锰铜铈氧化物催化剂氧化NO性能及动力学研究

实验以TiO2为载体采用浸渍法制备CuOx/TiO2、CeOx/TiO2、CuCeOx/TiO2和MnCuCeOx/TiO2催化剂,考察这些催化剂氧化NO活性,探究Cu、Ce摩尔比和添加Mn元素对CuCeOx/TiO2催化剂氧化NO活性的影响,使用扫描电镜观察催化剂表面结构。研究发现,Cu、Ce元素配合后的CuCeOx/TiO2催化剂氧化活性明显好于单独含Cu、Ce的催化剂,当Cu、Ce摩尔比为Cu:Ce=1∶2时,CuCeOx/TiO2催化剂氧化活性最好,在NO浓度500×10-6,O210%,空速为24 000 h-1,350℃时,NO氧化度为0.62;添加Mn元素可以提高CuCeOx/TiO2催化剂低温氧化活性,250℃时,MnCuCe/Ti-3和MnCuCe/Ti-5催化剂氧化度为0.53和0.69,300℃时,MnCuCe/Ti-3和MnCuCe/Ti-5催化剂氧化度均为0.76;此外,实验还研究了NO在MnCuCe/Ti-3催化剂上反应的动力学方程。     

基于遥感反演长江中游地区悬浮泥沙研究

悬浮泥沙定量研究对于调查长江的水质、地貌、生态环境等起着至关重要的作用。以长江中游武汉地区2012~2013年14幅不同时相的Landsat ETM+遥感影像为主要数据源,结合野外采样悬浮泥沙浓度数据,分析了悬浮泥沙遥感定量反演方法,数据处理中针对ETM+SLC OFF影像缝隙问题,采用自适应局部回归匹配算法（ALR）进行影像自动恢复处理,在波段选择中对悬浮泥沙浓度和光谱反射率数据进行相关性分析,并运用传统关系建模方法和高斯模型方法对比,比较悬浮泥沙定量反演模型,利用实测验证数据对反演模型精度进行评估。研究结果表明：（1）ALR可以有效的获取悬浮泥沙敏感波段的遥感光谱反射率;（2）ETM+Band3悬浮泥沙浓度的高斯模型相关系数最高,通过对比得到模型反演的验证精度较高,研究证明遥感定量反演适合于长江流域武汉段泥沙含量大范围监测     

污水处理厂剩余污泥对凤仙花和万寿菊生长的影响

采用盆栽方式,通过对花卉植物生长状况和各项生理指标的考察,研究了不同污泥施用比对凤仙花(Impatiens balsamina)和万寿菊(Tagetes erecta L.)生长的影响。结果表明,污泥施用比不高于5%(质量分数)时对两种花卉植物发芽有促进作用。在前期,对照组凤仙花和万寿菊生长较好,其株高、叶绿素和可溶性糖含量高于污泥施用组,丙二醛(MDA)含量低于污泥施用组。而在后期,污泥的施用对两种花卉生长促进作用明显,污泥施用组的两种花卉植物株高和各项生理指标优于对照组,尤其是开花状况显著好于对照组。凤仙花和万寿菊较优的污泥施用比分别为3%~5%和1%~5%。     

地下停车库空气污染物排放实测研究

通过对上海市某商业地下停车库库内及排风管道的连续监测,获得了CO、NO、非甲烷总烃(NMHC)、PM10等空气污染物浓度数据。结果表明:(1)地下停车库的休息日车流量明显大于工作日,且工作日小时车流与车位比为20%~50%、休息日小时车流与车位比为20%~80%。(2)总体上,地下停车库内CO、NO、NMHC浓度呈明显变化规律,营业时间现峰值,非营业时间现谷值;地下停车库内CO、NO、NMHC变化规律和车库排风中具有较好的一致性。(3)车库排风中污染物浓度水平均低于地下停车库内。(4)营业时间的CO、NO、NMHC小时浓度平均值明显增大,约为非营业时间的2.42~3.67倍。(5)单车次CO、NOX、NMHC排放量最大值分别为0.855、0.070、0.214g/(辆·次)。(6)营业时间,除地下停车库内CO外,NO、PM10的8h时间加权平均值符合《工作场所有害因素职业接触限值化学有害因素》(GBZ 2.1—2007,其中未规定NMHC)中时间加权平均容许浓度(PC-TWA);地下停车库内CO出现33.3%的超标频率,最大占标率104%。     

火电灰渣场自然恢复下灰渣养分及重金属含量研究

对自然恢复下4类不同年代样地的灰渣养分含量及重金属含量进行研究,通过对比分析发现,有机质、全氮、全钾、全磷含量随着自然恢复时间的增加呈现递增的趋势,全磷含量在各恢复阶段与对照样地之间并不存在显著差异(P0.05)。pH随着恢复时间的增加呈现递减的趋势。对灰渣综合质量指数进行研究发现,自然恢复长期、中期、短期与自然恢复初期对比均有显著提高(P0.05),且随着自然恢复时间的增加灰渣综合质量指数逐渐提高。对灰渣场锌、铅、铜3种重金属研究后发现,在自然恢复下随着时间的增加,灰渣中重金属含量均呈现递减的趋势。     

Crystallization Behavior and Dynamic Mechanical Properties of Poly(l-Lactic Acid) with Poly(Ethylene Glycol) Terminated by Benzoate

Effect of the addition of poly(ethylene glycol) terminated by benzoate (PEG-BA) on the crystallization behavior and dynamic mechanical properties of poly(l-lactic acid) PLLA is studied as compared with poly(ethylene glycol) (PEG-OH). It is found that PEG-BA is miscible with PLLA and shows good plasticizing effect. Because PEG-OH having the same degree of polymerization is immiscible with PLLA, the end group in PEG-BA, i.e., benzoate, plays an important role in the miscibility. Furthermore, PEG-BA does not induce the PLLA degradation at melt-processing, whereas PEG-OH leads to the hydrolysis degradation. Finally, the addition of PEG-BA pronounces the crystallization rate of PLLA at low crystallization temperatures and thus enhances the degree of crystallinity at conventional processing. Consequently, the temperature dependence of dynamic mechanical properties are similar to that for isotactic polypropylene.     

广州市建筑垃圾资源化的必要性分析

摘要：随着广州市城市化进程的不断加快,城市建筑垃圾的排出量也在快速增长,如何应对和处理建筑垃圾所带来的“垃圾围城”困境,已经成为人们不得不面对的重要问题,推进建筑垃圾资源化是开展建筑垃圾综合治理的有效途径。论述了建筑垃圾资源化再生利用的必要性、紧迫性,指出了广州市建筑垃圾资源化过程中存在的问题,为推进广州市建筑垃圾综合处理实践提供了参考。     

Effect of temperature and particle size on the thermal desorption of PCBs from contaminated soil

Thermal desorption is widely used for remediation of soil contaminated with volatiles, such as solvents and distillates. In this study, a soil contaminated with semivolatile polychlorinated biphenyls (PCBs) was sampled at an interim storage point for waste PCB transformers and heated to temperatures from 300 to 600 °C in a flow of nitrogen to investigate the effect of temperature and particle size on thermal desorption. Two size fractions were tested: coarse soil of 420–841 μm and fine soil with particles <250 μm. A PCB removal efficiency of 98.0 % was attained after 1 h of thermal treatment at 600 °C. The residual amount of PCBs in this soil decreased with rising thermal treatment temperature while the amount transferred to the gas phase increased up to 550 °C; at 600 °C, destruction of PCBs became more obvious. At low temperature, the thermally treated soil still had a similar PCB homologue distribution as raw soil, indicating thermal desorption as a main mechanism in removal. Dechlorination and decomposition increasingly occurred at high temperature, since shifts in average chlorination level were observed, from 3.34 in the raw soil to 2.75 in soil treated at 600 °C. Fine soil particles showed higher removal efficiency and destruction efficiency than coarse particles, suggesting that desorption from coarse particles is influenced by mass transfer.     

Some technical issues in managing PCBs

Polychlorinated biphenyls (PCBs) were important industrial chemicals featuring high thermal and chemical stability and low flammability. They were widely used as dielectric and thermal fluid in closed electro-technical applications (transformers, capacitors…) and also in numerous dispersive uses, ranking from auto-copying paper to sealant or coatings. During the 1960s, severe environmental consequences started becoming apparent. The stability of PCBs contributed to their persistence in the environment, their lipophilic character to bio-magnification. Fish-eating species seemed threatened in their existence. In Japan and in Taiwan, thousands of people consumed PCB-contaminated oil. The production of PCBs stopped completely during the 1980s. Usage could continue in closed applications only. In this paper, particular attention is given to two issues: the cleaning of PCB electric transformers and the potential impact of PCB-containing building materials. Other contributions will cover the management and treatment of PCB-contaminated soil, sludge or fly ash. The complete survey is being prepared by request of the Knowledge Center for Engineers and Professionals.     

TiO2-Cu2O/蒙脱土复合光催化剂的制备与性能

以钠基蒙脱土（MMT）为载体,先采用溶胶-凝胶法将纳米TiO₂引入到MMT层间,再采用化学沉积法将纳米Cu₂O负载在TiO₂/MMT上,制备出TiO₂-Cu₂O/MMT纳米复合光催化剂。采用XRD、SEM、紫外-可见漫反射技术对催化剂进行了表征。以甲基橙为目标污染物,考察了催化剂的光催化性能。表征结果显示：TiO₂与Cu₂O均匀分布在MMT的表面与片层孔隙中;TiO₂-Cu₂O/MMT结合了TiO₂和Cu₂O的特性,拓宽了催化剂的光吸收范围。实验结果表明,在光源为可见光、初始甲基橙质量浓度为20 mg/L、光催化剂加入量为2 g/L的条件下,TiO₂-Cu₂O/MMT纳米复合光催化剂对甲基橙的光催化降解效果明显优于单一负载的Cu₂O/MMT和TiO₂/MMT,大幅提高了催化剂的光催化效率,反应300 min时TiO₂-Cu₂O/MMT对甲基橙溶液的脱色率达到93%。