电镀污泥的热处理特性以及对金属回收的影响

焙烧-酸浸法可有效回收电镀污泥中的有价金属,而污泥的热处理特性是决定能否采用焙烧预处理的重要因素。研究了氧化焙烧和还原焙烧对污泥成分和金属浸出性的影响,并对焙烧前后的污泥进行了金属形态分析和X射线衍射(XRD)分析。结果表明,焙烧预处理实现了污泥减量和金属富集;ES1经氧化焙烧后金属浸出率接近原泥,Cu的浸出率达99%;ES2的还原焙烧效果优于氧化焙烧,特别是Cu的浸出率超过97%,XRD分析发现,还原焙烧过程中金属Cu被还原为铁铜合金;2种焙烧均造成了ES3中目标金属Ni的浸出率的降低;金属浸出性的下降与残渣态的形成有关。     

Treatment of 1,3-Butadiene in an Air Stream by a Biotrickling Filter and a Biofilter

ABSTRACT

This paper presents results obtained from a performance study on the biotreatment of 1,3-butadiene in an air stream using a reactor that consisted of a two-stage, in-series biotrickling filter connected with a three-stage, in-series biofilter. Slags and pig manure-based media were used as packing materials for the biotrickling filter and the biofilter, respectively. Experimental results indicated that, for the biotrickling filter portion, the butadiene elimination capacities were below 5 g/m³/hr for loadings of less than 25 g/m³/hr, and the butadiene removal efficiency was only around 17%. For the biofilter portion, the elimination capacities ranged from 10 to 107 g/m³/hr for loadings of less than 148 g/m³/hr. The average butadiene removal efficiency was 75–84% for superficial gas velocities of 53–142 m/hr and a loading range of 10–120 g/m³/hr. The elimination capacity approached a maximum of 108 g/m³/hr for a loading of 150 g/m³/hr. The elimination rates of butadiene in both the biotrickling filter and biofilter were mass-transfer controlled for influent butadiene concentrations below about 600 ppm for superficial gas velocities of 29–142 m/hr. The elimination capacity was significantly higher in the biofilter than in the biotrickling filter. This discrepancy may be attributed to the higher mass-transfer coefficient and gas-solid interfacial area offered for transferring the gaseous butadiene in the biofilter.     

Fingerprinting of High Boiling Hydrocarbon Fuels,Asphalts and Lubricants

Fingerprinting of hydrocarbon products requires high resolution differentiation of individual hydrocarbon compounds in any mixture. This requires the applications of various measuring techniques. In this paper, we have chosen the heavy hydrocarbons in fuels, lubricants and paving material as examples to discuss the methods for chemical characterization and differentiation. In the category most frequently termed "semi-volatile hydrocarbons" with boiling points from about 500°F to 1200°F or higher, there are several families of hydrocarbons, both natural and refined that are not easily distinguished by conventional EPA tests. Among the groups which we will use as examples are asphalts, hydraulic fluid, transmission oil, motor lubricating oils, heating oils, crude oil and coal. These hydrocarbon families are best studied using combined gas chromatography-mass spectrometry in full scan mode and characterizing various homologous series of hydrocarbons at known fragment ions. The hydrocarbon series providing the best information are: (1) N -alkanes; (2) iso-alkanes; (3) steranes; (4) terpanes; (5) polynuclear aromatic hydrocarbons; (6) aromatic steranes; and (7) specific polycyclic compounds.     

Effect of humic acids on physicochemical property and Cd(II) sorption of multiwalled carbon nanotubes

Zinc pyrithione is used as an antifouling agent. However, the environmental impacts of zinc pyrithione have recently been of concern. Zinc induces diverse actions during oxidative stress; therefore, we examined the effect of zinc pyrithione on rat thymocytes suffering from oxidative stress using appropriate fluorescent probes. The cytotoxicity of zinc pyrithione was not observed when the cells were incubated with 3 μM zinc pyrithione for 3 h. However, zinc pyrithione at nanomolar concentrations (10 nM or more) significantly increased the lethality of cells suffering from oxidative stress induced by 3 mM H₂O₂. The application of zinc pyrithione alone at nanomolar concentrations increased intracellular Zn²⁺ level and the cellular content of superoxide anions, and decreased the cellular content of nonprotein thiols. The simultaneous application of nanomolar zinc pyrithione and micromolar H₂O₂ synergistically increased the intracellular Zn²⁺ level. Therefore, zinc pyrithione at nanomolar concentrations may exert severe cytotoxic action on cells simultaneously exposed to chemicals that induce oxidative stress. If so, zinc pyrithione leaked from antifouling materials into surrounding environments would be a risk factor for aquatic ecosystems. Alternatively, zinc pyrithione under conditions of oxidative stress may become more potent antifouling ingredient.     

Optimization of photo-Fenton process parameters on carbofuran degradation using central composite design

Carbofuran, one of the most toxic and biorefractory carbamate compounds, is widely used in insecticides in Taiwan (9-18% of total insecticides production per year). In the present study, a central composite design experiment was used to study the effect of photo-Fenton treatment on carbofuran solution and to optimize the process variables such as carbofuran concentration (1-100 mg L(-1)), H(2)O(2) dosage rate (0.25-6 mg L(-1) min(-1)) and Fe(3+) dosage (1-50 mg L(-1)), which influenced the efficiency of carbofuran degradation and mineralization. The results indicated that all the variables investigated in this study had significant roles in the degradation and mineralization of carbofuran in solution. The carbofuran degradation and mineralization efficiencies were increased with increase in H(2)O(2) dosage rate and Fe(3+) dosage, and with decrease in carbofuran concentration. Furthermore, optimum values of both H(2)O(2) dosage rate and Fe(3+) dosage were found to shift to higher values as carbofuran concentration increased. Based on the model obtained in this study, optimum H(2)O(2) dosage rate and Fe(3+) dosage were found to be 4 mg L(-1) min(-1) and 20 mg L(-1), respectively, for 51 mg L(-1) of carbofuran concentration. Under these conditions, carbofuran was completely removed within 30 min and coupled with 78% mineralization at the end of experiment.     

环丁砜-哌嗪溶液吸收烟道气中二氧化碳

采用搅拌实验装置,研究环丁砜溶液及不同配比的环丁砜-PZ复合溶液对烟道气中二氧化碳的吸收和解吸性能,揭示了吸收容量与酸碱度、时间之间的内在联系,并对CO2初始逸出温度、试液再生温度、试液再生率、再生pH下降率进行了细致记录分析。实验结果表明,环丁砜-PZ复合溶液配比为0.4∶0.6时:吸收效果最佳,吸收量约为0.126 mol;再生温度最高,为105℃;再生率最高,为90.34%。同时与相同配比的MEA、DEA相比具有较大再生优势。实验结果还表明,环丁砜-PZ复合体系之间存在负交互作用。     

固定化白腐真菌反应器与接触氧化反应器联用处理癸二酸生产废水

采用固定化白腐真菌(WRF)反应器与接触氧化反应器联用处理癸二酸废水。在WRF反应器中,以汽曝玉米秸秆为载体,并添加铜、铁促进白腐真菌生长和产酶作用,载体的使用寿命约为45 d。在进水苯酚平均质量浓度为69.36 mg/L、平均进水COD为1 648.81 mg/L的条件下,经WRF反应器处理后,苯酚平均质量浓度降至7.59 mg/L,平均出水COD降至478.03 mg/L;再经接触氧化反应器处理后,苯酚平均质量浓度降至1.65 mg/L,平均出水COD降至297.31 mg/L。     

Measurement of the surface charge of ultrafine particles from laser printers and analysis of their electrostatic force

Ultrafine particles (UFPs) released from laser printers are electrostatically charged during the working processes of the devices, and the electrostatic force can obviously influence the dynamics of the particles. Due to the measurement difficulty and scarcity of relevant research, this issue was not reported. This study tried to address this issue through experimental measurement of the surface charge of UFPs and numerical investigation on the influence of electrostatic force on the dynamics of UFPs. A test chamber was set up to collect the UFPs, and the Scanning Electron Microscope was used to observe the morphologies of the UFPs. Based on the particle diameter and surface zeta potential, the surface charge of UFPs was calculated. The measurement results gave that particle emitted from laser printers are negatively charged and the average surface charge of particle emissions for four laser printers is in a range of about ?4.16 × 10^?17 to ?6.07 × 10^?17 C (～?260 to ?379 e). This paper also discussed the influence of electrostatic force on the dynamics of UFPs. According to the numerical investigation, it was found that, in the absence of electric field, the electrostatic force has to be considered when the surface charge is larger than 1 × 10^?16 C and when the UFP is very close to the wall with a distance of less than 0.01 m. These findings will guide constructively in predicting the dispersion and deposition of particles emitted from laser printers.     

Sensitivity of Portuguese forest fires to climatic, human, and landscape variables: subnational differences between fire drivers in extreme fire years and decadal averages

Within the changing fire regimes of Portugal, the relative importance of humans and climatic variability for regional fire statistics remains poorly understood. This work investigates the statistical relationship between temporal dynamics of fire events in Portugal and a set of socioeconomic, landscape, and climatic variables for the time periods of 1980–1990, 1991–2000, and extreme fires years. For 10 of 15 districts, it was possible to observe moderate shifts in the significance of fire drivers for the first two decadal periods. For others, pronounced changes of the significance of fire drivers were found across time. Results point toward a dynamic (perhaps highly non-linear) behavior of socioeconomic and landscape fire drivers, especially during the occurrence of extreme fire years of 2003 and 2005. At country level, population density alone explained 42% of the inter-annual and inter-district deviance in number of fires. At the same temporal and spatial scale, the explanatory power of temperature anomalies proved to explain 43% of area burnt. We highlight the necessity of including a broad set of socioeconomic and landscape fire drivers in order to account for potential significance shifts. In addition, although climate does trigger broad favorable fire conditions across Portugal mainland, socioeconomic and landscape factors proved to determine much of the complex fire patterns at a subnational scale.     

给水曝气生物滤池内置粉末活性炭复合净水效果的研究

在给水曝气生物滤池内置粉末活性炭,对比分析其对各工艺单元水质净化效果的影响,确定给水曝气生物滤池内置粉末活性炭的作用与最佳投加量,研究表明,给水曝气生物滤池将活性炭截留在滤池内,大幅度提高了粉末活性炭利用率,部分未饱和粉末活性炭通过反冲洗排入后续常规处理系统,作为生物载体仍能够进一步发挥生物强化作用。当粉末活性炭的投加量为8 mg/L时,砂滤出水氨氮、CODMn、浊度和色度均值分别为：0.02 mg/L,1.82 mg/L0,.46 NTU和6度,去除率分别达到99.6%、71.2%、99.1%和80.6%,出水指标达到《生活饮用水卫生标准（》GB5749-2006）和《饮用净水水质标准（》CJ94-2005）规定的标准。与常规工艺相比,投加量降低了20%～60%。