阴霾天气PM_(10)的微观特征及生物活性研究

利用高分辨率场发射扫描电镜(FESEM)、图像分析技术(IA),对北京市2004年12月一次严重的阴霾天气条件下采集的PM10(指空气动力学直径小于10μm的颗粒物)的微观形貌、粒度分布、主要颗粒物类型进行了分析,并运用质粒DNA评价法对阴霾和非阴霾天气条件下的PM10样品的生物活性进行了对比研究。结果表明,阴霾天气时PM10样品中以粒度较小的烟尘及其集合体为主,且多呈湿状,含有较多的二次颗粒物,并发现了残余的有机液滴颗粒。质粒DNA实验的结果显示,阴霾天气PM10样品的水溶和全样样品的TD20值(造成20%DNA破坏时所需要的样品剂量)分别为93μg.ml-1和50μg.ml-1,而同一月份非阴霾天气条件下PM10样品的水溶和全样样品的TD20值分别为200μg.ml-1和160μg.ml-1,表明阴霾天气PM10样品比非阴霾天气样品具较强的生物活性,即对人体健康存在着潜在的危害。且无论是阴霾还是非阴霾天气条件下的PM10的全样样品均较水溶样品具更大的生物活性。     

Thermal stabilization of chromium slag by sewage sludge: Effects of sludge quantity and temperature

To investigate the feasibility of detoxifying chromium slag by sewage sludge,synthetic chromium slag containing 3% of Cr(VI) was mixed with sewage sludge followed by thermal treatment in nitrogen gas for stabilizing chromium.The effects of slag to sludge ratio(0.5,1 and 2) and temperature(200,300,500,700 and 900°C) on treatment efficiency were investigated.During the mixing process before thermal treatment,59.8%-99.7% of Cr(VI) was reduced,but Cr could be easily leached from the reduction product.Increasing heating temperature and decreasing slag to sludge ratio strengthened the reduction and stabilization of Cr(VI).When the slag to sludge ratio was 0.5 and thermal treatment temperature was 300°C,the total leached Cr and Cr(VI) declined to 0.55 mg/L and 0.17 mg/L respectively,and 45.5% of Cr in the thermally treated residue existed as residual fraction.A two-stage mechanism was proposed for the reduction and stabilization of Cr.     

新型饮用水除氟材料Bio-F的除氟特性和比较研究

对3种传统除氟剂活性氧化铝、骨炭和改性沸石与自制的新型生物除氟剂Bio-F的除氟性能及影响因素（材料粒径、pH值、吸附时间、水样含氟浓度、其它离子、再生能力等）进行了比较,并模拟动态实验评估了这4种除氟材料对实际高氟地下水处理的效果.结果表明,Bio-F生物除氟剂对F^-的吸附过程符合Lagergren一级吸附动力学特征（R²=0.958 0）,吸附速率较快,且该过程属于吸热反应; Bio-F吸附F^-符合Langmuir吸附等温模型（R²=0.999 2）,吸附容量高,静态吸附容量可达4.088 3 mg·g^-1,分别约是活性氧化铝和改性沸石的1.8和 5.8倍.4种除氟材料吸附容量与氟浓度正相关,与吸附剂粒径负相关.高浓度的CO^2-₃、HCO^-₃明显抑制Bio-F的除氟（p<0.05）,但高浓度的Ca²⁺、NO^-₃、HPO^2-₄有利于Bio-F的除氟（p<0.001）.Bio-F除氟最佳停留时间3～4 min,远远低于沸石20 min和活性氧化铝11 min.在pH 4.0～9.0范围内Bio-F可保持90％以上吸附F^-的能力.再生性能稳定,10次再生后吸附容量变化不超过15%.Bio-F综合性能优于其它3种传统除氟剂,在我国广大农村地区推广有显著优越性.     

苯噻草胺在土壤中的吸附与解吸行为研究

采用批量平衡实验方法,研究了除草剂苯噻草胺在5种不同性质土壤中的吸附与解吸行为,并探讨了土壤有机质及溶液pH值对吸附的影响.结果表明,线性方程与Freundlich方程均能较好地拟合苯噻草胺在土壤中的吸附等温线.计算得到苯噻草胺在5种土壤中的碳标化分配系数K_oc在849.5～1?818.8 L·kg^-1之间,说明土壤对苯噻草胺有较强的吸附能力.苯噻草胺在土壤中的分配系数K_d、Freundlich常数K_f以及K_f(1/n)与土壤有机质含量均呈显著正相关.通过过氧化氢去除有机质后,土壤对苯噻草胺的吸附大大降低,说明土壤有机质是影响苯噻草胺在土壤中吸附的主要因素.对于同种土壤而言,苯噻草胺的吸附量随pH值的增大而减小.解吸实验表明,苯噻草胺在土壤中的解吸过程具有一定的滞后性,推测其在土壤中的迁移能力较差.     

Efficient removal of naphthalene-2-ol from aqueous solutions by solvent extraction

Naphthalene-2-ol is a typical biologically recalcitrant pollutant in dye wastewater.Solvent extraction of naphthalene-2-ol from aqueous solutions using mixed solvents was investigated.Various extractants and diluents were evaluated,and the effects of volume ratio of extractant to diluent,initial p H,initial concentration of naphthalene-2-ol in aqueous solution,extraction time,temperature,volume ratio of organic phase to aqueous phase(O/A),stirring rate and extraction stages,on extraction efficiency were examined separately.Regeneration and reuse of the spent extractant were also investigated.Results showed that tributyl phosphate(TBP) achieved 98% extraction efficiency for naphthalene-2-ol in a single stage extraction,the highest among the 12 extractants evaluated.Extraction efficiency was optimized when cyclohexane and n-octane were used as diluents.The solvent combination of 20% TBP,20% n-octanol and 60% cyclohexane(V/V) obtained the maximum extraction efficiency for naphthalene-2-ol,99.3%,within 20 min using three cross-current extraction stages under the following extraction conditions:O/A ratio of 1:1,initial p H of 3,25°C and stirring rate of 150 r/min.Recovery of mixed solvents was achieved by using 15%(W/W) Na OH solution at an O:A ratio of 1:1 and a contact time of 15 min.The mixed solvents achieved an extraction capacity for naphthalene-2-ol stably higher than90% during five cycles after regeneration.     

醋酸酯生产线物料输送泵的选型与污染物排放量的关系

以钱塘江上游某化工企业的醋酸酯生产线为例,通过分析物料输送泵优化技改前后的工艺流程和污染物排放情况,从而佐证化工行业物料输送泵的选型与污染物排放量是密切相关的,可以达到指导该类项目的环境影响评价和清洁生产审核,同时也能为企业的节能减排提供一定的技术依据。     

Interaction and independence on methane oxidation of landfill cover soil among three impact factors: water, oxygen and ammonium

To understand the influence patterns and interactions of three important environmental factors, i.e. soil water content, oxygen concentration, and ammonium addition, on methane oxidation, the soils from landfill cover layers were incubated under full factorial parameter settings. In addition to the methane oxidation rate, the quantities and community structures of methanotrophs were analyzed to determine the methane oxidation capacity of the soils. Canonical correspondence analysis was utilized to distinguish the important impact factors. Water content was found to be the most important factor influencing the methane oxidation rate and Type II methanotrophs, and the optimum value was 15% (w/w), which induced methane oxidation rates 10- and 6- times greater than those observed at 5% (w/w) and 20% (w/w), respectively. Ambient oxygen conditions were more suitable for methane oxidation than 3% oxygen. The addition of 100 mg-N·kg_drysoil⁻¹ of ammonium induced different effects on methane oxidation capacity when conducted at low or high water content. With regard to the methanotrophs, Type II was sensitive to the changes of water content, while Type I was influenced by oxygen content. Furthermore, the methanotrophic acidophile, Verrucomicrobia, was detected in soils with a pH of 4.9, which extended their known living environments.     

巴氏醋酸杆菌发酵处理甲醇废水合成细菌纤维素的研究

介绍了巴氏醋酸杆菌以甲醇为唯一碳源、以酵母膏或蛋白胨为氮源合成细菌纤维素,同时净化甲醇废水的方法,并对合成细菌纤维素的培养条件进行了研究。试验得出巴氏醋酸杆菌的适宜发酵条件为：发酵培养基中甲醇质量分数为3．5％左右,发酵培养基初始pH为5．0～6．0。接种量为5％,发酵培养温度为30℃,振荡器转速为100r／min。     

城市热环境及其微热环境的改善

以苏南５市县３０年来热环境诸因素的变化资料为依据,分析城市区域特征所引起的热环境诸因素的变化趋势,介绍包括规划城市区域的道路网,控制建筑物布局的密度,以及城市绿化和水面等在内的城市规划和建筑设计措施对于改善城市区域微热环境的效用。     

污水污泥低温热解处理技术研究

污水污泥低温热解是一种发展中的能量回收型污泥热化学处理技术。本研究对此过程进行了间歇实验研究,取得了最高能量回收率时的反应条件。以此为基础并结合文献数据,讨论了过程的能量平衡影响因素和经济估算问题。结果表明,最优反应条件为：反应温度270℃,停留时间30min;全过程能量平衡主要受脱水泥饼含水率影响,临界含水率78%;过程处理成本低于焚烧法。