Qualitative and Quantitative Assessment of Hepatitis A Virus in Wastewaters in Tunisia

Hepatitis A causes substantial morbidity in both industrialized and non-industrialized countries and represents an important health problem in several southern Mediterranean countries. The objectives of the study were as follows: (a) to assess the occurrence of hepatitis A virus (HAV) in Tunisia through the monitoring of urban wastewaters collected at wastewater treatment plants (WTPs); (b) to characterize environmental strains; and (c) to estimate the viral load in raw and treated sewages, in order to evaluate the potential impact on superficial waters receiving discharges. A total of 150 raw and treated wastewaters were collected from three WTPs and analyzed by both qualitative (RT-PCR/nested) and quantitative (qRT-PCR) methods. Of these, 100 (66 %) were found to be positive for HAV by the qualitative assay: 68.3 % in influents and 64.7 % in effluents. The vast majority of HAV sequences belonged to sub-genotype IA, with 11 different strains detected found to be identical to clinical strains isolated from Tunisian patients with acute hepatitis. Five unique variants were also detected, not previously reported in clinical cases. Only two IB strains were found, confirming the rarity of this sub-genotype in this country. The results of the present study indicate a wide circulation of the pathogen in the population, most probably in the form of asymptomatic infections, a finding consistent with the classification of the country as having intermediate/high endemicity. Quantitative data showed high viral loads in influents (3.5E+05 genome copies/liter, mean value) as well as effluents (2.5E+05 genome copies/liter, mean value), suggesting that contaminated water could be a critical element in transmission.     

钙、氯对磷酸盐稳定污染土壤中铅的促进作用研究

为探讨促进磷酸盐稳定污染土壤中铅的方法,在全铅含量为517 mg·kg-1的铅冶炼污染土壤中加入5 mmol·kg-1磷酸盐,同时加入10mmol·kg-1硝酸钙或5 mmol·kg-1氯化钾,在15%或30%的含水率下培养40 d,之后种植黑麦草.结果表明,与单独施用磷酸盐相比,采用磷酸盐与钙、氯结合或增加培养期间的土壤含水率后,土壤DTPA-Pb含量下降3.92%~26.1%;对于同一添加剂处理,培养期间土壤含水率从15%增加到30%,土壤有效铅(DTPA-Pb)含量下降8.83%~24.4%.增加土壤含水率后,土壤有效磷(Olsen-P)含量均显著升高(p0.05).土壤铅的EXAFS分析表明,与未施用磷酸盐的对照相比,土壤中加入磷酸盐后矿物态铅的比例由57%上升至81%,加施钙、氯或增加土壤含水率后,多数处理矿物态铅的比例有所下降,而有机结合态铅比例上升.与对照相比,污染土壤中施用磷酸盐后,植物产量大幅增加,但施用钙、氯或增加培养期间含水率后,部分处理植物产量有所下降.以上结果表明,在铅冶炼污染土壤中加入磷酸盐时,加入钙、氯或者增加土壤含水率均有利于铅的稳定,但以上措施可能对植物生长产生不利影响.     

Alteration of dominant cyanobacteria in different bloom periods caused by abiotic factors and species interactions

Freshwater cyanobacterial blooms have drawn public attention because they threaten the safety of water resources and human health worldwide. Heavy cyanobacterial blooms outbreak in Lake Taihu in summer annually and vanish in other months. To find out the factors impacting the cyanobacterial blooms, the present study measured the physicochemical parameters of water and investigated the composition of microbial community using the 16S rRNA gene and internal transcribed spacer amplicon sequencing in the months with or without bloom. The most interesting finding is that two major cyanobacteria, Planktothrix and Microcystis, dramatically alternated during a cyanobacterial bloom in 2016, which is less mentioned in previous studies. When the temperature of the water began increasing in July, Planktothrix appeared first and showed as a superior competitor for M. aeruginosa in NO₃^?-rich conditions. Microcystis became the dominant genus when the water temperature increased further in August. Laboratory experiments confirmed the influence of temperature and the total dissolved nitrogen (TDN) form on the growth of Planktothrix and Microcystis in a co-culture system. Besides, species interactions between cyanobacteria and non-cyanobacterial microorganisms, especially the prokaryotes, also played a key role in the alteration of Planktothrix and Microcystis. The present study exhibited the alteration of two dominant cyanobacteria in the different bloom periods caused by the temperature, TDN forms as well as the species interactions. These results helped the better understanding of cyanobacterial blooms and the factors which contribute to them.     

Production of new concrete with leather tannery waste used as partial replacement of the natural sand

Journal of Material Cycles and Waste Management - Leather production is a technology that boosts the economy because of its versatility and durability. However, the wastes generated throughout the...     

Face mask and medical waste generation in the City of Baguio,Philippines: its current management and GHG footprint

Journal of Material Cycles and Waste Management - The daily use of facemask to prevent virus transmission increases the negative effect on the environment because of improper waste disposal. Due to...     

Effect of humic substances on the precipitation of calcium phosphate

For phosphorus （P） recovery from wastewater, the effect of humic substances （HS） on the precipitation of calcium phosphate was studied. Batch experiments of calcium phosphate precipitation were undertaken with synthetic water that contained 20 mg/L phosphate （as P） and 20 mg/L HS （as dissolved organic carbon, DOC） at a constant pH value in the range of 8.0-10.0. The concentration variations of phosphate, calcium （Ca） and HS were measured in the precipitation process; the crystalline state and compositions of the precipitates were analysed by powder X-ray diffraction （XRD） and chemical methods, respectively. It showed that at solution pH 8.0, the precipitation rate and removal efficiency of phosphate were greatly reduced by HS, but at solution pH ≥9.0, the effect of HS was very small. The Ca consumption for the precipitation of phosphate increased when HS was added; HS was also removed from solution with the precipitation of calcium phosphate. At solution pH 8.0 and HS concentrations ≤3.5 mg/L, and at pH ≥ 9.0 and HS concentrations ≤ 10 mg/L, the final precipitates were proved to be hydroxyapatite （HAP） by XRD. The increases of solution pH value and initial Ca/P ratio helped reduce the influence of HS on the precipitation of phosphate.     

Changes in the Distribution of Broadleaf Tree Species in the Central Part of the Southern Urals since the 1970s

Russian Journal of Ecology - Changes in the distribution of broadleaf tree species—Tilia cordata Mill., Quercus robur L., Acer platanoides L., and Ulmus glabra Huds.—in the central part...     

Backwater Confluences of the Ohio River: Organic and Inorganic Fingerprints Explain Sediment Dynamics in Wetlands and Marinas

In the Ohio River (OR), backwater confluence sedimentation dynamics are understudied, however, these river features are expected to be influential on the system’s ecological and economic function when integrated along the river’s length. In the following paper, we test the efficacy of organic and inorganic tracers for sediment fingerprinting in backwater confluences; we use fingerprinting results to evidence sediment dynamics controlling deposition patterns in confluences used for wetland and marina functions; and we quantify the spatial extent of tributary drainages with wetland and marina features in OR confluences. Both organic and inorganic tracers statistically differentiate sediment from stream and river end‐members. Carbon and nitrogen stable isotopes produce greater uncertainty in fingerprinting results than inorganic elemental tracers. Uncertainty analysis of the nonconservative tracer term in the organic matter fingerprinting application estimates an apparent enrichment of the carbon stable isotopes during instream residence, and the nonconservativeness is quantified with a statistical approach unique to the fingerprinting literature. Wetland and marina features in OR confluences impact 42% and 11% of tributary drainage areas, respectively. Sediment dynamics show wetland and marina confluences experience deposition from river backwaters with longitudinally linear and nonlinear patterns, respectively, from sediment sources.     

Ultrafine particles at workplaces of a primary aluminium smelter

The number concentration and size distribution of ultrafine particles in a S?derberg and a prebake potroom of an aluminium primary smelter have been measured using a scanning mobility particle spectrometer. The particle morphology was studied by transmission electron microscopy (TEM). The study shows the existence of elevated number concentrations of ultrafine particles in both potrooms. The main source of these particles is likely to be the process of anode changing. The ultrafine particles were measured directly at the source but could also be identified as episodes of high number concentrations in the general background air. Unlike the larger particles belonging to the 50-100 nm mode, the nanoparticle mode could not be detected in the TEM indicating that they may not be stable under the applied sampling conditions and/or the high vacuum in the instrument.     

Bioaerosol sampling by a personal rotating cup sampler CIP 10-M

High concentrations of bioaerosols containing bacterial, fungal and biotoxinic matter are encountered in many workplaces, e.g. solid waste treatment plants, waste water treatment plants and sewage networks. A personal bioaerosol sampler, the CIP 10-M (M-microbiologic), has been developed to measure worker exposure to airborne biological agents. This sampler is battery operated; it is light and easy to wear and offers full work shift autonomy. It can sample much higher concentrations than biological impactors and limits the mechanical stress on the microorganisms. Biological particles are collected in 2 ml of liquid medium inside a rotating cup fitted with radial vanes to maintain an air flow rate of 10 l min(-1) at a rotational speed of approximately 7,000 rpm. The rotating cup is made of sterilisable material. The sampled particles follow a helicoidal trajectory as they are pushed to the surface of the liquid by centrifugal force, which creates a thin vertical liquid layer. Sterile water or another collecting liquid can be used. Three particle size selectors allow health-related aerosol fractions to be sampled according to international conventions. The sampled microbiological particles can be easily recovered for counting, incubation or further biochemical analysis, e.g., for airborne endotoxins. Its physical sampling efficiency was laboratory tested and field trials were carried out in industrial waste management conditions. The results indicate satisfactory collection efficiency, whilst experimental application has demonstrated the usefulness of the CIP 10-M personal sampler for individual bioaerosol exposure monitoring.