鄂尔多斯节能减排现状及建议

鄂尔多斯作为典型资源型城市,资源性产业在国民经济中长期占据主导地位,因此节能减排任务十分艰巨。本文分析总结了“十一五”以来鄂尔多斯市节能减排取得的成效及采取的主要措施,并在此基础上提出了几点建议。     

Spatiotemporal evolution of soil pH and zinc after the Aznalcollar mine spill

The residual pollution after the Aznalcóllar (southwestern Spain) pyrite mine spill is still a threat due to the continuing oxidation of sulfuric minerals. The objective of this paper was to analyze the combined effect of pyrite oxidation, sugar beet foam applications, and meteorological conditions on the spatiotemporal evolution of the pH and EDTA-extractable Zn concentration, using non co-located data from 11 sampling dates between June 1999 and March 2002. Median pH values ranged from 4.4 at the beginning of the monitoring period to 7.6 at the end, although values near 2.5 were observed throughout the entire period, despite of two sugar beet foam (SBF) applications. Zinc distributions were positively skewed and median concentrations ranged from 17 to 94 mg kg(-1). The inverse relationship between pH and Zn became weaker toward the end of the monitoring period as a consequence of the precipitation and posterior dissolution of newly formed minerals from the reaction products of the pyrite oxidation. Normal score maps showed that after the SBF applications only 0.5% of the monitored area was below the pH = 4 threshold, while on other dates up to one-third of the area remained below this value. The better performance of the second SBF application could be explained in terms of pyrite oxidation pathways and environmental conditions. From this analysis, with data obtained under uncontrolled field conditions, it is concluded that SBF should be applied before or during the wet and cold season to alleviate acidification, caused by the oxidation of pyrite or other sulfuric minerals.     

活性炭纤维对氯仿气体动态吸附的研究

为了探讨活性炭纤维(ACF)对氯仿有机废气的动态吸附,考察氯仿气体流速、浓度、温度、ACF再生次数对吸附效率的影响以及滤速和压降的关系。结果表明:低浓度、低流速、低温度均有利于吸附。ACF对氯仿的吸附以物理吸附为主。提高氯仿气体滤速,气体压降增大。     

Heterogeneous uptake of octamethylcyclotetrasiloxane (D4) and decamethylcyclopentasiloxane (D5) onto mineral dust aerosol under variable RH conditions

We have carried out kinetic studies to characterize the heterogeneous decay of octamethylcyclotetrasiloxane (D₄) and decamethylcyclopentasiloxane (D₅) in the presence of representative mineral dust aerosol in order to obtain a better understanding of the atmospheric fate of these siloxanes. The heterogeneous chemistry of D₄ and D₅ with various mineral dusts was studied in an environmental aerosol reaction chamber using FTIR absorption spectroscopy to monitor the reaction. The apparent heterogeneous uptake coefficient, γ_app, for D₄ and D₅ with various mineral dusts was measured under dry conditions and as a function of relative humidity (RH). In addition, the effect of initial D₄ and D₅ concentration on the rate and yield of the reaction was examined. The uptake coefficient, γ_app, for D₄ and D₅ was similar for the most reactive aerosols tested, with kaolinite ≈hematite > silica. Limited uptake onto carbon black and calcite surfaces was observed for either siloxane. Reaction with hematite and kaolinite resulted in multilayer coverages, suggesting extensive polymerization of D₄ and D₅ on the aerosol surface.     

CAST工艺处理低C/N生活污水的强化脱氮性能

研究了不同运行条件对CAST工艺处理低C/N实际生活污水脱氮性能的影响,并对pH值和ORP的变化规律进行了分析。结果表明,传统4 h运行模式下,提高原水C/N比,TN去除效果并无显著提高;对于低C/N生活污水,降低充水比有利于提高出水TN去除率,然而,充水比降至16%时,系统因低负荷运行发生污泥膨胀。在不投加外碳源的情况下,采用分段进水交替A/O运行模式可大幅改善系统脱氮性能,且TN去除率随着交替次数的增多而提高,交替4次平均去除率达87.23%。系统采用实时控制方式运行时,可根据有机物降解、氨氧化及反硝化时pH值和ORP曲线上是否出现拐点,来判断反应系统的曝气以及搅拌时间是否过长、适当或不足。     

污泥膨胀状态下原生动物群落结构分析

系统研究了丝状菌膨胀与非丝状菌膨胀2种典型污泥状态下原生动物的群落结构特征及其演变规律。伴随丝状菌的大量增殖,原生动物总量相应减少,匍匐型纤毛虫及有壳类肉足虫数量迅速上升,占据明显的优势地位,典型原生动物为斜管虫（Chilodonella sp.）、小轮毛虫（Trochilia minuta）以及匣壳虫（Centropyxis sp.）;非丝状菌污泥膨胀对原生动物总量及种群结构影响较小,伴随粘性菌胶团的大量出现,各功能类群的比例变化较小,但原生动物总量持续增加,其中菌食性纤毛虫呈线性增加,典型原生动物为钟虫（Vorticella sp.）。     

壳聚糖衍生物-镁盐复配去除中性兰模拟废水色度的研究

研究了有机高分子絮凝剂NCTS-M对中性兰染料的絮凝性能。通过测量絮体的Zeta电位以及对絮体进行彩色电视显微扫描初步探讨了该絮凝过程的絮凝机理。结果表明,当投加量为30 mg/L,pH=6时,絮凝效果最明显,脱色率可达93.1%。其絮凝机理主要是压缩双电层以及高分子吸附架桥作用,以压缩双电层为基础。絮凝剂中镁离子在中性条件下对絮凝过程也起到了较强的助凝作用。     

Determination of direct and fugitive PM emissions in a Mediterranean harbour by means of classic and novel tracer methods

Remodelling works are frequent in harbour areas, given that they must adapt to rapidly changing market requirements. Depending on their nature (construction, demolition, etc.), these works may be carried out during long periods of time and thus exert a significant impact on the air quality at the harbours and their surroundings. The air quality at the Valencia harbour was studied during an enlargement project. Four sampling stations aimed to cover the major dust-emitting activities in the harbour. In addition, a sampling campaign was carried out to collect dust materials at their emission sources (e.g., loading and unloading of clinker and petroleum coke, as well as the enlargement works). Differences obtained between PM levels at the monitoring sites were correlated with the distance between sampling stations and enlargement works and/or harbour operations, as well as with the preferential wind direction. In all cases, the days with the highest PM_10 levels were linked to wind directions coinciding with the location of the enlargement works or the clinker and petroleum coke stocks. Classic source apportionment methodologies (PCA and CMB) were applied to the data, but their interpretation was complex due to the similar chemical signatures of PM originating from direct and fugitive emissions from stocked materials (e.g., clinker), and the enlargement works. To overcome this difficulty, a novel non-statistical approach was used to obtain quantitative estimations of the contributions from sources (petroleum coke and clinker), based on the correlation between specific PM components (e.g., carbonaceous species) and source tracers (e.g., V). Finally, a qualitative test using phenolphthalein was devised to identify the presence of clinker on the filters, which provided positive results. This novel tracer approach is thus recommended for harbour authorities.     

四氯化钛精制除钒废弃物的综合利用

对四氯化钛铜丝除钒精制过程中产生的废弃物,采用酸碱联合法回收其中的铜和钒。考察了关键的碱处理及盐酸沉钒过程的影响因素。实验结果为：在碱处理溶液pH12．0—13．0,碱处理温度60℃,碱处理时间1h,沉钒溶液pH1．0～1．5,沉钒温度60℃,沉钒时间1h的条件下,铜和钒的回收率分别达到90％和75％以匕,获得的阴极铜和五氧化二钒的产品质量均达到国家标准。     

自动喷水灭火系统喷水强度概率分布特性及其控火性能研究

喷水强度是体现自动喷水灭火系统控火能力的重要参数,具有不均匀性和不确定性.传统的喷水强度设计主要考虑喷头的流量和保护面积,没有考虑其分布特性,对系统控火性能的影响.因此本文将喷水强度分布特性引入自动喷水灭火系统的控火性能研究.以公称口径为15 mm的传统下垂型玻璃球洒水喷头的喷水强度分布实验为基础,建立了包含径向距离和喷头工作压力等参数的喷水强度分布模型,采用蒙特卡罗方法获得了喷水强度的概率分布特性.参照不同危险等级场控火所需的喷水强度参数和不同喷头开启个数下的有效控火百分比,分析了喷水强度概率分布特性对控火性能的影响.研究结果表明,喷水强度概率分布特性对控火性能有重要影响,随径向距离的增加,喷水强度出现较小值的概率增大,控火性能下降,在某些危险较大的场所不能达到控火作用.对于同一危险等级场所,控火性能随着喷头安装间距减小而增强.研究方法可为合理评估喷头适用范围、优化喷头布置提供参考.