Regulation of hepatocyte proliferation

After partial hepatectomy the low proliferation rate of hepatocytes increases dramatically. This is based on a feed-back system whose central link is a liver cell proliferation hormon, the so-called hepatopoietin. The hormon originates from the Peyer's patches: after their resection, the liver cell proliferation after partial hepatectomy decreases by about 80%. Hepatopoietin effects organ specific but species nonspecific.     

Buchbesprechungen

The Science of Nature -     

The effect of oxygen tension on colony formation and cell proliferation of amniotic fluid cellsin vitro

The effects of reduced oxygen concentrations in the gas phase over the culture medium on colony formation and cell proliferation were investigated in high and low cell density primary and secondary cultures of amniotic fluid cells. Using two standard culture methods (25 cm² plastic flasks and Leighton type tubes) a significantly reduced culture time was observed at high cell density for mass cultures by incubation within a low oxygen tension gas phase (2.5 per cent to 7.5 per cent O₂) instead of conventional air (18 per cent O₂). At low cell density colony formation was significantly enhanced in cultures grown at reduced oxygen tension. Using gas permeable membranes as support, lowering the oxygen tension from 7.5 per cent to 2.5 per cent yielded an increase in plating efficiency of cells from approximately 5 per cent to 25 per cent, whereas plating efficiency was less than 2 per cent for cells grown at ambient 18 per cent O₂. It is suggested that low oxygen tension in the gas phase is an effective means of enhancing clonal growth in amniotic fluid cell cultures, thereby reducing both culture time and risk of culture failure.     

Numerical analysis of water and solute transport in variably-saturated fractured clayey till

This study numerically investigates the influence of initial water content and rain intensities on the preferential migration of two fluorescent tracers, Acid Yellow 7 (AY7) and Sulforhodamine B (SB), through variably-saturated fractured clayey till. The simulations are based on the numerical model HydroGeoSphere, which solves 3D variably-saturated flow and solute transport in discretely-fractured porous media. Using detailed knowledge of the matrix, fracture, and biopore properties, the numerical model is calibrated and validated against experimental high-resolution tracer images/data collected under dry and wet soil conditions and for three different rain events. The model could reproduce reasonably well the observed preferential migration of AY7 and SB through the fractured till, although it did not capture the exact depth of migration and the negligible impact of the dead-end biopores in a near-saturated matrix. A sensitivity analysis suggests fast flow mechanisms and dynamic surface coating in the biopores, and the presence of a plough pan in the till.     

A global assessment of chromium pollution using sperm whales (Physeter macrocephalus) as an indicator species

Chromium (Cr) is a well-known human carcinogen and a potential reproductive toxicant, but its contribution to ocean pollution is poorly understood. The aim of this study was to provide a global baseline for Cr as a marine pollutant using the sperm whale (Physeter macrocephalus) as an indicator species. Biopsies were collected from free-ranging whales around the globe during the voyage of the research vessel The Odyssey. Total Cr levels were measured in 361 sperm whales collected from 16 regions around the globe detectable levels ranged from 0.9 to 122.6 μg Cr g tissue⁻¹ with a global mean of 8.8 ± 0.9 μg g⁻¹. Two whales had undetectable levels. The highest levels were found in sperm whales sampled in the waters near the Islands of Kiribati in the Pacific (mean = 44.3 ± 14.4) and the Seychelles in the Indian Ocean (mean = 19.5 ± 5.4 μg g⁻¹). The lowest mean levels were found in whales near the Canary Islands (mean = 3.7 ± 0.8 μg g⁻¹) and off of the coast of Sri Lanka (mean = 3.3 ± 0.4 μg g⁻¹). The global mean Cr level in whale skin was 28-times higher than mean Cr skin levels in humans without occupational exposure. The whale levels were more similar to levels only observed previously in human lung tissue from workers who died of Cr-induced lung cancer. We conclude that Cr pollution in the marine environment is significant and that further study is urgently needed.     

Oxidative properties of ambient PM2.5 and elemental composition: Heterogeneous associations in 19 European cities

We assessed the extent to which constituents of PM_2.5 (transition metals, sodium, chloride) contribute to the ability to generate hydroxyl radicals (OH) in vitro in PM_2.5 sampled at 20 locations in 19 European centres participating in the European Community Respiratory Health Survey. PM_2.5 samples (n = 716) were collected on filters over one year and the oxidative activity of particle suspensions obtained from these filters was then assessed by measuring their ability to generate OH in the presence of hydrogen peroxide. Associations between OH formation and the studied PM constituents were heterogeneous. The total explained variance ranged from 85% in Norwich to only 6% in Albacete. Among the 20 centres, 15 showed positive correlations between one or more of the measured transition metals (copper, iron, manganese, lead, vanadium and titanium) and OH formation. In 9 of 20 centres OH formation was negatively associated with chloride, and in 3 centres with sodium. Across 19 European cities, elements which explained the largest variations in OH formation were chloride, iron and sodium.     

Substance-related environmental monitoring

Background  Due to the requirements of the EU Water Framework Directive and other legal regulations (e.g., national laws like the German Federal Soil Protection Act), but also due to the implementation of the new EU chemicals management system REACH, environmental monitoring will gain increasing importance for the surveillance of environmental quality as well as for the assessment of chemicals. Against this background, the Work Group on ‘Environmental Monitoring’ of the Division of ‘Environmental Chemistry and Ecotoxicology’ within the German Chemical Society has compiled a position paper on substance-related environmental monitoring. Scope  Core elements of this position paper are the definitions of important terms like monitoring, exposure monitoring, effect monitoring, and integrated monitoring. Moreover, temporal and spatial aspects (monitoring of spatial distributions, trend monitoring, and retrospective monitoring) and their applications are discussed. The main focus of this position paper is the coverage of aspects which have to be observed for the preparation and implementation of a monitoring program. Essential is the clear specification of the targets of the monitoring which determine the development of the monitoring concept and its realization, e.g., if environmental media (compartments) or organisms are most appropriate as samples for the aim of the study. Of course, also the properties of the target substances are important (e.g., lipophilicity/bioaccumulation as pre-requisite for an exposure monitoring with organisms). Finally, the monitoring phases of sample planning, sampling, storage and transport of samples, selection of analytical methods, quality assurance measures as well as reporting are discussed. Perspectives  An important issue for the future is to link the quantification of chemicals in environmental compartments (exposure and pollution monitoring) more closely to the study of biological effects (effect monitoring) than has been the case up to now. Furthermore, by inclusion of a spatial differentiation, a comprehensive evaluation of the state of an ecosystem can be obtained and the relevance of the results improved. Practical examples of monitoring studies which illustrate various aspects covered in this position paper will be presented in a series of publications by members of the Work Group in the following issues of this journal.

Numerical simulation of an array of fences in Saemangeum reclaimed land

This paper discusses about the quantitative effect of windbreak fences on wind velocity in the reclaimed land at Saemangeum in South Korea. Windbreak fences were constructed in the reclaimed land to reduce the wind velocity to prevent the generation and diffusion of dust. However, up to this time, no in-depth studies were conducted to quantitatively measure the effect of the windbreak fences on wind velocity thus an optimum windbreak structure is not yet determined. Using CFD simulations, the effects of fence porosity, fence height, and the distance between the adjacent fences were investigated. A wind tunnel experiment was initially conducted and data gathered were used to develop the CFD models. From the experiments and CFD simulations, the overall percentage difference of the measured velocities was 7.20% which is generally acceptable to establishing the reliability of the CFD models. The reduction effect on wind velocity was measured in between the adjacent fences up to a height of 0.6 m from the ground surface. In terms of porosity ( = 0, 0.2, 0.4, 0.6), 0.2 was found to be the optimum value. Conversely, the effect of fence height (0.6, 0.8 and 1.0 m) showed no significant difference; therefore, 0.6 m height is recommended. In addition, the reduction effect of distance between the adjacent fences (2, 4 and 6 m) on wind velocity having a 0.2 porosity has decreased to about 75% regardless of the distance. In the case of the reclaimed land in Saemangeum, a decrease of 75% can prevent the generation and diffusion of dusts. However, the source of dusts is very large. Therefore, constructing an array of windbreak with 6 m distance between them is deemed necessary.