Decomposition pathways and reaction intermediate formation of the purified, hydrolyzed azo reactive dye C.I. Reactive Red 120 during ozonation

In this study, an aqueous solution of purified, hydrolyzed C.I. Reactive Red 120 (RR 120, Color Index), was selected as a model to investigate the degradation pathways and to obtain additional information on the reaction intermediate formation. The dye was purified to avoid the influence of the impurities on the ozonation process and on the formation of oxidation by-products. To simulate the dye-bath effluents from dyeing processes with azo reactive dyes, a hydrolyzed form of the dye was chosen as a representative compound. High performance liquid chromatography/mass spectrometry and its tandem mass spectrometry was chosen to identify the decomposition pathways and reaction intermediate formation during the ozonation process. In addition total organic carbon and high performance ion chromatography analysis were employed to obtain further information on the reaction processes during ozonation. Purified, hydrolyzed RR 120 was decomposed under the direct nucleophilic attack by ozone resulting in oxidation and cleavage of azo group and aromatic ring, while the triazine group still remained in the solution even after prolonged oxidation time (120 min) due to its high resistance to ozonation. Phenol, 1,2-dihydroxysulfobezene, 1-hydroxysulfonbezene were detected as the degradation intermediates, which were further oxidized by O(3) and *OH to other open-ring products and then eventually led to simple oxalic and formic acid identified by HPIC.     

Determination of Nitrobenzene in Wastewater Using a Hanging Mercury Drop Electrode

The determination of trace amount nitrobenzene in wastewater on a hanging mercury drop electrode was studied. The determination conditions of pH, supporting electrolyte, accumulation potential, accumulation time, and voltammetric response were optimized. The sharp peak of the nitrobenzene was appeared at 0.05 V. The peak electric current was proportional to the concentration of nitrobenzene in the range of 1.47 × 10⁻⁵ ∼ 1.0 × 10⁻³ mol/l with relative standard deviations of 3.99 ∼ 8.94%. The detection limit of the nitrobenzene in water was 5 × 10⁻⁶ mol/l. The proposed method offered low limit of determination, easy operation, the use of simple instrumentation, high sensitivity and good reproducibility. It was applied to the determination of nitrobenzene in wastewater with an average recovery of 94.0% ∼ 105%. The proposed method provided fast, sensitive and sometimes real time detection of nitrobenzene.     

氟里昂12(CCl2F2)燃烧分解催化剂性能的研究

本文对贵金属、氧化物和复合氧化物体系催化剂上氟里昂_(12)(F_(12))燃烧分解反应进行了活性评价和稳定性研究.结果表明:TiO_2,ZrO_2/TiO_2催化剂对氟里昂_(12)燃烧分解反应具有良好的低温催化活性和较好的稳定性,ZrO_2/TiO_2催化剂具有一定的臭氧-催化氧化活性     

河流型饮用水水源保护区划分比较

比较分析了国内外河流型水源保护区划分的原则、方法和标准,例证了我国不同省份的划分实践。指出,我国各省多采用经验值划分水源保护区范围,部分省份划分方案久未更新,没有充分发挥保护区的作用。提出,应进一步细化水源保护区划分规范指导要求,及时修订省级水源保护区划分方案,并借鉴国外水源保护区划分经验,通过调整水质标准、重视公众参与、利用地理信息系统等方式划分水源保护区,从源头上预防水源污染,降低饮用水公共风险,保障饮用水安全。     

MoS_2/Bi_2S_3异质结光催化剂的制备及其光催化性能

以五水硝酸铋为铋源、钼酸钠为钼源、硫脲为硫源,采用简单的一步水热法合成了MoS_2/Bi_2S_3异质结光催化剂,采用XRD,SEM,TEM,BET,UV-Vis DRS技术对其进行了表征。表征结果显示,MoS_2纳米片在Bi_2S_3微棒表面生长,增加了比表面积和活性位点,并形成异质结构,促进了光生载流子的迁移,抑制了电子-空穴对的再复合。实验结果表明:钼酸钠与五水硝酸铋的质量比为1∶2时制备的复合光催化剂性能最好,反应180min时对亚甲基蓝的去除率可达96.4%,明显高于MoS_2和Bi_2S_3,且具有较高的稳定性;该催化剂对罗丹明B、甲基橙和4-硝基苯酚的去除率分别为97.1%、93.1%和90.5%,表明其对污染物具有普适性。     

以聚己内酯作为生物反硝化固体碳源的研究

为解决水体因低碳氮比而导致脱氮效率差的问题,将颗粒聚己内酯(PCL)重新塑形为阶梯环状,研究其作为反硝化过程的生物膜载体与固相碳源的反硝化性能。结果表明,在静态实验中,平均反硝化速率为8.57 mg NO3-N/(L·h);反硝化过程为零级反应。连续填充床实验中,超过90%的硝酸盐可被去除,出水NO2-N质量浓度低于0.20 mg/L;出水NH3-N质量浓度略有上升;出水溶解性有机碳(DOC)先上升后降低至1 mg/L左右。电子扫描显微镜扫描显示,PCL阶梯环反应表面空隙率较高,表面生物膜以杆菌为主,反应后被明显腐蚀;液相色谱检测显示PCL阶梯环分子量反应前后略有下降,其结构未受到破坏;表明该材料适合作为反硝化反应的碳源的同时,又可以作为载体供微生物附着生长。     

用水解酸化池-膜生物反应器处理活性艳红X-3B废水

采用水解酸化池-膜生物反应器处理含活性艳红X-3B的模拟废水,研究了水力停留时间（HRT）对水解酸化池废水处理效果的影响,考察了水解酸化池-膜生物反应器对废水的处理效果及膜生物反应器中污泥沉降性能对膜污染的影响。实验结果表明：水解酸化池HRT为16h时,废水的可生化性最好,挥发性脂肪酸质量浓度与COD比值为0．5;HRT为17h时,废水脱色率达69％,而COD的去除率受HRT影响较小;膜生物反应器主要起去除废水中COD的作用;水解酸化池-膜生物反应器处理后废水的脱色率和COD去除率分别为83％和97％;膜生物反应器中活性污泥沉降性能的变化直接影响膜污染的速率。     

气相色谱法直接测定水中微量有机胺

用配有氢火焰离子化检测器（FID）的气相色谱仪直接测定水中多种微量有机胺。试样经过滤后直接进样,在气相色谱仪上使用CP7448毛细管柱,用外标法测定水中微量甲胺、二甲胺、一乙胺、二乙胺的含量。在所选择的色谱操作条件下,甲胺、二甲胺、一乙胺、二乙胺的质量浓度分别在一定范围内与峰面积呈良好的线性关系。4种组分的回收率分别为96.7％,99．0％,101．2％,99．2％;精密度分别为4．3％,3．7％,5．5％,3．1％;检出限分别为2．0,2．0,1．5,1．5mg/L。该方法操作简便,回收率、精密度高。     

稀土酞菁锰对表面活性剂(LAS)的催化氧化性能研究

研究了一种新型含稀土酞菁锰(KCeO2MnPcX)催化剂对水中表面活性剂直链烷基苯磺酸钠(LAS)氧化降解的催化性能,讨论了影响催化氧化反应的各种因素,并确定了最佳反应条件。同时初步探讨了这种催化剂对表面活性剂的催化氧化机理,为处理表面活性剂废水提供了新的途径。     

ASBR反应器处理豆制品废水的试验

采用厌氧序批式活性污泥法处理食品加工废水。试验研究了反应器的最佳进水、反应时间比,从而得出最低进水pH值和最少加碱量,同时还研究了反应器在常温和低温下的处理能力,以及pH冲击、搅拌频率、消毒液对反应器的影响。结果表明:最佳进水、反应时间比为2.5h4.5h,此时进水pH值降低到5.0,加碱量大大减少;CODCr去除率随温度的降低而降低,25℃时,CODCr去除率为83.45%,20℃时,CODCr去除率降至73%左右,15℃时,CODCr去除率只有57%左右;本工艺条件下最佳搅拌频率为每小时搅拌10min,反应器对pH冲击具有一定耐受能力,但消毒液对处理效果影响较大且恢复困难。