Controlled-release fertilizer(CRF):A green fertilizer for controlling non-point contamination in agriculture

Fertilizers contribute greatly to high yields but also result in environmental non-point contamination, including the emission of greenhouse gas(N2O) and eutrophication of water bodies. How to solve this problem has become a serious challenge, especially for China as its high ecological pressure. Controlled-release fertilizer(CRF) has been developed to minimize the contamination while keeping high yield and has become a green fertilizer for agriculture. Several CRFs made with special coating technology were used for testing the fertilizer effects in yield and environment through pot experiment and field trial. The result indicated that the CRFs had higher N use efficiency, thus reducing N loss through leaching and volatilization while keeping higher yields. Comparing with imported standard CRFs,the test on CRFs showed similar fertilizer effect but with much lower cost. CRFs application is becoming a new approach for minimizing non-point contamination in agriculture.     

Occurrence and congeners specific of poiychlorinated biphenyls in agricultural soils from Southern Jiangsu, China

A total of 198 agricultural soil samples were collected from Zhangjiagang and Changshu in Southern Jiangsu for analysis of 13 polychlorinated biphenyls (PCBs) in order to assess the levels of pollution, sources, area distribution, and potential risk for the environment. All methods were rigorously tested and an adequate quality control was ensured. Only one site had no PCBs residues, and the highest total PCBs concentration in the surface soils was 32.83 ng/g. The average concentration in all the soil samples was 4.13 ng/g, signaling low-level pollution. Tetra-, penta-, and hexa-chlorinated biphenyls were dominant species in soil samples, accounting for more than 75% ofΣPCBs in the soil samples. PCB118 was the most abundant congener in all the samples. The PCB118 was about 20% ofΣPCBs. The soil organic matter content showed only a weak correlation with the levels of all PCB congeners, in which a better correlation was noted for the more volatile lighter PCB congeners than for the heavier homologues. To a certain extent, the sources and land use seemed to influence the levels of PCBs.     

锑的淡水水质基准及其对我国水质标准的启示

针对我国锑水生生物水质基准缺乏的问题，收集筛选了锑对淡水水生生物的急性和慢性毒性数据，使用评价因子法、毒性百分数排序法和物种敏感度分布法分别推导我国锑的淡水水质基准，通过综合分析和比较，选择物种敏感度分布法推导的急性和慢性的水质基准值（466.62μg/L和88.71μg/L）作为最终的基准推荐值.通过与国内外现有锑相关水质标准进行比较，提出在我国相关水质标准修订中分别制定保护水生生物和人体健康水质标准的建议，避免水质标准对水生生物的"过保护"问题.     

十堰市发展循环经济的思考

地处我国内陆腹地中央山区的湖北十堰,是举世瞩目的南水北调中线工程水源区,又是国家扶贫开发集中联片的重点区, 还是我国承东启西的重要生态功能区。面对中央实施中部崛起战略的大机遇,十堰山区如何把“工业兴市”与“生态立市”有机结合起来,并以此统筹水源区生态建设、县域经济和扶贫开发三大系统工程,不仅是事关全局的重大政治问题,而且是十分紧迫的现实经济问题。本研究运用科学的发展观,以循环经济原理为支撑,透析十堰环境保护与经济发展态势,分析十堰循环经济发展走势,以期通过发展循环经济,推进全市经济、社会、生态的协调发展。     

关于液化石油气码头泄漏火灾应急措施的探讨

分析了液化气泄漏火灾事故的特点，介绍了LPG的理化性质及其危险特性，提出了LPG码头泄漏处置和火灾扑救的方法。     

废塑料与炼焦配煤共焦化产物的分析

利用2kg模拟焦炉，进行了首钢炼焦配煤与北京市石景山区生活垃圾中的废塑料的共焦化实验。研究结果表明，添加废塑料有提高焦油收率和减少水的收率的趋势；但添加废塑料对成焦率、焦油产率及水产率的影响随废塑料处理方法和废塑料添加比例的不同而有差异；采用废塑料型煤或废塑料型煤破碎物与配煤共焦化在提高废塑料添加比例方面具有较大优势。     

连州电厂湿法烟气脱硫系统的综合评价

从技术性能、经济性能两方面对连州电厂的广东省首套石灰石 /石膏湿法烟气脱硫系统进行了全面的评价     

基于"3S"和GSM技术的近海溢油监测应用系统研究

介绍了Visual Basic6．0将“3S”和GSM有机集成中的关键技术以及系统实现的溢油面积、溢油量的计算,接收定位,溢油定位连续动态显示,信息查询,联机之间、控制中心与应急单位互相预警等功能。该系统不但为溢油应急提供指导,同时也为溢油事故的仲裁和索赔提供科学依据。     

膜生物反应器与传统活性污泥工艺除污特性比较

比较了膜生物反应器（MBR）和传统活性污泥工艺（CAS）在相同运行条件下对生活污水的除污特性.结果表明,MBR系统对COD、NH3-N和TN的平均去除率比CAS分别高14.4%、51.2%和37.3%.但MBR中膜的截留使系统相对比较封闭,制约了通过排放高磷污泥的生物法除磷,除磷效率仅为32.9%,低于CAS工艺（43.0%）;将MBR与化学除磷工艺相结合,MBR系统除磷效率可达93.3%.     

单缸摩托车发动机中低速性能优化

目的 解决某单缸摩托车发动机台架测试时中低速扭矩线性度差的问题.方法 基于CFD数值分析方法,运用热力学仿真分析软件GT-Power对发动机进行建模和标定,然后对原方案发动机进行摸底分析,最后通过优化配气机构和进排气系统来实现改善中低速性能的目标.结果 优化后的发动机台架测试结果中,发动机中低速扭矩线性度改善,动力性和经济性及排放都达到项目预期目标,峰值功率达到16 kW(9500 r/min),峰值扭矩达到18.6 N·m(7000 r/min),最低比油耗为183 g/(kW·h),CO、THC、NOx排放量分别为840、83、54 mg/km.配气机构运动学动力学性能与可靠性提升,进排气凸轮丰满系数分别达到5.14、5.15.结论 原方案中低速扭矩线性度差的原因为此转速段充气效率较低.优化凸轮型线、空滤器、消声器、排气管道参数能更好地利用进排气管道谐振效应来提升发动机中低速动力性能.