Disinfection by-products in Finnish drinking waters

Disinfection by-products (DBPs) were measured in plant effluents of 35 Finnish waterworks, which utilized different treatment processes and raw water sources. DBPs were measured also from the distribution systems of three waterworks. Di- and trichloroacetic acids, and chloroform were the major DBPs found in treated water samples. The concentration of six haloacetic acids (HAA6) exceeded the concentrations of trihalomethanes (THMs). Chlorinated drinking waters (DWs) originating from surface waters contained the highest concentration of HAA6 and THMs: 108 and 26 microg/l, respectively. The lowest concentrations of DBPs were measured from ozonated and/or activated carbon filtrated and chloraminated DWs. Higher concentrations of HAA6, THMs, and adsorbable organic halogens were measured in summer compared to winter. The levels of chlorinated acetic acids, chloroform, and bromodichloromethane correlated positively with mutagenicity. Past mutagenicity levels of DWs were examined. A major reduction in the use of prechlorination, increased use of chloramine disinfection, and better removal of organic carbon were the most important reasons for the 69% decrease in mutagenicity from 1985 to 1994.     

Natural attenuation of chlorinated solvents at Area 6, Dover Air Force Base: groundwater biogeochemistry

Monitored natural attenuation (MNA) has recently emerged as a viable groundwater remediation technology in the United States. Area 6 at Dover Air Force Base (Dover, DE) was chosen as a test site to examine the potential for MNA of tetrachloroethene (PCE) and trichloroethene (TCE) in groundwater and aquifer sediments. A "lines of evidence" approach was used to document the occurrence of natural attenuation. Chlorinated hydrocarbon and biogeochemical data were used to develop a site-specific conceptual model where both anaerobic and aerobic biological processes are responsible for the destruction of PCE, TCE, and daughter metabolites. An examination of groundwater biogeochemical data showed a region of depleted dissolved oxygen with elevated dissolved methane and hydrogen concentrations. Reductive dechlorination likely dominated in the anaerobic portion of the aquifer where PCE and TCE levels were observed to decrease with a simultaneous increase in cis-1,2-dichloroethene (cis-DCE), vinyl chloride (VC), ethene, and dissolved chloride. Near the anaerobic/ aerobic interface, concentrations of cis-DCE and VC decreased to below detection limits, presumably due to aerobic biotransformation processes. Therefore, the contaminant and daughter product plumes present at the site appear to have been naturally atteuated by a combination of active anaerobic and aerobic biotransformation processes.     

Metal accumulation in aquatic macrophytes from southeast Queensland,Australia

To determine the extent of metal accumulation in some aquatic macrophytes from contaminated urban streams in southeast Queensland, plants were sampled from six sites, along with contiguous sediments. In all, 15 different species were collected, the most common genera being Typha (Cattails or Bulrushes) and Persicaria (Knotweeds). Before heavy metal analysis, plants were further separated into various morphological tissues, and five selected samples were separated into various physiological tissues. The cadmium, copper, lead and zinc content of the plants were analysed using flames AAS. In general, plant roots exhibited higher metal concentrations than the contiguous sediments. Of the metals of interest, only for zinc was there a relatively clear pattern of increasing accumulation in aquatic macrophytes with increasing sediment metal concentrations. Comparison between morphological tissues of the sampled plants found that roots consistently presented higher metal concentrations than either the stems or leaves, however unlike previous studies, this investigation revealed no consistent trend of stems accumulating more metals than the leaves. For Typha spp., metal concentrations followed the order of roots > rhizomes > leaves, while for Persicaria spp. the order was roots > leaves > stems. The submerged species Myriophyllum aquaticum accumulated the highest levels of metals overall (e.g. Zn 4300 micrograms g-1 dry weight and Cd 6.5 micrograms g-1), and the emergent macrophytes also exhibited relatively high metal contents in their roots. The leaves of the submerged and floating-leafed species collected contained relatively high quantities of the four metals of interest, compared with the leaves of emergent aquatic macrophytes. In the Typha rhizome and Persicaria stem samples analysed for internal variation in metal content, there was a pattern of increasing metal concentrations towards the external sections of the stem, both for subterranean stems (rhizomes) and above-substrate stems. For Persicaria stems, no clear pattern was observed for cadmium and lead, the two metals investigated that are not required by plants for survival.     

Performance assessment of NAPL remediation in heterogeneous alluvium

Over the last few years, more than 40 partitioning interwell tracer tests (PITTs) have been conducted at many different sites to measure nonaqueous phase liquid (NAPL) saturations in the subsurface. While the main goal of these PITTs was to estimate the NAPL volume in the subsurface, some were specifically conducted to assess the performance of remedial actions involving NAPL removal. In this paper, we present a quantitative approach to assess the performance of remedial actions to recover NAPL that can be used to assess any NAPL removal technology. It combines the use of PITTs (to estimate the NAPL volume in the swept pore volume between injection and extraction wells of a test area) with the use of several cores to determine the vertical NAPL distribution in the subsurface. We illustrate the effectiveness of such an approach by assessing the performance of a surfactant/foam flood conducted at Hill Air Force Base, UT, to remove a TCE-rich NAPL from alluvium with permeability contrasts as high as one order of magnitude. In addition, we compare the NAPL volumes determined by the PITTs with volumes estimated through geostatistical interpolation of aquifer sediment core data collected with a vertical frequency of 5-10 cm and a lateral borehole spacing of 0.15 m. We demonstrate the use of several innovations including the explicit estimation of not only the errors associated with NAPL volumes and saturations derived from PITTs but also the heterogeneity of the aquifer sediments based upon permeability estimates. Most importantly, we demonstrate the reliability of the     

Using polymer mats to biodegrade atrazine in groundwater: laboratory column experiments

Large-scale column experiments were undertaken to evaluate the potential of in situ polymer mats to deliver oxygen into groundwater to induce biodegradation of the pesticides atrazine, terbutryn and fenamiphos contaminating groundwater in Perth, Western Australia. The polymer mats, composed of woven silicone (dimethylsiloxane) tubes and purged with air, were installed in 2-m-long flow-through soil columns. The polymer mats proved efficient in delivering dissolved oxygen to anaerobic groundwater. Dissolved oxygen concentrations increased from <0.2 mg l(-1) to approximately 4 mg l(-1). Degradation rates of atrazine in oxygenated groundwater were relatively high with a zero-order rate of 240-380 microg l(-1) or a first-order half-life of 0.35 days. Amendment with an additional carbon source showed no significant improvement in biodegradation rates, suggesting that organic carbon was not limiting biodegradation. Atrazine degradation rates estimated in the column experiments were similar to rates determined in laboratory culture experiments, using pure cultures of atrazine-mineralising bacteria. No significant degradation of terbutryn or fenamiphos was observed under the experimental conditions within the time frames of the study. Results from these experiments indicate that remediation of atrazine in a contaminated aquifer may be achievable by delivery of oxygen using an in situ polymer mat system.     

Preliminary background ozone concentrations in the mountain and coastal areas of Bulgaria

Urban and non-urban rural ozone (O3) concentrations are high in Bulgaria and often exceed the European AOT40 ecosystem as well as the AOT60 human health standards. This paper presents preliminary estimates to establish background, non-urban O3 concentrations for the southern region of Bulgaria. Ozone concentrations from three distinctly different sites are presented: a mountain site influenced by mountain-valley wind flow; a coastal site influenced by sea-breeze wind flow; and a 1700-m mountain peak site without 'local' wind flow characteristics. The latter offers the best estimate of 46-50 ppb for a background O3 level. The highest non-urban hourly value, 118 ppb, was measured at the mountain-valley site.     

As(III) removal from groundwaters using fixed-bed upflow bioreactors

The application of biological oxidation of iron and manganese, as a potential treatment method for the removal of arsenic from contaminated groundwaters, was examined in this paper. This method was based on the growth of certain species of indigenous bacteria, which are capable of oxidizing the soluble iron and manganese ions; the oxidized forms can be subsequently removed from the aqueous stream by over 97%, through their transformation to insoluble oxides and separation by a suitable filter medium. Arsenic was removed by around 80%, under certain conditions, which were found to be sufficient for Fe(II) removal (dissolved oxygen 2.7 mg/l, redox 280-290 mV, pH 7.2, U 8.25 m/h). The specific treatment technique presents several advantages towards conventional physicochemical treatment methods, such as enhanced coagulation or direct adsorption since: (a) it does not require the addition of other chemicals for oxidizing and removing As(III), (b) it does not require close monitoring of a breakthrough point, as in conventional column adsorption processes and (c) it could find application for the removal of, at least, three groundwater contaminants (Fe, Mn, As).     

Fire-LCA study of TV sets with V0 and HB enclosure material

A novel Life-Cycle Assessment model (Fire-LCA) has been defined for the determination of the environmental impact of measures taken to attain a high level of fire safety. This study, which represents the first application of this LCA model, concentrates on a comparison between a TV with an enclosure manufactured with a flame retardant (FR) plastic (V0-rated high impact polystyrene, HIPS, typical for the US market) and one manufactured with a non-flame retardant (HB-rated HIPS, typical for the European market). A fire model has been defined based on international statistics, which indicate that use of V0 rated enclosure material essentially removes the risk of TV fires while approximately 165 TV fires occur per million TVs in Europe each year where the enclosure material is breached. The application of the model indicates that emissions of some key species (such as dibenzodioxins and PAH) are actually lower for the TV with the FR enclosure than for the TV with the NFR enclosure. This has direct reprercussions for the assessment of the environmental impact of the FR TV relative to that of the NFR TV. Finally, when considering the risk associated with the use of flame retardants, it is also important to consider the risk associated with fires. Based on the in-depth analysis of available fire statistics, conducted as a part of this study, it has been estimated that as many as 160 people may die each year in Europe as a direct result of TV fires and as many as 2000 may be injured in the same period.     

Quantification of variability and uncertainty in lawn and garden equipment NOx and total hydrocarbon emission factors

Variability refers to real differences in emissions among multiple emission sources at any given time or over time for any individual emission source. Variability in emissions can be attributed to variation in fuel or feedstock composition, ambient temperature, design, maintenance, or operation. Uncertainty refers to lack of knowledge regarding the true value of emissions. Sources of uncertainty include small sample sizes, bias or imprecision in measurements, nonrepresentativeness, or lack of data. Quantitative methods for characterizing both variability and uncertainty are demonstrated and applied to case studies of emission factors for lawn and garden (L&G) equipment engines. Variability was quantified using empirical and parametric distributions. Bootstrap simulation was used to characterize confidence intervals for the fitted distributions. The 95% confidence intervals for the mean grams per brake horsepower/hour (g/hp-hr) emission factors for two-stroke engine total hydrocarbon (THC) and NOx emissions were from -30 to +41% and from -45 to +75%, respectively. The confidence intervals for four-stroke engines were from -33 to +46% for THCs and from -27 to +35% for NOx. These quantitative measures of uncertainty convey information regarding the quality of the emission factors and serve as a basis for calculation of uncertainty in emission inventories (EIs).     

Tolerance to,and avoidance of,hypoxia by the penaeid shrimp (Metapenaeus ensis)

Aquatic hypoxia caused by eutrophication may lead to mass mortality of valuable living resources such as fish and shrimp. However, there is little information on the hypoxic tolerance of penaeid shrimp, and whether they are able to avoid hypoxia. In laboratory experiments, LC50, LT50 and heart beats per minute were determined for juvenile Metapenaeus ensis at 0.5, 1.0, 2.0 and 6.0 mg O2 l(-1). The 8-h LC50, for DO was 0.77 mg O2 l(-1), while the LT50 at 0.5 mg O2 l(-1) was 399 min. Heart beat rate significantly declined when DO fell below 1.0 mg O2 l(-1). When confronted with a gradient of dissolved oxygen, M. ensis were able to avoid hypoxic areas and move to oxygenated water. M. ensis appeared to be sensitive to hypoxia, and their ability to detect and avoid hypoxia may enhance their survival in habitats where hypoxia may occur.