Carbon mitigation potential and costs of forestry options in Brazil,China, India,Indonesia, Mexico,the Philippines and Tanzania

This paper summarizes studies of carbon (C) mitigation potential and costs of about 40 forestry options in seven developing countries. Each study uses the same methodological approach – Comprehensive Mitigation Assessment Process (COMAP) – to estimate the above parameters between 2000 and 2030. The approach requires the projection of baseline and mitigation land-use scenarios. Coupled with data on a per ha basis on C sequestration or avoidance, and costs and benefits, it allows the estimation of monetary benefit per Mg C, and the total costs and carbon potential. The results show that about half (3.0 Pg C) the cumulative mitigation potential of 6.2 Petagram (Pg) C between 2000 and 2030 in the seven countries (about 200× 10⁶ Mg C yr^-1) could be achieved at a negative cost and the remainder at costs ranging up to $100 Mg C^-1. About 5 Pg C could be achieved, at a cost less than $20 per Mg C. Negative cost potential indicates that non-carbon revenue is sufficient to offset direct costs of these options. The achievable potential is likely to be smaller, however, due to market, institutional, and sociocultural barriers that can delay or prevent the implementation of the analyzed options.     

Hydrogen storage and distribution systems

Hydrogen storage and transportation or distribution is closely linked together. Hydrogen can be distributed continuously in pipelines or batch wise by ships, trucks, railway or airplanes. All batch transportation requires a storage system but also pipelines can be used as pressure storage system. Hydrogen exhibits the highest heating value per weight of all chemical fuels. Furthermore, hydrogen is regenerative and environment friendly. There are two reasons why hydrogen is not the major fuel of toady’s energy consumption: First of all, hydrogen is just an energy carrier. And, although it is the most abundant element in the universe, it has to be produced, since on earth it only occurs in the form of water. This implies that we have to pay for this energy, which results in a difficult economic task, because since the industrialization we are used to consuming energy for free. The second difficulty with hydrogen as an energy carrier is the low critical temperature of 33 K, i.e. hydrogen is a gas at room temperature. For mobile and in many cases also for stationary applications the volumetric and gravimetric density of hydrogen in a storage system is crucial. Hydrogen can be stored by six different methods and phenomena: high pressure gas cylinders (up to 800 bar), liquid hydrogen in cryogenic tanks (at 21 K), adsorbed hydrogen on materials with a large specific surface area (at T < 100 K), absorbed on interstitial sites in a host metal (at ambient pressure and temperature), chemically bond in covalent and ionic compounds (at ambient pressure), oxidation of reactive metals e.g. Li, Na, Mg, Al, Zn with water. These metals easily react with water to the corresponding hydroxide and liberate the hydrogen from the water. Finally, the metal hydroxides can be thermally reduced to the metals in a solar furnace.     

Alteration in Rhizosphere Soil Properties of Afforested <Emphasis Type="Italic">Rhamnus lycioides</Emphasis> Seedlings in Short-Term Response to Mycorrhizal Inoculation with <Emphasis Type="Italic">Glomus intraradices</Emphasis> and Organic Amendment

The reestablisment of autochthonous plant species is an essential strategy for recovering degraded areas under semiarid conditions. A field experiment was carried out to assess the short-term effect of two reafforestation methods involving mycorrhizal inoculation and compost addition on soil quality parameters and Rhamnus lycioides seedling growth. The nutrient content (NPK) and enzymatic activities (dehydrogenase, urease, protease-BAA, acid phosphatase and β-glucosidase) increased and bulk density decreased in the rhizosphere soil with the organic amendment. Biomass C of rhizosphere soil increased by at least 240% with respect to the control soil after mycorrhizal inoculation and the combination of compost addition + mycorrhizal inoculation. Both mycorrhizal inoculation and composted organic residue addition increased R. lycioides seedling growth in the same proportion. In the short term, we conclude that the application of both reafforestation methods not only enhances the establishment of R. lycioides seedlings, but also improves soil quality.     

Synthesis of Short-chain-length/Medium-chain-length Polyhydroxyalkanoate (PHA) Copolymers in Peroxisome of the Transgenic Arabidopsis Thaliana Harboring the PHA Synthase Gene from Pseudomonas sp. 61-3

In this paper, the photosynthetic production of short-chain-length/medium-chain-length polyhydroxyalkanoate (PHA) copolymers is reported. The wild-type and highly active doubly mutated PHA synthase 1 (S325T/Q481K, abbreviated ST/QK) genes from Pseudomonas sp. 61-3 were introduced into Arabidopsis thaliana. Peroxisome targeting signal 1 (PTS1) was used to target PHA synthases into the peroxisome to synthesize PHA from the intermediates of the β-oxidation pathway. The transgenic Arabidopsis produced PHA copolymers consisting of 40–57 mol% 3-hydroxybutyrate, 21–49 mol% 3-hydroxyvalerate, 8–18 mol% 3-hydroxyhexanoate, and 2–8 mol% 3-hydroxyoctanoate. The maximum PHA contents were 220μ g/g cell dry weight (cdw) in leaves, and 36μ g/g cdw in stems, respectively. The expression of the ST/QK mutated PHA synthase in leaves gene did not lead to significant difference in PHA content and monomer composition of PHAs, compared to the wild-type PHA synthase gene, suggesting that the supply of monomers may be a rate-determining step of PHA biosynthesis in the peroxisome. However, in stems, there were significant differences dependent on whether the wild-type or ST/QK mutated PHA synthase was expressed. These results suggest that tissue-specific monomer availability is important in determining the final mol% composition of PHA copolymers produced by the peroxisome in plants.     

Quantifying dry NH3 deposition to an ombrotrophic bog from an automated NH3 field release system

Providing an accurate estimate of the dry component of N deposition to low N background, semi-natural habitats, such as bogs and upland moors dominated by Calluna vulgaris is difficult, but essential to relate nitrogen deposition to effects in these communities. To quantify the effects of NH₃ inputs to moorland vegetation growing on a bog at a field scale, a field release NH₃ fumigation system was established at Whim Moss (Scottish Borders) in 2002. Gaseous NH₃ from a line source was released along of a 60 m transect, when meteorological conditions (wind speed >2.5 m s^?1 and wind direction in the sector 180–215°) were met, thereby providing a profile of decreasing NH₃ concentration with distance from the source. In a complementary study, using a NH₃ flux chamber system, the relationships between NH₃ concentrations and cuticular resistances were quantified for a range of NH₃ concentrations and micrometeorological conditions for moorland vegetation. Cuticular resistances increased with NH₃ concentration from 11 s m^?1 at 3.0 μg m^?3 to 30 s m^?1 at 30 μg m^?3. The NH₃ concentration data and the concentration-dependent canopy resistance are used to calculate NH₃ deposition taking into account leaf surface wetness. The implications of using an NH₃ concentration-dependent cuticular resistance and the importance for refining critical loads are discussed.     

Facile Preparation of Chitosan Films for High Performance Removal of Reactive Blue 19 Dye from Aqueous Solution

This study aimed at finding effective strategies for high-performance removal of reactive blue 19 (RB19) dye from aqueous solution. Chitosan (CS) films had been prepared by using solvent casting with mild drying for this purpose. The CS films were characterized by X-ray diffraction, field-emission scanning electron microscopy, and Fourier transform infrared (FTIR) spectroscopy. The performance of RB19 removal using CS were evaluated by varying contact time, solution pH, initial dye concentration, and adsorbent dosage. Adsorption isotherms, kinetics, and desorption were investigated by batch experiments. Results showed that CS films exhibited the optimal adsorption performance for RB19 removal and high maximum adsorption capacities of RB19, which were 799 and 822.4 mg g^?1 at 20 and 40 °C, respectively. Adsorption kinetic data were well described by the pseudo-second-order kinetic model. FTIR analyses further indicated that interactions between RB19 and the CS film occurred during adsorption. The CS films also exhibited satisfactory desorption of RB19 at about 80 % after 30 min of desorption at pH 11. Our study demonstrated that the CS films can be easily prepared and applied for effective removal of RB19 in treatment of wastewater.     

Report on the fifth meeting of INRA’s national network of ecotoxicologists,ECOTOX

The fifth meeting of INRA’s national network of ecotoxicologists took place on 25 to 27 November 2014 in Biarritz, France. The main aim of the meeting was to bring together ecotoxicologists from INRA and associated partners, providing them ample opportunity to share and discuss their latest scientific results as well as the national policy of research in ecotoxicology and to precise perspectives for the network.