The prevention of occupational injuries in two industrial plants using an incident reporting scheme

INTRODUCTION: The aim of this study was to examine whether the introduction of an incident reporting scheme with feedback in two industrial plants had an effect on the number of major incidents. METHOD: An intervention design with measurements before the implementation of the incident reporting scheme and two years later was used to examine the relationship between incident rates, safety climate, the willingness to report incidents and perceived management commitment to safety. RESULTS: The results showed that a successful implementation of an incident reporting scheme was followed by a decline in the incidence of major incidents at a Danish metal plant. A key factor in implementing the scheme was top management commitment, which was lacking at another plant, where the implementation of a similar scheme failed. CONCLUSION: Although the study shows some encouraging results concerning the use of incident reporting schemes to prevent occupational accidents, the possibility to draw causal conclusions is limited in the present study, and further studies are needed before the effectiveness of such schemes can be evaluated with certainty.     

GEOGRAPHIC INFORMATION SYSTEM BASED NONPOINT POLLUTION MODELING1

ABSTRACT: The reauthorization of the Clean Water Act reemphasizes the need for regional scale monitoring and management of nonpoint pollution loads. The magnitude of the task will require that local governments and their consultants integrate information systems and modeling if they are to manage the massive data sets and conduct the array of simulations that will be needed to support the decision making processes. Interfacing geographic information systems (GIS) and nonpoint pollution modeling is a logical approach. The objective of the present study was to use the 37,000-acre area defined by the Kensington Quadrangle sheet in Montgomery County, Maryland, to show that GIS-supported nonpoint pollution modeling is practical and economically attractive. The purpose of the GIS is to estimate the spatial distribution of nonpoint nitrogen, phosphorous, zinc, lead, BOD, and sediment using a model developed by the Northern Virginia Planning District Commission. The system allows the user to change land uses in subareas to simulate the consequences of additional development or alternate management strategies. The tests show that in-house development of this type of special purpose GIS is a practical alternative to vendor supplied systems and that the required databases can be developed quite reasonably.     

Fuzzy decision analysis for integrated environmental vulnerability assessment of the mid-Atlantic Region

A fuzzy decision analysis method for integrating ecological indicators was developed. This was a combination of a fuzzy ranking method and the analytic hierarchy process (AHP). The method was capable of ranking ecosystems in terms of environmental conditions and suggesting cumulative impacts across a large region. Using data on land cover, population, roads, streams, air pollution, and topography of the Mid-Atlantic region, we were able to point out areas that were in relatively poor condition and/or vulnerable to future deterioration. The method offered an easy and comprehensive way to combine the strengths of fuzzy set theory and the AHP for ecological assessment. Furthermore, the suggested method can serve as a building block for the evaluation of environmental policies.     

Combined use of rapid bioassessment protocols and sediment quality triad to assess stream quality

Physical, chemical and biological conditions at five stations on a small southeastern stream were evaluated using the Rapid Bioassessment Protocols (RBP) and the Sediment Quality Triad (SQT) to assess potential biological impacts of a municipal wastewater treatment facility (WWTF) on downstream resources. Physical habitat, benthic macroinvertebrates and fish assemblages were impaired at Stations 1 and 2 (upstream of the WWTF), suggesting that the degraded physical habitat was adversely impacting the fish and benthic populations. The SQT also demonstrated that Stations 1 and 2 were degraded, but the factors responsible for the impaired conditions were attributed to the elevated concentrations of polycylclic aromatic hydrocarbons (PAHs) and metals (Mn, Pb) in the sediments. The source of contaminants to the upper reaches of the stream appears to be storm-water runoff from the city center. Increased discharge and stabilized base flow contributed by the WWTF appeared to benefit the physically-altered stream system. Although the two assessment procedures demonstrated biological impairment at the upstream stations, the environmental factors identified as being responsible for the impairment were different: the RBP provided insight into contributions associated with the physical habitat and the SQT contributed information on contaminants and sediment quality. Both procedures are important in the identification of physical and chemical factors responsible for environmental impairment and together they provide information critical to the development of appropriate management options for mitigation.     

Relations of Habitat-Specific Algal Assemblages to Land Use and Water Chemistry in the Willamette Basin, Oregon

Benthic algal assemblages, water chemistry, and habitat were characterized at 25 stream sites in the Willamette Basin, Oregon, during low flow in 1994. Seventy-three algal samples yielded 420 taxa — mostly diatoms, blue-green algae, and green algae. Algal assemblages from depositional samples were strongly dominated by diatoms (76% mean relative abundance), whereas erosional samples were dominated by blue-green algae (68% mean relative abundance).Canonical correspondence analysis (CCA) of semiquantitative and qualitative (presence/absence) data sets identified four environmental variables (maximum specific conductance, % open canopy, pH, and drainage area) that were significant in describing patterns of algal taxa among sites. Based on CCA, four groups of sites were identified: streams in forested basins that supported oligotrophic taxa, such as Diatoma mesodon;small streams in agricultural and urban basins that contained a variety of eutrophic and nitrogen-heterotrophic algal taxa; larger rivers draining areas of mixed land use that supported planktonic, eutrophic, and nitrogen-heterotrophic algal taxa; and streams with severely degraded or absent riparian vegetation (> 75% open canopy) that were dominated by other planktonic, eutrophic, and nitrogen-heterotrophic algal taxa. Patterns in water chemistry were consistent with the algal autecological interpretations and clearly demonstrated relationships between land use, water quality, and algal distribution patterns.     

Zinc fractionation in contaminated soils by sequential and single extractions: influence of soil properties and zinc content

We studied the fractionation of zinc (Zn) in 49 contaminated soils as influenced by Zn content and soil properties using a seven-step sequential extraction procedure (F1: NH4NO3; F2: NH4-acetate, pH 6; F3: NH3OHCl, pH 6; F4: NH4-EDTA, pH 4.6; F5: NH4-oxalate, pH 3; F6: NH4-oxalate/ascorbic acid, pH 3; F7: residual). The soils had developed from different geologic materials and covered a wide range in soil pH (4.0-7.3), organic C content (9.3-102 g kg(-1)), and clay content (38-451 g kg(-1)). Input of aqueous Zn with runoff water from electricity towers during 26 to 74 yr resulted in total soil Zn contents of 3.8 to 460 mmol kg(-1). In acidic soils (n = 24; pH <6.0), Zn was mainly found in the mobile fraction (F1) and the last two fractions (F6 and F7). In neutral soils (n = 25; pH > or =6.0), most Zn was extracted in the mobilizable fraction (F2) and the intermediate fractions (F4 and F5). The extractability of Zn increased with increasing Zn contamination of the soils. The sum of mobile (F1) and mobilizable (F2) Zn was independent of soil pH, the ratio of Zn in F1 over F1+F2 plotted against soil pH, exhibited the typical shape of a pH sorption edge and markedly increased from pH 6 to pH 5, reflecting the increasing lability of mobilizable Zn with decreasing soil pH. In conclusion, the extractability of Zn from soils contaminated with aqueous Zn after decades of aging under field conditions systematically varied with soil pH and Zn content. The same trends are expected to apply to aqueous Zn released from decomposing Zn-bearing contaminants, such as sewage sludge or smelter slag. The systematic trends in Zn fractionation with varying soil pH and Zn content indicate the paramount effect of these two factors on molecular scale Zn speciation. Further research is required to characterize the link between the fractionation and speciation of Zn and to determine how Zn loading and soil physicochemical properties affect Zn speciation in soils.     

Properties of Distillers Grains Composites: A Preliminary Investigation

Interest in renewable biofuel sources has intensified in recent years, leading to greatly increased production of ethanol and its primary coproduct, Distillers Dried Grain with Solubles (DDGS). Consequently, the development of new outlets for DDGS has become crucial to maintaining the economic viability of the industry. In light of these developments, this preliminary study aimed to determine the suitability of DDGS for use as a biofiller in low-cost composites that could be produced by rapid prototyping applications. The effects of DDGS content, particle size, curing temperature, and compression on resulting properties, such as flexural strength, modulus of elasticity, water activity, and color were evaluated for two adhesive bases. The composites formed with phenolic resin glue were found to be greatly superior to glue in terms of mechanical strength and durability: resin-based composites had maximum fiber stresses of 150–380 kPa, while glue composites had values between 6 kPa and 35 kPa; additionally, glue composites experienced relatively rapid microbial growth. In the resin composites, both decreased particle size and increased compression resulted in increased mechanical strength, while a moderate DDGS content was found to increase flexural strength but decrease Young’s modulus. These results indicate that DDGS has the potential to be used in resin glue-based composites to both improve flexural strength and improve potential biodegradability.     

Reduction of ferrate(VI) and oxidation of cyanate in a Fe(VI)-TiO2-UV-NCO- system

The aqueous photocatalytic degradation of cyanate (NCO(-)), which is a long-lived neurotoxin formed during the remediation of cyanide in industrial waste streams, was studied in the ferrate(VI)-UV-TiO2-NCO(-) system. Kinetics measurements of the photocatalytic reduction of ferrate(VI) were carried out as a function of [NCO(-)], [ferrate(VI)], [O(2)], light intensity (I(o)), and amount of TiO2 in suspensions at pH 9.0. The photocatalytic reduction rate of ferrate(VI) in the studied system can be expressed as -d[Fe(VI)]/dt=kI(o)(0.5) [NCO(-)] [TiO2]. The rate of photocatalytic oxidation of cyanate with ferrate(VI) was greater than the rate in the analogous system without ferrate(VI). The possibility of involvement of reactive ferrate(V) species for this enhancement was determined by studying the reactivity of ferrate(V) with NCO(-) in a homogeneous solution using a premix pulse radiolysis technique. The rate constant for the reaction of ferrate(V) and NCO(-) in alkaline medium was estimated to be (9.60+/-0.07) x 10(2) M(-1) s(-1), which is much slower than the ferrate(VI) self-decomposition reaction (k approximately 10(7) M(-1) s(-1)). An analysis of the kinetic data in the Fe(VI)-UV-TiO2-NCO(-) system suggests that ferrate(V) is not directly participating in the oxidation of cyanate. Possible reactions in the system are presented to explain results of ferrate(VI) reduction and oxidation of cyanate.     

Sorption and predicted mobility of herbicides in Baltic soils

This study was undertaken to determine sorption coefficients of eight herbicides (alachlor, amitrole, atrazine, simazine, dicamba, imazamox, imazethapyr, and pendimethalin) to seven agricultural soils from sites throughout Lithuania. The measured sorption coefficients were used to predict the susceptibility of these herbicides to leach to groundwater. Soil-water partitioning coefficients were measured in batch equilibrium studies using radiolabeled herbicides. In most soils, sorption followed the general trend pendimethalin > alachlor > atrazine approximately amitrole approximately simazine > imazethapyr > imazamox > dicamba, consistent with the trends in hydrophobicity (log K(ow)) except in the case of amitrole. For several herbicides, sorption coefficients and calculated retardation factors were lowest (predicted to be most susceptible to leaching) in a soil of intermediate organic carbon content and sand content. Calculated herbicide retardation factors were high for soils with high organic carbon contents. Estimated leaching times under saturated conditions, assuming no herbicide degradation and no preferential water flow, were more strongly affected by soil textural effects on predicted water flow than by herbicide sorption effects. All herbicides were predicted to be slowest to leach in soils with high clay and low sand contents, and fastest to leach in soils with high sand content and low organic matter content. Herbicide management is important to the continued increase in agricultural production and profitability in the Baltic region, and these results will be useful in identifying critical areas requiring improved management practices to reduce water contamination by pesticides.