新烟碱类农药的污染现状及转化行为研究进展

新烟碱类(neonicotinoids)农药自在20世纪80年代中期引入以来,便发展成为世界上使用最广泛的一类杀虫剂。近年来,该类化合物在环境中被不断检出,并通过饮用水和食物等方式进入食物链,给人类健康带来极大的安全隐患。文章综述了新烟碱类杀虫剂在空气、土壤、水相、生物体和人体中的暴露浓度,以及这类农药在环境中的转化行为。目前针对新烟碱类杀虫剂的环境暴露研究仍十分有限,需要更全面调查其在多环境介质中的暴露状况以综合评价其生态风险。关于新烟碱类化合物的毒理学研究主要集中在急性毒性试验,而对于其他形式的毒性效应有待进一步研究。最后对新烟碱农药未来的研究重点和方向提出了展望。     

丙烯酸酯类高吸油树脂的合成及其吸附性能

采用悬浮聚合法,以甲基丙烯酸甲酯(MMA)和丙烯酸丁酯(BA)为单体、二乙烯苯(DVB)为交联剂、过氧化苯甲酰(BPO)为引发剂,合成了一种丙烯酸酯类高吸油树脂。实验结果表明,在m(MMA)∶m(BA)=0.5、DVB加入量为0.8%、BPO加入量为1.2%的最佳条件下,树脂对氯仿的吸油率可达30.6 g/g,对氯仿、柴油、甲苯、废机油、花生油、丙酮等有机溶剂和油品的保油率可达90.0%以上。     

MAP沉淀法目标产物最优形成条件及分析方法

为了确定鸟粪石(MAP：MgNH₄PO₄·6H₂O)形成的最优条件,引入化学剖析法,利用酸溶液将鸟粪石沉淀法中所得沉淀物溶解后进行相应的元素分析;提出一种根据沉淀物中的NH⁺₄-N含量间接计算确定鸟粪石含量(即纯度)的分析方法.根据这种计算分析方法,分别得出了不同pH条件下以自来水(主要为地下水)和超纯水作为溶剂所合成的鸟粪石纯度,并对pH和Ca²⁺在鸟粪石形成过程中的影响进行了评估.结果表明,该计算分析方法能够有效实现对MAP沉淀法目标产物的定量分析,弥补了国内外目前普遍依靠XRD技术定性判断所得沉淀物中鸟粪石是否存在的缺陷.以超纯水作为溶剂时,使鸟粪石纯度>90%的最佳pH范围在7.5～9.0,而以自来水为溶剂时,获得相同鸟粪石纯度最佳pH范围则是7.0～7.5.实际污水中常常含有相当数量的Ca²⁺,实施碱性条件(pH>8.0)的MAP沉淀势必大幅降低鸟粪石的纯度.因此,对实际污水回收磷而言,MAP沉淀法的最优pH条件应控制在中性范围(<8.0)以内.     

Ecotourism Model and Benefits of Periphery Regions in Western Sichuan Province

There are many problems in the minority regions of western Sichuan Province, such as serious soil erosion, fragile ecological environment, low levels of economy and so on. Ad-vantages of tourism resources in the periphery regions should be fully utilized, and multi-tourism meets the characteristics and present situation of the minority regions. The multi-tourism de-velopment model can exert the functions of tourism as the key industry. Based on the demands and the internal linkages among different industries, the model can accelerate the development of related-industries, such as eco-agriculture, eco-industry and so on. Through implementing the multi-tourism model, we can fully utilize the advantages of the periphery regions and promote the sustainable development of regional economy.     

Classification and comparison of municipal solid waste based on thermochemical characteristics

Municipal solid waste (MSW) has been normally sorted into six categories, namely, food residue, wood waste, paper, textiles, plastics, and rubber. In each category, materials could be classified further into subgroups. Based on proximate and ultimate analysis and heating value, statistical methods such as analysis of variance (ANOVA) and cluster analysis were applied to analyze the characteristics of MSW in every subgroup and to try to distinguish their relative properties. The chemical characteristics analysis of MSW showed that polyethylene (PE), polypropylene (PP), and polystyrene (PS) had the highest volatile matter content, with almost no ash and fixed carbon, while polyethylene terephthalate (PET) had high carbon content but low hydrogen content. Bones and vegetables had the highest ash content, while nutshells and rubber had the highest fixed carbon content. Paper and starch food had the highest oxygen content, and wool and bones had the highest nitrogen and sulfur content. Polyvinyl chloride (PVC) had the highest chlorine content at about 55%. PE, PP, and PS had the highest heating value, followed by chemical products such as rubber and chemical fiber. Conversely, paper, vegetables and bones had the lowest heating value. The results of cluster analysis of MSW components showed that fruit peel, weeds, wood, bamboo, leaves and nutshells could be classified as the lignocellulose category; starch food, cotton, toilet paper, printing paper and cardboard could be classified as the glucose monomer category; wood and chemical fiber could be classified as the high nitrogen and sulfur category; and PE, PP, and PS could be cluster as the polyolefin category.

Implications: The yield of municipal solid waste (MSW) is constantly increasing and waste to energy (WTE) has been used extensively all over the world. During the processes of incineration, pyrolysis, or gasification, the impact of physical and chemical properties of MSW is of great significance. However, the traditional classification of MSW is too general to provide more detailed information in many investigations. It is necessary to perform the investigation of characteristics of combustible MSW to distinguish different categories of MSW and find out their subclassification.     

滤料粒径对BAF小尺度下流场形态及挂膜速度的影响

为探讨颗粒粒径对曝气生物滤池(BAF)运行效果的影响,采用数值模拟和实验研究方法分析了滤料粒径对曝气生物滤池流场形态及挂膜速度的作用机理.选用5个颗粒尺寸结构空间作为计算区域,利用Fluent软件对相同颗粒间隙、不同颗粒粒径下BAF小尺度下的流场形态进行模拟分析,并通过对3种粒径下流线图、速度矢量图、压力分布及湍流强度变化的对比分析,发现颗粒粒径为3 mm时流场形态最好,最有利于气水混合及氧传质的进行.同时,为验证模拟结果的正确性,对同种材质、相同运行条件下3种不同颗粒粒径进行挂膜速度对比,通过考察挂膜启动28 d的COD去除率变化及污泥生物量的对比分析,发现颗粒粒径为3 mm时,运行最为稳定,系统运行第16 d时就达到了80%的COD去除效率.     

不同来源废水COD、TOC与Cl-的关系

通过对含盐化工废水(A)、受潮汐影响的河流水(B)、城市生活污水处理厂排水(C)、采油废水(D)4种不同来源废水进行为期15 d的采样监测,测定了其COD、TOC和Cl-浓度,分析比较了3种废水指标之间的关系,其中COD分别使用重铬酸钾法、氯气校正法和碘化钾碱性高锰酸钾法3种方法进行测定.实验结果表明,4种废水Cl-浓...     

饮用水除砷技术研究进展

饮用水中的砷对人体健康危害很大。介绍了从饮用水中去除砷的各种方法,总结了目前除砷技术存在的不足,指出混凝微滤工艺具有除砷效率高、能耗低、操作简单等优点,应成为今后饮用水除砷技术的发展方向。     

清浊分流条件下的混凝-臭氧处理棉针织印染清废水

根据污染源头控制和废水回用的要求,对典型棉针织染整厂的不同生产过程废水排水水质特征进行了统计分析,提出了较实用的废水源头清浊分流方案。在此基础上重点研究了混凝-臭氧组合工艺对清废水处理效果,确定了最优的工艺条件。结果表明,清废水主要为洗水,占废水总量的25%～30%;混凝-臭氧组合工艺的最优工艺条件为：pH为6～9,PAC投加量为48 mg/L,PAM投加量为1.0 mg/L,臭氧接触时间为12 min（臭氧浓度为14.5 mg/L）,这时,清废水COD、色度去除率分别为71%和98%,实践证明,出水水质完全能够满足染整生产。     

Estimate on spillover effect of environmental pollution between peripheral areas

ABSTRACT

Interaction of environmental pollution between peripheral areas has become a central topic in the field of resources and environment but little is known about the actual impact on peripheral areas in the current literature. This paper sets out a simultaneous equation model to investigate the spillover effect of environmental pollution between China’s peripheral areas utilizing the panel data of 218 cities in China. Making use of indicators for measuring the impact on environmental pollution, it identifies that environmental pollution between cities of China has a significant two-way spillover effect. After standardization of variables, it is found that the spillover effect of peripheral areas on urban environmental pollution cannot be neglected. Nearly, a third of the environmental pollution level in a city is induced by the environmental pollution in peripheral areas. If the indicator of environmental pollution in peripheral areas is missing, wrong conclusions will be drawn. Therefore, government should shift the emphasis of environmental regulation from local to global, and improve the overall environmental quality through coordinated management of regional environment.