离子色谱法测定饮用水和面包中的溴酸根

选用ＡＳ９－ＨＣ高容量阴离子交换色谱柱,不需处理除去干扰离子,可直接进样。测定了两种水样,其中一种检出溴酸根,方法检出根０．００５ｍｇ．１＾－１水样加标回收率９１．３－９３．４％。采用全新的自动化样品处理技术－加速溶剂萃取萃取面包中的溴酸根。经ＡＳ９－ＳＣ阴离子交换色谱柱分离,选择最佳淋洗条件。电导检测,方法检 ０．０７ｍｇ．１＾－１,对十二种市售包进行测定,均未检出溴酸根,样品加标回收率７９．９     

VB程序实现微量元素相关比值的计算

微量元素的相关比值在许多领域都有不同的作用,随着研究工作的日益精细,数据越来越多,使得不少学者要把大量时间花在数据的整理和计算上,既不利于准确的统计,又浪费了时间.在探讨、实现了地壳中微量元素的相关比值的VB程序,使得在运用这些比值时方便、准确、省时,为研究工作减少许多不必要的麻烦.     

活性炭吸附水中铅离子的动态研究

本文采用两种煤质活性炭，研究了其对不同浓度二价铅离子溶液的吸附，应用固定床吸附动力学模型，Ｍａｒｑａｄｔ方法非线性回归固定床吸附流出曲线，获得了铅离子在活性炭上的扩散传质系数。结果发现，孔扩散系数Ｄｐ强裂地依赖于铅离子入口浓度，随着入口浓度的升高，孔扩散系数变小，随后用上述扩攻系数理论预测了其它操作条件下的流出曲线，结果表明实验曲线与理论预测曲线能很好地相符，动态法能可靠地获取固吸附过程的吸附及扩     

纳米TiO2光催化氧化异丙醇和丙酮反应的研究

分别研究了纳米TiO2 在主波长为 364nm的汞灯光照下催化氧化i C3H7OH和CH3COCH3水溶液的反应速率 .通过XRD ,TEM ,BET和FT IR PAS对催化剂进行表征 ,粉末的晶型主要为锐钛矿型 .平均粒径在 1 5nm左右 ,比表面积为 1 0 1 0± 0 2m2 ·g- 1 ,FT IR PAS的检测结果表明 ,CH3COCH3是i C3H7OH光催化氧化的中间产物 ,其光催化氧化反应为 :i C3H7OH [O]CH3COCH3[O]CH3COOH[O]…[O]CO2 H2 O     

扬州市生态旅游发展战略的研究

分析扬州市旅游业发展的优势和劣势，论述并评价扬州市主要的生态旅游资源，进行扬州市生态旅游发展的功能分区与项目策划，提出实施扬州市生态旅游发展战略的对策及措施。     

高效油水分离器和过滤器处理油田污水的现场实验研究

为了开发高效、低耗的含油污水处理工艺技术和设备,在吉林油田新立采油厂,对石油大学（北京）研制开发的高效油水分离器和高效过滤器处理油田污水的技术性能进行了现场测试研究。油水分离器采用斜通道波纹板作内构件,过滤器用炉渣做滤料。现场实验表明：高效油水分离器和高效过滤器串联处理油田污水,不论污水含油量高低,其过滤器出口水中含油量不高于１０ｍｇ／Ｌ者达９４％：过滤器出口水中悬浮物不高于１０ｍｇ／Ｌ者占８６％。结果说明该套装置在油和悬浮物的脱除及操作方面性能优异。有推广应用前景。     

酸雨损害农作物的对策研究——喷水消除酸雨对农作物的损害

经模拟酸雨处理植物的试验表明,酸雨对植物叶片的直接损害是由于酸雨水滴滞留在叶面引起的。若在雨后2h内喷水(pH7.0±0.2)以驱除滞留在叶面的水滴,叶片则无受害症状,叶绿素含量、生物产量和经济产量所受的影响也将减轻甚至完全不受影响。     

我国中小城市大气污染总量控制研究

本文提出了一套适合于我国中小城市大气污染总量控制研究的技术路线和模型。通过环境容量规划和污染综合治理规划的有机结合，从而达到以优化的方式协调经济发展与环境保护的矛盾。对镇江市的应用结果表明，本文提出的技术路线和模型是合理可行的。所给出的总量控制方案既能符合经济发展的需要，又能经济有效地控制并改善区域的大气环境质量。     

Estimation of organic carbon blank values and error structures of the speciation trends network data for source apportionment

Because the particulate organic carbon (OC) concentrations reported in U.S. Environment Protection Agency Speciation Trends Network (STN) data were not blank corrected, the OC blank concentrations were estimated using the intercept in particulate matter < or = 2.5 microm in aerodynamic diameter (PM2.5) regression against OC concentrations. The estimated OC blank concentrations ranged from 1 to 2.4 microg/m3 showing higher values in urban areas for the 13 monitoring sites in the northeastern United States. In the STN data, several different samplers and analyzers are used, and various instruments show different method detection limit (MDL) values, as well as errors. A comprehensive set of error structures that would be used for numerous source apportionment studies of STN data was estimated by comparing a limited set of measured concentrations and their associated uncertainties. To examine the estimated error structures and investigate the appropriate MDL values, PM2.5 samples collected at a STN site in Burlington, VT, were analyzed through the application of the positive matrix factorization. A total of 323 samples that were collected between December 2000 and December 2003 and 49 species based on several variable selection criteria were used, and eight sources were successfully identified in this study with the estimated error structures and min values among different MDL values from the five instruments: secondary sulfate aerosol (41%), secondary nitrate aerosol (20%), airborne soil (15%), gasoline vehicle emissions (7%), diesel emissions (7%), aged sea salt (4%), copper smelting (3%), and ferrous smelting (2%). Time series plots of contributions from airborne soil indicate that the highly elevated impacts from this source were likely caused primarily by dust storms.