Laboratory investigation of three distinct emissions monitors for hydrochloric acid

The measurement of hydrochloric acid (HCl) on a continuous basis in coal-fired plants is expected to become more important if HCl standards become implemented as part of the Federal Mercury and Air Toxics Standards (MATS) standards that are under consideration. For this study, the operational performance of three methods/instruments, including tunable diode laser absorption spectroscopy (TDLAS), cavity ring down spectroscopy (CRDS), and Fourier transform infrared (FTIR) spectroscopy, were evaluated over a range of real-world operating environments. Evaluations were done over an HCl concentration range of 0–25 ppmv and temperatures of 25, 100, and 185 °C. The average differences with respect to temperature were 3.0% for the TDL for values over 2.0 ppmv and 6.9% of all concentrations, 3.3% for the CRDS, and 4.5% for the FTIR. Interference tests for H₂O, SO₂, and CO, CO₂, and NO for a range of concentrations typical of flue gases from coal-fired power plants did not show any strong interferences. The possible exception was an interference from H₂O with the FTIR. The instrument average precision over the entire range was 4.4% for the TDL with better precision seen for concentrations levels of 2.0 ppmv and above, 2.5% for the CRDS, and 3.5% for the FTIR. The minimum detection limits were all on the order of 0.25 ppmv, or less, utilizing the TDL values with a 5-m path. Zero drift was found to be 1.48% for the TDL, 0.88% for the CRDS, and 1.28% for the FTIR.

Implications: This study provides an evaluation of the operational performance of three methods/instruments, including TDL absorption spectroscopy (TDLAS), cavity ring down spectroscopy (CRDS), and FTIR spectroscopy, for the measurement of hydrochloric acid (HCl) over a range of real-world operating environments. The results showed good instrument accuracy as a function of temperature and no strong interferences for flue gases typical to coal-fired power plants. The results show that these instruments would be viable for the measurement of HCl in coal-fired plants if HCl standards become implemented as part of the Federal Mercury and Air Toxics Standards (MATS) standards that are under consideration.     

Transport and retention of fullerene nanoparticles in natural soils

Commercial production and use of fullerene (C60) nanomaterials will inevitably lead to their release into the environment, where knowledge of C60 fate and transport is limited. In this study, a series of one-dimensional column experiments was conducted to assess the transport and retention of nanoscale fullerene aggregates (nC60) in water-saturated soils. Under the experimental conditions, complete retention of nC60 was observed in columns (2.5 cm inside diameter x 11 cm length) packed with Appling or Webster soil, which contain 0.75 and 3.33% organic carbon by weight, respectively. When the volume of aqueous nC60 suspension (approximately 4.5 mg L(-1)) applied to Appling soil was increased from 5 to 65 pore volumes, the travel distance increased from 3 to 8 cm, and the retention capacity approached a limiting value of 130 microg g(-1), although nC60 was not detected in the column effluent. The addition of 20 mg C L(-1) Suwannee River humic acid to the influent suspension increased the nC60 transport in Appling soil but did not resul in breakthrough. Attempts to simulate the experimental data using clean-bed filtration theory were not satisfactory, yielding retention profiles that failed to match observed data. Subsequent incorporation of a limiting retention capacity expression into the mathematical model resulted in accurate predictions of the measured nC60 retention profiles and transport behavior. The sizable retention capacities observed in this study suggest that transport of nC60 is limited in relatively fine-textured soils containing appreciable amounts of clay minerals and organic matter, with substantial accumulation of nC60 aggregates near the point of release.     

Trisomy 12 mosaicism detected by mid–trimester amniocentesis

Trisomy 12 mosaicism was found in about 15 per cent of cultured amniocytes obtained from a 32-year-old white female at 17·6 weeks of gestation. Termination of pregnancy was elected and multiple tissues were obtained for chromosome analysis. Of 158 cells examined, only 1 cell in placenta was found with an extra number 12 chromosome. Pathological examination of the fetus did not reveal significant physical abnormalities. This report illustrates the difficulty of confirming trisomy 12 mosaicism which has been detected on prenatal diagnosis. The presence of trisomy 12 in one placental cell obtained from the curettage specimen suggests the possibility of confined placental mosaicism in this case.     

Incorporating green and sustainable remediation analysis in coal combustion residuals (CCR) surface impoundment closure decision making

In response to new coal combustion residuals (CCR) disposal regulations, many coal‐fired utilities have closed existing unlined surface impoundments (SIs) that were traditionally used for disposal of CCR. The two primary closure options are closure‐in‐place (CIP), which involves dewatering and capping, and closure‐by‐removal (CBR), which includes excavation, transportation, and disposal of the CCR into a lined landfill. This article provides a methodology and a case study of how green and sustainable remediation concepts, including accounting for the life cycle environmental footprints and the physical risks to workers and community members, can be incorporated into the closure decision‐making process. The environmental impacts, occupational risks, and traffic‐related fatalities and injuries to workers and community members were calculated and compared for closure alternatives at a hypothetical site. The results demonstrated that the adverse impacts of the CBR option were significantly greater than those of the CIP option with respect to the analyzed impact pathways.     

Landscape Correlates of Breeding Bird Richness Across the United States Mid-Atlantic Region

Using a new set of landscape indicator data generated by the U.S.EPA, and a comprehensive breeding bird database from the National Breeding Bird Survey, we evaluated associations between breeding bird richness and landscape characteristics across the entire mid-Atlantic region of the United States. We evaluated how these relationships varied among different groupings (guilds) of birds based on functional, structural, and compositional aspects of individual species demographics. Forest edge was by far the most important landscape attribute affecting the richness of the lumped specialist and generalist guilds; specialist species richness was negatively associated with forest edge and generalist richness was positively associated with forest edge. Landscape variables (indicators) explained a greater proportion of specialist species richness than the generalist guild (46% and 31%, respectively). The lower value in generalists may reflect finer-scale distributions of open habitat that go undetected by the Landsat satellite, open habitats created by roads (the areas from which breeding bird data are obtained), and the lumping of a wide variety of species into the generalist category. A further breakdown of species into 16 guilds showed considerable variation in the response of breeding birds to landscape conditions; forest obligate species had the strongest association with landscape indicators measured in this study (55% of the total variation explained) and forest generalists and open ground nesters the lowest (17% of the total variation explained). The variable response of guild species richness to landscape pattern suggests that one must consider species' demographics when assessing the consequences of landscape change on breeding birds.     

Estimating Remediation and Contaminant Respiration Emissions for Alternatives Comparisons at Petroleum Spill Sites

Greenhouse gas emissions assessments for site cleanups typically quantify emissions associated with remediation and not those from contaminant biodegradation. Yet, at petroleum spill sites, these emissions can be significant, and some remedial actions can decrease this additional component of the environmental footprint. This article demonstrates an emissions assessment for a hypothetical site, using the following technologies as examples: excavation with disposal to a landfill, light nonaqueous‐phase liquid (LNAPL) recovery with and without recovered product recycling, passive bioventing, and monitored natural attenuation (MNA). While the emissions associated with remediation for LNAPL recovery are greater than the other considered alternatives, this technology is comparable to excavation when a credit associated with product recycling is counted. Passive bioventing, a green remedial alternative, has greater remedial emissions than MNA, but unlike MNA can decrease contaminant‐related emissions by converting subsurface methane to carbon dioxide. For the presented example, passive bioventing has the lowest total emissions of all technologies considered. This illustrates the value in estimating both remediation and contaminant respiration emissions for petroleum spill sites, so that the benefit of green remedial approaches can be quantified at the remedial alternatives selection stage rather than simply as best management practices. ©2015 Wiley Periodicals, Inc.     

Creosote DNAPL Recovery‐Well Design for Mass Removal

Sites with dense nonaqueous‐phase liquid (DNAPL) contamination present significant remediation challenges in terms of technical practicability and cost. Remedial approaches to DNAPL sites often follow a management approach rather than removal or eradication approaches, particularly due to the uncertainties associated with the benefits of partial source mass removal, as complete source removal is unlikely. Mass‐removal technologies should be evaluated for all DNAPL sites, although implementation of recovery technologies will be limited to a few sites based upon site‐specific factors. Sitewide remedial strategies that employ source reduction, where applicable, and incorporate associated risk‐reduction technologies, including monitored natural attenuation, are advised. Creosote DNAPL sites are particularly challenging, as they are predominantly composed of low‐solubility polycyclic aromatic hydrocarbons that form long‐term continuing sources. Additionally, the physical properties of creosote DNAPL, including high viscosity and relatively low density, result in significant migration potential and considerable dissolved‐phase groundwater impacts. An innovative creosote DNAPL source recovery well design was developed to achieve separate‐phase removal of pooled creosote DNAPL. The design presented herein employs modified circulation‐well technology to mobilize DNAPL to the engineered recovery well, where it is gravity‐settled into a sump to permit separate‐phase mass removal of the emplaced DNAPL source without groundwater production or treatment. A discharge mass flux protocol was developed to verify dissolved‐phase plume stability and the benefit of the source mass removal. © 2013 Wiley Periodicals, Inc.     

Geographic Analysis of Forest Health Indicators Using Spatial Scan Statistics

Geographically explicit analysis tools are needed to assess forest health indicators that are measured over large regions. Spatial scan statistics can be used to detect spatial or spatiotemporal clusters of forests representing hotspots of extreme indicator values. This paper demonstrates the approach through analyses of forest fragmentation indicators in the southeastern United States and insect and pathogen indicators in the Pacific Northwest United States. The scan statistic detected four spatial clusters of fragmented forest including a hotspot in the Piedmont and Coastal Plain region. Three recurring clusters of insect and pathogen occurrence were found in the Pacific Northwest. Spatial scan statistics are a powerful new tool that can be used to identify potential forest health problems.     

Heavy metal release from contaminated soils: comparison of column leaching and batch extraction results

Heavy metals in soils may adversely affect environmental quality. In this study, we investigated the release of Zn, Cd, Pb, and Cu from four contaminated soils by column leaching and single and sequential batch extractions. Homogeneously packed soil columns were leached with 67 mL/g 10(-2) M CaCl2 to investigate the exchangeable metal pool and subsequently with 1400 mL/g 10(-2) M CaCl2 adjusted to pH 3 to study the potential of metal release in response to soil acidification. In two noncalcareous soils (pH 5.7 and 5.1), exchange by Ca resulted in pronounced release peaks for Zn and Cd that were coupled to the exchange of Mg by Ca, and 40 to 70% of total Zn and Cd contents were rapidly mobilized. These amounts compared well with exchangeable pools determined in single and sequential batch extractions. In two soils with near-neutral pH, the effluent concentrations of Zn and Cd were several orders of magnitude lower and no pronounced elution peaks were observed. This behavior was also observed for Cu and Pb in all four soils. When the soils were leached at pH 3, the column effluent patterns reflected the coupling of CaCO3 dissolution (if present) and other proton buffering reactions, proton-induced metal release, and metal-specific readsorption within the soil column. Varying the flow rate by a factor of five had only minor effects on the release patterns. Overall, Ca exchange and subsequent acidification to pH 3 removed between 65 and 90% of total Zn, Cd, Pb, and Cu from the four contaminated soils.