可见光响应型CuO/BiVO4的光催化活性研究

采用浸渍法制备了CuO/BiVO4光催化剂,通过X射线衍射(XRD)、热重/差示扫描量热(TG/DSC)和傅立叶红外光谱(FTIR)对其进行了表征,并在可见光照射下考察了其光催化氧化亚甲基蓝(MB)的动力学特性。结果表明,Cu的掺杂并未改变BiVO4的晶型结构;Cu(NO3)2/BiVO4在热处理(30～300℃)过程中,NO3-已经完全分解,Cu最终以CuO的形式存在于CuO/BiVO4光催化剂体系中;掺杂不同量Cu的CuO/BiVO4中的Cu2+/Bi+(摩尔比)实测值与理论值相近,该系列光催化剂的合成过程具有较高的可信度;在可见光照射下,CuO/BiVO4光催化降解MB反应符合表观一级反应动力学特征;当Cu2+/Bi+为0.050时,反应动力学速率常数(k)达到最高值(0.4334h-1),此时的k比单体BiVO4作用下的提高了1.04倍;由于异质结的存在,CuO/BiVO4与单体BiVO4相比,电子和空穴的利用率大大增加,使得CuO/BiVO4的光催化活性较单体BiVO4有了大幅度提高。     

臭氧氧化法深度处理纤维板生产废水的研究

采用臭氧氧化法深度处理纤维板生产废水,探讨了臭氧投加量以及反应时间对COD和色度去除的影响,得到了最佳的工艺参数,并分析了这种处理方法的经济性。结果表明,当臭氧投加量为180mg/L、反应时间为30min时,纤维板生产废水的COD、色度去除率分别为58.3%、98.3%。采用臭氧氧化法深度处理纤维素废水的投资成本为600～700元/t,运行成本为0.8～1.2元/t,较Fenton氧化处理方法而言,在处理效率和经济成本上具有较大优势。     

On-road traffic emissions in a megacity

A new annual bottom–up emission inventory of criteria pollutants and greenhouse gases from on-road mobile sources was developed for 2006 for the metropolitan area of Buenos Aires, Argentina, within a four-year regional project aimed at providing tools for chemical weather forecast in South America. Under the scarcity of local emission factors, we collected data from measuring campaigns performed in Argentina, Brazil, Chile and Colombia and compiled a data set of regional emission factors representative of Latin American fleets and driving conditions. The estimated emissions were validated with respect to downscaled national estimates and the EDGAR global emission database. Our results highlight the role of older technologies accounting in average for almost 80% of the emissions of all species. The area exhibits higher specific emissions than developed countries, with figures two times higher for criteria pollutants. We analyzed the effect on emissions of replacing gasoline by compressed natural gas, occurring in Argentina since 1995. We identified (i) a relationship between number of vehicles and a compound socioeconomic indicator, and (ii) time-lags in vehicle technologies between developed and developing countries, which can be respectively applied for spatial disaggregation and the development of projections for other Latin American cities. The results may also be employed to complement global emission inventories and by local policy makers as an environmental management tool.     

Relation between management's behavioural intentions toward the environment and environmental actions

Drawing on Ajzen's Theory of Planned Behaviour, this paper analyses whether there is a relation between management's behavioural intentions toward an environmental problem and the company's specific actions in this area, and also considers the impact of the company size on these actions. For the data, a questionnaire was sent to 184 managers employed in industrial companies located in Spain which belonged to the automobile industry. The empirical analysis produces positive and significant regression coefficients and provides support for the hypotheses proposed. Specifically, the results show that the environmental actions carried out in the company respond at least in part to management's behavioural intentions toward these issues and the size of the firm.     

Scale-up of electrochemical oxidation system for treatment of produced water generated by Brazilian petrochemical industry

Scale-up of anodic oxidation system is critical to the practical application of electrochemical treatment in bio-refractory organic wastewater treatment. In this study, the scale-up of electrochemical flow system was investigated by treating petrochemical wastewater using platinized titanium (Ti/Pt) and boron-doped diamond (BDD) anodes. It was demonstrated that flow cell was successfully scaled-up because when it was compared with batch mode (Rocha et al. 2012b), higher performances on organic matter removal were achieved. Under the suitable operating conditions and better anode material, the chemical oxygen demand (COD) of petrochemical wastewater was reduced from 2,746 to 200 mg L^?1 within 5 h with an energy consumption of only 56.2 kWh m^?3 in the scaled-up BDD anode system. These results demonstrate that anode flow system is very promising in practical bio-refractory organic wastewater treatment.     

煤粉炉掺烧干化污泥的污染物排放研究

结合某电厂420 t/h四角煤粉炉掺烧污泥项目的实验室分析测试,了解煤粉掺烧不同含水率不同比例的干化污泥条件下烟气中污染物和灰渣中重金属的排放特性。结果表明,在实验研究配比和燃烧的条件下,大部分重金属元素Pb、Cu、Cr和Ni残留在灰渣中,Zn、Cd部分残留在灰渣中,As、Hg和Se等易挥发元素释放到烟气中,在灰渣中的含量很小。掺烧污泥后,灰渣中的重金属含量较单烧单煤都有了一定幅度的升高,Zn的含量是单煤的2倍,其余重金属是单煤的1.1~1.2倍。3种不同的掺混比例之间的污染气体排放浓度基本相似。烟气中主要污染物及重金属浓度可以满足现行国家标准。与单烧单煤相比,CO、HCl以及其他有机气体排放浓度基本相同;NH3的排放浓度较单煤有所升高;SO2、NOx和CO2排放浓度略有降低;飞灰浓度有所升高。烟气中的重金属,Hg含量升高了30%,Pb含量约为单煤的4.3~4.8倍。以上研究结果可为环保达标和飞灰利用提供基础数据。     

江汉平原土地利用对钉螺分布的影响研究

分析了江汉平原2009年易于钉螺孳生的3种土地利用类型（滩地、河渠和水田）比例与钉螺密度的关系。首先,在ERDAS9.2和ENVI4.7软件中对江汉平原2009年的Landsat5TM遥感影像进行了预处理。在已有的多期土地利用数据的基础上,借助eCognition软件利用向量相似度指标来提取土地利用变化区域,结合目视解译经验并运用遥感指标通过建立规则集对变化区域进行分类,将变化区域的分类结果更新2000年数据,得到了该区域2009年的土地利用数据。接下来,整理了江汉平原2009年螺情资料并计算出村级钉螺平均密度,绘制了2009年钉螺分布图。将绘制的钉螺分布图与土地利用分类图叠置分析,并结合收集的螺情数据确定了钉螺易于孳生的3种土地利用类型,分别为滩地、河渠和水田。最后,将钉螺密度与这3种土地利用比例进行线性回归分析。研究结果表明,钉螺密度与这三种土地利用类型比例存在线性回归关系,模型精度为R2=0857。该结论对通过遥感影像来估算钉螺密度具有指导意义,另外也可以为湖北省提出合理用地和灭螺并重的土地利用模式提供一定的科学参考     

Mechanical and toxicological evaluation of concrete artifacts containing waste foundry sand

The creation of metal parts via casting uses molds that are generally made from sand and phenolic resin. The waste generated after the casting process is called waste foundry sand (WFS). Depending on the mold composition and the casting process, WFS can contain substances that prevent its direct emission to the environment. In Brazil, this waste is classified according to the Standard ABNT NBR 10004:2004 as a waste Class II (Non-Inert). The recycling of this waste is limited because its characteristics change significantly after use. Although the use (or reuse) of this byproduct in civil construction is a technically feasible alternative, its effects must be evaluated, especially from mechanical and environmental points of view. Thus, the objective of this study is to investigate the effect of the use of WFS in the manufacture of cement artifacts, such as masonry blocks for walls, structural masonry blocks, and paving blocks. Blocks containing different concentrations of WFS (up to 75% by weight) were produced and evaluated using compressive strength tests (35 MPa at 28 days) and toxicity tests on Daphnia magna, Allium cepa (onion root), and Eisenia foetida (earthworm). The results showed that there was not a considerable reduction in the compressive strength, with values of 35 ± 2 MPa at 28 days. The toxicity study with the material obtained from leaching did not significantly interfere with the development of D. magna and E. foetida, but the growth of the A. cepa species was reduced. The study showed that the use of this waste in the production of concrete blocks is feasible from both mechanical and environmental points of view.     

Copper distribution in surface and subsurface soil horizons

The horizons of four natural soils were treated with Cu²⁺ in an acid medium to study the retention capacity of Cu. The possible mineralogical changes arising because of the treatment were also studied. The soil properties and characteristics with the greatest influence on the metal retention and its distribution among the different soil fractions were determined. Crystalline phases of each horizon were determined by X-ray diffraction (XDR). The morphology, structural distribution and particle chemical composition of soil samples were investigated using field emission scanning electron microscopy. Cu distribution in the different geochemical phases of the soil was studied using a sequential extraction. The treatment led to an increase in the amorphous phases and the formation of new crystalline phases, such as rouaite (Cu₂(NO₃)(OH)₃) and nitratine (NaNO₃). Cu was also found superficially sorbed on amorphous hydroxy compounds of Fe that interact with albite, muscovite and gibbsite, and also on spherical and curved particles of aluminium clays. The largest amount of Cu retained was in an exchangeable form, and the smallest amount associated with the crystalline Fe oxides and residual fraction. In the surface horizons, the predominant Cu retention process is complexation in organomineral associations, while in the subsurface horizons it is adsorption.