Development of injury criteria for pelvic fracture in frontal crashes

OBJECTIVE: This article assesses the position-dependent injury tolerance of the hip in the frontal direction based on testing of eight postmortem human subjects. METHODS: For each subject, the left and right hemipelvis complex was axially loaded using a previously developed test configuration. Six positions were defined from a seated femur neutral condition, combining flexed, neutral, and extended femur positions with abducted, neutral, and adducted positions. RESULTS: Axial injury tolerances based on peak force were found to be 6,850 +/- 840 N in the extended, neutral position and 4,080 +/- 830 N in the flexed, neutral position. From the flexed neutral orientation, the peak axial force increased 18% for 20 degrees abduction and decreased 6% for 20 degrees adduction. From the extended, neutral orientation, the peak axial force decreased 4% for 20 degrees abduction and decreased 3% for 20 degrees adduction. However, as there is evidence that increases in loading may occur after the initiation of fracture, the magnitude of the peak force is likely related to the extent of injury, not to the initial tolerance. Using the axial femur force at the initiation of fracture (assessed with acoustic crack sensors) as a potentially more relevant indicator of injury may lower the existing injury criteria. This fracture initiation force varied by position from 3,010 +/- 560 N in the flexed, neutral position to 5,470 N in the extended, abducted position. Further, there was a large position-dependent variation in the ratio of fracture initiation force to the peak axial force. The initiation of fracture was 83% of the peak axial force in the extended, abducted position, but the ratio was 34% in the extended, adducted position. CONCLUSIONS: This may have significant implications for the development of pelvic injury criteria by automobile designers attempting to mitigate pelvis injuries.     

Depositional records of plutonium and (137)Cs released from Nagasaki atomic bomb in sediment of Nishiyama reservoir at Nagasaki

In a sediment core of Nishiyama reservoir at Nagasaki city, depth profiles of (240)Pu/(239)Pu isotopic ratio, (239+240)Pu and (137)Cs activities were determined. Sediments containing plutonium and (137)Cs, which were deposited immediately after a detonation of Nagasaki atomic bomb, were identified in the core. Observed below the sediments were macroscopic charcoals, providing evidence for initial deposit of the fallout of the Nagasaki atomic bomb. This is the first entire depositional records of plutonium and (137)Cs released from the Nagasaki atomic bomb together with those from atmospheric nuclear tests.     

Size- and density-distributions and sources of polycyclic aromatic hydrocarbons in urban road dust

Polycyclic aromatic hydrocarbons (PAHs) present in size- and density-fractionated road dust were measured to identify the important fractions in urban runoff and to analyse their sources. Road dust was collected from a residential area (Shakujii) and a heavy traffic area (Hongo Street). The sampling of road dust from the residential area was conducted twice in different seasons (autumn and winter). The collected road dust was separated into three or four size-fractions and further fractionated into light (<1.7 g/cm3) and heavy (>1.7 g/cm3) fractions by using cesium chloride solution. Light particles constituted only 4.0+/-1.4%, 0.69+/-0.03% and 3.4+/-1.0% of the road dust by weight for Shakujii (November), Shakujii (February) and Hongo Street, respectively but contained 28+/-10%, 33+/-3% and 44+/-8% of the total PAHs, respectively. The PAH contents in the light fractions were 1-2 orders of magnitude higher than those in the heavy fractions. In the light fractions, the 12PAH contents in February were significantly higher than the 12PAH contents in November (P<0.01), whereas in the heavy fractions, no significant difference was found (P>0.05). Cluster analysis revealed that there was a significant difference in the PAH profiles between locations rather than between size-fractions, density-fractions and sampling times. Multiple regression analysis indicated that asphalt/pavement was the major source of Shakujii road dust, and that tyre and diesel vehicle exhaust were the major sources of finer and coarser fractions collected from Hongo Street road dust, respectively.     

Concentrations, enrichment and predominant sources of Sb and other trace elements in size classified airborne particulate matter collected in Tokyo from 1995 to 2004

APM was collected and trace elements existing in the particles were monitored since May 1995 in this study. APM sample was collected separately by size (d < 2 microm, 2-11 microm and >11 microm) on the roof of the university building (45 m above ground) in the campus of Faculty of Science and Engineering, Chuo University, Tokyo, Japan, using an Anderson low volume air sampler. The collected sample was digested by HNO3, H2O2 and HF using a microwave oven, and major elements (Na, Mg, Al, K, Ca and Fe) were measured by ICP-AES, and trace elements (Li, Be, Ti, V, Cr, Mn, Co, Ni, Cu, Zn, As, Se, Mo, Cd, Sb, Ba and Pb) were measured by ICP-MS. It was observed that the APM concentration was higher between the winter and the spring, compared to during the summer. The enrichment factor was calculated for each element in each set of APM (d < 2 microm, 2-11 microm and >11 microm). Seasonal trends of enrichment factors were examined, and the elements were classified into 3 groups according to the common seasonal behavior. It is likely that the elements in the same group have common origins. Toxic pollutant elements (Sb, Se, Cd, Pb and As) were found in small particles with d of <2 microm in concentrated levels. Antimony (Sb) had the highest enrichment factor, and the results suggested that Sb level in APM was extremely high. The origins of Sb were sought, and wastes from plastic incineration and brake pad wears of automobiles were suspected. Each set of APM (d < 2 microm, 2-11 microm and >11 microm) was classified by the shape, and the shape-dependent constituents of a single APM particle were quantitatively measured by SEM-EDX. High concentration of Sb was found in APM <2 microm and square particles. Particles less than 2 microm and square shaped particles were major particles produced by actual car braking experiments. From these experimental results it was concluded that the source of Sb in squared APM <2 microm is considered to be from brake pad wear.     

Estimation of contribution from non-point sources to perfluorinated surfactants in a river by using boron as a wastewater tracer

The contribution of non-point sources to perfluorinated surfactants (PFSs) in a river was evaluated by estimating their fluxes and by using boron (B) as a tracer. The utility of PFSs/B as an indicator for evaluating the impact of non-point sources was demonstrated. River water samples were collected from the Iruma River, upstream of the intake of drinking water treatment plants in Tokyo, during dry weather and wet weather, and 13 PFSs, dissolved organic carbon (DOC), total nitrogen (TN), and B were analyzed. Perfluorohexane sulfonate (PFHxS), perfluorooctane sulfonate (PFOS), perfluoroheptanoate (PFHpA), perfluorooctanoate (PFOA), perfluorononanoate (PFNA), perfluorodecanoate (PFDA), perfluoroundecanoate (PFUA), and perfluorododecanoate (PFDoDA) were detected on all sampling dates. The concentrations and fluxes of perfluorocarboxylates (PFCAs, e.g. PFOA and PFNA) were higher during wet weather, but those of perfluoroalkyl sulfonates (PFASs, e.g. PFHxS and PFOS) were not. The wet/dry ratios of PFSs/B (ratios of PFSs/B during wet weather to those during dry weather) agreed well with those of PFS fluxes (ratios of PFS fluxes during wet weather to those during dry weather), indicating that PFSs/B is useful for evaluating the contribution from non-point sources to PFSs in rivers. The wet/dry ratios of PFOA and PFNA were higher than those of other PFSs, DOC, and TN, showing that non-point sources contributed greatly to PFOA and PFNA in the water. This is the first study to use B as a wastewater tracer to estimate the contribution of non-point sources to PFSs in a river.     

Biodegradation of endosulfan by Mortieralla sp. strain W8 in soil: Influence of different substrates on biodegradation

To examine the bioremediation potential of Mortierella sp. strain W8 in endosulfan contaminated soil, the fungus was inoculated into sterilized and unsterilized soil spiked with endosulfan. Wheat bran and cane molasses were used as substrates to understand the influence of different organic materials on the degradation of endosulfan in soil. Strain W8 degraded α- and β-endosulfan in both sterilized and unsterilized soil. In unsterilized soil with wheat bran+W8, α- and β- endosulfan were degraded by approximately 80% and 50%, respectively after 28 d incubation against the initial endosulfan concentration (3 mg kg(-1) dw). The corresponding values for α- and β-endosulfan degradation with wheat bran only were 50% and 3%. Endosulfan diol metabolite was detected after 14 d incubation in wheat bran+W8 whereas it was not found with wheat bran only. Production of endosulfan sulfate, the main metabolite of endosulfan, was suppressed with wheat bran+W8 treatment compared with wheat bran only. It was demonstrated that wheat bran is a more suitable substrate for strain W8 than cane molasses. Wheat bran+W8 is a superior fungus and substrate mix for bioremediation in soil contaminated with endosulfan.