制备无硫膨胀石墨的最优条件是:石墨(g)∶浓硝酸(mL)∶30%H2O2(mL)∶乙酸酐(mL)=1∶2.25∶0.25∶0.6,在30℃条件下氧化反应60 min,加入插层剂后在60℃条件下插层反应90 min,此条件无硫膨胀石墨的膨胀体积达317 mL/g使用XPS、FT-IR、XRD和SEM对无硫膨胀石墨进行了表征并对其吸油性能和再生性能进行了研究。结果表明,所制备无硫膨胀石墨对原油和柴油的最大吸附量分别为66.3 g/g和62.7 g/g。吸附原油后的无硫膨胀石墨抽滤再生后首次再生率为49.1%,原油的回收率为64.5%。     

氮掺杂TiO2可见光光催化剂的制备及性能

以尿素和钛酸丁酯为原料,通过溶胶-凝胶法低温下制备了高可见光催化活性的氮掺杂TiO2(NDT)光催化剂,采用XRD、TEM、BET和UV-Vis DRS等测试手段对其进行了表征,并在自制光催化反应器中降解甲基橙评价了样品的光催化活性。结果表明,当氮与钛的摩尔比为0.5∶1时,350℃焙烧的样品(NDT350)具有最佳的可见光光谱吸收和光催化活性,该催化剂为锐钛矿晶相,平均粒径为21 nm,比表面积为89.13 m2/g。可见光辐照下,NDT350降解甲基橙的表观反应速率常数为1.381×10-2min-1,是商业P25催化剂的16.85倍。NDT350优良的可见光催化活性与其大的比表面积和强烈的可见光光谱吸收有关。     

脂肽类生物表面活性剂液体发酵条件的响应面优化

通过Plackett-Burman和Box-Behnken实验对解淀粉芽孢杆菌XZ-173液体发酵生产表面活性素进行了响应面优化研究。首先使用Plackett-Burman实验对影响表面活性素产量的17个因素进行显著性筛选,结果表明,MnSO4、CuSO4、温度和转速为显著性因素。再运用Box-Behnken实验对这4个显著因素的取值进一步优化,得到各因素优化后的数值分别为4.4 mg/L(MnSO4)、0.18 mg/L(CuSO4)、29℃(温度)和163 r/min(转速)。响应面分析结果表明:该菌株产生表面活性素的最佳培养基为:葡萄糖15 g/L,蛋白胨5 g/L,L-谷氨酸钠6 g/L,KH2PO40.8 g/L,MgSO40.4 g/L,KCl 0.4 g/L,酵母提取物3 g/L,L-苯丙氨酸2.5 mg/L,MnSO44.4 mg/L,CuSO40.18 mg/L,FeSO40.12 mg/L;最适培养条件:pH 7.5,温度29℃,转速163 r/min,接种量5%,装液量50 mL/250 mL,摇床培养36 h。在优化后的条件下,表面活性素实际产量为336 mg/L,实际实验结果与模型预测结果相一致。表面活性素采用HPLC技术分离,发现其在浓度仅为50 mg/L时EI24就可达到70%以上,反映了表面活性素优异的乳化活性以及广阔的应用前景。     

堇青石负载Pd和过渡金属氧化物催化剂的表征及其对CO的催化氧化活性

以堇青石蜂窝陶瓷(CC)为载体,采用浸渍法制备了堇青石负载Pd和过渡金属混合氧化物催化剂,记作Pd-M-Mn(M=Cu,Co,Fe,Ni)/CC。实验结果表明:Pd-Co-Mn/CC催化剂的催化活性最高;随着Pd负载量的增加,CO转化率提高;当Pd负载量为1.00%时,反应温度为150℃时CO转化率达到98%,200℃时CO转化率达到100%;在反应温度150℃条件下,Pd-Co-Mn/CC催化剂(Pd负载量1.00%)的CO转化率在前30h内小幅度下降,随后稳定在90%以上,反应100h后,催化剂表面颜色由黑色变为棕褐色。     

Identification and quantitative detection of Legionella spp. in various aquatic environments by real-time PCR assay

In this study, a SYBR green quantitative real-time PCR was developed to quantify and detect the Legionella spp. in various environmental water samples. The water samples were taken from watershed, water treatment plant, and thermal spring area in Taiwan. Legionella was detected in 13.6 % (24/176), and the detection rate for river water, raw drinking water, and thermal spring water was 10, 21.4, and 16.6 %, respectively. Using real-time PCR, concentration of Legionella spp. in detected samples ranged between 9.75?×?10⁴ and 3.47?×?10⁵?cells/L in river water, 6.92?×?10⁴ and 4.29?×?10⁵?cells/L in raw drinking water, and 5.71?×?10⁴ and 2.12?×?10⁶?cells/L for thermal spring water samples. The identified species included Legionella pneumophila (20.8 %), Legionella jordanis (4.2 %), Legionella nautarum (4.2 %), Legionella sp. (4.2 %), and uncultured Legionella sp. (66.6 %). The presence of L. pneumophila in aquatic environments suggested a potential public health threat that must be further examined.