Effects of sample storage on biosolids compost stability and maturity evaluation

Compost stability and maturity are important parameters of compost quality. To date, nearly all compost characterization has been performed using samples freshly collected because sample storage can affect compost stability and maturity evaluation. However, sample preservation is sometimes necessary, especially for scientific research purposes. There is little information available on the effects of sample storage on compost stability and maturity. Samples of biosolids compost with different levels of stability and maturity were collected from four compost facilities in Florida (referred to as Register, Winslow, Sunset, and Meadow). Comparisons of CO2 evolution, seed germination rate, and water-soluble organic carbon (WSOC) were made between fresh samples with short storage at 4 degrees C for less than 1 wk and air-dried or frozen compost samples stored for 1 yr. The effects of storage (air-dry or frozen) on the measured parameters depended on compost stability and maturity and on the compost material source. Frozen storage reduced the peak CO2 evolution of Register samples by 12 to 29%, while accumulated CO2 evolution was reduced by 43 to 64% and 110 to 277% with air-dry and frozen storage, respectively. The storage effect on CO2 evolution with more stable compost was inconsistent. Storage did not affect compost phytotoxicity, except for samples from the Sunset facility. Air-drying reduced the WSOC by up to 35%, and freezing increased it by up to 34%, while both storage methods had no significant effect on samples of low WSOC. Despite all these variations, WSOC had a significant and consistent relation to CO2 evolution and seed germination rates with R2 of 0.78 and 0.57, respectively, regardless of storage methods.     

Copper and calcium transport through an unsaturated soil column

To determine the relative importance of the physical and chemical factors that influence the movement of heavy metals through soils, leaching experiments were carried out under conditions of constant molarity during unsaturated steady-state water flow through a Manawatu fine sandy loam (a Dystric Fluventic Eutochrept). The movement and exchange of copper was studied in a binary Cu-Ca system. The movement of the associated anions, namely chloride and sulfate, was also monitored. The measurements were compared with predictions from the convection-dispersion equation (CDE), linked with cation exchange theory. The agreement between the measured and predicted breakthrough of sulfate and copper was good. This indicates that copper retardation in the Manawatu soil is closely related to the cation exchange capacity, and that exchange between Ca and Cu is the main process of Cu retardation in the Manawatu soil. However, copper appeared slightly later in the effluent than predicted, indicating that non-exchange processes are also involved in copper transport. Measurements of suction cups could also be used to obtain the parameters for the CDE to describe sulfate movement through the soil. Time domain reflectometry (TDR) measurements of the bulk-soil electrical conductivity could be used to monitor the movement of both sulfate and copper. This indicates that TDR can also be used to monitor cation transport and exchange through the soil, provided the percolating solution causes a sufficient change in the electrical conductivity.     

Herbicide and nutrient transport from an irrigation district into the South Saskatchewan River

Pesticides and nutrients can be transported from treated agricultural land in irrigation runoff and thus can affect the quality of receiving waters. A 3-yr study was carried out to assess possible detrimental effects on the downstream water quality of the South Saskatchewan River due to herbicide and plant nutrient inputs via drainage water from an irrigation district. Automated water samplers and flow monitors were used to intensively sample the drainage water and to monitor daily flows in two major drainage ditches, which drained approximately 40% of the flood-irrigated land within the irrigation district. Over three years, there were no detectable inputs of ethalfluralin into the river and those of trifluralin were less than 0.002% of the amount applied to flood-irrigated fields. Inputs of MCPA, bromoxynil, dicamba and mecoprop were 0.06% or less of the amounts applied, whereas that for clopyralid was 0.31%. The relatively higher input (1.4%) of 2,4-D to the river was probably due its presence in the irrigation water. Corresponding inputs of P (as total P) and N (as nitrate plus ammonia) were 2.2 and 1.9% of applied fertilizer, respectively. Due to dilution of the drainage water in the river, maximum daily herbicide (with the exception of 2,4-D) and nutrient loadings to the river would not have resulted in significant concentration increases in the river water. There was no consistent remedial effect on herbicides entering the river due to passage of the drainage water through a natural wetland. In contrast, a considerable portion of the nutrients entering the river originated from the wetland.     

Computerized Map of Risk to Manage Wildlife Species in Urban Areas

For the last 20 years, human–wildlife conflicts have been rapidly increasing in towns. Although people want “greener” cities, the expansion of disliked species causes problems that are difficult to manage and to reduce. The complexity of the numerous factors involved in these human–wildlife relations needs the development of a comprehensive tool for urban planners. Today, with the development of computers and geographical information systems, it is easier to analyze and combine different spatial data as methods used for the management of risks in studies of natural hazards. Here we present a method for assessing and mapping the risk in cases of human–wildlife conflict. An application to starling management in a town in western France will show the efficiency of our methods to combine information given by a network of experts and to highlight higher risk sites. The map of risk provides a spatial result useful for comprehension, communication between people and agencies, and public education.     

The Interior-to-Edge Breakpoint Distance as a Guideline for Nature Conservation Policy

A method is proposed to quantify disturbance impact on isolated habitats. For every landscape patch, the breakpoint distance, defined as the penetration distance for which equality of interior and edge habitat is observed, can be calculated. Disturbance with equal impact at all patch sides is assumed. Effects of patch compactness, size, convolution, and perforation are discussed. The potential use of the measure for nature reserve design is discussed. The breakpoint distance follows the reserve design guidelines for individual patches, based on island biogeography and is consistent with the form and function principle. A large breakpoint distance is preferred for natural habitats. Small size, small compactness, intense convolution, and the occurrence of many gaps depress the breakpoint distance.     

Airborne surveys of Swiss nuclear facility sites

Annually since 1989, biannually since 1994, the environs (approximately 50 km2) of the Swiss nuclear facilities are surveyed (by helicopters) flying the same survey lines. The equipment and the data processing software used for these surveys were built and developed at the Institute of Geophysics, ETH Zurich. For mapping of man-made radiation at or around nuclear facility sites a pixel representation and the MMGC (man-made gross count) ratio is used. So far no artificial radioactivity that could not be explained by the Chernobyl event (1986) or by earlier nuclear weapon tests was detected outside the fenced sites of the nuclear facilities.     

Aerial measurements on uranium ore mining, milling and processing areas in Germany

The paper describes aerial measurements at several sites containing residues from uranium mines, waste rock dumps and tailings ponds of the Wismut company in Saxony and Thuringia. For the measurements, a computerized gamma-ray spectrometer equipped with a HPGe-detector and a NaI(Tl)-detector array with a volume of 121 was used. Radioactive anomalies from natural radionuclides have been detected and mapped. The activity concentrations of 226Ra, 228Th and 40K in areas with elevated radioactivity from natural radionuclides were determined from aerial measurements. Ground-based measurements--as far as available--confirmed these results. The mean 226Ra activity concentrations in the different waste rock dumps were found to be in the range 370 to 1600 Bq kg-1. The highest mean 226Ra activity concentrations were measured for the tailings ponds with values up to 1300 Bq kg-1. For 40K and 208Tl, activity concentrations of 860 and 40 Bq kg-1, respectively, were obtained as averages of all measurements. These values are commonly found in the environment. In general, there is reasonable agreement between the results measured with different detectors and measuring methods.     

Extraction of full absorption peaks in airborne gamma-spectrometry by filtering techniques coupled with a study of the derivatives. Comparison with the window method

In this paper, an adaptation of a spectral profile analysis method, currently used in high-resolution spectrometry, to airborne gamma measurements is presented. A new algorithm has been developed for extraction of full absorption peaks by studying the variations in the spectral profile of data recorded with large-volume NaI detectors (16 l) with a short sampling time (2 s). The use of digital filters, taking into consideration the characteristics of the absorption peaks, significantly reduced the counting fluctuations, making detection possible based on study of the first and second derivatives. The absorption peaks are then obtained by modelling, followed by subtraction of the Compton continuum in the detection window. Compared to the conventional stripping ratio method, spectral profile analysis offers similar performance for the natural radioelements. The 137Cs 1SD detection limit is approximately 1200 Bq/m2 in a natural background of 200 Bq/kg 40K, 33 Bq/kg 238U and 33 Bq/kg 232Th. At low energy the very high continuum leads to detection limits similar to those obtained by the windows method, but the results obtained are more reliable. In the presence of peak overlaps, however, analysis of the spectral profile alone is not sufficient to separate the peaks, and further processing is necessary. Within the framework of environmental monitoring studies, spectral profile analysis is of great interest because it does not require any assumptions about the nature of the nuclides. The calculation of the concentrations from the results obtained is simple and reliable, since only the full absorption contributions are taken into consideration. A quantitative estimate of radioactive anomalies can thus be obtained rapidly.     

Exposure of workers in mineral processing industries in Brazil

The mining, milling and processing of uranium and thorium bearing minerals may result in radiation doses to workers. A preliminary survey pilot program, that included six mines in Brazil (two coal mines, one niobium mine, one nickel mine, one gold mine and one phosphate mine), was launched in order to determine the need to control the radioactive exposure of the mine-workers. Our survey consisted of the collection and analysis of urine samples, complemented by feces and air samples. The concentrations of uranium, thorium and polonium were measured in these samples and compared to background data from family members of the workers living in the same dwelling and from residents from the general population of Rio de Janeiro. The results from the coal mines indicated that the inhalation of radon progeny may be a source of occupational exposure. The workers from the nickel, gold and phosphate mines that were visited do not require a program to control internal radiological doses. The niobium mine results showed that in some areas of the industry exposure to thorium and uranium might occur.     

Improvements in modeling sagebrush concentrations of radioiodine released from the Hanford site

The Hanford Environmental Dose Reconstruction Project estimated the radiation dose to individuals from historical emissions of radioactive materials from the Hanford Site in Washington State. Project validation studies using predicted activity concentrations of 131I on sagebrush (Artemisia tridentata) showed a systematic underestimation against historical data during cold weather months, indicating a need for sagebrush model improvement. A deposition model for semi-volatile organic materials presented by Komp and McLachlen (Environ. Sci. Tech. 31 (1997) 886-890) is adapted here for gaseous iodine onto sagebrush. The deposition model includes a temperature-dependent term based on an integrated van't Hoff equation. Calibration data for the model are obtained from a release of 131I in 1963. Modeling results for releases in 1946 show a good match between historical data and predicted results using the new model. The new model shows improvement over interception-fraction type models, but requires plant-type-specific calibration data.