铜川斜坡变形与作用因素分析

斜坡变形与失稳活动是黄土高原突出的地质地貌现象．它有较强的致灾性。本文通过陕西铜川斜坡变形的现场实际调查，研究了该地斜坡的形态、物质组成、变形形式以及作用因素等。本研究对厚层黄土区斜坡变形灾害的防治有较重要意义。     

循环温度荷载下管式能量桩荷载传递机理研究

基于模型试验方法,开展加热(制冷)工作模式下,实心和管式能量桩的热响应测试研究;分析多次加热/制冷循环作用下两种能量桩的热力耦合特性,实测桩顶位移、桩身应变、以及桩侧摩阻力等变化规律,并对实际运行过程中实心和管式能量桩的承载特性进行初步讨论。研究结果表明,相同直径的管式能量桩换热效率高于实心能量桩,管式能量桩对加热循环的热响应要高于实心能量桩;多次循环后,能量桩桩顶产生塑性沉降、桩身产生微小的塑性应变,桩侧摩阻力值增加。     

双进口涡向起旋流流场实验研究

通过实验的方法,实测了双进口涡向起旋圆管内旋转流场,得出圆管内各断面上旋转流场分布、旋转流的速度分布、压力分布的特点,并分析拟合得出旋流速度指数衰减的公式。     

高浓度钻井废泥浆处理工艺的试验研究

为实现钻井泥浆无害化处理,提出了"酸化破胶-固液分离-催化氧化-微生物降解"的处理方法,并采用钻井现场废泥浆进行了系列试验研究。结果表明:泥浆密度调节为1.15 kg/dm3,酸化pH≤3,固液分离效果最佳;过滤分离后固相浸毒液达到国家排放标准;液相经Fenton氧化、微生物降解后,COD将降低到110 mg/L以下。该方法运行成本低,处理彻底无隐患,为进一步工业化试验奠定了基础。     

水功能区划在流域排污权初始分配中的应用——以沙颖河流域为例

排污权交易是治理环境污染问题的有效手段,排污权初始分配则是排污权交易制度实施的基础,在流域水功能区划基础上研究排污权初始分配问题,将有助于流域排污权交易制度的有效实施.结合我国现行行政特征和流域水功能区划成果,以行政单元作为排污权初始分配主体开展排污权初始分配研究.选取沙颍河流域为例,根据淮河水利委员会制定的沙颍河流域水功能区划及COD、氨氮限排总量要求,以COD、氨氮作为排污权初始分配的客体,通过等比例削减方法对沙颍河流域内的行政单元进行了排污权初始分配,得到了流域内各行政单元的COD、氨氮初始排放权,并将分配结果与区域社会经济发展水平等进行了比较研究,研究认为将水功能区划应用于排污权初始分配研究是一种有效的尝试.在此基础上探讨了关于排污权初始分配的政策可行性、初始分配的方法及地方政府定位等几方面问题,目的在于为将来的排污权分配研究工作提供一些思考和建议.     

珠三角城市群典型城市土壤邻苯二甲酸酯污染特征

选择了经济相对发达的珠江三角洲城市群中的典型中小城市的菜园和果园表层土壤(0～20 cm)进行调查取样,采用气相色谱法,对土壤样品中的16种邻苯二甲酸酯(PAEs)进行了测定,分析了其分布特征,并初步探讨了本区域的PAEs的污染控制问题.结果表明:在珠三角城市中,东莞土壤的PAEs含量最高,各地土壤中的PAEs均值高低顺序依次为东莞＞深圳(珠海)＞中山(惠州);菜园土壤中的平均PAEs含量比果园高37%左右;从珠三角城市菜地和果园的平均PAEs分布来看,东莞和深圳的菜地PAEs明显高于果园;珠海、中山和惠州菜地的平均PAEs与果园基本持平.16种PAEs类化合物在珠江三角洲不同城市的分布的差异非常大,不同城市所受到的主要PAEs化合物污染的种类不同;与美国土壤PAEs控制标准相比,珠三角城市果园和菜地土壤的PAEs主要为DEP和DnBP超标,这两类PAEs化合物应该成为重点的污染控制对象.     

丘陵区坡面土壤有机碳及颗粒有机碳分布特征

测定了紫色丘陵区疏林地、荒草地和坡耕地三种土地利用方式下土壤有机碳和颗粒有机碳含量,探讨不同利用方式与坡位下土壤有机碳和土壤颗粒有机碳的分布特征.结果表明:不同土地利用方式下上坡位和中坡位土壤有机碳和颗粒有机碳含量均为疏林地＞坡耕地＞荒草地,而在下坡位两者含量变化差异较大;不同土地利用方式下各坡位土壤剖面有机碳含量均是在0～5 cm层富集,颗粒有机碳的含量也表现出一定在剖面分异性;不同土地利用方式土壤颗粒有机碳分配比例为(0.74±0.01)～(0.34±0.02),不同土地利用方式之间土壤颗粒有机碳分配比例差异较小.相关分析表明,不同利用方式下土壤有机碳、全氮和颗粒有机碳含量之间均呈显著的相关性.     

镉胁迫对莴苣幼苗生长及抗氧化酶系统的影响

以笋王一号(Lactucasativa L. sativa var.Angustata Irish.cv Sunwang NO.1)为材料,通过营养液水培试验,研究了不同浓度的Cd胁迫对莴苣幼苗生长和抗氧化酶的影响.试验结果表明:10～100 μmol·L-1Cd2+对幼苗株高、根长、叶面积和叶数的增加具有明显的抑制作用,且随着浓度的增加抑制程度加重,但低浓度的Cd2+(1 μmol·L-1)却产生了一定的促进作用;幼苗根、叶中MDA含量和G-POD、叶中SOD活性随着Cd处理浓度的增加明显增加,但根中的SOD在100 μmol·L-1Cd胁迫下明显低于对照,同时,1 μmol·L-1Cd对根和叶片中的APX和CAT活性有一定的激活效应,以后随着Cd处理浓度的提高表现为抑制效应,且随着Cd浓度的增加抑制效应逐渐增强.     

Selective sorption of perfluorooctane sulfonate on molecularly imprinted polymer adsorbents

Perfluorooctane sulfonate (PFOS), as a potential persistent organic pollutant, has been widely detected in water environments, and has become a great concern in recent years. PFOS is very stable and difficult to decompose using conventional techniques. Sorption may be an attractive method to remove it from water. In this study, the molecularly imprinted polymer (MIP) adsorbents were prepared through the polymerization of 4-vinylpyridine under different preparation conditions in order to remove perfluorooctane sulfonate (PFOS) from water. The MIP adsorbents using perfluorooctanoic acid (PFOA) as the template had good imprinting effects and could selectively remove PFOS from aqueous solution. The sorption behaviors including sorption kinetics, isotherms, and effect of pH, salt, and competitive anions were investigated. Experimental results showed that the sorption of PFOS on the MIP adsorbents was very fast, pH-dependent, and highly selective. The achieved fast sorption equilibrium within 1 h was attributed to the surface sorption on the fine adsorbents. The sorption isotherms showed that the sorption selectivity of PFOS on the MIP adsorbents decreased at high PFOS concentrations, which may be due to the double-layer sorption and the formation of PFOS micelles on the sorbent surface. The sorption of PFOS on the MIP adsorbents was mainly dominated by the electrostatic interaction between the protonated vinylpyridine on the adsorbent surface and the anionic PFOS. The prepared MIP adsorbents can potentially be applied in water and wastewater treatment for selective removal of PFOS.     

Life cycle assessment of TV sets in China: A case study of the impacts of CRT monitors

Along with the rapid increase in both production and use of TV sets in China, there is an increasing awareness of the environmental impacts related to the accelerating mass production, electricity use, and waste management of these sets. This paper aims to describe the application of life cycle assessment (LCA) to investigate the environmental performance of Chinese TV sets. An assessment of the TV set device (focusing on the Cathode Ray Tube (CRT) monitor) was carried out using a detailed modular LCA based on the international standards of the ISO 14040 series. The LCA was constructed using SimaPro software version 7.2 and expressed with the Eco-indicator' 99 life cycle impact assessment method. For a sensitivity analysis of the overall LCA results, the CML method was used in order to estimate the influence of the choice of the assessment method on the results. Life cycle inventory information was compiled by Ecoinvent 2.2 databases, combined with literature and field investigations on the current Chinese situation. The established LCA study shows that the use stage of such devices has the highest environmental impact, followed by the manufacturing stage. In the manufacturing stage, the CRT and the Printed Circuit Board (PCB) are those components contributing the most environmental impacts. During the use phase, the environmental impacts are due entirely to the methods of electricity generation used to run them, since no other aspects were taken into account for this phase. The final processing step-the end-of-life stage-can lead to a clear environmental benefit when the TV sets are processed through the formal dismantling enterprises in China.