长庆油田4731B型非金属集输管道老化特性实验研究

为推广非金属复合管在油田集输油领域的应用，明确其在集输环境中的老化特性是关键问题。基于集输油现场的工程条件，针对长庆油田试用的4731B型钢丝缠绕增强复合管，以采出原油、采出水为实验介质，通过挂片实验、水压爆破实验，借助电镜扫描、拉伸测试对复合管内衬层老化行为、拉伸性能以及复合管极限承压与老化特性进行研究。结果表明:采出原油与采出水均可渗透扩散进入内衬层内部，还会发生局部深入渗透；采出原油、采出水的局部渗透速率分别可达3.4，10.6 mm/a；在某些工况下，内衬层表面产生裂纹；短时间（168 h）内的介质渗透甚至裂纹对其机械性能影响较小，而光氧老化影响显著；现场服役813 d后，复合管极限承压下降2.79%，表明复合管承压性能稳定。     

Precursors and potential sources of ground-level ozone in suburban Shanghai

• Air masses from Zhejiang Province is the major source of O₃ in suburban Shanghai. • O₃ formation was in VOC-sensitive regime in rural Shanghai. • O₃ formation was most sensitive to propylene in rural Shanghai. A high level of ozone (O₃) is frequently observed in the suburbs of Shanghai, the reason for this high level remains unclear. To obtain a detailed insight on the high level of O₃ during summer in Shanghai, O₃ and its precursors were measured at a suburban site in Shanghai from July 1, 2016 to July 31, 2016. Using the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) model and concentration weighted trajectories (CWT), we found that Zhejiang province was the main potential source of O₃ in suburban Shanghai. When the sampling site was controlled by south-western winds exceeding 2 m/s, the O₃-rich air masses from upwind regions (such as Zhejiang province) could be transported to the suburban Shanghai. The propylene-equivalent concentration (PEC) and ozone formation potential (OFP) were further calculated for each VOC species, and the results suggested that propylene, (m+p)-xylene, and toluene played dominant roles in O₃ formation. The Ozone Isopleth Plotting Research (OZIPR) model was used to reveal the impact of O₃ precursors on O₃ formation, and 4 base-cases were selected to adjust the model simulation. An average disparity of 18.20% was achieved between the simulated and observed O₃ concentrations. The O₃ isopleth diagram illustrated that O₃ formation in July 2016 was in VOC-sensitive regime, although the VOC/NO_x ratio was greater than 20. By introducing sensitivity (S), a sensitivity analysis was performed for O₃ formation. We found that O₃ formation was sensitive to propylene, (m+p)-xylene, o-xylene and toluene. The results provide theoretical support for O₃ pollution treatment in Shanghai.     

Study on phosphorus loadings in ten natural and agricultural watersheds in subtropical region of China

Water eutrophication in subtropical regions of southern China threatens watershed health and is of major concern. However, annual phosphorus (P) loading and its dominant causes are still unclear, especially at the watershed scale. In this study, we investigated dynamic P loadings and associated factors (e.g., land use, livestock production, and runoff depth) in ten watersheds that varied in area from 9 to 5,212 ha in a hilly area of Hunan Province, China. A flowmeter was installed at the outlet of each watershed, and total P (TP) and soluble P (SP) concentrations were monitored periodically from June 2010 to October 2012. The results showed that annual P loadings (APLs) in the ten watersheds ranged from 22.8 to 247.8 kg P/km² and that P loss primarily occurred from April to June of each year during the main rainfall season in the study area. In addition, the average eutrophication (>0.05 mg P/L) ratio for stream waters was 86.7 % during the study period, which was indicative of a potentially serious condition for the local water environments. Annual P loadings were linearly related to livestock density (LD; R?=?0.92, p?<?0.01), whereas the eutrophication ratio of stream water was significantly (p?<?0.05) correlated with LD (R?=?0.61), percentage cropland (R?=?0.71), and percentage forest cover (R?=??0.68). Thus, it is concluded that the control of livestock production has the greatest potential for reducing P loadings in watersheds in this subtropical area. This will be beneficial to the amelioration and protection of local environment.     

Optimization of bio-drying of kitchen waste: inoculation,initial moisture content and bulking agents

Journal of Material Cycles and Waste Management - Bio-drying has been proved to be a promising method for treatment of MSW (municipal solid waste) and sewage sludge due to its high energy...     

含阶梯结构的高层楼梯井内烟气湍流及输运特征量的全局敏感性分析

高层建筑竖井火灾中影响因素众多,并且各因素对高层楼梯井火灾中重要现象、关键数值等的影响大小不一,使得此类火灾中的实验或理论研究成本较高。通过建立全局敏感性分析平台,定量考察了高层楼梯井结构所涉及因素的影响大小,并能够方便地筛选掉对所考察量影响较小的因素,以降低实验或计算成本。使用数值模拟方法,通过CFD软件对包含阶梯几何框架的高层楼梯井结构火灾进行了共计60次工况计算。并且根据计算结果,使用全局参数敏感性分析方法,得出建筑尺寸、热释放速率、环境参数对高层楼梯井内烟气湍流特性及输运特性的敏感性排序。结果表明,火源热释放速率对各输出参数的影响均占38%以上。     

Determination of trace metal concentrations in soil profiles of municipal waste dumps in Nigeria

The concentrations of trace metals (Cd, Pb, Cu, Cr, Fe, Ni, Zn and Co) were studied in soil profiles of eight municipal waste dump sites in Warri metropolis. The results indicate that concentrations of trace metals varied widely among the different dumpsites and decreased with depths in a studied soil profile. The accumulation pattern for the heavy metals in the soil profiles follows the order: Fe > Pb > Mn > Co > Cr > Zn > Ni > Cu > Cd. The concentrations of metals found in these sites was below the Canadian remediation criteria for land for agricultural, residential and commercial/industrial purposes except for the cadmium levels in some sites that exceeded criterion values for agricultural and residential. In such sites, remedial actions are required before any form of chosen development can take place. The levels of heavy metals found in these dump sites were higher than that of the control site. The examined metals showed no significant correlation with soil physicochemical properties at the surface horizon, which is suggestive evidence that these metals arise from anthropogenic input.     

Critical Review of Norms and Standards for Biodegradable Agricultural Plastics Part II: Composting

The critical review of norms and standards and corresponding tests to determine the compostability of biodegradable plastics, possibly applicable also to biodegradable agricultural plastics, shows that many norms concerning testing and labelling of compostable plastics have been established at the international level. Some of them are about plastic materials, some others are about products like packaging. The media and conditions of testing cover mainly the conditions designed for industrial composting facilities, and only a few concern home composting conditions. Considering that the end of life management of biodegradable agricultural plastic products will be done at the farm to reduce the management of the waste and also its cost, only a few of these norms are considered to be suitable for adaptation to cover also biodegradable agricultural plastic products. The biodegradability validation criteria under composting conditions, such as the threshold percentage of biodegradation and disintegration, the time and temperature, and the ecotoxicity, are presented for the main norms and standard testing methods. Based on these different norms and their content, a list of specs and technical requirements that could be adapted to meet farm composting conditions for agricultural compostable plastics is proposed. These requirements may be used as criteria for the establishment of a new integrative norm for agricultural compostable plastics.     

Research on Methods for Building Volcano Disaster Information System--taking Changbai Mountain as an example

1IntroductionAs a many-volcano-distributed country,China is covered with many volcanoes and lava rocks.A-mong the one-thousand-or-so volcanoes,Changbai Mountain Volcano,Wudalianchi Volcano,Tengchong Volcano and Ashikule Volcano of West Kunlun are the mostlatentcatastrophic erup-tive active volcanoes.In recent years,the activity of the earth' s crust in some volcanic areas isobviously becoming increasing violent.Butfew scholars have monitored and evaluated volcano inChina.So building VDI…     

昌黎生态监控区夏季浮游植物群落年际变化特征分析

为研究昌黎生态监控区夏季浮游植物群落结构特征及其与环境因子关系,采用2005~2013年夏季(8月)昌黎生态监控区海域浮游植物及环境因子的监测资料,基于Arc GIS 10.0和Canoco软件平台,运用典范对应分析方法,对浮游植物群落结构进行分析.结果表明,近9 a共鉴定出浮游植物3门23科39属105种,其中,硅藻门16科32属90种,占浮游植物总数的85.7%;甲藻门共6科6属14种,占总种类数的13.3%;金藻门1种.各年的优势种存在很大差异,按照优势度Y值的大小包括辐射圆筛藻(Coscinodiscus radiatus)、柔弱角毛藻(Coscinodiscus debilis)、笔尖根管藻(Rhizosolenia styliformis)、柏氏角管藻(Cerataulina bergoni)、威氏圆筛藻(Coscinodiscus wailesii)、海链藻(Thalassiosira sp.)、三角角藻(Ceratium tripos)、洛氏角毛藻(Coscinodiscus wailesii)、中肋骨条藻(Ceratium tripos)等.夏季细胞丰度年际变化较大,呈现逐渐降低的趋势.浮游植物的多样性指数H'值介于0.015~3.889,均匀度指数J值介于0.009~1,年际变化幅度较小;各站位间物种分布不均匀,优势种较少且优势度较大.对浮游植物群落与环境因子进行典范对应分析(CCA),结果表明影响夏季浮游植物群落结构变化的环境因子包括水温、营养盐(磷酸盐、硝酸氮、氨氮)、盐度等,且是各个环境因子相互作用的结果.     

电化学氢化物发生法处理含锑废水及对锑的回收

采用电化学氢化物发生法对模拟含锑废水进行处理,锑与水电解产生的氢形成氢化物从溶液中脱除,而后收集并加热分解锑化氢得到金属锑.实验表明,在酸性条件下对Sb(Ⅲ)去除效果较好,p H=4时去除率为76.1%.Sb(Ⅲ)与电解水产生的氢结合形成锑化氢从溶液中逸出是溶液中锑去除的最主要途径(回收率为66.2%),电沉积和吸附也对锑的去除做出少量贡献.Sb(Ⅴ)须预还原为Sb(Ⅲ)再氢化进行去除.试用了铅、石墨、钨这3种电解阴极材料,铅电极处理效果最佳.