Characterization of atmospheric PM10 and related chemical species in southern Taiwan during the episode days

The concentrations of atmospheric PM10 on days with episodes of pollution were examined at four different sampling sites (CC, DL, LY, and HK) in southern Taiwan. The related to particulates water-soluble ionic species (Na+, K+, Mg2+, Ca2+, NH4+, Cl-, NO3-, SO4(2-)), carbonaceous species (EC and OC) and metallic species (Zn, Ni, Pb, Fe, Mn, Al, Si, V) were also analyzed. On the episode days of this study, the PM10 mass concentration ranged from 155 to 210 microgm(-3), from 150 to 208 microgm(-3), from 182 to 249 microgm(-3), and from 166 to 228 microgm(-3) at CC, DL, LY, and HK, respectively. The results indicate that the dominant water-soluble species were SO4(2-), NO3-, NH4+, and Cl- at the four sampling sites on these days. Moreover, the high sulfate and nitrate conversion values (SOR and NOR) presented herein suggest that secondary formations from SO2 to SO4(2-) and from NO2 to NO3- are present in significant quantities in the atmosphere of southern Taiwan on episode days. In particular, high SOR and NOR verified that both SO4(2-) and NO3- dominated the increase of atmospheric PM10 concentration in southern Taiwan on episode days.     

汽车尾气净化催化剂涂层改性研究

汽车尾气净化催化剂的净化转化效果及其耐久性，与催化剂涂层的涂覆量以及涂层和载体的结合强度密切相关。本文研究了几种不同类型表面活性剂对浆料固体含量、涂层涂覆量以及涂层结合强度的影响。研究结果表明，不使用表面活性剂时，30％为最佳的固体含量；在使用表面活性剂的情况下，浆料的固体含量可以提高至35％。非离子型表面活性剂有助于提高催化剂涂层涂覆量，而使用离子型表面活性剂的浆料球磨过程中产生大量泡沫，无法涂覆。使用非离子型表面活性剂的催化剂涂层的结合强度最好。     

各种影响因子对电解法预处理医药废水的影响研究

探讨了电解法预处理医药废水时停留时间、电解电压、废水初始浓度、温度和废水pH值等影响因子对去除色度、COD和提高废水可生化性等处理效果的影响，并考察了其应用于工业实际废水处理的可行性。实验结果表明：电解法更适合高浓度医药废水的处理，色度的去除率可达到90％以上；电解时间宜控制在40-60min；电解电压越高，废水COD和色度去除效果越好；在实验温度范围内，温度对色度和COD去除率的影响不大；废水pH值为7．5时电解效果最佳，工程运用宜控制在6—9之间。     

青霉菌HHE-P7利用酱油废水产生微生物絮凝剂的研究

研究了微生物絮凝剂产生菌HHE-P7在酱油废水中产生微生物絮凝剂的絮凝特性。实验表明，酱油废水由于碳源丰富，是一种良好的培养基。HHE-P7菌最佳培养条件为：COD20000mg／L，K2HP041．0g／L，培养3d。最佳絮凝条件为在1L高岭土水中投加10～15mL微生物絮凝剂（MBF7），pH调至9，则絮凝率为90％以上；微生物絮凝荆在水系中主要起吸附架桥的作用。     

生物活性炭法深度处理纺织废水二级出水中生物活性的研究

采用上流式曝气生物活性炭法处理碱减量印染废水二级生物处理出水，利用TTC-脱氢酶活性（DHA）法监测反应器内DHA生物活性分布。研究发现反应器内生物炭表面附着生物膜活性较高，特别是反应器上部生物碳粒同样具有较高的DHA活性，这与反应器运行一年多能够保持对COD、色度和UV等较高去除率有一定关系。还研究了活性炭吸附、反应器反冲洗对DHA活性的影响。本研究为曝气生物活性炭法有效去除印染碱减量废水中难降解有机物提供了一定的理论依据。     

Rapid degradation of butachlor in wheat rhizosphere soil

The degradative characteristics of butachlor in non-rhizosphere, wheat rhizosphere, and inoculated rhizosphere soils were measured. The rate constants for the degradation of butachlor in non-rhizosphere, rhizosphere, and inoculated rhizosphere soils were measured to be 0.0385, 0.0902, 0.1091 at 1 mg/kg, 0.0348, 0.0629, 0.2355 at 10 mg/kg, and 0.0299, 0.0386, 0.0642 at 100 mg/kg, respectively. The corresponding half-lives for butachlor in the soils were calculated to be 18.0, 7.7, 6.3 days at 1 mg/kg, 19.9, 11.0, 2.9 days at 10 mg/kg, and 23.2, 18.0, 10.8 days at 100 mg/kg, respectively. The experimental results show that the degradation of butachlor can be enhanced greatly in wheat rhizosphere, and especially in the rhizosphere inoculated with the bacterial community designated HD which is capable of degrading butachlor. It could be concluded that rhizosphere soil inoculated with microorganisms-degrading target herbicides is a useful pathway to achieve rapid degradation of the herbicides in soil.     

Wet air oxidation of a reactive dye solution using CoAlPO(4)-5 and CeO(2) catalysts

Wet air oxidation of a prepared reactive dye solution was performed to assess the efficacy of CoAlPO(4)-5 and CeO(2) as catalysts in the reaction. Via adsorption and oxidation of dye, CoAlPO(4)-5 effectively decreased American Dye Manufacturers Institute and chemical oxygen demand (COD) values in the dye solution. At a reaction temperature of 135 degrees C and an applied pressure of 1.0 MPa, color and COD removal were as high as 95% and 90%, respectively, after 2 h. Active sites on the outer surface of CoAlPO(4)-5 are responsible for adsorption and decomposition of dye while active sites in the pores dominate further destruction and oxidation of intermediate products. Since the outer surface only represents a minor part of the total surface, the color removal does not increase appreciably with loading of CoAlPO(4)-5. The CeO(2) catalyst, calcined from cerium chloride under high thermal impact (type A CeO(2)) was very effective in removing color and COD from the solution. This catalyst demonstrated near 100% color removal at temperatures above 135 degrees C and the COD removal could be above 95% at 165 degrees C. With both CoAlPO(4)-5 and CeO(2) catalysts, COD rose and then fell back during the reaction, a feature typical of a consecutive reaction. In contrast to prepared CeO(2), a commercial CeO(2) did not exhibit any catalytic ability for the removal of color and COD. The durability of both CoAlPO(4)-5 and prepared CeO(2) is considered to be fair.     

制浆废液降低普钙水分的应用研究

针对我国采用高临界流动水分的磷矿进行湿法生产普钙普遍存在产品水分达不到部颁标准的难题,直接采用制浆废液(利用其主要对环境有害成分之一--MNA作减水剂)进行降低普钙水分的研究和应用.实验结果表明,添加少量的减水剂MNA可显著降低国内朝阳、昆阳、浏阳和国外摩洛哥等单种磷矿以及昆阳-朝阳混矿的矿浆粘度和水分.采用国产昆阳-朝阳混矿进行工业生产试验结果表明,添加0.35%～0.4%干矿粉重量的减水剂MNA,不仅可使球磨添加水量从145 kg降至103 kg,矿浆含水量从30.5%降至27%,成品肥含水量从16.24%降至13.77%,而且可使有效磷从10.67%升至12.24%,转化率由86.57%提高到90.45%,矿浆细度由90.18%提高到93.12%.实验和工业生产试验表明,直接用造纸制浆废液降低普钙水分,既确保和改善了普钙的产品质量,又治理了环境污染,取得了较好的经济、环境和社会效益.     

错流式动态膜-生物反应器中污泥活性的研究

应用错流式动态膜-生物反应器(CDMBR)对己内酰胺废水进行了180 d的实验,实验过程中测定反应器的膜出水和上清液的水质,并对污泥进行了耗氧呼吸速率测定.结果表明,上清液COD一直保持在100mg/L以下,而膜出水的则保持在50 mg/L以下,膜对上清液的COD去除率达50%,而对氮的去除没有贡献.可溶性细胞产物(SMP)在反应器内容易积累,停留足够的时间后能被生物降解.通过投加抑制剂测定耗氧呼吸速率,发现异养菌、硝化细菌和亚硝化细菌的活性由于F/M的降低和SMP积累受到一定的抑制,但不影响系统的处理效率.跨膜压力、膜面流速越大,通量衰减得也就越快.     

一种新型复合球填料在低浓度污水再生回用中的应用研究

新型复合球填料为沸石与悬浮球填料的有机组合体,密度约为0.92～0.97g/cm3,比表面积为711～1185m2/m3,表面粗糙,物化性能稳定.在曝气量为20∶1,停留时间为6 h时,装有新型复合球填料的反应柱挂膜容易,成膜时间短,膜不易脱落,且生物相丰富.膜成熟时对生活污水中的氨氮和COD都有很好的去除效果,出水氨氮浓度≤2 mg/L,去除率≥93%;出水COD浓度≤22 mg/L,去除率≥80%.新型复合球反应柱在稳定状态处理低浓度的二级出水时,出水氨氮浓度≤2 mg/L,去除率≥89%,出水COD浓度为10～36 mg/L,去除率为48%～81%.出水水质符合GB50335-2002标准.