Fenton法氧化处理水中土霉素的研究

为了评价Fenton法预处理抗生素生产废水中残留的高浓度土霉素的可行性,对Fenton试剂(Fe2 -H2O2)法催化氧化降解水溶液中的土霉素进行了研究.探讨了H2O2与Fe2 投加比例、投加量以及起始pH值对降解效果的影响,同时考察了土霉素废水中大量共存的草酸根离子对氧化过程的影响.结果表明,当H2O2与Fe2 按照5:1的比例投加时降解效率最高,最佳初始pH值在3.0-4.0之间.在最佳投加比例下,H2O2投加量为0.9 mmol/L,100 mg/L的土霉素可在10 min内得到完全降解.最佳反应条件下经过处理后土霉素水溶液TOC的去除率达40%左右,可生化性(BOD5/COD)也得到明显的改善.水中共存的草酸根离子对氧化效率具有明显的影响,但通过增加亚铁离子的量可以消除草酸的影响.     

Rhodobacter sp. NP25b菌株缺氧降解壬基酚聚氧乙烯醚的研究

从城市污水处理厂活性污泥中分离得到一株能够在缺氧条件下以壬基酚聚氧乙烯醚(NPEOs)为惟一碳源和能源生长的菌株NP25b.经生理生化鉴定和16S rRNA基因序列分析,该菌株属于红细菌属(Rhodobacter sp.),对该菌株降解NPEOs的特性进行了研究.结果表明,在缺氧条件下,菌株NP25b在7 d内对初始底物浓度为400 mg/L NPEOs的降解率可达84%.利用液相色谱-质谱(LC-MS)和气相色谱-质谱(GC-MS)对NPEOs降解中间产物进行了分析,结果表明,主要降解产物为短链NPEOs和壬基酚聚氧乙烯醚乙酸(NPECs),其中包括具有较强内分泌干扰效应的NP1EO.该菌株能够代谢含有疏水基团的聚氧乙烯醚类表面活性剂,例如辛基酚聚氧乙烯醚和脂肪醇聚氧乙烯醚.推测菌株NP25b降解NPEOs是通过乙氧基(EO)链末端氧化后逐步切割完成的.     

氧化镁基催化剂及脱硝性能研究

为控制燃烧烟气中NOx的污染,对共混合方法制备的氧化镁基催化剂进行烟气直接催化分解法脱硝实验研究,分析模拟烟气脱硝塔内温度及床层高度及氧气浓度、NO浓度和空速对脱硝效率的影响.研究表明:氧化镁基催化剂可以采用直接催化分解法对烟气脱硝,脱硝率85%～95%,氧化镁基催化吸附剂组成为氧化镁、固化剂、添加剂;脱硝的床层高度4～5 cm,脱硝反应温度130～170℃,烟气空速2 500～3 000 h-1;研究推测出氧化镁基催化剂存在活性缺陷,并对脱硝机理进行了初步分析.     

Radiation-induced degradation of methyl orange in aqueous solutions

Degradation of methyl orange under gamma-irradiation was investigated. The reactions followed pseudo first-order kinetics. Apparent degradation rate constant, estimated through linear regression analysis, increased with an increase of dose rate and a decrease of initial methyl orange concentration. Degradation of methyl orange was significantly accelerated under oxidative condition, but was slightly enhanced under reductive condition. However, the result of decoloration was better under reductive condition than oxidative one. An analysis on the intermediates using Fourier transform infrared and gas chromatography/mass spectrometry demonstrates that the radiolytic degradation of methyl orange was processed with different C-N cleavages under oxidative and reductive conditions.     

Sorption of pentachlorophenol on surficial sediments: the roles of metal oxides and organic materials with co-existed copper present

The sorption characteristics of pentachlorophenol (PCP) in the surficial sediments were investigated using a selective extraction procedure. The results show that the Gamma(max) of PCP sorption decreased from 1.60mumolg(-1) to 0.69mumolg(-1) by approximately 60% after selective removal of organic materials from the sediments. The sorption of PCP in the sediments after selective removal of Mn oxides increased nearly up to 600% (from 1.60mumolg(-1) to 11.11mumolg(-1)) and, to a less degree, the PCP sorption in the sediments after simultaneous removal of Fe/Mn oxides (Gamma(max)=3.53mumolg(-1)). The analysis of the data using an additional model indicates that the contribution of Mn oxides to PCP sorption was negative, and Fe oxides and organic materials both have greater potential for sorption of PCP with less contribution from residues including Mn and Fe oxides in the residual fractions determined by a sequential extraction procedure and clay and silicate minerals. The differences in the decreased degrees of PCP sorption with increasing of Cu suggest that competition between Cu and PCP for sorption sites mainly takes place on Fe oxides.     

溶胶凝胶法制备磷钨酸掺杂TiO2薄膜及其光催化性能

以钛酸四丁酯为前驱物,采用溶胶凝胶法制备了磷钨酸掺杂的二氧化钛薄膜。通过XRD、FT-TR对该薄膜进行了表征,研究了薄膜在对氯苯酚光降解中的催化活性。结果表明,当磷钨酸与二氧化钛摩尔比为0.01∶1、薄膜烧结温度600℃、对氯苯酚溶液浓度30 mg/L（pH＝5）、光催化8 h的条件下,对氯苯酚的降解率超过90%,且薄膜可以重复使用。磷钨酸对二氧化钛的光催化活性具有明显的促进作用。     

锌精炼铅塔燃烧系统烟气温度模糊控制研究

针对锌精馏铅塔动态过程中的非线性、非最小相位特征、不稳定性、时滞和负荷干扰,基于模糊控制策略下给出了锌精馏铅塔燃烧系统新的控制方法.运用模糊控制系统对锌精馏铅塔的烟气温度进行仿真研究和实时控制结果表明,该研究所设计的模糊控制器能够克服许多干扰因素,产生了良好的控制效果.     

污水厂污泥一体化竖式强化渗滤浓缩自然干化与消化研究

针对目前国内污泥处理处置存在的问题,为实现污泥浓缩消化一体化,开发了污泥一体化强化渗滤浓缩自然干化与消化新工艺反应器,并进行了城市水厂污泥处理试验.结果表明,在有机负荷为0.8 kg VSS/(m3·d)、平均水力停留时间为8.3 d、污泥停留时间为120 d的条件下,污泥有机物去除率可达到44.4%,排泥含水率达到79.1%,污泥消化与浓缩过程起到了相互促进的作用.渗滤液须抽回至污水处理厂处理.     

Levels of polychlorinated dibenzo-p-dioxins and dibenzofurans in China and chemometric analysis of potential emission sources

Aimed to give a preliminary image of dioxin pollution in China, chemometric analysis was performed to determine background dioxin levels during the period 1994-2002 and potential emission sources. Using principal components analysis (PCA), the congener profiles of 71 sediment samples from rivers, lakes, and sea bays around China were compared with the congener profiles of various known or suspected industrial, residential, and municipal dioxin sources to determine whether the dioxin residues typically found in a broad range of potential environmental sources could explain the presence of these chemicals in China. It was found that the background dioxin levels of China were similar to those of lightly polluted samples from other countries during the period 1994-2002. Primary ferrous ore sintering and secondary lead and aluminum smelters were the major sources of dioxin emission in China. Chloranil and wastewater from chemical plants, sodium pentachlorophenate, and pulp bleaching were also important sources of dioxin emission. Open burning of e-waste as well as diesel-fueled and leaded gas-fueled vehicles were additional possible sources of dioxin. In contrast to other countries, in China, flue gases from incineration of municipal waste, hazardous waste, and medical waste might be minor sources of dioxin emission.     

Assessment of population exposure to particulate matter pollution in Chongqing, China

To determine the population exposure to PM(10) in Chongqing, China, we developed an indirect model by combining information on the time activity patterns of various demographic subgroups with estimates of the PM(10) concentrations in different microenvironments (MEs). The spatial and temporal variations of the exposure to PM(10) were illustrated in a geographical information system (GIS). The population weighted exposure (PWE) for the entire population was 229, 155 and 211 microg/m(3), respectively, in winter, summer and as the annual average. Indoor PM(10) level at home was the largest contributor to the PWE, especially for the rural areas where high pollution levels were found due to solid fuels burning. Elder people had higher PM(10) exposure than adults and youth, due to more time spent in indoor MEs. The highest health risk due to particulate was found in the city zone and northeast regions, suggesting that pollution abatement should be prioritized in these areas.