三元乙丙橡胶超细纤维复合膜的制备及其截留性能

以四氢呋喃和N,N-二甲基甲酰胺为溶剂,配制三元乙丙橡胶(EPDM)纺丝液,通过静电纺丝技术制备了EPDM超细纤维,进而以聚偏氟乙烯(PVDF)微滤膜为基膜制备了EPDM超细纤维复合膜。采用红外光谱(FTIR)和扫描电子显微镜(SEM)对EPDM超细纤维的结构和形态进行了表征。考察了复合膜对苯乙烯废水的截留效果和复合膜通量的变化情况。实验结果表明:EPDM超细纤维具有类似无纺布形式的多孔纤维网状结构,其直径在0.2~2.0μm之间;复合膜在操作压力为0.1MPa的条件下,处理质量浓度为100μg/mL的模拟苯乙烯废水,膜通量约为5.90mL/(cm2.h),苯乙烯去除率可达89.7%。     

Properties of alkali-activated systems with stone powder sludge

This article investigates the effects of stone powder sludge on the microstructure and strength development of alkali-activated fly ash and blast furnace slag mixes. Stone powder sludge produced from a crushed aggregate factory was used to replace fly ash and granulated blast furnace slag at replacement ratios of 0%, 10%, 20%, and 30% by mass. The unit weight and compressive strength of the samples were measured, and scanning electron microscopy/energy dispersive spectroscopy and X-ray diffraction (XRD) analyses were performed. The test results indicated that the compressive strength of alkali-activated blast furnace slag mixes using stone powder sludge was higher than that of the alkali-activated blast furnace slag control mix, but the compressive strength of alkali-activated fly ash mixes decreased with increasing replacement ratio of stone powder sludge. Microscopy results indicated that for alkaliactivated blast furnace slag samples, broken surfaces were more evident than for the alkali-activated fly ash samples. For all XRD diagrams, broad and diffuse peaks were observed around 2θ = 35° (d = 2.96–3.03 Å), implying amorphous or short-ordering structure phases.     

城市总体规划环评指标体系的建立及其应用

本研究首先介绍了DPSIR模型构建的原理,接着以合肥市为对象,从驱动力、压力、状态、影响、响应5个方面来构建的共36个指标,并采用层次分析法对指标权重的确定和多级灰色关联分析对指标进行综合评价,得出评价结果。合肥市在2004~2005年处于较低可持续发展水平(0.3398、0.3876)、在2010年处于中等可持续发展水平(0.5369)、在2015年处于较高可持续发展水平(0.6016)、在2020年处于较高可持续发展水平(0.7847),该预测评价结果与合肥市城市可持续发展趋势相符。最后采用改进熵值法验证多级灰色关联综合分析结论,计算得出的结果表明,该两种方法评价结论基本相同。因此,本研究对城市总体规划环境影响评价的评价方法的建立与完善,有着较强的实践意义和参考价值。     

提高油田伴生气回收率的研究与应用

文章阐述了陆梁油田在开发过程中采用油气混输技术、天然气发电机橇技术、锅炉烧湿气等技术,将伴生气回收率提高至92.10%;油气混输技术能够实现边缘区块油气全密闭输送;集中处理站锅炉燃烧湿气技术可增加处理站天然气外输气量,降低运行成本;小型活动天然气发电机橇的应用,可以充分利用富裕天然气降低生产成本,同时减少富裕天然气火炬放空燃烧量,收到了良好的经济效益和环境效益。     

Solid phase extraction with pyrenebutyric acid-bonded silica for analysis of polychlorinated biphenyls in sewage water by gas chromatography-mass spectrometry

A solid phase extraction (SPE) method using pyrenebutyric acid-bonded silica (PYB) as sorbent was developed to determine 23 polychlorinated biphenyls (PCBs) in sewage water by gas chromatography-mass spectrometry (GC-MS). Factors were optimized in SPE procedures including elution solvent, pH, and cartridge burden. The recoveries of 23 PCB congeners were 69.44-111.91% under optimized conditions. Comparisons were also conducted among PYB-SPE, C(18)-SPE and United States Environmental Protection Agency 608 (USEPA608) methods in the analysis of PCBs in sewage water samples. The results showed that the performance of PYB-SPE method was similar with USEPA608 method and better than C(18)-SPE method. Both PYB-SPE and USEPA608 methods were then employed to analyze PCBs in real spiked sewage water samples. The recoveries of PCB congeners determined by PYB-SPE method ranged from 70.6% to 92.4% in real spiked sewage water samples which were identified to be in accordance with USEPA608 method. Limits of detection (LOD) were in the range of 0.06-0.22ngL(-1) for PCB congeners. The optimized PYB-SPE method was successfully applied to the determination of PCBs in sewage water samples.     

Optimum conditions for microbial carbonate precipitation

The type of bacteria, bacterial cell concentration, initial urea concentration, reaction temperature, the initial Ca(2+) concentration, ionic strength, and the pH of the media are some factors that control the activity of the urease enzyme, and may have a significant impact on microbial carbonate precipitation (MCP). Factorial experiments were designed based on these factors to determine the optimum conditions that take into consideration economic advantage while at the same time giving quality results. Sporosarcina pasteurii strain ATCC 11859 was used at constant temperature (25°C) and ionic strength with varying amounts of urea, Ca(2+), and bacterial cell concentration. The results indicate that the rate of ureolysis (k(urea)) increases with bacterial cell concentration, and the bacterial cell concentration had a greater influence on k(urea) than initial urea concentration. At 25 mM Ca(2+) concentration, increasing bacterial cell concentration from 10(6) to 10(8)cells mL?1 increased the CaCO(3) precipitated and CO(2) sequestrated by over 30%. However, when the Ca(2+) concentration was increased 10-fold to 250 mM Ca(2+), the amount of CaCO(3) precipitated and CO(2) sequestrated increased by over 100% irrespective of initial urea concentration. Consequently, the optimum conditions for MCP under our experimental conditions were 666 mM urea and 250 mM Ca(2+) at 2.3×10? cells mL?1 bacterial cell concentration. However, a greater CaCO(3) deposition is achievable with higher concentrations of urea, Ca(2+), and bacterial cells so long as the respective quantities are within their economic advantage. X-ray Diffraction, Scanning Electron Microscopy and Energy Dispersive X-ray analyzes confirmed that the precipitate formed was CaCO(3) and composed of predominantly calcite crystals with little vaterite crystals.     

Persistent organic pollutants and heavy metals in adipose tissues of patients with uterine leiomyomas and the association of these pollutants with seafood diet, BMI, and age

Background, aim, and scope  

Persistent organic pollutants and heavy metals can cause diseases in women, however, the relationships of these pollutants and uterine leiomyomas (UL), which are non-cancerous tumors of the uterus, are unclear. This study focused on the quantification of organochlorine pesticides (OCPs), polychlorinated biphenyls (PCBs), polycyclic aromatic hydrocarbons (PAHs), polybrominated diphenyl ethers (PBDEs), and heavy metals in subcutaneous and visceral fat obtained from patients with UL and in subcutaneous fat of a control group of women without UL to determine if there were any correlations between concentrations of persistent organic pollutants (POPs) and heavy metals and the incidence of UL.     

4A沸石去除水中Pb2＋的研究

在静态条件下,研究了4A沸石对废水中Pb2＋的吸附性能,并探讨了影响吸附的因素。实验表明：当温度为30℃,废水pH为5～6,0．01g4A沸石对100mg／LPb2＋溶液10mL吸附20min,Pb2＋的去除率可达到99％以上。在实验研究条件下,4A沸石对Pb2＋的吸附符合Langmuir和Freundlich等温吸附方程,相关系数为0．9819和0．9998。经计算,4A沸石对Pb2＋的饱和吸附量为125mg／g。4A沸石吸附水中Pb2＋达到吸附平衡的时间较短;溶液pH值的变化对吸附效果影响不显著;温度从室温略微升高,Pb2＋的去除率略有增大。吸附在4A沸石上的Pb“可回收利用,处理后的4A沸石可以再生,且重复使用性能较好。     

生产者责任延伸制与电子废弃物管理——环境法规

日益增加的固体废弃物和工业废弃物已成为主要的社会问题。回收服务相对来说还很不足,导致很多废弃物只能进行简单的填埋、焚烧处理。这将导致严重的环境污染。借鉴国外一些发达国家废物管理领域的政策趋势,我国近年来出台了一系列关于电子废弃物管理的政策法规,但也暴露出正规的废物处理企业无法取得规模收益,入不敷出,电子废弃物处理基金的征收及补贴对象不明确等诸多问题。引入生产者责任延伸制将外部影响内部化,在理念和功能等方面适应了电子废弃物管理的需要。     

钢渣吸附处理苯酚废水的研究

采用恒温振荡的方法,考察了钢渣粒径、吸附温度、振荡速度、溶液pH值、溶液初始浓度对苯酚去除率的影响。结果表明,在粒径为120~180目、pH=4.0、苯酚溶液浓度在500 mg/L以内、苯酚/钢渣质量比为1∶1 000时吸附效果最好。钢渣对苯酚的吸附能较好地符合Langmuir和Freundlich吸附等温线,线性相关系数分别为0.9971和0.9916,吸附机理为表面吸附。