Characteristics of chlorofluorocarbons (CFCs) emitted from a municipal waste treatment facility

The emission concentrations of several chlorofluorocarbons (CFCs) were measured from a municipal waste treatment facility (located in Seoul, Republic of Korea) to investigate the emission characteristics of CFCs in the urban environment. To this end, a total of five CFCs (CFC-10, CFC-11, CFC-20, CFC-30, and CFC-113) were analyzed by the thermal desorption-gas chromatography-mass spectrometry (TD-GC-MS) method. The results of this study indicate that the formation of CFC-11 (8.21 ± 1.68 ppb in spring) and CFC-20 (3.92 ± 3.93 ppb in spring) proceeded very actively within the facility. Moreover, CFC-113 was also found in relatively high concentrations (3.34 ± 1.31 ppb in spring) in the treatment facility. Unlike other CFCs, CFC-10 was observed mainly at ambient (and reference) locations and one point inside the treatment facility. In conclusion, emissions of some important CFCs are a prominent process, as they were measured either frequently or abundantly both in winter and spring. It is further indicated that certain CFCs (like CFC-11 and CFC-30) are subject to highly significant seasonal variations.     

A study on the evaluations of emission factors and uncertainty ranges for methane and nitrous oxide from combined-cycle power plant in Korea

In this research, in order to develop technology/country-specific emission factors of methane (CH₄) and nitrous oxide (N₂O), a total of 585 samples from eight gas-fired turbine combined cycle (GTCC) power plants were measured and analyzed. The research found that the emission factor for CH₄ stood at “0.82 kg/TJ”, which was an 18 % lower than the emission factor for liquefied natural gas (LNG) GTCC “1 kg/TJ” presented by Intergovernmental Panel on Climate Change (IPCC). The result was 8 % up when compared with the emission factor of Japan which stands at “0.75 kg/TJ”. The emission factor for N₂O was “0.65 kg/TJ”, which is significantly lower than “3 kg/TJ” of the emission factor for LNG GTCC presented by IPCC, but over six times higher than the default N₂O emission factor of LNG. The evaluation of uncertainty was conducted based on the estimated non-CO₂ emission factors, and the ranges of uncertainty for CH₄ and N₂O were between ?12.96 and +13.89 %, and ?11.43 and +12.86 %, respectively, which is significantly lower than uncertainties presented by IPCC. These differences proved that non-CO₂ emissions can change depending on combustion technologies; therefore, it is vital to establish country/technology-specific emission factors.     

Field application of electrokinetic remediation for multi-metal contaminated paddy soil using two-dimensional electrode configuration

In this study, we evaluated the feasibility of in situ electrokinetic remediation for arsenic (As)-, copper (Cu)-, and lead (Pb)-contaminated soil, in a pilot-scale field application with two-dimensional electrode configurations. Square and hexagonal configurations with different electrode spacing, 1 m and 2?m, were investigated under a constant 100 V. A square configuration with electrode spacing of 2 m removed 61.5 % of As, 11.4 % of Cu, and 0.9 % of Pb, respectively, and a hexagonal configuration with the same spacing showed a higher removal efficiency in top (59 % of As, 0–0.5 m) and middle (53 % of As, 0.5–1.0 m) layers, but much lower removal efficiency in the bottom layer (1–1.5 m), which was thought to be due to groundwater flow through periodic rise and fall of tides. Fractionation analysis showed that As bound to Fe–Mn oxyhydroxide was the main form of As removed by the electrokinetic process. The two-dimensional configuration wasted less electrical energy by Joule heating, and required fewer electrode installations, compared to the one-dimensional electrode configuration.     

Nitrate and ammonium ions removal from groundwater by a hybrid system of zero-valent iron combined with adsorbents

Nitrate (NO(3)(-)) is a commonly found contaminant in groundwater and surface water. It has created a major water quality problem worldwide. The laboratory batch experiments were conducted to investigate the feasibility of HCl-treated zero-valent iron (Fe(0)) combined with different adsorbents as hybrid systems for simultaneous removal of nitrate (NO(3)(-)) and ammonium (NH(4)(+)) ions from aqueous solution. The maximum NO(3)(-) removal in combined Fe(0)-granular activated carbon (GAC), Fe(0)-filtralite and Fe(0)-sepiolite systems was 86, 96 and 99%, respectively, at 45 °C for 24 h reaction time. The NO(3)(-) removal rate increased with the increase in initial NO(3)(-) concentration. The NO(3)(-) removal efficiency by hybrid systems was in the order of sepiolite > filtralite > GAC. The NH(4)(+) produced during the denitrification process by Fe(0) was successfully removed by the adsorbents, with the removal efficiency in the order of GAC > sepiolite > filtralite. Results of the present study suggest that the use of a hybrid system could be a promising technology for achieving simultaneous removal of NO(3)(-) and NH(4)(+) ions from aqueous solution.     

α-环糊精接枝壳聚糖纤维的合成及其对对硝基酚的包合吸附与释放

在氰基硼氢化钠存在的弱酸性条件下将6-去氧-6-甲酰基-α-环糊精接枝到壳聚糖纤维上,制备了α-环糊精接枝壳聚糖纤维.测定了不同温度和时间下,α-环糊精接枝壳聚糖纤维对对硝基酚(PNP)的包合吸附与释放性能,及其包合稳定性常数和热力学参数.结果表明,α-环糊精接枝壳聚糖纤维是一种高效的PNP分离剂,对PNP具有良好的分子识别、包合吸附和释放性能,其PNP包合吸附容量可达到2.93 mg/g,318 K时PNP释放度可达到70%左右,并可反复包合吸附与释放;该包合反应为放热反应,分子间的范德华力起主导作用;包合物的稳定性受温度影响较大,低于298 K时较稳定,318 K时PNP释放达到平衡;在同一温度下,PNP释放度随时间的增加而提高.     

Study on integrated management of PCB containing waste and PCB contaminated waste: proposal of new congeners for quantification

In the present study, new congeners were selected for the efficient management of PCB containing waste and PCB contaminated waste, and the applicability of these new indicators was confirmed. As a result, 8 indicator congeners and 4 index peaks which were named “Proposed new method 1” and “Proposed new method 2” were selected. For the assessment of a novel quantitative method, comparative tests using conventional methods were conducted, and the factors for total PCB were calculated for each method. Results from these tests showed that the average values for the factors of CEN/TC19/WG22, DIN 51527, and the test method by the disposal regulation for ocean dumping in Korea were 1.86, 3.47, and 2.52, respectively, while those for the proposed new method 1 and proposed new method 2 were 2.98 and 5.56, respectively. For PCB contaminated waste, the factor was found to be 1.99, 3.42, and 3.02 using the conventional methods, 2.67 using the proposed new method 1, and 5.57 using the proposed new method 2. It is expected that, in accordance with the results of the present study, the management of PCB waste can be integrated, regardless of the type of waste involved.