Gasification characteristics of biomass for tar removal by secondary oxidant injection

Gasification experiments for sawdust were conducted using a fixed bed reactor at 900 °C by varying the secondary oxidant injection ratio to determine the optimal conditions for tar removal along with the enhancement of gasification efficiency. Secondary oxidant was injected as an oxidant at the top zone of the gasifier in varying ratios of 10–30% of the total amount of oxidant. This method was based on the primary method of tar removal and gasification efficiency improvement by thermal cracking of tar. Various gasification performance parameters were evaluated and tar content was estimated by measuring the fluctuation of weight of the activated carbon filter. The results showed that the concentration of tar in the producer gas decreased by injecting the secondary oxidant, even though syngas yield decreased. The recycling potential of the char produced in the gasification experiments was also assessed with the purpose of utilizing char as an adsorbent by determining its surface area and pore volume. The results demonstrated that the char produced from the gasification experiment had similar quality to that of the activated carbon used in this experiment.     

Fir decline and mortality in the southern Siberian Mountains

Regional Environmental Change - Increased dieback and mortality of “dark needle conifer” (DNC) stands (composed of fir (Abies sibirica), Siberian pine (Pinus sibirica) and spruce (Picea...     

Aquatic biomonitoring of Giardia cysts and Cryptosporidium oocysts in peninsular Malaysia

An aquatic biomonitoring of Giardia cysts and Cryptosporidium oocysts in river water corresponding to five villages situated in three states in peninsular Malaysia was determined. There were 51.3 % (20/39) and 23.1 % (9/39) samples positive for Giardia and Cryptosporidium (oo)cysts, respectively. Overall mean concentration between villages for Giardia cysts ranged from 0.10 to 25.80 cysts/l whilst Cryptosporidium oocysts ranged from 0.10 to 0.90 oocysts/l. Detailed results of the river samples from five villages indicated that Kuala Pangsun 100 % (9/9), Kemensah 77.8 % (7/9), Pos Piah 33.3 % (3/9) and Paya Lebar 33.3 % (1/3) were contaminated with Giardia cysts whilst Cryptosporidium (oo)cysts were only detected in Kemensah (100 %; 9/9) and Kuala Pangsun (66.6 %; 6/9). However, the water samples from Bentong were all negative for these waterborne parasites. Samples were collected from lower point, midpoint and upper point. Midpoint refers to the section of the river where the studied communities are highly populated. Meanwhile, the position of the lower point is at least 2 km southward of the midpoint and upper point is at least 2 km northward of the midpoint. The highest mean concentration for (oo)cysts was found at the lower points [3.15?±?6.09 (oo)cysts/l], followed by midpoints [0.66?±?1.10 (oo)cysts/l] and upper points [0.66?±?0.92 (oo)cysts/l]. The mean concentration of Giardia cysts was highest at Kuala Pangsun (i.e. 5.97?±?7.0 cysts/l), followed by Kemensah (0.83?±?0.81 cysts/l), Pos Piah (0.20?±?0.35 cysts/l) and Paya Lebar (0.10?±?0.19 cysts/l). On the other hand, the mean concentration of Cryptosporidium oocysts was higher at Kemensah (0.31?±?0.19 cysts/l) compared to Kuala Pangsun (0.03?±?0.03cysts/l). All the physical and chemical parameters did not show significant correlation with both protozoa. In future, viability status and molecular characterisation of Giardia and Cryptosporidium should be applied to identify species and genotypes/subgenotypes for better understanding of the epidemiology of these waterborne parasites.     

A Collaborative Effort to Model Plant Response to Acidic Rain

Radish plants were exposed three times per week to simulated acidic rain at pH values of 2.6 to 5.4 over the course of four weeks in trials performed at Argonne, Illinois; Ithaca and Upton, New York; Corvallis, Oregon; Oak Ridge, Tennessee; and Toronto, Canada. Uniform genotype, soil media and planting techniques, treatment procedures, biological measurements, and experimental design were employed. Growth of plants differed among trials as a result of variation in greenhouse environmental conditions according to location and facilities. Larger plants underwent greater absolute but lower relative reductions in biomass after exposure to the higher levels of acidity. A generalized Mitscherlich function was used to model the effects of acidity of simulated rain or dry mass of hypocotyls using data from three laboratories that performed duplicate trials. The remaining data, from three other laboratories that performed only one trial each, were used to test the model. When the laboratory by trial effect was removed (influence of different growth. conditions), lack of fit to the Mitscherlich function was insignificant. Thus, a single mathematical model satisfactorily characterized the relationship between acidity and mean plant response. The pH value associated with a 10 percent reduction in mass was 3.3 ± 0.3 for hypocotyls. No value was estimated for shoots because effects oh shoots were not significant. The results of this study demonstrate that a generalized exposure-response model can be developed in the presence of large variations in environmental conditions when plant culture and exposure to simulated rain are standardized among laboratories.     

HCI Sorption by Dry NaHCO3 for Incinerator Emissions Control

The sorption of hydrochloric acid (HCI) by thermally decomposed sodium bicarbonate (NaHCO₃) was investigated using a fixed-bed reactor containing sorbent particles dispersed in a bed of spherical glass beads. The gas flow rate (68° F and 760 mm Hg) was 0.039 cfm (1.1 liter/min) and the bed had a cross-sectional area of 0.0055 sq. ft. (5.1 sq. cm). The influence of particle diameter (10, 45 and 163 μm), temperature (225, 275, 375, 455, and 550° F), superficial gas velocity (11 and 21 fpm at reactor conditions, 375° F), and Inlet HCI gas concentration (415 ppm and 760 ppm in N₂, 275 and 455° F) were studied. Results showed that HCI sorption increased strongly with increasing temperature but was only weakly dependent on particle diameter, superficial gas velocity, and HCI gas concentration.     

The Potential of Pulse-Jet Baghouses for Utility Boilers. Part 2: Performance of Pulse-Jet Fabric Filter Pilot Plants

Pulse-jet fabric filters (PJFFs) are widely used in U.S. industrial boiler applications and in utility and industrial boilers abroad. Their small size and reduced cost relative to more conventional reverse-gas baghouses makes the use of PJFFs appear to be an attractive particulate control option for utility boilers. This paper (Part 2 of a three-part series) summarizes the results of pilot PJFF studies sponsored by the Electric Power Research Institute at different utility sites in the United States. The purpose of these tests is to evaluate PJFF performance for U.S. fossil-fuel-fired applications. These data are also used to corroborate the results of a recent worldwide survey of PJFF user experience, as described in Part 1 of this series. Part 3 will provide a cost comparison of PJFFs to other particulate control options such as electrostatic precipitators and reverse-gas baghouses.     

Decomposition of SF6 in an RF Plasma Environment

Abstract

Sulfur hexafluoride (SF₆)-contained gas is a common pollutant emitted during the etching process used in the semiconductor industry. This study demonstrated the application of radio-frequency (RF) plasma in the decomposition of SF₆. The decomposition fraction of SF₆ [η_SF6 (C_in–C_out)/C_in x 100%] and the mole fraction profile of the products were investigated as functions of input power and feed O₂/SF₆ ratio in an SiO₂ reactor. The species detected in both SF₆/Ar and SF₆/O₂/Ar RF plasmas were SiF₄, SO₂, F₂, SO₂F₂, SOF₂, SOF₄, S₂F₁₀, S₂OF₁₀, S₂O₂F₁₀, and SF₄. The results revealed that at 40 W, η_SF6 exceeded 99%, and the reaction products were almost all converted into stable compounds such as SiF₄, SO₂, and F₂ with or without the addition of oxygen. Sulfur oxyfluorides such as SO₂F₂, SOF₂, SOF₄, S₂OF₁₀, and S₂O₂F₁₀ were produced only below 40 W. The results of this work can be used to design a plasma/chemical system for online use in a series of a manufacturing process to treat SF₆-containing exhaust gases.     

Characterizing Driving Patterns for Zhuhai for Traffic Emissions Estimation

Abstract

Zhuhai, a relatively less developed city on the western coast of the Pearl River Delta (PRD) of China, is planning to undergo major development in coming years. A Hong Kong-Zhuhai-Macao Bridge project has been approved by the Central Government of China. The project will have great impact on the driving pattern and vehicular emissions to the city. This baseline study collected speed-time data of two instrumented private cars in morning and evening periods, as well as a daytime nonpeak period of >10 consecutive days in the spring and winter of 2003. The authors used the microwave speed sensor and global positioning system installed in the instrumented cars and used car-chasing technique to perform the data collection. They used the statistical package SPSS to assess the consistency, as well as to evaluate the variability of the data. Nine parameters, namely, average speed, average running speed, average acceleration rate, average deceleration rate, mean length of a driving period, time proportions of driving modes, average number of acceleration-deceleration changes, root mean square acceleration, and positive acceleration kinetic energy are calculated to represent the driving characteristics. A driving cycle for private cars was developed. If emission tests were conducted using the Zhuhai driving cycle, the level of vehicle emissions measured is likely to be in between that of the Federal Test Procedure (FTP) cycle and the Melbourne Peak cycle.