Application of a Chemical Mass Balance Receptor Model to Respirable Particulate Matter in Mexico City

Mexico City frequently experiences high levels of air pollution. This is due mainly to its topography and meteorology that suppress pollutant diffusion and dispersion. The atmospheric mixing is extremely poor, especially during the dry winter months. The levels of certain pollutants, such as particulate matter, are of concern since they have severe effects on public health. Visibility deterioration is one of the most noticeable effects in large cities. Biological effects of particulate matter on man and animals, ranging from mild eye irritation to death, have been reported. The effects depend on the size of the particles, their solubility, and toxicity. The main objective of this paper is to present the results of a chemical mass balance receptor model applied to a well-characterized data set of particulate matter collected in the Mexico City Metropolitan Area (MCMA). Samples of particulate matter were collected using a denuder and a Hi-Vol system for the respi-rable fraction and total suspended particles, respectively. In this paper the analysis of a database consisting of the chemical composition of 33 samples of respirable particulate matter (aerosols with diameter less than 2.5 µm) is presented. The 12-hour samples were acquired during day and night periods in a typical medium-income neighborhood from December 19, 1989 through February 5, 1990.     

Distribution coefficients of potentially toxic elements in soils from the eastern Amazon

The solid-solution distribution or partition coefficient (Kd) is a measure of affinity of potentially toxic elements (PTE) for soil colloids. Kd plays a key role in several models for defining PTE guideline values in soils and for assessing environmental risks, and its value depends on edaphic and climatic conditions of the sites where the soils occur. This study quantified Kd values for Cd, Co, Cr, Cu, Hg, Ni, Pb, and Zn from representative soil samples from Brazil’s eastern Amazon region, which measures 1.2 million km². The Kd values obtained were lower than those set by both international and Brazilian environmental agencies and were correlated with the pH, Fe and Mn oxide content, and cationic exchange capacity of the soils. The following order of decreasing affinity was observed: Pb?>?Cu?>?Hg?>?Cr?>?Cd?≈?Co?>?Ni?>?Zn.     

Thermal valorization of post-consumer film waste in a bubbling bed gasifier

The use of plastic bags and film packaging is very frequent in manifold sectors and film waste is usually present in different sources of municipal and industrial wastes. A significant part of it is not suitable for mechanical recycling but could be safely transformed into a valuable gas by means of thermal valorization. In this research, the gasification of film wastes has been experimentally investigated through experiments in a fluidized bed reactor of two reference polymers, polyethylene and polypropylene, and actual post-consumer film waste. After a complete experimental characterization of the three materials, several gasification experiments have been performed to analyze the influence of the fuel and of equivalence ratio on gas production and composition, on tar generation and on efficiency. The experiments prove that film waste and analogue polymer derived wastes can be successfully gasified in a fluidized bed reactor, yielding a gas with a higher heating value in a range from 3.6 to 5.6 MJ/m³ and cold gas efficiencies up to 60%.     

Antiradical activity of natural honeys and antifungal effect against Penicillium genera

The purpose of the study was to examine the antiradical activity of 11 natural honeys and to evaluate the antifungal properties of honey. Honey samples (10) were collected from different locations of Slovak Republic. Honeys were native to different plant species of Robinia pseudoacaccia, Brassica napus subs. napus, Castanea sativa Mill. Thymus serpyllum vulgaris and the other samples had multifloral origin. The low antiradical activitity in honey samples was determined. The best results were found in thyme honey from Rhodos (11.84 %) and Castanea honey from Nitra (10.61 %). The lowest antiradical activity was found in Acacia honey and determined to be 7.62 %. Statistically significant differences (P< 0.001) were found among thyme/Rhodos and Castanea/Nitra. The antifungal activities of honey samples were tested by 10 %, 25 % and 50 % (by mass per volume) concentration against fungi Penicillium crustosum, P. expansum, P. griseofulvum, P. raistrickii and P. verrucosum and by the agar well diffusion method. The solutions containing 10 % (by mass per volume) of honey did not have any effect on the growth of fungi. The strongest antifungal effect was shown by 50 % honey concentration against P. raistrickii.     

Environmental monitoring of water resources around a municipal landfill of the Rio Grande do Sul state,Brazil

Environmental Science and Pollution Research - In Brazil, landfills are commonly used as a method for the final disposal of waste that is compliant with the legislation. This technique, however,...     

Atmospheric influence on the distribution of organic pollutants in the Guadalquivir River estuary, SW Spain

In the lower Guadalquivir river basin, a system stressed by a wide variety of anthropogenic activities, eight pesticides (four triazines, two chloroacetanilide herbicides, one organochlorine, and one organophosphorus insecticide); and four emerging pollutants (two personal care products, one organophosphorous flame retardant, and one xanthine alkaloid) were analyzed in river water during a 2-year monitoring program, and after rain episodes. Samples were extracted using the solid phase extraction (SPE) technique prior to determination of compounds using gas chromatograph coupled to a mass spectrometer detector. Except for caffeine, recoveries were mostly above 80 %, while limits of detection and quantification were in the low nanograms per liter level (except for dimethoate). Terbuthylazine, simazine (triazine herbicides), and dimethoate (organophosphorus insecticide), present in agrochemicals, were predominant in the river water, although concentrations were below the quality standards established by the EU Water-Framework-Directive. A general trend to increase concentration was observed after rain events, in particular for pesticides, possibly as a consequence of surface runoff.     

Validation of a multiclass multiresidue method and monitoring results for 210 pesticides in fruits and vegetables by gas chromatography-triple quadrupole mass spectrometry

A rapid, sensitive, accurate and reliable multiresidue method for the identification and quantification of 210 relevant pesticides in four representative fruit and vegetable commodities (tomato, potato, spring onion and orange) has been developed and validated by gas chromatography in tandem with triple quadrupole mass spectrometry. The method has been fully validated and applied to 292 samples from different countries. Prior to instrumental analysis, an extraction procedure based on a sample extraction of multiclass analytes, using the ethyl acetate method was employed. Mass spectrometric conditions were individually optimized for each compound in the selected reaction monitoring (SRM) mode to achieve maximum sensitivity. The pesticides were separated in less than 25 min. This was followed by an exhaustive control of the retention times. The Retention Time Locking Method was applied, working at a constant pressure throughout the analysis. System maintenance was reduced by using a purged capillary flow device that provided backflush capabilities by reversing column flow immediately after elution of the last compound of interest. Istotopically labelled internal standards were employed to improve the quality of the analytical results.     

Metal extractability patterns to evaluate (potentially) mobile fractions in periurban calcareous agricultural soils in the Mediterranean area—analytical and mineralogical approaches

A set of periurban calcareous agricultural Mediterranean soils was spiked with a mixture of Cd, Cu, Pb and Zn at two levels within the limit values proposed by current European legislation, incubated for up to 12 months, and subjected to various one-step extraction procedures to estimate mobile (neutral salts) and potentially mobile metal fractions (complexing and acidic extraction methods). The results obtained were used to study metal extractability patterns according to the soil characteristics. The analytical data were coupled with mineralogical investigations and speciation modelling using the Visual Minteq model. The formation of soluble metal-complexes in the complexing extracts (predicted by the Visual Minteq calculations) led to the highest extraction efficiency with complexing extractants. Metal extractability patterns were related to both content and composition of carbonate, organic matter, Fe oxide and clay fractions. Potentially mobile metal fractions were mainly affected by the finest soil fractions (recalcitrant organic matter, active lime and clay minerals). In the case of Pb, scarce correlations between extractable Pb and soil constituents were obtained which was attributed to high Pb retention due to the formation of 4PbCO₃·3PbO (corroborated by X-ray diffraction). In summary, the high metal proportion extracted with complexing agents highlighted the high but finite capacity to store potentially mobilizable metals and the possible vulnerability of these soils against environmental impact from metal accumulation.     

Study of the solubility and stability of polystyrene wastes in a dissolution recycling process

Dissolution with suitable solvents is one of the cheapest and more efficient processes for polystyrene waste management. In this work the solubility of polystyrene foams in several solvents benzene, toluene, xylene, tetrahydrofuran, chloroform, 1,3-butanediol, 2-butanol, linalool, geraniol, d-limonene, p-cymene, terpinene, phellandrene, terpineol, menthol, eucalyptol, cinnamaldheyde, nitrobenzene, N,N-dimethylformamide and water has been determined.Experimental results have shown that to develop a “green process” the constituents of essential oils, d-limonene, p-cymene, terpinene, phellandrene, are the most appropriate solvents. The action of these solvent does not produce any degradation of polymer chains. The solubility of the polymer in the mentioned solvents at different temperatures has been investigated. The solvent can be easily recycled by distillation.