Development of the IM147: an alternative inspection/maintenance mass-emission transient test to address vehicle preconditioning concerns

A series of studies was performed to develop an alternative to the U.S. Environmental Protection Agency's gold standard IM240 mass-based emission test. The new IM147 test was based on the second phase of the IM240 that consists of 147 sec of transient vehicle operation. Paired IM240/IM147 tests were conducted on vehicles ranging from 1981 to 1996 to determine IM147 cutpoints and excess emissions were identified. Additionally, an optimized test procedure was developed that combined possible triplicate IM147s with improved drive trace quality control, fast-pass, and retest methods. The optimized procedure was found to provide improved vehicle preconditioning with a relatively minor decrease in excess emissions identification. Resulting identification rates ranged from 96 to 100% for hydrocarbons (HC), 93-100% for CO, and 93-100% for NOx, depending on cutpoint selection, while false failures caused by lack of vehicle preconditioning were reduced to essentially zero. Significant vehicle throughput improvements were achieved through the development of software algorithms involving modal fast-pass and retest procedures. Modal drive trace variation limits also were developed to improve test accuracy. The combination of the algorithms reduced average IM147 test times by nearly 60%.     

Der Weg in die Nachhaltigkeit

Ohne Zusammenfassung     

Biological dehalogenation and halogenation reactions

A large number of halogenated compounds is produced by chemical synthesis. Some of these compounds are very toxic and cause enormous problems to human health and to the environment. Investigations on the degradation of halocompounds by microorganisms have led to the detection of various dehalogenating enzymes catalyzing the removal of halogen atoms under aerobic and anaerobic conditions involving different mechanisms. On the other hand, more than 3500 halocompounds are known to be produced biologically, some of them in great amounts. Until 1997, only haloperoxidases were thought to be responsible for incorporation of halogen atoms into organic compounds. However, recent investigations into the biosynthesis of halogenated metabolites by bacteria have shown that a novel type of halogenating enzymes, FADH(2)-dependent halogenases, are involved in biosyntheses of halogenated metabolites. In every gene cluster coding for the biosynthesis of a halogenated metabolite, isolated so far, one or several genes for FADH(2)-dependent halogenases have been identified.     

Herausforderungen des Klimawandels

Ohne Zusammenfassung     

Impact of engine lubricant properties on regulated gaseous emissions of 2000-2001 model-year gasoline vehicles

The impact of the sulfur (S) content in lubricating oil was evaluated for four ultra-low-emission vehicles and two super-ultra-low-emission vehicles, all with low mileage. The S content in the lube oils ranged from 0.01 to 0.76%, while the S content of the gasoline was fixed at 0.2 ppmw. Vehicles were configured with aged catalysts and tested over the Federal Test Procedure, at idle and at 50-mph cruise conditions. In all testing modes, variations in the S level of the lubricant did not significantly affect the regulated gas-phase tailpipe emissions. In addition to the regulated gas-phase emissions, a key element of the research was measuring the engine-out sulfur dioxide (SO2) in near-real-time. This research used a new methodology based on a differential optical absorption spectrometer (DOAS) to measure SO2 from the lubricants used in this study. With the DOAS, the contribution of SO2 emissions for the highest-S lubricant was found to range from less than 1 to 6 ppm on a gasoline S equivalent basis over the range of vehicles and test cycles used. The development and operation of the DOAS is discussed in this paper.     

Matrix-immobilized organoclay for the sorption of polycyclic aromatic hydrocarbons and pentachlorophenol from groundwater

Sorbent materials consisting of organoclay immobilized onto the surface of a solid support were evaluated for use in pentachlorophenol (PCP) and polycyclic aromatic hydrocarbon (PAH) remediation of groundwater at a creosote-contaminated Superfund site. Cetylpyridinium-exchanged low pH montmorillonite clay (CP-LPHM) was bonded to either sand (CP-LPHM/sand) or granular activated carbon (GAC) (CP-LPHM/GAC) using the free acid form of carboxymethylcellulose as an adhesive. Effluent from an oil-water separator was eluted through equal bed volumes of composite (4 g 3:2 CP-LPHM/GAC or 13 g CP-LPHM/sand), affinity-extracted, and quantitatively analyzed by GC/MS. PCP, naphthalene, fluorene, phenanthrene, pyrene, and total PAHs were initially reduced by both CP-LPHM/GAC (> or =99%, 61%, 99%, > or =99%, 97%, and 94%, respectively) and CP-LPHM/sand (90%, 70%, 94%, 95%, 93%, and 86%, respectively). Complete breakthrough of naphthalene occurred after approximately 15 h of elution through 3:2 CP-LPHM/GAC and 22 h through CP-LPHM/sand. PCP showed complete breakthrough following 18 h of elution through 3:2 CP-LPHM/GAC and 26 h through CP-LPHM/sand. However, 50% breakthrough was not attained for higher molecular weight PAHs, as fluoranthene, pyrene, benzo[a]anthracene, and chrysene continued to be greatly reduced with both 3:2 CP-LPHM/GAC (98%, 95%, 94%, and 95%, respectively) and CP-LPHM/sand (75%, 73%, 76%, and 78%, respectively) after 48 h of continuous elution. Results confirm prior studies, indicating that these organoclay-containing composites have a high capacity for contaminants found in wood preserving waste. Further, results suggest that the inclusion of CP-LPHM may be useful as part of an effective strategy for groundwater remediation of high concentrations of PCP and PAHs, in particular high molecular weight and carcinogenic PAHs.