2013 — 2016年西安市臭氧时空变化特性与影响因素

臭氧污染主要是由前体物氮氧化物（NO_x）和挥发性有机物（VOC）的过量排放引起的,通过NO_x/?SO₂的比值可得知西安地区已经受到了光化学烟雾型污染的影响,大气中臭氧含量与NO_x的含量相关性较高;西安13个站点的8小时平均浓度分布变化大体可分为单峰变化和持续递减类型,浓度主要集中在0?—?90 μg???m^?3,不同站点臭氧含量相差较大;2013?—?2016年,高新西区臭氧超标天数最多,为146天,是超标天数最少的兴庆小区的2倍多。高浓度臭氧主要出现在高温度、低湿度、实时风向为东南风或南风的天气。此外,治理臭氧污染必须限制机动车尾气排放,同时研究表明来自秦岭的植物VOC对于西安臭氧浓度影响很大。     

典型水库型湖泊中CDOM吸收及荧光光谱变化特征:基于沿岸生态系统分析

为进一步了解水库型湖泊溶解性有机质(DOM)的地球化学特征,本文以三峡库区典型内陆水库型湖泊——长寿湖为研究对象,利用紫外-可见和三维荧光光谱,并结合湖区周边生态系统分析,讨论了长寿湖水体中CDOM的组成、来源和空间分布特征.结果表明,长寿湖不同采样点DOM浓度(DOC和CDOM)存在一定程度的空间分布差异,但各点FDOM分布较为稳定.回水区出现DOM累积,由于受陆源输入影响有限,水体内源活动主导,具有较明显"内源控制"特征,芳香性和分子量相对较低;而周边陆地以人工林兼旅游开发为主的采样点,陆源输入在带入较多腐殖化(高芳香性)组分的同时,人为活动排放也是导致其类蛋白组分丰富的重要原因;入湖区尽管周边果林和居民生活对水体DOM有一定影响,但上游河流输入的影响也不容忽视.另外,各采样点也出现了不受周边生态系统影响的独立的相关性特征,例如芳香性特征常数(SUVA280)和光谱斜率[S(275~295)]显著负相关、CDOM和FDOM极显著正相关、CDOM和S(275~295)负相关等.同时,长寿湖水体中CDOM的生色团主要由具有芳香性结构的大分子组分构成;至少51%的CDOM波动可以通过FDOM变化来进行解释,其中回水区荧光组分对CDOM变动的影响最为明显.在采用传统FI值无法区分DOM来源差异性时,结合采样点沿岸生态系统,综合紫外-可见和荧光光谱特征,有助于对DOM组成及来源进行解析.     

北京市新建城区不透水地表径流N、P输出形态特征研究

2010年通过对北京市新建城区典型不透水地表径流水样的采集与分析,研究新建城区地表径流水质特征及其N、P输出形态组成,以期为城市地表径流污染的源区控制提供科学依据.结果表明,北京市新建区典型不透水地表屋面和道路地表径流污染初期冲刷效应显著,屋面径流污染负荷的输出主要集中在初期10 mm径流,而道路径流污染负荷的输出主要集中在初期15 mm径流.屋面地表径流TSS、COD、TN、NH4+-N、NO3--N和TP事件浓度均值分别为50.2、81.7、6.07、2.94、1.05和0.11 mg·L-1;道路地表径流TSS、COD、TN、NH4+-N、NO3--N和TP事件浓度均值分别为539.0、276.4、7.00、1.71、1.51和0.61 mg·L-1.屋面径流颗粒态COD、TN和TP分别占20.8%、12.3%和49.7%,道路径流颗粒态COD、TN和TP分别占68.6%、20.0%和73.6%.屋面径流溶解性氮素占总氮87.7%,其中NH4+-N和NO3--N分别占57.6%和22.5%,道路径流溶解性氮素占总氮的80.0%,其中NH4+-N和NO3--N分别占42.1%和35.0%.城市地表径流污染控制应加强NH4+-N和NO3--N的去除.     

垦殖对湿地土壤有机碳垂直分布及可溶性有机碳截留的影响

通过测定和计算兴凯湖地区沼泽湿地及由其垦殖而来的旱田和水田土壤剖面有机碳含量和密度及土壤剖面不同深度土壤溶液中可溶性有机碳含量,分析了垦殖对兴凯湖周边沼泽湿地土壤有机碳垂直分布及土壤剖面截留可溶性有机碳的影响.结果表明,垦殖显著影响湿地0～40 cm土壤有机碳含量,大豆田和水稻田0～10、10～20、20～30、30～40 cm土壤有机碳含量与湿地相比分别降低了79.07%和82.01%、79.01%和82.28%、79.86%和92.90%、37.49%和78.05%;40 cm以下土层土壤有机碳含量垦殖前后差异不显著.大豆田和水稻田有机碳密度相比沼泽湿地分别降低了25.50%和47.35%,但三者1 m深土壤中大部分的有机碳均是储存在0～50 cm土层中.垦殖前后土壤有机碳含量与深度之间的关系均可用指数函数来描述,垦殖改变了土壤有机碳含量但并未改变其随土壤深度的变化规律.垦殖为大豆田土壤剖面对可溶性有机碳的截留效果较湿地和水稻田更明显,沼泽湿地和水稻田对可溶性有机碳的截留效果大致相当.     

适用于中国燃煤电厂的汞监测及排放控制技术

随着GB 13223—2011《火电厂大气污染物排放标准》的颁布,汞排放问题正式列入了控制目标,这必将对燃煤电厂的环保设施提出新的更高的要求。在综述国外汞监测技术的前提下,总结脱硫脱硝污染物监测的经验,针对中国的具体情况分析了新形势下我国燃煤电厂汞监测技术的发展方向和关键技术的开发重点。同时分析了在最大化地利用燃煤电厂现有环保设施和设备的情况下,如何开发在今后一段时期内最适宜在我国广泛应用的汞排放控制技术,也对国内今后的政策发展进行了预测。     

餐厨垃圾与污水污泥共消化产酸试验研究

研究了餐厨垃圾与污水污泥在不同混合比例、不同污泥停留时间条件下的共消化产酸效果。试验结果表明:当餐厨垃圾与污水污泥TS比为1∶3时,SRT=1 d的反应器酸化效率最高,且乙酸含量占优,产酸效果较佳;当TS之比为1∶1时,各反应器产酸量普遍高于1∶3时,其中SRT=5 d产酸反应器,最高酸化效率达5.94,产酸量最大,且乙酸含量占优,运行效果最佳。     

硫酸钙垢层清洗方法研究

从化学热力学角度和沉淀转化角度,理论上分析了碳酸钠、氢氧化钠分别与硫酸钙发生化学反应的可能性和反应进行的限度。并结合动力学规律,提出影响化学反应的条件,通过实验进行检验。最后提出,在实际工作中,达到良好清洗目的可采取的措施。     

Photocatalytic activity of TiO2 containing anatase nanoparticles and rutile nanoflower structure consisting of nanorods

A series of TiO2 with different crystal phases and morphologies was synthesized via a facile hydrothermal process using titanium nbutoxide and concentrated hydrochloric acid as raw materials. The photocatalytic activity of the samples was evaluated by degradation of Methyl Orange in aqueous solution under UV-Visible light irradiation. On the basis of detailed analysis of the characterizing results of high-resolution transmission electron microscopy, X-ray powder diffraction measurements, X-ray photoelectron spectroscopy and Brunauer-Emmett-Teller measurement, it was concluded that the photo-activity of the catalyst is related directly to the 3D morphology and the crystal phase composition. An excellent catalyst should have both a futile 3D flower-like structure and anatase granulous particles. The 3D flower-like structure could enhance light harvesting, as well as the transfer of reactant molecules from bulk solution to the reactive sites on TiO2. In addition, the optimum anatase/rutile phase ratio was found to be 80：20, which is beneficial to the effective separation of the photogenerated electron-hole pairs.     

Enhanced photocatalytic activity of quantum-dot-sensitized one-dimensionally-ordered ZnO nanorod photocatalyst

An efficient photocatalyst was fabricated by assembling quantum dots （QDs） onto one-dimensionally-ordered ZnO nanorods, and the photocatalytic properties for Methyl Orange degradation were investigated by scanning electron microscopy, transmission electron microscopy, X-ray diffraction, UV-Vis-NIR absorption spectroscopy and photoluminescence. The results indicate that the catalyst with assembled QDs is more favorable for the degradation than the pristine ZnO nanorods. The QDs with core-shell structure lower the photocatalytic ability due to the higher carder transport barrier of the ZnS shell layer. Besides its degradation efficiency, the photocatalyst has several advantages given that the one-dimensionally-ordered ZnO nanorods have been grown directly on indium tin oxide substrates. The article provides a new method to design an effective and easily recyclable photocatalyst.     

Preparation of MgO/B2O3 coatings by plasma spraying on SUS304 surface and effects of heat-resistant

This study mainly deals with the preparation of MgO/B₂O₃ coatings by plasma spraying on the SUS304 surface and the effects of heatresistant. The power materials of low thermal conductivity were selected to control the heat divergent performance of high temperature parts. The reticular micro-structure between the cover thermal layer and the substrate was prepared by using the plasma spraying method. The powder mixture of MgO and B₂O₃ were selected as spraying materials and the SUS304 was used as the substrate material. The MgO/B₂O₃ coating was prepared on the surface of the SUS304 to provide better cover thermal performance. The properties of the microstructures and the morphologies were studied by Optical Microscope, Scanning Electron Microscope, Electron Probe Microanalyzer, and X-ray Diffraction. The results showed that the cover thermal performance has been improved.