简单芽孢杆菌产高效微生物絮凝剂

通过从绿化植物根际土壤和污水处理厂的活性污泥中分离筛选絮凝剂产生菌,得到一株稳定高效的微生物絮凝剂产生菌PS1,根据形态学特征、生理生化实验以及16S rDNA序列分析将其鉴定为简单芽孢杆菌(Bacillus simplex)。对菌株PS1产生絮凝剂的最佳培养时间、絮凝活性分布以及pH、CaCl2、絮凝剂投量对絮凝效果的影响进行了研究,并考察了其对实际废水的絮凝效果。结果表明,菌株PS1产絮凝剂的最佳培养时间为36 h,产生的絮凝活性物质全部存在于发酵液离心后的上清液中;当pH为7.0～8.5、CaC12投量为0.25～0.35 g/L、发酵液投加量的体积分数为1.5%～2.5%时,菌株PS1发酵液对4 g/L的高岭土悬浊液的絮凝效果最佳,絮凝率达到97%。菌株PS1所产絮凝剂对城市污水、啤酒废水、淀粉废水、医院废水的絮凝率可达90%以上。     

不同质量浓度苦草对铜绿微囊藻生长及抗氧化酶系统的影响

采用苦草（Vallisneria spiralis Linn.）和铜绿微囊藻（Microcystis aeruginosa）共生培养的实验方法,通过追踪测定铜绿微囊藻的生物量、叶绿素a含量、丙二醛（MDA）含量、超氧化物歧化酶（SOD）和过氧化物酶（POD）活性,研究了不同质量浓度苦草对铜绿微囊藻生长及抗氧化酶系统的影响。结果表明,质量浓度大于10 g/L时,苦草对铜绿微囊藻有明显的抑制作用,表现为苦草质量浓度为10、20和40 g/L时,第15天对铜绿微囊藻的抑制率分别为63.3%、94.7%和99.8%,培养过程中,铜绿微囊藻的叶绿素a含量逐渐减少,而SOD、POD活性及MDA含量呈现先增加后逐渐降低的趋势,表明苦草释放的化感物质在经过一定时间积累后能够明显抑制铜绿微囊藻SOD和POD的活性,引起细胞的氧化损伤,促进叶绿素的分解,从而导致藻类死亡,这是苦草抑制铜绿微囊藻生长的原因之一。     

进水水质成分改变引发的污泥粘性膨胀及控制

在研究强化SBR工艺除污性能时,由于可溶性淀粉投加导致进水水质成分发生改变,污泥沉降性能在短时间内迅速恶化,污泥出现大量的粘液。镜检发现,大量指状菌胶团异常增殖且丝状菌的数量也逐渐减少。实验结果表明,系统膨胀属于污泥粘性膨胀。停止可溶性淀粉和提高主反应池的DO浓度,污泥粘性膨胀并未得到恢复,但污泥粘液逐渐消失。粘液消失后,通过模拟前期进水水质成分和缩短泥龄,污泥粘性膨胀得以控制,污泥沉降性能在短时间内恢复。实验还研究了污泥粘性膨胀对污染物去除性能的影响。     

自洁式三级串联的水样在线过滤系统的研制和应用

基于玻璃纤维对小颗粒物的截留和微孔过滤,以及超声波辅助清洗等方法原理,设计和制作了带反冲洗自洁功能的三级串联在线过滤系统,将滤网（初级）、超声波作用下装填有玻璃纤维的过滤器（二级）、微孔滤管（三级）串联,对较高浊度的环境水样进行在线过滤。评估了模拟水样和实际水样中浊度的去除效果,证明该系统对水样中颗粒物有很好的去除并大幅降低水样浊度。在优化的条件下,原始浊度范围在4～100NTU的水样经过滤后,浊度均能降至1NTU以下。以标准方法测定的典型水质指标（活性磷、铵氮、亚硝酸盐氮和硝酸盐氮）的浓度为基准,计算水样经所设计的过滤系统处理后,这4种营养盐的回收率一般在85％-130％之间,说明本系统的使用基本不影响目标物的测定。     

MnxCe1-xO2／γ-Al2O3催化剂的制备及其催化甲苯的燃烧性能

以γ-Al2O3为载体,以MnxCe1-xO2为催化活性组分,采用浸渍法制备了一系列负载型MnxCe1-xO2／γ-Al2O3催化剂（x=0、0．2、0．4、0．6、0．8、0．9、1）,在固定床反应器中评价了催化剂对甲苯的催化燃烧性能。结果表明,MnxCe1-xO2／γ-Al2O3催化剂的催化活性与催化剂的焙烧温度、活性组分MnxCe1-xO2的负载量以及Mn、Ce摩尔比有显著关系,其中焙烧温度550℃、负载量为20％、Mn、Ce摩尔比为4：1时,即MnxCe1-xO2／γ-Al2O3催化剂对甲苯的催化性能最佳,反应温度为180℃时,甲苯的转化率达到95％。并在连续100h的稳定性操作后,催化剂的活性基本无变化。采用XRD、BET以及SEM等分析测试手段对催化剂的结构以及表面进行了表征。     

陶瓷印花废水处理的混凝剂及工艺条件

采用混凝剂聚合氯化铝（PAC）、聚丙烯酰胺（PAM）、聚合硫酸铁（PFS）对陶瓷印花废水进行混凝沉降处理,监测水样的吸光度、浊度、悬浮物,以脱色率、浊度去除率、悬浮物去除率评价混凝处理的效果。结果表明：PAC是陶瓷印花废水沉降处理的理想混凝剂;水样的吸光度、浊度、悬浮物随混凝剂用量增大和沉降时间延长而呈降低趋势,而脱色率、浊度去除率、悬浮物去除率随混凝剂和沉降时间的增大呈增大的趋势;PAC投加量为20mg／L,沉降时间约为24h,水样脱色率达到90．0％,而当PAC投加量达到100mg／L,沉降时间约为4h,陶瓷印花水的脱色率可达到96．0％。证明了药剂用量的增加与沉降时间的延长对混凝过程具有增效作用。     

A real-time,dynamic early-warning model based on uncertainty analysis and risk assessment for sudden water pollution accidents

A real-time, dynamic, early-warning model (EP-risk model) is proposed to cope with sudden water quality pollution accidents affecting downstream areas with raw-water intakes (denoted as EPs). The EP-risk model outputs the risk level of water pollution at the EP by calculating the likelihood of pollution and evaluating the impact of pollution. A generalized form of the EP-risk model for river pollution accidents based on Monte Carlo simulation, the analytic hierarchy process (AHP) method, and the risk matrix method is proposed. The likelihood of water pollution at the EP is calculated by the Monte Carlo method, which is used for uncertainty analysis of pollutants’ transport in rivers. The impact of water pollution at the EP is evaluated by expert knowledge and the results of Monte Carlo simulation based on the analytic hierarchy process. The final risk level of water pollution at the EP is determined by the risk matrix method. A case study of the proposed method is illustrated with a phenol spill accident in China.     

Degradation of aqueous Rhodamine B by plasma generated along the water surface and its enhancement using nanocrystalline Fe-, Mn-, and Ce-doped TiO2 films

The degradation of aqueous Rhodamine B (RhB) was examined using a dual-channel spark switch module designed to regulate the steepness of pulsed high voltage with microsecond rise time. Depending on the energy per pulse, a spark along the water surface (SPWS) or streamer along the water surface (STWS) was formed. STWS was found to have a better degradation effect and energy efficiency toward RhB than SPWS at the same power; however, addition of H₂O₂ amounts resulted in increased degradation, the effect being more pronounced using SPWS. The initial concentration of RhB also appeared to influence the rate constant of the degradation reaction. Furthermore, TiO₂ films doped with Fe, Mn, and Ce were found to enhance the degradation performance of plasma. A possible reaction mechanism of plasma formation along the water surface was concluded by determination of the main inorganic products in the liquid and gas phases.     

Characterization of residue from leached cathode ray tube funnel glass: reutilization as white carbon black

Cathode ray tube (CRT) funnel glass remains an urgent environmental problem and is composed mainly of lead oxide and silicon oxide. In this research, the residue could be obtained from 2 h to 500 rpm activated CRT funnel glass after extracting lead via acid leaching under the conditions of HNO₃ concentration 1.0 mol/L, leaching temperature 95 °C and leaching time 1 h. In order to reutilize the residue, its physico-chemical properties were characterized by scanning electron microscopy, Brunauer–Emmett–Teller, thermogravimetric analysis, X-ray diffraction and Fourier transform infrared spectroscopy. The results indicated that the residue was an amorphous superfine powder with approximately 93 wt% silica oxide and specific surface area of more than 170 m²/g. It can be reutilized as white carbon black.     

Crystallization Behavior and Dynamic Mechanical Properties of Poly(l-Lactic Acid) with Poly(Ethylene Glycol) Terminated by Benzoate

Effect of the addition of poly(ethylene glycol) terminated by benzoate (PEG-BA) on the crystallization behavior and dynamic mechanical properties of poly(l-lactic acid) PLLA is studied as compared with poly(ethylene glycol) (PEG-OH). It is found that PEG-BA is miscible with PLLA and shows good plasticizing effect. Because PEG-OH having the same degree of polymerization is immiscible with PLLA, the end group in PEG-BA, i.e., benzoate, plays an important role in the miscibility. Furthermore, PEG-BA does not induce the PLLA degradation at melt-processing, whereas PEG-OH leads to the hydrolysis degradation. Finally, the addition of PEG-BA pronounces the crystallization rate of PLLA at low crystallization temperatures and thus enhances the degree of crystallinity at conventional processing. Consequently, the temperature dependence of dynamic mechanical properties are similar to that for isotactic polypropylene.