Combined toxic impacts of thiamethoxam and four pesticides on the rare minnow (Gobiocypris rarus)

To examine pesticide mixture toxicity to aqueous organisms, we assessed the single and combined toxicities of thiamethoxam and other four pesticides (chlorpyrifos, beta-cypermethrin, tetraconazole, and azoxystrobin) to the rare minnow (Gobiocypris rarus). Data from 96-h semi-static toxicity assays of various developmental phases (embryonic, larval, juvenile, and adult phases) showed that beta-cypermethrin, chlorpyrifos, and azoxystrobin had the highest toxicities to G. rarus, and their LC₅₀ values ranged from 0.0031 to 0.86 mg a.i. L^?1, from 0.016 to 6.38 mg a.i. L^?1, and from 0.39 to 1.08 mg a.i. L^?1, respectively. Tetraconazole displayed a comparatively high toxicity, and its LC₅₀ values ranged from 3.48 to 16.73 mg a.i. L^?1. By contrast, thiamethoxam exhibited the lowest toxic effect with LC₅₀ values ranging from 37.85 to 351.9 mg a.i. L^?1. Rare minnow larvae were more sensitive than embryos to all the pesticides tested. Our data showed that a pesticide mixture of thiamethoxam–tetraconazole elicited synergetic toxicity to G. rarus. Moreover, pesticide mixtures containing beta-cypermethrin in combination with chlorpyrifos or tetraconazole also had synergetic toxicities to fish. The majority of pesticides are presumed to have additive toxicity, while our data emphasized that the concurrent existence of some chemicals in the aqueous circumstance could cause synergetic toxic effect, leading to severe loss to the aqueous environments in comparison with their single toxicities. Thence, the synergetic impacts of chemical mixtures should be considered when assessing the ecological risk of chemicals.

     

Biodegradable microplastics (BMPs): a new cause for concern?

Environmental Science and Pollution Research - With the increasingly serious pollution of plastics, biodegradable plastics (BDPs) have attracted attention as a new material that can replace...     

Habitat changes in the most important stopover sites for the endangered red-crowned crane in China: a large-scale study

Environmental Science and Pollution Research - The red-crowned crane (Grus japonensis) is an endangered bird species that has been listed as one of the Class I National Key Protected Wild Animals...     

Insight into selected emerging micropollutant interactions with wastewater colloidal organic carbon: implications for water treatment and analysis

Environmental Science and Pollution Research - This study reports how adding a membrane filter (0.45-μm cellulose nitrate filter) between a glass fibre filter and the solid phase extraction...     

涉外火电厂工程环保设计技巧

根据设计经验,针对涉外工程与国内工程设计理念存在一定的差异,对涉外火电厂的环保设计心得和技巧进行了总结,对同类工程环保设计工作具有参考和借鉴作用。     

三线城市电动汽车充电设施规划研究

发展电动汽车是落实我国"节能减排"产业政策的重要举措。电动汽车充电设施是电动汽车发展的基础,其规划将直接影响电动汽车的可持续发展。针对三线城市的特点,从充电方式和电动汽车接入对电网的影响出发,确定了三线城市电动汽车充电设施的规划原则、流程和阶段。     

热阻力概念的修正及计算方法

以隧道火灾为背景,对一维加热管流中的热阻力进行了研究。通过压力场数值模拟与理论分析,直接证实了热阻力的存在,并表明传统概念上的热阻力明显大于实际的能量损失。根据能量方程提出水平无粘管流的热阻力应等于气流经过加热区的全压力降,而非静压力降;等截面管流的热阻力大小应为传统热阻力值的1/2。这一修正使热阻力概念具有了严格的流体力学意义。在定义新的热阻力系数基础上,建立了2个热阻力系数表达式及低马赫数条件下热阻力的近似表达式。将该近似表达式与热损失方程进行对比,表明两者在低马赫数条件下具有一致性。研究成果进一步发展了热阻力理论体系,对隧道火灾及其它相关工程热物理问题的研究与应用都具有重要价值。     

Biochar and cattle manure amendments improve the quality of green waste compost as growing substrate for Centaurea cyanus

Journal of Material Cycles and Waste Management - This study aimed at investigating the impacts of different percentages of biochar (BC) (at 0, 15, and 25%; by vol.) and/or cattle manure (CM) (at...     

岸线码头密度对河道水动力和污染物输移影响分析——以武汉河段为例

为研究岸线码头密度对河流水动力变化及污染物输移的影响,以武汉河段为例,基于Mike21模型建立了适用于该河段的平面二维水动力-水质模型,计算了长为9.6 km的岸线范围内布置不同密度码头群后引起的附近区域内水位、流速变化以及突发水污染事故后的自净能力变化,从空间差异性、最大变幅等角度对比了三者的差异,并归纳了码头密度与水动力条件、污染物浓度变幅之间的关系.结果 表明:(1)随着码头密度增加,工程区上游水位变化较流速更敏感,工程区及下游局部位置水位变幅较小,而流速变化较为敏感,表现为前沿主流区流速增大,近岸区流速减小;当码头密度大于1.25～2.5座/km的临界范围后,水动力条件随码头密度的变幅逐渐减缓.(2)修建码头后,受水动力变化影响,工程区河段上游污染物浓度变化呈"峰前减、峰后增",但工程区下游呈"峰前增、峰后减"的特征;工程区间内表现为主流区浓度增大、近岸带浓度减小、高浓度滞留时间总体增加的变化特点.(3)受码头工程群影响,无论是区间整体上,还是局部范围内,污染物浓度相对水动力条件变幅更大,对河段内水源地的取水可能造成不利影响.以上认识对于河流岸线开发利用规模选取和效应评估具有参考意义.     

Transformation of hazardous lead into aluminosilicate ceramics: structure evolution and lead leaching

This study investigated crystallization mechanisms for the formation of lead aluminosilicate by sintering lead stabilization with kaolin-based precursors. PbAl2Si2O8 was found to be the only stable lead aluminosilicate in low-PbO system and demonstrates its highly intrinsic resistance to acid attack in leaching test. A three-stage PbAl2Si2O8 formation mechanism was supported by the results of the changing temperature in the system. Amorphization of sintered products was observed in both PbO/kaolinite and PbO/mullite systems at 600–700°C. When the temperature was increased to 750–900°C, the crystallochemical formation of lead aluminosilicates (i.e., Pb4Al4Si3O16, Pb6Al6Si2O21, and PbAl2Si2O8) was observed. Pb4Al4Si3O16 and Pb6Al6Si2O21 were found to be the intermediate phases at 700–900°C. Finally, PbAl2Si2O8 was found to be the only crystallite phase to host Pb at above 950°C. A maximum of 80% and 96.7% Pb can be incorporated into PbAl2Si2O8 in PbO/kaolinite and PbO/mullite systems, respectively, but the final products exhibited different microstructures. To reduce environmental hazard of lead, this strategy demonstrated a preferred mechanism of immobilizing lead into PbAl2Si2O8 structure via kaolin-based precursors.