Ein Beitrag zur Diskussion über die Freilassung transgener Organismen

Problems which might be caused by the release of transgenic organisms are discussed from the viewpoint of genetics, population genetics and ecology. On this background, the differences between "classical" methods to recombine genetic information and the more recent ones of gene engineering are pointed out and the predictability of gene interactions is discussed. Moreover, the possibility of uncontrolled reproduction of released transgenic organisms and the distribution of manipulated genes are demonstrated on the basis of our knowledge on nontransgenic organisms. Finally, the problems of risk assessment are emphasized.     

Influence of surfactant-facilitated interfacial tension reduction on chlorinated solvent migration in porous media: observations and numerical simulation

The ability of a multiphase flow model to capture the migration behavior of chlorinated solvents under conditions of surfactant-facilitated interfacial tension (IFT) reduction is assessed through comparison of model predictions with observations from controlled laboratory experiments. Tetrachloroethene (PCE) was released in two-dimensional saturated systems, packed with sandy media that incorporated rectangular lenses of capillary contrast. Spatially uniform interfacial tension conditions were created in the tanks by pre-flushing the porous medium with either Milli Q water or an aqueous surfactant solution. Experimental observations showed that surfactant-facilitated IFT reductions substantially lowered capillary resistance to the vertical downward migration of PCE and enabled PCE to enter finer grained, less permeable lenses that were not penetrated in the absence of surfactant. An immiscible flow model was used to simulate the conditions of the laboratory experiments. Under higher IFT conditions (47.5 and 5 dyn/cm), the model could successfully predict the general migration behavior of the organic liquid. Model predictions, however, exhibited poorer agreement with observed migration pathways under low IFT conditions (0.5 dyn/cm). In all cases, the predicted PCE distributions were influenced by selection of the parametric model for capillary retention and relative permeability. Simulated migration rates were more consistent with observed behavior when the Brooks-Corey/Burdine model was employed. For low interfacial tensions, improved predictions of migration pathways were obtained through grid refinement and incorporation of small-scale packing variability. Simulations highlight the substantial sensitivity of model predictions to the capillary pressure-scaling factor, grid resolution, and small-scale porosity variations at interfaces of permeability contrast under reduced IFT conditions.     

Disinfection of surfaces by photocatalytic oxidation with titanium dioxide and UVA light

Particularly in microbiological laboratories and areas in intensive medical use, regular and thorough disinfection of surfaces is required in order to reduce the numbers of bacteria and to prevent bacterial transmission. The conventional methods of disinfection with wiping are not effective in the longer term, cannot be standardized, are time- and staff-intensive and use aggressive chemicals. Disinfection with hard ultraviolet C (UVC) light is usually not satisfactory, as the depth of penetration is inadequate and there are occupational medicine risks. Photocatalytic oxidation on surfaces coated with titanium dioxide (TiO2) might offer a possible alternative. In the presence of water and oxygen, highly reactive OH-radicals are generated by TiO2 and mild ultraviolet A (UVA). These radicals are able to destroy bacteria, and may therefore be effective in reducing bacterial contamination. Direct irradiation with UVC however can produce areas of shadow in which bacteria are not inactivated. Using targeted light guidance and a light-guiding sheet (out of a UVA-transmittant, Plexiglas, for example), as in the method described in the present study, bacterial inactivation over the entire area is possible. The effectiveness of the method was demonstrated using bacteria relevant to hygiene such as Escherichia coli, Pseudomonas aeruginosa, Staphylococcus aureus and Enterococcus faecium. For these bacteria, a reduction efficiency (RE) more than 6log10 steps in 60 min was observed. Using Candida albicans, a RE of 2log10 steps in 60 min was seen. Light and scanning electron microscopic examinations suggest that the germ destruction achieved takes place through direct damage to cell walls caused by OH-radicals.     

Uptake of nitroaromatic compounds in plants

The uptake of nitroaromatic compounds by plants from the soil was studied at an ammunition site. After the development of analytical methods for 2,4,6-trinitrotoluene, aminodinitrotoluenes and dinitrotoluenes in plant material, we could show that these substances accumulated in the roots of plants and are found to a lesser extent inleaves and stems. We observed only moderate differences between various plant species. It is likely that a metabolic transformation in plants leads to the formation of dinitrotoluenes which are considered to be potent carcinogens. Results from soils with a wide range of explosive concentrations show a good correlation between the plant and soil concentrations. The relative accumulation in plant material is higher at lower soil concentrations. At low soil concentrations of about 1 mg trinitrotoluene/kg soil, an accumulation factor of about 0.5 can be derived. These data are an important input for the risk assessment of ammunition sites.     

Hochwasser 2002

In August 2002, highly contaminated areas in the region of Bitterfeld, e.g. the floodplain of the creek Spittelwasser, as well as the adjacent regions of Jeßnitz and Raguhn, were submerged by the river Mulde. An input of mobilized contaminated sediments in residential areas was the matter of concern. The objective of the present study was to estimate the pollutants load on the basis of chemical and biological data and identify the sources of pollutants. Deposited sludge and flood water samples were assessed on the basis of biological and chemical analyses and in comparison with administrative reference values. The pollution of the investigated sites was rather heterogeneous. At several sites, tolerance limits of the German Klärschlammverordnung or the Bundesbodenschutzverordnung were clearly exceeded, e.g. for Pb, As and HCH. Organic extracts exhibited significant effects in several biotests. This may be relevant with respect to direct particle uptake via ingestion or respiration. Pollution patterns for heavy metals as well as for organic pollutants differed significantly from the pattern found in the Spittelwasser flood plain before the inundation, which is in contrast to the initial hypothesis of a possible transport of contaminated Spittelwasser sediments into residential areas. Interestingly, a correlation of chemical load and the overall biological effect could be shown. From the viewpoint of the precautionary principle, the identification of the compounds exerting toxic effects and of the respective pollutant sources would be desirable.     

Bodennahes Ozon: Trends in Bayern

Long-term ground-based measurements of ozone in Bavaria (Germany) are evaluated in respect of their trend during the last 20 years. First a method is described to characterize the measuring-sites in relation to the levels of precursors: The derived division in three classes proved its worth interpreting the results. Following, the trend of ozone-concentration are calculated by linear regression analysis and are tested in respect of their significance. Generally the Bavarian results fit in the trends of a long-term increase of ozone-concentrations observed at several central European stations. In detail, there are differences between stations situated at elevated sites or at other sites without traffic (class I) and stations situated at sites with significant influence of nearby traffic (classes II and III). At stations of class I an increase of ozone until the mid 80’s is recorded. Afterwards this trend seems to be stopped. But at the stations of classes II and III an increase of ozone is occuring only since the mid 80’s. The observed trends are correlated with the trends of NO_x-emissions.     

Fernmeßverfahren

The combination of remote sensing methods like Doppler lidar and FTIR allows remote determination of mass fluxes of gases. Doppler lidar measures the three-dimensional wind vector in the vicinity of diffuse sources, or the velocity of air in a chimney plume if an industrial complex is monitored. FTIR is a multicomponent remote sensing method for gas concentrations. The Fourier transformation of an interferogram of a Michelson interferometer within a FTIR system converts the recorded intensity (function of optical path length) to a spectral signal (function of wavenumber). Both information, velocity and concentration, give the mass fluxes of the tracer (gas). A first test was performed at Munich-Nord power station with FTIR and cw-Doppler lidar. Fluxes of CO₂, CO, NO, and HCl were determined. The results are in good agreement with the fluxes measured byin situ instruments of the power station. The method can be used to control industrial complexes from an outside observation site.