炸药及火工品可靠性与安全性评定方法

可靠性的评定结果是否可信,直接关系到炸药及火工品的使用安全性和作用可靠性。但是,现有炸药及火工品可靠性评定方法却存在着达不到置信度要求、评价结果偏于危险的缺点。为此,提出了一种确定炸药及火工品安全度和可靠度的高精度方法,并给出了应用实例。该方法不仅可信程度高,而且适用于小样本情况,尤其是在利用了以往试验数据后,既可提高安全性和可靠性评定的精度,又可大大节省试验的费用及时间     

脱硝钢架表面体型系数及风致响应分析∗

火电厂中的脱硝钢架由于其高度较高、外形不规则,风荷载是其承受的主要荷载之一。为确保该类结构风荷载的正确评估,以某典型脱硝钢架为研究对象,基于流固耦合理论,利用数值风洞方法对脱硝钢架结构表面体型系数及风致响应进行了研究。根据刚度与质量等效的原则,提出了复杂脱硝钢架结构连续体模型的简化方法,模型简化前后的 1 阶自振周期与振型接近,可近似模拟原结构的平动情况。风向角的变化对迎风面及变截面处体型系数的影响较大,可以忽略风向角对侧面及顶面体型系数的影响。在 0°风向角工况下,结构的位移与应力极值均显著大于 90°风向角工况。因此,0°风向对于结构而言为相对较不利风向,在脱销钢架整体结构方向布置时应予以避免。     

两性—阴离子复配湿润剂对硫化矿尘润湿性的实验研究

为了探讨两性-阴离子湿润剂复配剂对硫化矿尘的润湿性能,通过毛细管正向渗透实验法,研究椰油酰胺基丙基甜菜碱（CAB）、十二烷基二甲基甜菜碱（BS-12）、十二烷基苯磺酸钠（LAS）、脂肪醇聚氧乙烯醚硫酸钠（AES）单体湿润剂的润湿性能;利用静滴法,测量各单体与矿石的接触角。单体实验结果表明两性离子湿润剂中BS-12、阴离子湿润剂中LAS的润湿性能相对较好。选用这两种试剂进行复配实验,结果表明:浸润深度大于20 mm,复配剂比单质湿润剂润湿性能好;最佳复     

冷藏技术对发光细菌活性及毒性测试性能的影响

由于发光细菌的在线毒性监测技术受到了细菌生物活性稳定性保持问题的制约,探索一种脱脂牛奶菌悬液冷藏复苏方法,以提高发光细菌活性的保持时间。比较了明亮发光杆菌新鲜菌液冷藏、冻干粉菌悬液冷藏和脱脂牛奶菌悬液冷藏对发光细菌生物活性的影响,同时,比较了不同渗透压调节液对菌悬液急性毒性测试的灵敏度和稳定性的影响。结果表明,质量分数为25%的脱脂牛奶可提高发光细菌生物活性的稳定性,菌悬液冷藏7d后复苏,相对发光率仍可达92%。2%NaCl和10%蔗糖为渗透压调节液时,冷藏至第7天的发光细菌脱脂牛奶菌悬液对重金属毒性测试的灵敏度,与新鲜菌液基本相同,但添加蔗糖降低了其对有机物的测试灵敏度。利用发光细菌脱脂牛奶冷藏菌悬液对Zn~(2+)进行连续7d的毒性测试,EC_(50)的变异系数小于15%,结果稳定性良好。     

湛江特呈岛红树林植物群落的结构和动态特征

对特呈岛红树林植被进行多次和全面的调查,通过采用格子样的方法,选取面积为100～800 m^2的样地,每片样地再分成若干10 m×10 m的样方,对红树林样地内的植物进行每木测量,记录各植物的种名、胸径、高度、冠幅等,并进行重要性以及多样性等常规的群落分析,判定该地区植被的生长特征以及研究其演替动态变化。结果表明：①面积较大的群落主要有3个类型,即白骨壤群落（Avicennia marina）、白骨壤＋红海榄群落（Avicennia marina＋Rhizophora stylosa）、白骨壤-桐花树群落（Avicennia marina-Aegiceras corniculatum）;其它面积较小的群落有：白骨壤＋红海榄-木榄＋桐花树群落（vicennia marina＋Rhizophora stylosa-Bruguiera gymnorrhiza＋Aegiceras corniculatum）、红海榄＋木榄群落（Rhizophora stylosa＋Bru-guiera gymnorrhiza）;②在3个主要群落中,优势种的苗木和小树相对较少,优势种群的年龄结构均为衰退型;③各群落的Simpson指数关系为：白骨壤＋红海榄群落﹥红海榄＋木榄群落﹥白骨壤＋红海榄—木榄＋桐花树群落﹥白骨壤—桐花树群落﹥白骨壤群落;白骨壤群落的重要值为300,为典型的单优群落;④特呈岛的白骨壤群落是中国该类群落中面积最大的,目前长势良好,无病虫害,并且红树林外缘的白骨壤枝干在波浪冲刷或人为原因下,受到较严重的侵蚀,其幼树在林外缘基本无法存活,需要加强保护,对其生理生态学特征也值得进一步深入研究。     

磁处理技术降解有机污水

磁处理作为一项节能、环保、成本低廉的技术,在工农业各个领域都具有广泛的适用性和推广价值。本文概述了磁处理降解有机污水的实验研究,并对其作用机理进行了总结。     

Carbon Embodied in International Trade of China and Its Emission Responsibility

Abstract

Carbon emissions embodied in international trade of China during 1997–2007 are accounted by input–output method based on Chinese input–output table and global trade analysis project database. It is revealed that carbon emissions embodied in imports and exports both increased during 1997–2007, but carbon emissions embodied in exports are greater than those embodied in imports, China is a net export nation in embodied carbon. The net exports of embodied carbon account for about 10.82% of the total carbon emissions in 1997, dropped to 7.15% in 2002, increased to 13.13% in 2006, and slightly dropped to 12.64% in 2007. Low-end position of international industry division is an objective factor of being a net exporter of embodied carbon for China, and usage of a large amount of obsolete energy-using equipments wasted much energy and increased carbon emissions embodied in exports. Importers should take more responsibilities for carbon emissions embodied in trade, and China should take a certain responsibility for unreasonable energy dissipations too.     

Polycyclic aromatic hydrocarbons in effluents from wastewater treatment plants and receiving streams in Tianjin, China

Surface water, suspended particulate matter, pore water, and sediment samples were collected and analyzed for polycyclic aromatic hydrocarbons (PAHs) in Yongding New River, South Drainage Canal and North Drainage Canal, which receive most of wastewater from industrial city of Tianjin. PAH concentrations in effluent samples of wastewater treatment plants (WTP) discharging into the South Drainage Canal and North Drainage Canal were quantified for the first time. The results showed that the discharge of the WTPs recently only contributed to the PAH contamination in the canals near the outlets of the WTPs. PAH levels in sediments of the streams were greatly higher than those in soils by riverbank probably due to receiving large amounts of untreated wastewater. Unusually high benz[a] anthracene concentration strongly influenced the seasonal and spatial variation of total PAH concentrations in South Drainage Canal. Paired samples t test of ??Nap, Fl, Phe, Fluo and ??Nap, Phe, Fluo, Chry concentrations, which were dominant components in the air samples from non-heating and heating season, respectively, in the suspended particulate matters from the streams showed that PAH source from air deposition was more important for Yongding New River than that for South Drainage Canal and North Drainage Canal. Source apportionment based on PAH profiles indicated that coal combustion was the major PAH contamination source, and coke oven sources and wood combustion also contributed to the PAH contamination of the streams. This was further indicated by organic petrography analysis.     

蚯蚓和堆肥固定化添加模式对漆酶降解土壤五氯酚的影响

利用土壤五氯酚（PCP）污染模拟实验,研究两种不同生态型蚯蚓（赤子爱胜蚓Eisenia foetida和壮尾环毛蚓Amynthas robustus E.Perrie）和堆肥固定化添加模式对漆酶降解土壤PCP的影响。在42 d培养期内,测试了不同处理下PCP质量分数、漆酶活性,以及土壤呼吸和微生物碳氮等微生物指标。结果表明：堆肥固定化漆酶降解土壤PCP的效果优于壳聚糖固定化漆酶和自由漆酶,主要原因是堆肥固定化漆酶能够有效地提高漆酶稳定性,减缓其活性下降速度。此外,堆肥还能提高土壤微生物的数量与活性,显著提升土壤漆酶的活性。添加两种生态型蚯蚓对漆酶活性影响不显著,但均可以显著提高土壤微生物的数量与活性,加速土壤中PCP的降解。壮尾环毛蚓对土壤微生物数量与活性的提升效果优于赤子爱胜蚓。     

Enhanced the photoelectrochemical performance of Bi2XO6 (X = W, Mo) for detecting hexavalent chromium by modification of CuS

In this work, Bi₂XO₆ (X = W, Mo) are synthesized at different temperatures. The results of tests find the optimal temperatures of Bi₂WO₆ and Bi₂MoO₆ are 180 and 160°C (BW-180, BM-160). Then, BW-180 and BM-160 are further compounded with different contents of CuS. The results of photoelectrochemical (PEC) tests show that CuS can improve the PEC performance of semiconductor materials, and it has better performance when CuS mass fraction is 5%. These maybe the photoelectron potentials generated by CuS/Bi₂XO₆ (X = Mo, W) heterojunction reduce the combination of photogenerated electrons and holes. When the PEC sensor based on 5%-CuS/BW-180 detects Cr(VI), it has a linear range of 1–80 μmol/L with detection limit of 0.95 μmol/L, while the PEC sensor based on 5%-CuS/BM-160 detects Cr(VI) has a linear range of 0.5–230 μmol/L and a detection limit of 0.12 μmol/L. Thus, 5%-CuS/Bi₂XO₆ has potential application in hexavalent chromium detection.