Mn对超富集植物青葙Cd毒害的缓解效应

为了探究Cd胁迫下青葙中Mn的生理作用,通过水培实验,研究在Cd暴露下(0、5和25 μmol·L-1 )施加Mn(5、100和1 000 μmol·L-1 )对青葙的干重、叶绿素含量、Cd含量和青葙根部不同区域实时Cd2+流速的影响.结果表明,提高Mn的供应水平可缓解Cd对青葙生长的抑制效应.在Cd浓度为5 μmol...     

Investigation of PM2.5 pollution during COVID-19 pandemic in Guangzhou, China

The COVID-19 pandemic has raised awareness about various environmental issues,including PM_2.5 pollution.Here,PM_2.5 pollution during the COVID-19 lockdown was traced and analyzed to clarify the sources and factors influencing PM_2.5 in Guangzhou,with an emphasis on heavy pollution.The lockdown led to large reductions in industrial and traffic emissions,which significantly reduced PM_2.5 concentrations in Guangzhou.Interestingly,the trend of PM_2.5     

Large-scale utilization of desulfurization ash and fly ash for unfired production of high-strength road-base stones

Journal of Material Cycles and Waste Management - This paper utilizes desulfurization ash (DA), fly ash (FA) and ordinary Portland cement (OPC) to prepare unfired high-strength road-base stones by...     

均相Fenton氧化-混凝法强化处理印染废水

采用均相Fenton氧化—混凝法对印染废水进行了强化处理。结果表明,该法特别适用于处理同时含有亲水性和疏水性染料的印染废水,处理过程充分发挥了均相Fenton氧化和混凝的协同作用,对废水中的水溶性有机物、胶粒和疏水性污染物均有较好的去除效果。在印染废水初始pH4.0左右,H2O2、FeSO4·7H2O和絮凝剂聚硅酸氯化铝(PASC)的加入量分别为3.6,1.8,8mL时,处理后废水的色度降到35,COD降到103mg/L,去除率分别高达95%和94.3%,脱色效果显著。     

混凝—催化氧化法处理丁苯橡胶生产废水

以聚合氯化铝（PAC）、阴离子聚丙烯酰胺（PAM）为混凝剂,以H2O2-O3为氧化剂,采用混凝-催化氧化法处理对丁苯橡胶生产废水。考察了混凝剂种类及其加入量、废水pH对混凝处理效果的影响,氧化剂及其加入量、反应时间和废水pH对COD去除率的影响。实验得出的最佳工艺条件：混凝实验,废水pH为7、PAC和PAM加入量为400mg／L和4mg／L;催化氧化实验,废水pH为7～8、H2O2加入量为200mg／L、H2O2与O3的质量比为0．5。处理后,废水COD从860mg／L降至145mg／L,COD去除率达83．1％,出水水质达到国家二级排放标准。     

Thermal conversion of rice husks and sawdust to liquid fuel

The paper focuses on studying the conversion of rice husks and sawdust into liquid fuel. Rice husks, sawdust and their mixture are pyrolyzed at temperatures between 420 and 540 degrees C, and the main product of liquid fuel is obtained. The experimental result shows that the yield of liquid fuel depends on various factors such as feedstock and temperature. The maximum yields for rice husks, sawdust and their mixture are 56%, 61% and 60% at 465, 490 and 475 degrees C, respectively. Analyses with GC-MS and other apparatus show that the liquid fuel is a complicated compound with low caloric value and can be directly used as a fuel oil for combustion in a boiler or a furnace without any upgrading. Alternatively, the fuel can be refined to be used by vehicles.     

CO2资源化利用的现状及前景

介绍了CO2分离捕集最新工艺——电化学法、膜法、化学循环燃烧法的研究进展。评述分析了CO2的各种资源化应用前景：CO2气体用作生物碳源、辅助注射成型剂及有机物（如氨基甲酸酯、表面活性剂）合成原料等;液态CO2用于人造金刚石、热泵干燥、超临界CO2萃取及固体干冰冷喷射清洗等。CO2作为一种潜在的丰富碳源,应不断研发其新的应用领域,加快其工业化应用。     

Growth factors, kinetics and biodegradation mechanism associated with Pseudomonas nitroreducens TX1 grown on octylphenol polyethoxylates

The growth properties and biodegradation mechanism of a Gram-negative bacterium, Pseudomonas nitroreducens TX1 that was able to grow on branched octylphenol polyethoxylates (OPEO(n), average n=9.5) as the sole carbon source over a wide concentration range (1-100,000 mgl(-1)) were studied. Analysis of growth factors indicated the highest specific growth rate (micro) of 0.53 h(-1) was obtained at an initial concentration of 5,000 mgl(-1) OPEO(n). An optimal C/N ratio of 12 was obtained for (NH(4))(2)SO(4) as the nitrogen source in a cultivated medium at pH 7. The kinetic analysis demonstrated that bacterial growth and OPEO(n) degradation followed the Monod equation and were based on a substrate concentration inhibition model and pseudo-first-order reaction, respectively. The substrate inhibition coefficient was over 18,000 mgl(-1) and this indicates that the strain has an ability to sustain growth at high concentrations of OPEO(n) and use it as the sole carbon source under such a stress condition. Furthermore, LC-MS analysis showed that the biodegradation mechanism of dodecyl octaethoxylate (AEO8) by P. nitroreducens TX1 was the sequential cleavage of the ethoxylate chain.     

喷淋环栅式除尘脱硫反应器的数学模拟

研制了一种由内外圈构成的喷淋环栅式除尘脱硫反应装置,气、液两相在内外圈之间通向运动,紊流冲激环栅时接触传质。基于溶质渗透理论,提出了以内塔穿孔速率V,液气比L/G,吸收浆液pH值为参数的脱硫效率模型。对比某电厂工况条件下测得的一系列实验数据,显示出该模型与实际情况具有良好的一致性,表明该模型可以用来作为工程设计、最优化技术和推测工业数据的理论参考工具。     

城市危险化学品事故统计分析与对策

通过对2002-2004年发生在中国内地12个主要城市的435起非爆炸品类危险化学品事故统计分析,发现:(1)危险化学品事故总体呈进一步发展趋势;(2)处于城市生活区的化工企业发生危险化学品事故对城市的影响最大;(3)危险化学品在运输阶段,发生事故的比例最高;(4)民用燃气是造成使用阶段危险化学品事故的主要危险源,而人为失误和违规操作是民用燃气类危险化学品事故的主要原因.在统计分析基础上提出了相应的对策.