Measurement of real time black carbon for investigating spot loading effects of Aethalometer data

Measurements of real-time continuous PM_2.5 black carbon (BC) concentrations were made using a single-wavelength Aethalometer (@880 nm) in three different environments, i.e., an indoor office, a residential indoor living room and an urban site, to evaluate the difference in temporal behaviors of BC particles and investigate the optical shadowing effect in the Aethalometer BC data. An empirical method was used for correcting the optical saturation effect on the original BC data obtained from the measurements at the three sites. Also, the elemental carbon (EC) concentrations from 24-h filter-based measurements of PM_2.5 particles were determined using a thermal optical transmittance (TOT) method at the same urban site for comparison with the Aethalometer BC results. Transient events of BC were often observed for period of a few hours at all sites, reaching a maximum level of 27.3 μg m^?3 at the urban site. The diurnal cycles of the BC concentrations observed at the two indoor environments were found to be considerably affected by the air exchange rate, occupants' behavior patterns and nearby traffic emissions. The time-series plots of the Aethalometer data showed obvious discontinuities at the filter spot change, and a rise in the apparent BC concentrations after filter tape advances. Also, the relationship between the attenuation and BC concentration was found to be non-linear at all sites. The empirical approach presented here demonstrated a definite improvement in the continuity of the BC data across the time gaps of each tape advance. The compensated BC concentration was 1.10–1.23 times greater than the raw BC data, depending on the observation sites, with the highest difference observed between the raw and compensated BC data at an indoor office near a small traffic road. The 24-h integrated EC concentration was approximately 12% higher than the original 24-h average BC concentration and 6% lower than the loading compensated BC concentration, showing that the loading compensation process accounted for the saturation effect of the filter tape.     

Biochemical and cellular effects of electrophiles present in ambient air samples

Ambient vapor-phase samples collected in Riverside, California had shown that both redox and electrophilic activity were present, with the vapor phase containing higher levels of electrophiles than the particle phase. In this study, the biochemical effects of the vapor-phase electrophiles were examined using the purified thiol proteins, glyceraldehyde-3-phosphate dehydrogenase (GAPDH), protein tyrosine phosphatase 1B (PTP1B) and KELCH-1 like ECH-associated protein 1 (Keap1). The results demonstrated that the thiol proteins were inactivated by the vapor-phase samples through covalent modifications. Next, two cellular responses, epidermal growth factor receptor (EGFR)/mitogen-activated protein (MAP) kinase and NF-E2-related factor 2 (Nrf2), to the ambient vapor-phase samples were assessed in A549 and RAW 264.7 cell lines, respectively. The vapor-phase samples, at non-oxidative concentrations, increased phosphorylation of EGFR, which is negatively regulated by PTP1B, and its downstream MAP kinase, extracellular signal-regulated kinase (ERK)1/2. Activation of Nrf2, which requires Keap1 alkylation, and expression of its downstream proteins were also observed. The electrophilic compounds present in ambient vapor-phase were shown to modify cellular proteins through covalent modification and to activate diverse cellular responses that can lead to inflammatory and adaptive responses.     

Allocation and banking in Korean permits trading

This paper investigates how Korean industry would respond to four different allocation and banking options in CO₂ permit trading within a fully dynamic computational general equilibrium framework. Four different allocations are categorized—a uniform allocation and three performance-based allocations. We explore that performance-based allocation and banking lower losses in Korean potential GDP, allowing energy-intensive industry more flexibility in inter-temporal decision making on purchasing and selling permits. The steel industry can derive a particular advantage from a performance-based allocation with respect to energy use, while the semiconductor industry would prefer a performance-based allocation with respect to value-added. The two key conclusions are (i) the Korean economy should replace an absolute allocation with a performance-based allocation, and (ii) the banking of permits enables market players to reallocate allowances more efficiently in a long-term commitment period. These results support the findings of the key study by Kling and Rubin (1997).     

Performance evaluation of an in situ nitrous acid measurement system and continuous measurement of nitrous acid in an indoor environment

Nitrous acid (HONO) may cause adverse effects to mucous membranes and lung function when people are exposed to higher HONO concentrations than those present in typical indoor residential environments. Therefore, determination of HONO concentration in indoor environments is required to investigate occurrences of high HONO levels. In this work, a high-time-resolution measurement system was utilized to better understand the levels and dynamic behavior of HONO in an indoor environment. The performance of the in situ HONO analyzer applied to this work was evaluated using a 12-hr integrated annular denuder technique under ambient conditions. Both methods for the measurements of HONO were in good agreement, with a regression slope of 0.84, an intercept of 0.09, and correlation coefficient (r2) of 0.67. Indoor HONO and nitrogen oxide concentrations were also observed for approximately 5 days in winter in the living room of an apartment that had a gas range for cooking in the kitchen. Investigation of the relationships among nitric oxide (NO), nitrite (NO2), and HONO concentrations suggests that HONO production during combustion could be the result of direct emission, whereas the heterogeneous NO2 chemistry during the background period and after combustion was the possible pathway of HONO production. Controlled combustion experiments, performed at a burning rate of 50% valve setting, show peak HONO concentrations during the unvented combustion to be approximately 8-10 times higher than background levels depending on the time of day. At a burning rate setting of 50%, the peak concentration of HONO during unvented combustion was found to be 33-37% higher than those from "weak" (airflow = 340 m3/hr) and "strong" (airflow = 540 m3/hr) vented combustions. The decay rate of the HONO concentrations for the unvented combustion conditions was approximately 2-fold higher in the daytime than in the nighttime and significantly less than those of NO and NO2.     

Toxicological evaluation of the chemical oxidation methods for landfill stabilization

As the stabilization criteria for landfill sites, only chemical criteria for the leachate discharges from the landfill sites have been used in Japan and many other countries. Recently, chemical oxidation has been developed as a method for the early-stabilization of landfills. However, by-products that are difficult to detect by chemical analysis can be produced by this method. Therefore, toxicity tests are useful tools for detecting the changes of leachate quality after application of this method. The heat source in the A landfill was analyzed by organic position inquiry technology, and ozone-treated leachate was sprayed back to the heat source in the landfill. Toxicity changes of the leachate after the spray were monitored using Microtoxtrade mark, ToxScreen-II, and DaphTox tests. The hardly-degradable organic matter was efficiently removed and toxicities of the leachate in the heat source decreased after the application. These toxicity results were significantly related to chemical oxygen demand (COD) changes. Thus, it was concluded that the toxicity tests were effective for monitoring the leachate quality after applying the chemical oxidation method for landfill stabilization, and its incorporation to establish the criteria for early-stabilization of landfill sites needs to be considered.     

Benefits of mitigated ambient air quality due to transportation control on childhood asthma hospitalization during the 2002 summer Asian games in Busan, Korea

The objective of this study is to see whether there were any health benefits of mitigated air pollution concentration due to reduced traffic flow during a citywide intervention for the 2002 Summer Asian Games. Relative risks of hospitalization for childhood asthma during the post-Asian Game period compared with the baseline period were estimated using a time-series analysis of the generalized additive Poisson model. Fourteen consecutive days of traffic volume control in Busan during the Games reduced all regulated air pollutant levels by 1-25%. The estimated relative risk of hospitalization during the post-Games period over the baseline period was 0.73 (95% confidence interval [CI] = 0.49, 1.11). We observed that this reduced air pollution was unique in 2002 when the traffic volume reduction program was applied during the Games period. This empirical data provides epidemiologic evidence of the health benefits resulting from environmental interventions to reduce ambient air pollution.     

A small change in the design of a slit bioaerosol impactor significantly improves its collection characteristics

While several methods are available for bioaerosol monitoring, impaction remains the most common one, particularly for collecting fungal spores. Earlier studies have shown that the collection efficiency of many conventional single-stage bioaerosol impactors falls below 50% for spores with an aerodynamic diameter between 1.7 and 2.5 microm because their cut-off size is 2.5 microm or greater. The cut-off size reduction is primarily done by substantially increasing the sampling flow rate or decreasing the impaction jet size, W, to a fraction of a millimetre, with both measures often impractical to implement. Some success has recently been reported on the utilization of an ultra-low jet-to-plate distance, S (S/W < 0.1), in circular impactors. This paper describes a laboratory evaluation and some field testing of two single-stage, single-nozzle, slit bioaerosol impactors, Allergenco-D and Air-O-Cell, which feature the same jet dimensions and flow rate but have some design configuration differences that were initially thought to be of low significance. The collection efficiency and the spore deposit characteristics were determined in the laboratory using real-time aerosol spectrometry and different microscopic enumeration methods as the test impactors were challenged with the non-biological polydisperse NaCl aerosol and the aerosolized fungal spores of Cladosporium cladosporioides, Aspergillus versicolor, and Penicillium melinii. The tests showed that a relatively small reduction in the jet-to-plate distance of a single-stage, single-nozzle impactor with a tapered inlet nozzle, combined with adding a straight section of sufficient length, can significantly decrease the cut-off size to the level that is sufficient to efficiently collect spores of all fungal species. Furthermore, it appears that the slit jet design may improve the application of partial spore counting methodologies with respect to those applied to circular deposits. Data from a demonstration field study, conducted with the two samplers in environments containing a variety of fungal species, supported the laboratory findings.     

The stability of butyltin compounds in a dredged heavily-contaminated sediment

A treatment process for marine sediment heavily contaminated with tributyltin (TBT) was designed that included dehydrating, sunlight drying and dumping processes. The time course in butyltin (BTs) compounds, TBT, dibutyltin (DBT) and monobutyltin concentrations were investigated in the sediment treated under various conditions (light (UV, sunlight and light exclusion), moisture (air-drying and water saturation) and wetting and drying cycles). Significant changes in all the BT compound concentrations with time were not found regardless of the sediment conditions for light and moisture. The results indicated the high stabilities of TBT and DBT in the sediments versus light and moisture condition changes, probably taking place in the treatment process. It is also estimated that the BTs in the sediment are resistant to photo-degradation and biochemical degradation and their half lives are relatively long. In contrast, the decreases in the TBT and DBT were observed during the wetting and drying cycle treatment for the water saturated sediment both during exposure to sunlight and under a dark condition. This result suggested the hypothesis that the TBT degradation could be accelerated by the high microbial activity induced by the moisture changing treatments.     

1H-NMR-based metabolomic studies of bisphenol A in zebrafish (Danio rerio)

Proton nuclear magnetic resonance (¹H-NMR) spectroscopy was used to study the response of zebrafish (Danio rerio) to increasing concentrations of bisphenol A (4,4′-(propane-2,2-diyl)diphenol, BPA). Orthogonal partial least squares discriminant analysis (OPLS-DA) was applied to detect aberrant metabolomic profiles after 72 h of BPA exposure at all levels tested (0.01, 0.1, and 1.0 mg/L). The OPLS-DA score plots showed that BPA exposure caused significant alterations in the metabolome. The metabolomic changes in response to BPA exposure generally exhibited nonlinear patterns, with the exception of reduced levels of several metabolites, including glutamine, inosine, lactate, and succinate. As the level of BPA exposure increased, individual metabolite patterns indicated that the zebrafish metabolome was subjected to severe oxidative stress. Interestingly, ATP levels increased significantly at all levels of BPA exposure. In the present study, we demonstrated the applicability of ¹H-NMR-based metabolomics to identify the discrete nature of metabolic changes.     

Recovery of Nd and Dy from rare earth magnetic waste sludge by hydrometallurgical process

This paper describes a hydrometallurgical process for recovering neodymium (Nd) and dysprosium (Dy) from a magnetic waste sludge generated from the Nd–Fe–B(–Dy) manufacturing process. Phase analysis by XRD study revealed Nd(OH)₃ and Fe₂O₃ as main mineral phases, and chemical analysis by ICP showed the contents of 35.1 wt% Nd, 29.5 wt% Fe, 1.1 wt% Dy and 0.5 wt% B. A solution of 1 M HNO₃ + 0.3 M H₂O₂ was used to dissolve up to 98 % Nd and 81 % Dy, while keeping Fe dissolution below 15 % within 10 min. Fe dissolved in solution was completely removed as Fe(OH)₃ at pH 3 followed by precipitation of Nd and Dy with oxalic acid (H₂C₂O₄) and recovered 91.5 % of Nd and 81.8 % of Dy from solution. The precipitate containing Nd and Dy was calcined at 800 °C to obtain Nd₂O₃ as final product with 68 % purity, and final recovery of 69.7 % Nd and 51 % of Dy was reported in this process.