TEMPORAL AND GEOMORPHIC VARIATIONS OF STREAM STABILITY AND MORPHOLOGY: MAHOGANY CREEK,NEVADA1

ABSTRACT: Detailed studies of long-term management impacts on rangeland streams are few because of the cost of obtaining detailed data replicated in time. This study uses government agency aquatic habitat, stream morphologic, and ocular stability data to assess land management impacts over four years on three stream reaches of an important rangeland watershed in northwestern Nevada. Aquatic habitat improved as riparian vegetation reestablished itself with decreased and better controlled livestock grazing. However, sediment from livestock disturbances and road crossings and very low stream flows limited the rate of change. Stream type limited the change of pool variables and width/depth ratio, which are linked to gradient and entrenchment. Coarse woody debris removal due to previous management limited pool recovery. Various critical-element ocular stability estimates represented changes with time and differences among reaches very well. Ocular stability variables tracked the quantitative habitat and morphologic variables well enough to recommend that ocular surveys be used to monitor changes with time between more intensive aquatic surveys.     

OPTIMIZATION MODELING OF A NEW FACILITY FOR THE CALIFORNIA STATE WATER PROJECT1

ABSTRACT: A non-linear optimization model is applied to the California State Water Project (SWP) and portions of the Central Valley Project (CVP). The model accounts for the major hydrologic, regulatory, and operational features of both projects. The model maximizes long-term SWP yields over a 70-year period, using a quarterly time step. The potential for increased yield associated with a proposed facility improvement is evaluated with the model. The proposed facility is an extension of the Folsom-South Canal, which would allow water to be conveyed from the American River below Folsom Reservoir into New Melones Reservoir on the Stanislaus River or into the California Aqueduct. Model results indicate that extension of the Folsom-South Canal has the potential to increase SWP yields by 13 percent.     

MODELING THE BUILDUP AND WASHOFF OF POLLUTANTS ON URBAN WATERSHEDS1

ABSTRACT: A model for urban stormwater quality was developed in this study. The basis for the model is the process by which pollutants build up on the watershed surface. For the wet climate of the study site, it was assumed that there exists an interval of time over which the pollutant buildup equals the pollutant washoff (no accumulation of pollutant). The buildup model was represented by a linear function of the antecedent dry time. The buildup function was then linked with a pollutant washoff model represented by a power function of the storm runoff volume. Various time intervals for no net accumulation were tested to calibrate the model. The model was calibrated to observed data for two small urban basins in Baton Rouge, Louisiana, and model results were used to analyze the behavior of phosphorus concentrations in storm runoff from these basins over a long period of time.     

THE ARMA MODELS APPLIED TO THE FLOW OF KARSTIC SPRINGS1

ABSTRACT: Autoregressive moving average (ABMA) models have been applied to study the flow series of the karstic springs of La Villa, Fuente Mayor (Spain), and Aliou (France). The theoretical meaning of the parameters involved in the model upon applying it to a simplified scheme of the emptying of a karstic aquifer is first analyzed. The types of transformations necessary to apply these models to the flow series that lack normality and have strong periodic components are also indicated, as are the advantages of this type of model and the physical significance of the parameters obtained, with respect to the standpoint of hydraulics, ranging from rather homogeneous aquifers (La Villa) to extremely karstic (Aliou), including aquifers with intermediate characteristics (Fuente Mayor).     

WASTE LOADINGS FROM A FRESHWATER ATLANTIC SALMON FARM IN SCOTLAND1

ABSTRACT: Recent studies suggest that waste generation from the freshwater phase of Atlantic salmon (Salmo salar L.) production varies considerably on an annual basis. A fish farm on the West Coast of Scotland was visited regularly during a two-year period to determine inflow and outflow water quality. Waste output budgets of suspended solids (SS), biochemical oxygen demand (BOD), total nitrogen (TN), total phosphorus (TP), total ammonia nitrogen (TAN = NH₃+NH₄⁺), dissolved reactive phosphorus (DRP) and total phosphorus (TP) were produced. The annual waste loadings obtained were 71 kg TN t fish^?1 yr^?1 (one year of data only), 10.9–11.1 kg TP t fish^?1 yr^?1, 1.2–2.1 kg DRP t fish^?1 yr^?1, 422–485 kg BOD₅ t fish^?1 yr^?1, 327–337 kg SS t fish^?1 yr^?1, and 30–35 kg TAN-N t fish^?1 yr^?1. Simple linear regression models relating waste parameter production to water temperature and feeding regime were developed. When compared to existing data for other salmonid production systems, greater ranges of daily waste loadings were observed. Wide variations in concentrations of these parameters during a daily cycle were also observed, suggesting that mass balance estimates of waste production will provide more robust estimates of waste output than frequent monitoring of outflow water quality.     

Assessment of the maximum possible liquid superheat during flashing leak flow

During the discharge of flashing liquids through leaks due to abrupt depressurization a transient thermodynamic non-equilibrium in the form of a boiling delay in the superheated liquid flow can occur. As a consequence the actual mass flow quality is smaller than calculated under the assumption of an immediate adjustment of the thermodynamic equilibrium between the phases. For the prediction of the leak mass flow for a given pressure difference the magnitude of this self-adjusting mass flow quality is needed.

Most of the models cited in the literature include only the equilibrium mass quality as limiting quantity and ignore further effects as that of the depressurization velocity or the mean nucleus distance. For the assessment of the maximum possible liquid superheat during flashing only the conduction heat transfer from a stagnant liquid to the bubble surface is used to describe the bubble growth.

The sub-model for the bubble growth due to expansion and mass transfer necessary for the global prediction of the transient thermodynamic non-equilibrium in flashing liquids was validated using bubble radii measured by Hooper et al. [Bubble growth and pressure relationship in the flashing of superheated water. Technical publication 6904, Mechanical Engineering Department, University of Toronto, 1969] for the case of a sudden depressurization of initially saturated water. On this basis the calculated time-dependent temperature field, the actual mass quality, the mean liquid temperature and, in comparison to the corresponding values based on the assumption of immediate thermodynamic equilibrium, the maximum possible liquid superheat are predicted.     

Prevention of musculoskeletal complaints in nursing: Aims, approach and content of an ergonomic-educational programme

In 1992 a comprehensive health-promotion project was initiated in seven nursing-homes in the Netherlands. This project was designed to implement an ergonomic-educational programme, with the intention of reducing physical workload and to bring about safe working in order to prevent work-related musculoskeletal complaints. After a period of external support, employees of the nursing-homes should be able to proceed with the programme independently. In this paper the content of the programme and its underlying strategies and theories are described. So far, the programme has got off to a good start in all the nursing-homes. Positive effects of the programme could be demonstrated and guidelines and protocols for safe working were introduced. However, it is as yet too early for definitive conclusions to be drawn regarding the aspect of continuity.     

Pressure- volume- temperature relationships of soy protein isolate/starch plastic

The use of pressure-volume-temperature (PVT) studies in processing of a biodegradable plastic composition made from soy protein isolate and corn starch is described. The ability of PVT measurements to predict the combined effects of pressure, volume, and temperature effects is demonstrated. The results show that the PVT relations of the plastic can be predicted by using a regression analysis similar to the Tait equations of state. A change in slope of the PVT curves was observed at around 80‡C, which is ascribed to the glass-transition process of the plastic. Evidence of onset of thermal degradation of the plastic was observed at ca. 160‡C under 0 to 200 MPa isobaric pressure. This thermal degradation precluded determination of the crystal melting point of the plastic.     

Laboratory scale studies on gaseous emissions generated by the incineration of an artificial automotive shredder residue presenting a critical composition

Car manufacturers must eliminate automotive shredder residues (ASR). Two ways of incineration are of interest: at 850°C in municipal waste incinerators or at higher temperatures, above 1100°C in cement plants. These processes reduce the mass and the volume of waste to be disposed of in landfills and energy recovery might be possible. Regulations govern the emission of gaseous effluents to control environmental risk. To determine gaseous effluents from a pilot sacle or an industrial incineration plant, an artificial ASR was made by mixing three representative organic polymers present in the real ASR, namely polyvinylchloride, polyurethane and rubber. This mixture was incinerated at 850 and 1100°C in laboratory experiments and the analyses of the principal gaseous effluents such as carbon oxides, nitrogen oxides, volatile organic compounds, hydrochloric and hydrocyanic acids and sulphur compounds are presented and discussed. Lastly, in order to simulate artificial ASR behaviour, the composition of the combustion gases at equilibrium was calculated using a Gibbs energy minimisation code.