Mass transfer coefficients for volatilization of polychlorinated biphenyls from the Hudson River,New York measured using micrometeorological approaches

Air–water exchange is an important process controlling the fate of many organic chemicals in the environment. Modeling this process is hampered by the lack of direct observations. Thus, the purpose of this work was to derive direct measurements of the mass transfer coefficients for air–water exchange (v_aw) of polychlorinated biphenyls (PCBs) that may be used to check the validity of values derived from tracer gas experiments. v_aw values for PCBs were determined using previously published turbulent fluxes divided by the corresponding dissolved phase concentrations. The median v_aw values for each homolog decreased with increasing molecular weight and ranged from 0.29 for hexachlorobiphenyls to 2.2 m d^?1 for monochlorobiphenyls with a propagated uncertainty of about 70%, lower than in previous studies. Due to relatively low wind speeds and possible sorption of PCBs to colloids, these numbers may be biased low. These field measurements of v_aw differ by as much as a factor of 23 from predictions based on the widely-used Whitman two-film model. Therefore a new formulation for the calculation of v_aw based on field measurements is needed. This study demonstrates that micrometeorological approaches are a viable option for the measurement of v_aw for hydrophobic organics such as PCBs and should be used to generate enough field data on the air–water exchange of hydrophobic organics to allow the development of new predictive models.     

Ozone Artifacts and Carbonyl Measurements Using Tenax GR,Tenax TA,Carbopack B,and Carbopack X Adsorbents

Abstract

Four popular thermally desorbable adsorbents used for air sampling (Tenax TA, Tenax GR, Carbopack B, and Carbopack X) are examined for the potential to form artifacts with ozone (O₃) at environmental concentrations. The performance of these adsorbents for the ketone and alde-hyde species identified as O₃-adsorbent artifacts was also characterized, including recovery, linearity, and method detection limits (MDLs). Using gas chromatography/mass spectrometry, 13 different artifacts were identified and confirmed for both Tenax TA and Tenax GR, 9 for Carbopack B, but none for Carbopack X. Several O₃ artifacts not reported previously were identified, including: pentanal, 3-hexanone, 2-hexanone, hexanal, 3-heptanone, and heptanal with Tenax TA; pentanal, 3-hexanone, 2-hexanone, hexanal, and 3-heptanone on Tenax GR; and 1-octene and 1-nonene with Carbopack B. Levels of straight-chain aldehyde artifacts rapidly diminished after a few cycles of adsorbent conditioning/O₃ exposure, and concentrations could be predicted using a first-order model. Phenyl-substituted carbonyl artifacts (benzalde-hyde and acetophenone) persisted on Tenax TA and GR even after 10 O₃ exposure-conditioning cycles. O₃ breakthrough through the adsorbent bed was most rapid in adsorbents that yielded the highest levels of artifacts. Overall, artifact composition and concentration are shown to depend on O₃ concentration and dose, conditioning method, and adsorbent type and age. Calibrations showed good linearity, and most compounds had reasonable recoveries, for example, 90 ±15% for Tenax TA, 97 ±23% for Tenax GR, 101 ±24% for Carbopack B, and 79 ±25% (91 ±9% for n-aldehydes) for Carbopack X. Benzeneacetaldehyde recovery was notably poorer (22–63% across the four adsorbents). MDLs for several compounds were relatively high, up to 5 ng. By accounting for both artifact formation and method performance, this work helps to identify which carbonyl compounds can be measured using thermally desorbable adsorbents and which may be prone to bias because of the formation of O_3- adsorbent artifacts.     

光催化氧化降解垃圾渗滤液中溶解性有机物

研究了UV-TiO2光催化氧化降解垃圾渗滤液过程中溶解性有机物(DOM)的变化特征。结果表明:在适宜条件下,UV-TiO2光催化氧化降解垃圾渗滤液的色度、COD和DOC的去除率分别可达97%、72%和60%;紫外光谱分析说明渗滤液DOM中包括多种含有共轭双键、羰基的大分子有机物及多环芳香类化合物,不同光催化处理液中DOM具有基本一致的结构单元和官能团;红外光谱分析说明渗滤液DOM中含有大量包括羟基、羧基、氨基和苯环的芳香族化合物,在光催化处理液中这几种官能团都能被有效降解;GC/MS分析结果表明,渗滤液DOM中含有72种有机污染物,醇类、羧酸和酮类分别为25、14和12种;在光催化72 h处理液中,有机物减少为44种;酯类和醇类较多,分别为12种和16种;酮类8种,羧酸没有检出。     

改性沸石对低浓度氨氮废水的动态吸附

采用氯化钠溶液对甘肃白银天然沸石改性,以低浓度氨氮(NH4+-N)废水为处理对象,对比了天然沸石和改性沸石的动态吸附特性并绘制穿透曲线,利用Origin软件对实验数据分析处理,得出穿透曲线的通式。结果表明:在相同条件下,改性沸石的穿透时间和吸附饱和时间都比天然沸石的长约1.5倍;沸石经氯化钠改性后,对NH4+-N的吸附速率和饱和吸附量都明显提高,吸附性能显著改善。Origin软件对水溶液中NH4+-N的吸附穿透曲线的Logistic模型回归式具有较高的精度,该模型可以很好地反映沸石吸附剂的动态吸附过程。     

双室微生物燃料电池处理硝酸盐废水

基于双室微生物燃料电池(microbial fuel cell,MFC),针对阴极分别接种活性污泥(A-MFC)和反硝化细菌(D-MFC),研究其产电情况和硝酸盐废水去除效果。结果表明,在产电的同时都可有效去除废水中的硝酸盐污染物。在外接电阻100Ω的情况下,2种MFC均具有良好的产电性能,A-MFC和D-MFC达到的最大输出电压分别为119.6 mV和117.2mV,最大功率密度分别为23.40 mW/m2和26.63 mW/m2;同时两者在阴极室的平均反硝化速率分别为1.86 mg/(L.d)和2.19 mg/(L.d),阳极室的平均COD去除率分别为81.9%和82.4%。另外,通过扫描电镜观察可知,A-MFC和D-MFC阴极碳布表面形貌存在差异,并且阳极与阴极碳布表面形貌差异显著。     

响应面法优化聚丙烯酸/腐殖酸/累托石吸附剂的制备条件

以累托石、丙烯酸及腐殖酸为原料制备出能同时吸附重金属和多环芳烃的吸附剂聚丙烯酸/腐殖酸/累托石,采用响应面试验设计法优化吸附剂的制备条件。利用Design Expert软件,建立了预测吸附剂对Cd2+、菲吸附量的二次回归模型,对回归模型进行了方差分析,并确定了吸附剂的最佳制备条件。结果表明,二次回归模型能较好地模拟Cd2+、菲的吸附量与影响因子丙烯酸中和度、引发剂量和交联剂量之间的关系。各因子对Cd2+吸附量的影响次序为:交联剂量>引发剂量>丙烯酸中和度;对菲吸附量的影响次序为引发剂量>交联剂量>丙烯酸中和度。吸附剂的最佳制备条件为:累托石、丙烯酸和腐殖酸三者的质量比为65∶30∶5,丙烯酸中和度、引发剂量和交联剂量分别为75.16%、2.57%和0.44%。在此优化条件下制备的吸附剂对Cd2+和菲的吸附量分别为170.19 mg/g和7.36 mg/g。     

柠檬酸盐络合铜在污泥上的吸附

利用二沉池污泥进行吸附柠檬酸盐络合铜实验。研究了吸附动力学、热力学、液固比以及pH值对吸附的影响,同时对比污泥吸附前后FTIR光谱推测吸附主要基团。结果表明,吸附速率受多种机制共同影响;准二级动力学模型能较好地描述污泥吸附柠檬酸盐络合铜动力学数据;增加液固比,总铜去除率下降;偏酸性环境下污泥对络合铜吸附效果较优;吸附过程符合Langmuir等温模型;红外光谱特征分析表明,污泥含有的—OH、酰胺基、—COO-、硅酸盐物质可能是污泥吸附络合铜的主要活性基团。     

树脂固定床吸附含酚废水预测模型研究

针对应用于实际工业化的树脂固定床吸附研究较少,而与之相关的固定床吸附穿透曲线可以用来确定固定床吸附操作参数,为固定床的设计和实际操作提供指导。通过对恒定波振荡理论和吸附等温方程的联合,来预测固定床吸附穿透曲线;并研究了不同操作条件对大孔弱碱树脂吸附对硝基酚穿透曲线预测模型的影响。以期望为树脂固定床的设计和实际工业应用产生指导意义。     

高职院校计算机应用专业《JSP动态网站设计》课程改革探析

通过分析当前社会需求,结合高职高专院校目前的教学模式,提出计算机应用专业的《JSP动态网站设计》课程的教学改革方案。在基于工作任务的lAPP（导入-分析-实践-项目）教学情境中,开展“课堂实训＋虚拟公司＋校外实训基地”三位一体的实践模式教学,同时,将对工作过程的考核纳入课程的整个考核体系之中,使学生在课程中能够获得真实的职业体验和完善的实践能力。     

Phytoavailability and geospeciation of cadmium in contaminated soil remediated by Rhodobacter sphaeroides

A microorganism was isolated from oil field injection water and identified as Rhodobacter sphaeroides. It was used for the remediation of simulated cadmium-contaminated soil. The phytoavailability of Cd was investigated through wheat seedling method to determine the efficiency of remediation. It was found that after remediation, the accumulation of Cd in wheat roots and leaves decreased by 67% and 53%, respectively. The Cd speciation in soil was determined with Tessier extraction procedure. It was found that the total Cd content in soil did not change during the experiments, but the geo-speciation of Cd changed remarkably. Among the five fractions, the concentration of exchangeable phases decreased by 27-46% and that of the phases bound to Fe-Mn oxides increased by 22-44%. The decrease of Cd accumulation in wheat showed significant positive correlation with the decrease of exchangeable phases. It could be concluded that the remediation of R. sphaeroides was carried out through the conversion of Cd to more stable forms. The decrease of sulfate concentration in supernatant indicated that the R. sphaeroides consumed sulfate.